Capability green

Tract consultants are a landscape architecture practice, founded in 1973 as an offshoot to the highly innovative, interdisciplinary design and build company Merchant Builders, and was perhaps the first truly corporate practice of this type in Australia. Founding directors Rodney Wulff and Steve Calhoun were both instrumental in establishing the undergraduate landscape architecture course at RMIT University, and bringing our Jim Sinatra, who had taught Calhoun at the University of Iowa. Wulff remained for many years the holder of the only doctorate in landscape architecture in the country. This combination of an academic, design and professional agenda was a rich one for Tract in their early days. This founding generosity and interest in the intellectual aspects of landscape architecture continues in relation to the university in a number of ways, including information ones, such as the regular employment of applicants who fail to get into the course at RMIT. In preparing them for re-applying, he has given a number of individuals a way into the profession that the university could not allow.

A numerical method to quantify the axial shortening of vertical elements in concrete buildings

Differential axial shortening, distortion and deformation in high rise buildings is a serious concern. They are caused by three time dependent modes of volume change; “shrinkage”, “creep” and “elastic shortening” that takes place in every concrete element during and after construction. Vertical concrete components in a high rise building are sized and designed based on their strength demand to carry gravity and lateral loads. Therefore, columns and walls are sized, shaped and reinforced differently with varying concrete grades and volume to surface area ratios. These structural components may be subjected to the detrimental effects of differential axial shortening that escalates with increasing the height of buildings. This can have an adverse impact on other structural and non-structural elements. Limited procedures are available to quantify axial shortening, and the results obtained from them differ because each procedure is based on various assumptions and limited to few parameters. All these prompt to a need to develop an accurate numerical procedure to quantify the axial shortening of concrete buildings taking into account the important time varying functions of (i) construction sequence (ii) Young’s Modulus and (iii) creep and shrinkage models associated with reinforced concrete. General assumptions are refined to minimize variability of creep and shrinkage parameters to improve accuracy of the results. Finite element techniques are used in the procedure that employs time history analysis along with compression only elements to simulate staged construction behaviour. This paper presents such a procedure and illustrates it through an example. Keywords: Differential Axial Shortening, Concrete Buildings, Creep and Shrinkage, Construction Sequence, Finite Element Method.

Village green

For a communal garden in Copenhagen, Stig L. Andersson uses grasses of varying texture and height, creating a new view or spatial experience from every angle. The idea of vegetation texture being an important constituent of planting design is pervasive. Gardening books tell aspiring designers that "colour, texture and form" are the central aspects of planting arrangements. While these elements contribute to this language, they have tended to limit the language of planting to a singular, two dimensional paradigm, where planting is designed in static elevation. This has developed from a perennial-border approach demonstrated by the early 20th century garden designer Gertrude Jekyll, where the viewer is parallel to the bed, and the planting is layered to address this view. If one were to characterise the difference between a garden design and a landscape architectural approach, the latter would seem self-conscious in its use of space, movement and vision.

Green Marketing Communities and blogs : mapping consumer’s attitudes for future sustainable marketing

The last three decades have seen consumers’ environmental consciousness grow as the environment has moved to a mainstream issue. Results from our study of green marketing blog site comments in the first half of 2009 finds thirteen prominent concepts: carbon, consumers, global and energy were the largest themes, while crisis, power, people, water, fuel, product, work, time, water, organic, content and interest were the others. However sub issues were also identified, as the driving factor of this information is coming from consumer led social networks. While marketers hold some power, consumers are the real key factor to possess influence for change. They want to drive change and importantly, they have the power. Power to the people.

Seismic performance of brick infilled RC frame structures in low and medium rise buildings in Bhutan

The construction of reinforced concrete buildings with unreinforced infill is common practice even in seismically active country such as Bhutan, which is located in high seismic region of Eastern Himalaya. All buildings constructed prior 1998 were constructed without seismic provisions while those constructed after this period adopted seismic codes of neighbouring country, India. However, the codes have limited information on the design of infilled structures besides having differences in architectural requirements which may compound the structural problems. Although the influence of infill on the reinforced concrete framed structures is known, the present seismic codes do not consider it due to the lack of sufficient information. Time history analyses were performed to study the influence of infill on the performance of concrete framed structures. Important parameters were considered and the results presented in a manner that can be used by practitioners. The results show that the influence of infill on the structural performance is significant. The structural responses such as fundamental period, roof displacement, inter-storey drift ratio, stresses in infill wall and structural member forces of beams and column generally reduce, with incorporation of infill wall. The structures designed and constructed with or without seismic provision perform in a similar manner if the infills of high strength are used.

Implication of global warming on air-conditioned office buildings in Australia

As climate change will entail new conditions for the built environment, the thermal behaviour of air-conditioned office buildings may also change. Using building computer simulations, the impact of warmer weather is evaluated on the design and performance of air-conditioned office buildings in Australia, including the increased cooling loads and probable indoor temperature increases due to a possibly undersized air-conditioning system, as well as the possible change in energy use. It is found that existing office buildings would generally be able to adapt to the increasing warmth of year 2030 Low and High scenarios projections and the year 2070 Low scenario projection. However, for the 2070 High scenario, the study indicates that the existing office buildings in all capital cities of Australia would suffer from overheating problems. For existing buildings designed for current climate conditions, it is shown that there is a nearly linear correlation between the increase of average external air temperature and the increase of building cooling load. For the new buildings designed for warmer scenarios, a 28-59% increase of cooling capacity under the 2070 High scenario would be required.

