Misleading conduct arising from public statements : establishing the knowledge base of the target audience

Despite the very substantial body of primary sources and secondary literature on Australia’s much-litigated statutory provisions proscribing misleading or deceptive conduct, the courts have provided little in the way of assistance about how to establish the knowledge base of the target audience at whom the public statement was directed. The purpose of this case note is to compare and contrast two recent decisions of the High Court of Australia that highlight the difficulties faced by applicants in attempting to establish a contravention of the relevant legislation where conduct is directed at a segment of the public or the public as a whole.

Design and experimental testing of air slab caps which convert commercial electron diodes into dual purpose, correction-free diodes for small field dosimetry

Purpose Two diodes which do not require correction factors for small field relative output measurements are designed and validated using experimental methodology. This was achieved by adding an air layer above the active volume of the diode detectors, which canceled out the increase in response of the diodes in small fields relative to standard field sizes. Methods Due to the increased density of silicon and other components within a diode, additional electrons are created. In very small fields, a very small air gap acts as an effective filter of electrons with a high angle of incidence. The aim was to design a diode that balanced these perturbations to give a response similar to a water-only geometry. Three thicknesses of air were placed at the proximal end of a PTW 60017 electron diode (PTWe) using an adjustable “air cap”. A set of output ratios (ORfclin Det ) for square field sizes of side length down to 5 mm was measured using each air thickness and compared to ORfclin Det measured using an IBA stereotactic field diode (SFD). k fclin, f msr Qclin,Qmsr was transferred from the SFD to the PTWe diode and plotted as a function of air gap thickness for each field size. This enabled the optimal air gap thickness to be obtained by observing which thickness of air was required such that k fclin, f msr Qclin,Qmsr was equal to 1.00 at all field sizes. A similar procedure was used to find the optimal air thickness required to make a modified Sun Nuclear EDGE detector (EDGEe) which s “correction-free” in small field relative dosimetry. In addition, the feasibility of experimentally transferring k fclin, f msr Qclin,Qmsr values from the SFD to unknown diodes was tested by comparing the experimentally transferred k fclin, f msr Qclin,Qmsr values for unmodified PTWe and EDGEe diodes to Monte Carlo simulated values. Results 1.0 mm of air was required to make the PTWe diode correction-free. This modified diode (PTWeair) produced output factors equivalent to those in water at all field sizes (5–50 mm). The optimal air thickness required for the EDGEe diode was found to be 0.6 mm. The modified diode (EDGEeair) produced output factors equivalent to those in water, except at field sizes of 8 and 10 mm where it measured approximately 2% greater than the relative dose to water. The experimentally calculated k fclin, f msr Qclin,Qmsr for both the PTWe and the EDGEe diodes (without air) matched Monte Carlo simulated results, thus proving that it is feasible to transfer k fclin, f msr Qclin,Qmsr from one commercially available detector to another using experimental methods and the recommended experimental setup. Conclusions It is possible to create a diode which does not require corrections for small field output factor measurements. This has been performed and verified experimentally. The ability of a detector to be “correction-free” depends strongly on its design and composition. A nonwater-equivalent detector can only be “correction-free” if competing perturbations of the beam cancel out at all field sizes. This should not be confused with true water equivalency of a detector.

Occupational Health and Safety, Courts and Crime: the legal construction of occupational health and safety offences in Victoria

This book reports on an empirically-based study of the manner in which the Magistrates' Courts in Victoria, construct occupational health and safety (OHS) issues when hearing prosecutions for offences under the Victorian OHS legislation. Prosecution has always been a controversial element in the enforcement armoury of OHS regulators, but at the same time it has long been argued that the low level of fines imposed by courts has had an important chilling effect on the OHS inspectorate's enforcement approaches, and on the impact of OHS legislation. Using a range of empirical research methods, including three samples of OHS prosecutions carried out in the Victorian Magistrates' Courts, Professor Johnstone shows how courts, inspectors, prosecutors and defence counsel are involved in filtering or reshaping OHS issues during the prosecution process, both pre-trial and in court. He argues that OHS offences are constructed by focusing on "events", in most cases incidents resulting in injury or death. This "event-focus" ensures that the attention of the parties is drawn to the details of the incident, and away from the broader context of the event. During the court-based sentencing process defence counsel is able to adopt a range of techniques which isolate the incident from its micro and macro contexts, thereby individualising and decontextualising the incident.

