Source apportionment of ultrafine and fine particle concentrations in Brisbane, Australia

Purpose: To investigate the significance of sources around measurement sites, assist the development of control strategies for the important sources and mitigate the adverse effects of air pollution due to particle size. Methods: In this study, sampling was conducted at two sites located in urban/industrial and residential areas situated at roadsides along the Brisbane Urban Corridor. Ultrafine and fine particle measurements obtained at the two sites in June-July 2002 were analysed by Positive Matrix Factorization (PMF). Results: Six sources were present, including local traffic, two traffic sources, biomass burning, and two currently unidentified sources. Secondary particles had a significant impact at Site 1, while nitrates, peak traffic hours and main roads located close to the source also affected the results for both sites. Conclusions: This significant traffic corridor exemplifies the type of sources present in heavily trafficked locations and future attempts to control pollution in this type of environment could focus on the sources that were identified.

Tourist use of mopeds in Queensland

Tourist use of mopeds in Queensland is encouraged by licensing regulations permitting moped riding for car licence holders, who may lack prior knowledge or experience of moped or motorcycle use. Using official crash and registration data, this research examines moped use by tourists, identified as crash-involved riders holding an interstate or overseas licence. Tourists were more likely to be younger, female, in single vehicle crashes, and deemed at fault than Queensland licence holders. Potential safety issues include poor riding skills, inexperience, inattention and lack of protective clothing. Moped rental companies play an important role in managing client crash and injury risks. These risks could also be reduced through introduction of more stringent licensing requirements, though this may be detrimental to moped rental companies as well as to tourist mobility and enjoyment. The discussion considers the relevance of adventure tourism perspectives and theory to the use of mopeds by tourists.

Observational research and verbal protocol methods

This paper describes observational research and verbal protocols methods, how these methods are applied and integrated within different contexts, and how they complement each other. The first case study focuses on nurses’ interaction during bandaging of patients’ lower legs. To maintain research rigor a triangulation approach was applied that links observations of current procedures, ‘talk-aloud’ protocol during interaction and retrospective protocol. Maps of interactions demonstrated that some nurses bandage more intuitively than others. Nurses who bandage intuitively assemble long sequences of bandaging actions while nurses who bandage less intuitively ‘focus-shift’ in between bandaging actions. Thus different levels of expertise have been identified. The second case study consists of two laboratory experiments. It focuses on analysing and comparing software and product design teams and how they approached a design problem. It is based on the observational and verbal data analysis. The coding scheme applied evolved during the analysis of the activity of each team and is identical for all teams. The structure of knowledge captured from the analysis of the design team maps of interaction is identified. The significance of this work is within its methodological approach. The maps of interaction are instrumental for understanding the activities and interactions of the people observed. By examining the maps of interaction, it is possible to draw conclusions about interactions, structure of knowledge captured and level of expertise. This research approach is transferable to other design domains. Designers will be able to transfer the interaction maps outcomes to systems and services they design.

Potential dietary consquences of food insecurity among Australian adults residing in urbanised disadvantaged areas

Introduction: Food insecurity is the limited/uncertain availability, access to or ability to acquire nutritionally-adequate, culturallyrelevant and safe foods. Adults suffering from food insecurity are at risk of inadequate nutrient intakes or, paradoxically, overweight/ obesity and the development of chronic disease. Despite the global financial crisis and rising costs of living, there are few studies investigating the potential dietary consequences of food insecurity among the Australian population. This study examined whether food insecurity was associated with weight status and poorer intakes of fruits, vegetable and takeaway foods among adults residing in socioeconomically-disadvantaged urbanised areas. Methods: In this cross-sectional study, a random sample of residents (n=1000) were selected from the most disadvantaged suburbs of Brisbane city (response rate 51%). Data were collected by postal questionnaire which ascertained information on sociodemographic information, household food security status, height, weight, fruit and vegetable intakes and takeaway consumption. Data were analysed using chi-square and logistic regression. Results: The overall prevalence of food insecurity was 31%. Food insecurity was not associated with weight status among men or women. Associations between food security status and potential dietary consequences differed for men and women. Among women, food security was not associated with intakes of fruit, vegetable or takeaway consumption. Contrastingly, among men food security was associated with vegetable intakes and consumption of takeaway food: men reporting food insecurity had lower intakes of vegetables and were more likely to consume takeaway foods compared to those that were food secure. Conclusion: Food security is an important public health issue in Australia and has potential dietary consequences that may adversely affect the health of food-insecure groups, most notably men residing in food-insecure households.

