Online estimation of distorted power system signal parameters

An algorithm based on the concept of Kalman filtering is proposed in this paper for the estimation of power system signal attributes, like amplitude, frequency and phase angle. This technique can be used in protection relays, digital AVRs, DSTATCOMs, FACTS and other power electronics applications. Furthermore this algorithm is particularly suitable for the integration of distributed generation sources to power grids when fast and accurate detection of small variations of signal attributes are needed. Practical considerations such as the effect of noise, higher order harmonics, and computational issues of the algorithm are considered and tested in the paper. Several computer simulations are presented to highlight the usefulness of the proposed approach. Simulation results show that the proposed technique can simultaneously estimate the signal attributes, even if it is highly distorted due to the presence of non-linear loads and noise.

Analysis of phasor measurement method in tracking the power frequency of distorted signals

This paper presents an analysis of phasor measurement method for tracking the fundamental power frequency to show if it has the performance necessary to cope with the requirements of power system protection and control. In this regard, several computer simulations presenting the conditions of a typical power system signal especially those highly distorted by harmonics, noise and offset, are provided to evaluate the response of the Phasor Measurement (PM) technique. A new method, which can shorten the delay of estimation, has also been proposed for the PM method to work for signals free of even-order harmonics.

Power management and power flow control with back-to-back converters in a utility connected microgrid

This paper proposes a method for power flow control between utility and microgrid through back-to-back converters, which facilitates desired real and reactive power flow between utility and microgrid. In the proposed control strategy, the system can run in two different modes depending on the power requirement in the microgrid. In mode-1, specified amount of real and reactive power are shared between the utility and the microgrid through the back-to-back converters. Mode-2 is invoked when the power that can be supplied by the DGs in the microgrid reaches its maximum limit. In such a case, the rest of the power demand of the microgrid has to be supplied by the utility. An arrangement between DGs in the microgrid is proposed to achieve load sharing in both grid connected and islanded modes. The back-to-back converters also provide total frequency isolation between the utility and the microgrid. It is shown that the voltage or frequency fluctuation in the utility side has no impact on voltage or power in microgrid side. Proper relay-breaker operation coordination is proposed during fault along with the blocking of the back-to-back converters for seamless resynchronization. Both impedance and motor type loads are considered to verify the system stability. The impact of dc side voltage fluctuation of the DGs and DG tripping on power sharing is also investigated. The efficacy of the proposed control ar-rangement has been validated through simulation for various operating conditions. The model of the microgrid power system is simulated in PSCAD.

Load sharing and power quality enhanced operation of a distributed microgrid

This paper describes control methods for proper load sharing between parallel converters connected in a microgrid and supplied by distributed generators (DGs). It is assumed that the microgrid spans a large area and it supplies loads in both in grid connected and islanded modes. A control strategy is proposed to improve power quality and proper load sharing in both islanded and grid connected modes. It is assumed that each of the DGs has a local load connected to it which can be unbalanced and/or nonlinear. The DGs compensate the effects of unbalance and nonlinearity of the local loads. Common loads are also connected to the microgrid, which are supplied by the utility grid under normal conditions. However during islanding, each of the DGs supplies its local load and shares the common load through droop characteristics. Both impedance and motor loads are considered to verify the system response. The efficacy of the controller has been validated through simulation for various operating conditions using PSCAD. It has been found through simulation that the total Harmonic Distortion (THD) of the of the microgrid voltage is about 10% and the negative and zero sequence component are around 20% of the positive sequence component before compensation. After compensation, the THD remain below 0.5%, whereas, negative and zero sequence components of the voltages remain below 0.02% of the positive sequence component.

La Boite The Story of an Australian Theatre Company

Since its genesis in 1925, La Boite has never been afraid of change. Despite controversies, crises and crippling set-backs that should have closed its stage doors many times, La Boite - which began life as the Brisbane Repertory Theatre Society - has proved itself an extraordinary survivor. When the opportunity came to build its own theatre, its inspired choice of theatre-in-the-round gave Brisbane an iconic performance space that attracted a whole new generation of actors, directors and designers and placed La Boite at the forefront of contemporary theatre practice. The place, in Katharine Brisbane’s words, “to see the red meat of theatre”. Always enterprising, with gritty determination it became a professional theatre company of national significance; and early in the new millennium triumphantly re-located to its new home at The Roundhouse Theatre. La Boite –The Story of an Australian Theatre Company both interrogates and celebrates the history of Queensland’s oldest theatre company. Highlighting the roles key people played in its evolution – particularly four remarkable women – Christine Comans explores La Boite’s colourful past, its cultural significance to Brisbane, and its vibrant and enduring role in the nation’s theatrical history.