Safety, courts and crime: occupational safety and health prosecutions in the Magistrates' courts

This paper reports on an empirically based study of occupational safety and health prosecutions in the Magistrates' courts in the State of Victoria, Australia. It examines the way in which the courts construct occupational safety and health issues during prosecutions against alleged offenders, and then theorises the role of the criminal law in health and safety regulation. The paper argues that courts, inspectors, prosecutors and defence counsel are involved in filtering or reshaping occupational safety and health issues during the prosecution process, both pre-trial and in court. An analysis of the pattern of investigation of health and safety offences shows that they are constructed by focusing on 'events', in most cases incidents resulting in injury or death. This 'event focus' ensures that the attention of the parties is drawn to the details of the incident and away from the broader context of the event. This broader context includes the way in which work is organised at the workplace and the quality of occupational safety and health management (the micro context), and the pressures within capitalist production systems for occupational safety and health to be subordinated to production imperatives (the macro context). In particular, during the court-based sentencing process, defence counsel is able to adopt a range of 'isolation' techniques that isolate the incident from its micro and macro contexts, thereby individualising and decontextualising the incident. The paper concludes that the legal system plays a key role in decontextualising and individualising health and safety issues, and that this process is part of the 'architecture' of the legal system, and a direct consequence of the 'form of law'.

The defence of hardship to specific performance actions

The decision of Evans v Robcorp Pty Ltd[2014] QSC 26 is of interest as being an instance where the defence of hardship, in this case, financial hardship, was successfully pleaded in defence to a summary application for specific performance of a contract for the sale of land. Equity has always recognised the defence of hardship in response to an action for specific performance which, as an equitable remedy, might be refused in the discretion of the Court (Hewett v Court (1983) 149 CLR 639 at 664). However, whilst the remedy is discretionary, there are certain accepted principles which have guided the courts in their application of this defence to particular facts. It is not a blanket defence to a claim for specific performance where the buyer simply does not have the funds to complete the contract at the time when settlement is called for. Occasionally, a radical change in, say for instance, the health of the defendant between contract and completion, perhaps coupled with a long delay by a seller in calling for completion not being the fault of the buyer might enliven the defence (Patel v Ali [1984]1 Ch 283)

Commercial friendships between gay salesmen and straight female customers

Perhaps it is now sacrosanct in marketing to contemplate that many service encounters, especially those in retail settings, are social encounters in which bonds between and among customers and employees are critical drivers of consumption (Beatty et al., 1996; Rosenbaum, 2006). Indeed, within retail settings, it is often possible for salespeople and customers to form so-called “commercial friendships” (Price and Arnould, 1999). These friendships result in both salespeople and their customers having social interactions that are close to those experienced in personal friendships (Swan et al., 2001), and which are extremely satisfying for all parties. Outside of marketing, the social science literature (Grigoriou, 2004; Rumens, 2008; Russell, DelPriore, Butterfield, and Hill, 2013) and popular press (de la Cruz and Dolby, 2007; Hopcke and Rafaty, 1999; Tilmann-Healy, 2001, Whitney, 1990) is replete with knowledge regarding the “absolutely fabulous” friendships (Hopcke and Rafaty, 1999) that often form between gay men and straight women. In fact, Western culture regularly highlights the compatibility of gay men and straight women in film, television, and writing, to the extent that they have now influenced popular thinking on the topic, so that gay men and straight females are viewed as sharing common plights and interests (Rumens, 2008). Yet, thus far, marketing researchers have looked askance at the effect of friendships between gay male employees and heterosexual female customers in consumption settings, such as retail stores and boutiques. Indeed, with the exception of Peretz’s (1995) participant observation regarding how young and outwardly gay salesmen use their ambiguous gender to sell women’s clothing, in a Paris-based luxury boutique, any theoretical explorations regarding retail-based commercial friendships between gay salesmen and female customers are non-existent—until now. This research addresses this apparent chasm in the literature by putting forth an original framework that shows how the emotional closeness between gay salesmen and female customers, due to the absence of sexual interest and inter-female competition, results in an intense emotional closeness, that facilitates pleasurable retail transactions, customer satisfaction, loyalty, and positive word-of-mouth. In doing so, this work extends the commercial friendship paradigm by considering retail-based, commercial friendships between an under-researched marketplace dyad; gay men and straight females. It is worth noting here that some straight women may find the idea of commercial friendships with gay salesmen as undesirable, due to the very notion of having relationships with retail organizations or employees (Noble and Phillips, 2004), or a personal disdain for homosexuality.