Potential health and dietary consequences of food insecurity among Australian adults residing in urbanised disadvantaged areas

Purpose: Food insecurity is the limited/uncertain availability or ability to acquire nutritionally-adequate, culturally-relevant and safe foods. Adults suffering from food insecurity are at risk of inadequate nutrient intakes or, paradoxically, overweight/obesity and the development of chronic disease. Despite the global financial crisis and rising costs of living, few studies have investigated the potential dietary and health consequences of food insecurity among the Australian population. This study examined whether food insecurity was associated with health behaviours and dietary intakes among adults residing in socioeconomically-disadvantaged urbanised areas. Methods: In this cross-sectional study, a random sample of residents (n = 1000) were selected from the most disadvantaged suburbs of Brisbane city (response rate 51%). Data were collected by postal questionnaire which ascertained information on socio-demographic information, household food security, height, weight, frequency of healthcare utilisation, presence of chronic disease and intakes of fruit, vegetables and take-away. Data were analysed using logistic regression. Results/Findings: The prevalence of food insecurity was 25%. Those reporting food insecurity were two-to-three times more likely to have seen a general practitioner or been hospitalised within the previous 6 months. Furthermore, food insecurity was associated with a three-to-six-fold increase in the likelihood of experiencing depression. Food insecurity was associated with higher intakes of some take-away foods, however was not significantly associated with weight status or intakes of fruits or vegetables among this disadvantaged sample. Conclusion: Food insecurity has potential adverse health consequences that may result in significant health burdens among the population, and this may be concentrated in socioeconomically-disadvantaged suburbs.

An introduction to mixed methods research for nephrology nurses

Mixed methods research is the use of qualitative and quantitative methods in the same study to gain a more rounded and holistic understanding of the phenomena under investigation. This type of research approach is gaining popularity in the nursing literature as a way to understand the complexity of nursing care and as a means to enhance evidenced-based practice. This paper introduces nephrology nurses to mixed methods research, its terminology and application to nephrology nursing. Five common mixed methods designs will be described highlighting the purposes, strengths and weaknesses of each design. Examples of mixed methods research will be given to illustrate the wide application of mixed methods research to nursing and its usefulness in nephrology nursing research.

Direct fabrication as a patient-targeted therapeutic in a clinical environment

A paradigm shift is taking place in orthopaedic and reconstructive surgery. This transition from using medical devices and tissue grafts towards the utilization of a tissue engineering approach combines biodegradable scaffolds with cells and/or biological molecules in order to repair and/or regenerate tissues. One of the potential benefits offered by solid freeform fabrication (SFF) technologies is the ability to create such biodegradable scaffolds with highly reproducible architecture and compositional variation across the entire scaffold due to their tightly controlled computer-driven fabrication. Many of these biologically activated materials can induce bone formation at ectopic and orthotopic sites, but they have not yet gained widespread use due to several continuing limitations, including poor mechanical properties, difficulties in intraoperative handling, lack of porosity suitable for cellular and vascular infiltration, and suboptimal degradation characteristics. In this chapter, we define scaffold properties and attempt to provide some broad criteria and constraints for scaffold design and fabrication in combination with growth factors for bone engineering applications. Lastly, we comment on the current and future developments in the field, such as the functionalization of novel composite scaffolds with combinations of growth factors designed to promote cell attachment, cell survival, vascular ingrowth, and osteoinduction.