Adaptation to global warming by changing internal loads of buildings

Global warming can have a significant impact on the building thermal environment and energy performance. Because greenhouse gas concentrations are still continuing to increase, this warming process will continue and may accelerate. Adaptation to global warming is therefore emerging as one of the key requirements for buildings. This requires all the existing and new buildings not only to perform and operate satisfactorily in the new environment but also to satisfy the environmental performance criteria of sustainability. Through a parametric study using the building simulation technique, this paper investigates the adaptation potential of changing the building internal load densities to the future global warming. Case studies for office buildings in major Australian capital cities are presented. Based on the results of parametric study, possible adaptation strategies are also proposed and evaluated.

Preparation of future weather data to study the impact of climate change on buildings

The dynamic interaction between building systems and external climate is extremely complex, involving a large number of difficult-to-predict variables. In order to study the impact of climate change on the built environment, the use of building simulation techniques together with forecast weather data are often necessary. Since most of building simulation programs require hourly meteorological input data for their thermal comfort and energy evaluation, the provision of suitable weather data becomes critical. In this paper, the methods used to prepare future weather data for the study of the impact of climate change are reviewed. The advantages and disadvantages of each method are discussed. The inherent relationship between these methods is also illustrated. Based on these discussions and the analysis of Australian historic climatic data, an effective framework and procedure to generate future hourly weather data is presented. It is shown that this method is not only able to deal with different levels of available information regarding the climate change, but also can retain the key characters of a “typical” year weather data for a desired period.

A study of green product industries in Taiwan

Based on the model of ‘The Smile of Value Creation' (Mudambi 2007) and the theory of concept marketing, this study aims to examine the top 20 Taiwanese environmental marks companies, and explore their circumstances, innovation patterns and value chain system in Taiwan. It found out all of them are information technology product and household appliances companies. In addition, they make special efforts in two parts of value creation: product (including basic and applied ‘R and D' (Research and Design), design, commercialization) and marketing (including advertising and brand management, specialized logistics, after-sales services). They also locate their branches depending on different stages of the value chain, and expand them globally.

Rethinking regional green space networks in China

Ecological networks are often represented as utopian webs of green meandering through cities, across states, through regions and even across a country (Erickson, 2006, p.28; Fabos, 2004, p.326; Walmsley, 2006). While this may be an inspiring goal for some in developed countries, the reality may be somewhat different in developing countries. China, in its shift to urbanisation and suburbanisation, is also being persuaded to adjust its planning schemes according to these aspirational representations of green spaces (Yu et al, 2006, p.237; Zhang and Wang, 2006, p.455). The failure of other countries to achieve regional goals of natural and cultural heritage protection on the ground in this way (Peterson et al, 2007; Ryan et al, 2006; von Haaren and Reich, 2006) suggests that there may be flaws in the underpinning concepts that are widely circulated in North American and Western European literature (Jongman et al, 2004; Walmsley, 2006). In China, regional open space networks, regional green infrastructure or regional ecological corridors as we know them in the West, are also likely to be problematic, at least in the foreseeable future. Reasons supporting this view can be drawn from lessons learned from project experience in landscape planning and related fields of study in China and overseas. Implementation of valuable regional green space networks is problematic because: • the concept of region as a spatial unit for planning green space networks is ambiguous and undefinable for practical purposes; • regional green space networks traditionally require top down inter-governmental cooperation and coordination which are generally hampered by inequalities of influence between and within government agencies; • no coordinating body with funding powers exists for regional green space development and infrastructure authorities are still in transition from engineering authorities; • like other infrastructure projects, green space is likely to become a competitive rather than a complementary resource for city governments; • stable long-term management, maintenance and uses of green space networks must fit into a ‘family’ social structure rather than a ‘public good’ social structure, particularly as rural and urban property rights are being re-negotiated with city governments; and • green space provision is a performance indicator of urban improvement in cities within the city hierarchy and remains quantitatively-based (land area, tree number and per capita share) rather than qualitatively-based with local people as the focus.

The Green Falcon - Solar Powered Unmanned Aerial Vehicle

In recent months the extremes of Australia’s weather have affected, killed a good number of people and millions of dollars lost. Contrary to a manned aircraft or a helicopter; which have restricted air time, a UAS or a group of UAS could provide 24 hours coverage of the disaster area and be instrumented with infrared cameras to locate distressed people and relay information to emergency services. The solar powered UAV is capable of carrying a 0.25Kg payload consuming 0.5 watt and fly continuously for at low altitude for 24 hrs ,collect the data and create a special distribution . This system, named Green Falcon, is fully autonomous in navigation and power generation, equipped with solar cells covering its wing, it retrieves energy from the sun in order to supply power to the propulsion system and the control electronics, and charge the battery with the surplus of energy. During the night, the only energy available comes from the battery, which discharges slowly until the next morning when a new cycle starts. The prototype airplane was exhibited at the Melbourne Museum form Nov09 to Feb 2010.