Competition Law in Australia [6th ed.]

Competition Law in Australia, 6th edition provides a comprehensive discussion of the provisions of the Competition and Consumer Act 2010 (Cth) (CCA) dealing with the regulation of competition and markets in Australia. This book covers disparate topics, such as restrictions in horizontal and vertical agreements, horizontal mergers and acquisitions, misuse of market power, and access to services necessary to compete in upstream or downstream markets. However, the unifying theme of this text is that it is not possible to use a formalistic approach in applying the CCA. The decisions of the courts, and the competition authorities responsible for implementing and enforcing the CCA, underline the need to undertake a detailed substantive economic analysis of the effect of the agreement or conduct at issue on competition, efficiency and consumer welfare.

An Australian perspective on the ALI-III global principles for cooperation in International insolvency cases

In 2012, Professor Ian Fletcher (United Kingdom) and Professor Bob Wessels (The Netherlands) presented a Report to the American Law Institute and the International Insolvency Institute entitled Transnational Insolvency: Global Principles for Cooperation in International Insolvency Cases (“Global Principles”). This followed their appointment as Joint Reporters to investigate whether the essential provisions of the American Law Institute Principles of Cooperation among the North American Free Trade Agreement Countries with their annexed Guidelines Applicable to Court-to-Court Communication in Cross-border Cases may, with certain necessary modifications, be acceptable for use by jurisdictions across the world. This article comments on the Global Principles from the perspective of a jurisdiction which has adopted the UNCITRAL Model Law on Cross-border Insolvency (“Model Law”). In 2008, Australia enacted a standalone statute, the Cross-border Insolvency Act 2008 (Cth) to which is annexed the Model Law. In that process, it made minimal changes to the Model Law text. Against the background of the 2008 Act, related procedural laws as well as Australia’s general insolvency statutes and recent cross-border insolvency jurisprudence, this article comments on the potential relevance of the Transnational Insolvency Report as a point of reference for Australian courts and insolvency administrators when addressing international insolvency cases. By comparing the Global Principles with the Model Law as closely adopted in Australia, this analysis is a resource for other Model Law jurisdictions when considering the potential relevance of the Global Principles for their own international insolvency practice.

Developments in court to court communications in International insolvency cases

As business increasingly operates on a global basis, courts are called upon more often to adjudicate insolvency cases with international connections. The financial collapse of Lehman Brothers Holding Inc (‘Lehman Holdings’) provides a recent example where courts across many jurisdictions were called upon to determine issues arising from a multistate insolvent enterprise. Lehman Holdings filed for Chapter 11 bankruptcy protection in the United States on 15 September 2008. Lehman Brothers was the fourth largest investment bank in America and the largest company ever to file for bankruptcy in the United States. However the effects of its collapse were felt worldwide, including within Australia.

Design & performance of a networked ad-hoc acoustic communications system using inexpensive commercial CDMA modems

We present a new approach for creating and implementing an ad-hoc underwater acoustic sensor network based on connecting a small processor to the serial port of a commercial CDMA acoustic modem. The processor acts as a "node controller" providing the networking layer that the modems lack. The ad-hoc networking protocol is based on a modified dynamic source routing (DSR) approach and can be configured for maximising information throughput or minimising energy expenditure. The system was developed in simulation and then evaluated during field trials using a 10 node deployment. Experimental results show reliable multi-hop networking under a variety of network configurations, with the added ability to determine internode ranges to within 1.5 m for localisation.