Within-subject intra- and inter-method consistency of two experimental risk attitude elicitation methods

We compare the consistency of choices in two methods to used elicit risk preferences on an aggregate as well as on an individual level. We asked subjects to choose twice from a list of nine decision between two lotteries, as introduced by Holt and Laury (2002, 2005) alternating with nine decisions using the budget approach introduced by Andreoni and Harbaugh (2009). We find that while on an aggregate(subject pool) level the results are (roughly) consistent, on an individual(within-subject) level,behavior is far from consistent. Within each method as well as across methods we observe low correlations. This again questions the reliability of experimental risk elicitation measures and the ability to use results from such methods to control for the risk aversion of subjects when explaining e�ects in other experimental games.

Foundations of International Climate Law : Objectives, principles and methods

This chapter explores the objectives, principle and methods of climate law. The United Nations Framework Convention on Climate Change (UNFCCC) lays the foundations of the international regime by setting out its ultimate objectives in Article 2, the key principles in Article 3, and the methods of the regime in Article 4. The ultimate objective of the regime – to avoid dangerous anthropogenic interference – is examined and assessments of the Intergovernmental Panel on Climate Change (IPCC) are considered when seeking to understand the definition of this concept. The international environmental principles of: state sovereignty and responsibility, preventative action, cooperation, sustainable development, precaution, polluter pays and common but differentiated responsibility are then examined and their incorporation within the international climate regime instruments evaluated. This is followed by an examination of the methods used by the mitigation and adaptation regimes in seeking to achieve the objective of the UNFCCC. Methods of the mitigation regime include: domestic implementation of policies, setting of standards and targets and allocation of rights, use of flexibility mechanisms, and reporting. While it is noted that methods of the adaptation regime are still evolving, the latter includes measures such as impact assessments, national adaptation plans and the provision of funding.

Guerrilla research tactics: alternative research methods

This case-study explores alternative and experimental methods of research data acquisition, through an emerging research methodology, ‘Guerrilla Research Tactics’ [GRT]. The premise is that the researcher develops covert tactics for attracting and engaging with research participants. These methods range between simple analogue interventions to physical bespoke artefacts which contain an embedded digital link to a live, interactive data collecting resource, such as an online poll, survey or similar. These artefacts are purposefully placed in environments where the researcher anticipates an encounter and response from the potential research participant. The choice of design and placement of artefacts is specific and intentional. DESCRIPTION: Additional information may include: the outcomes; key factors or principles that contribute to its effectiveness; anticipated impact/evidence of impact. This case-study assesses the application of ‘Guerrilla Research Tactics’ [GRT] Methodology as an alternative, engaging and interactive method of data acquisition for higher degree research. Extending Gauntlett’s definition of ‘new creative methods… an alternative to language driven qualitative research methods' (2007), this case-study contributes to the existing body of literature addressing creative and interactive approaches to HDR data collection. The case-study was undertaken with Masters of Architecture and Urban Design research students at QUT, in 2012. Typically students within these creative disciplines view research as a taxing and boring process, distracting them from their studio design focus. An obstacle that many students face, is acquiring data from their intended participant groups. In response to these challenges the authors worked with students to develop creative, fun, and engaging research methods for both the students and their research participants. GRT are influenced by and developed from a combination of participatory action research (Kindon, 2008) and unobtrusive research methods (Kellehear, 1993), to enhance social research. GRT takes un-obtrusive research in a new direction, beyond the typical social research methods. The Masters research students developed alternative methods for acquiring data, which relied on a combination of analogue design interventions and online platforms commonly distributed through social networks. They identified critical issues that required action by the community, and the processes they developed focused on engaging with communities, to propose solutions. Key characteristics shared between both GRT and Guerrilla Activism, are notions of political issues, the unexpected, the unconventional, and being interactive, unique and thought provoking. The trend of Guerrilla Activism has been adapted to: marketing, communication, gardening, craftivism, theatre, poetry, and art. Focusing on the action element and examining elements of current trends within Guerrilla marketing, we believe that GRT can be applied to a range of research areas within various academic disciplines.

Investigation of sensitivity based load ranking with composite load model in power system

Load modeling plays an important role in power system dynamic stability assessment. One of the widely used methods in assessing load model impact on system dynamic response is through parametric sensitivity analysis. Load ranking provides an effective measure of such impact. Traditionally, load ranking is based on either static or dynamic load model alone. In this paper, composite load model based load ranking framework is proposed. It enables comprehensive investigation into load modeling impacts on system stability considering the dynamic interactions between load and system dynamics. The impact of load composition on the overall sensitivity and therefore on ranking of the load is also investigated. Dynamic simulations are performed to further elucidate the results obtained through sensitivity based load ranking approach.

Distinguishing new science from calibration effects in the electron-volt neutron spectrometer VESUVIO at ISIS

The "standard" procedure for calibrating the Vesuvio eV neutron spectrometer at the ISIS neutron source, forming the basis for data analysis over at least the last decade, was recently documented in considerable detail by the instrument’s scientists. Additionally, we recently derived analytic expressions of the sensitivity of recoil peak positions with respect to fight-path parameters and presented neutron–proton scattering results that together called in to question the validity of the "standard" calibration. These investigations should contribute significantly to the assessment of the experimental results obtained with Vesuvio. Here we present new results of neutron–deuteron scattering from D2 in the backscattering angular range (theata > 90 degrees) which are accompanied by a striking energy increase that violates the Impulse Approximation, thus leading unequivocally the following dilemma: (A) either the "standard" calibration is correct and then the experimental results represent a novel quantum dynamical effect of D which stands in blatant contradiction of conventional theoretical expectations; (B) or the present "standard" calibration procedure is seriously deficient and leads to artificial outcomes. For Case(A), we allude to the topic of attosecond quantumdynamical phenomena and our recent neutron scattering experiments from H2 molecules. For Case(B),some suggestions as to how the "standard" calibration could be considerably improved are made.

Sensitivity of peak positions to flight-path parameters in a deep-inelastic scattering neutron TOF spectrometer

The effects of small changes in flight-path parameters (primary and secondary flight paths, detector angles), and of displacement of the sample along the beam axis away from its ideal position, are examined for an inelastic time-of-flight (TOF) neutron spectrometer, emphasising the deep-inelastic regime. The aim was to develop a rational basis for deciding what measured shifts in the positions of spectral peaks could be regarded as reliable in the light of the uncertainties in the calibrated flight-path parameters. Uncertainty in the length of the primary or secondary flight path has the least effect on the positions of the peaks of H, D and He, which are dominated by the accuracy of the calibration of the detector angles. This aspect of the calibration of a TOF spectrometer therefore demands close attention to achieve reliable outcomes where the position of the peaks is of significant scientific interest and is discussed in detail. The corresponding sensitivities of the position of peak of the Compton profile, J(y), to flight-path parameters and sample position are also examined, focusing on the comparability across experiments of results for H, D and He. We show that positioning the sample to within a few mm of the ideal position is required to ensure good comparability between experiments if data from detectors at high forward angles are to be reliably interpreted.

Factors affecting marketing decision making with an ethical content : collusive tendering in the construction contract market

Reports of immoral marketing practices i n the construction industry attract political, media and public but not much academic interest. This paper adopts a behavioural perspective and proposes a model for applying marketing ethics concepts and methods in the study of collusion in the construction contract market. An extensive multidisciplinary review of existing literature identified a lack of adequate conceptualisation of the mechanisms and decision making factors of collusive tendering. The process of developing the model is detailed in this paper. The objectives and methodology of the research project that tested the model are also outlined. The paper concludes with a brief note on the contributions and application of the proposed model.