Power system stability analysis based on descriptive study of electrical indices

In a power network, when a propagation energy wave caused by a disturbance hits a weak link, a reflection is appeared and some of energy is transferred across the link. In this work, an analytical descriptive methodology is proposed to study the dynamical stability of a large scale power system. For this purpose, the measured electrical indices (angle, or voltage/frequency) following a fault in different points among the network are used, and the behaviors of the propagated waves through the lines, nodes and buses are studied. This work addresses a new tool for power system stability analysis based on a descriptive study of electrical measurements. The proposed methodology is also useful to detect the contingency condition and synthesis of an effective emergency control scheme.

Evaluation of aerial remote sensing techniques for vegetation management in power line corridors

The following paper presents an evaluation of airborne sensors for use in vegetation management in powerline corridors. Three integral stages in the management process are addressed including, the detection of trees, relative positioning with respect to the nearest powerline and vegetation height estimation. Image data, including multi-spectral and high resolution, are analyzed along with LiDAR data captured from fixed wing aircraft. Ground truth data is then used to establish the accuracy and reliability of each sensor thus providing a quantitative comparison of sensor options. Tree detection was achieved through crown delineation using a Pulse-Coupled Neural Network (PCNN) and morphologic reconstruction applied to multi-spectral imagery. Through testing it was shown to achieve a detection rate of 96%, while the accuracy in segmenting groups of trees and single trees correctly was shown to be 75%. Relative positioning using LiDAR achieved a RMSE of 1.4m and 2.1m for cross track distance and along track position respectively, while Direct Georeferencing achieved RMSE of 3.1m in both instances. The estimation of pole and tree heights measured with LiDAR had a RMSE of 0.4m and 0.9m respectively, while Stereo Matching achieved 1.5m and 2.9m. Overall a small number of poles were missed with detection rates of 98% and 95% for LiDAR and Stereo Matching.

Cyber bullying in schools and the law : is there an effective means of addressing the power imbalance?

Cyber bullying – or bullying through the use of technology – is a growing phenomenon which is currently most commonly experienced by young people and the consequences manifested in schools. Cyber bullying shares many of the same attributes as face-to-face bullying such as a power imbalance and a sense of helplessness on the part of the target. Not surprisingly, targets of face-to-face bullying are increasingly turning to the law, and it is likely that targets of cyber bullying may also do so in an appropriate case. This article examines the various criminal, civil and vilification laws that may apply to cases of cyber bullying and assesses the likely effectiveness of these laws as a means of redressing that power imbalance between perpetrator and target.

Detection and Estimation of Nonstationary Power Transients

This chapter looks at issues of non-stationarity in determining when a transient has occurred and when it is possible to fit a linear model to a non-linear response. The first issue is associated with the detection of loss of damping of power system modes. When some control device such as an SVC fails, the operator needs to know whether the damping of key power system oscillation modes has deteriorated significantly. This question is posed here as an alarm detection problem rather than an identification problem to get a fast detection of a change. The second issue concerns when a significant disturbance has occurred and the operator is seeking to characterize the system oscillation. The disturbance initially is large giving a nonlinear response; this then decays and can then be smaller than the noise level ofnormal customer load changes. The difficulty is one of determining when a linear response can be reliably identified between the non-linear phase and the large noise phase of thesignal. The solution proposed in this chapter uses “Time-Frequency” analysis tools to assistthe extraction of the linear model.

“Show me a bad kid and I’ll show you a lousy parent” : making parents responsible for youth crime in Australian and Canadian contexts

In this article we survey relevant international literature on the issue of parental liability and responsibility for the crimes of young offenders. In addition, as a starting point for needed cross-jurisdictional research, we focus on different approaches that have been taken to making parents responsible for youth crime in Australia and Canada. This comparative analysis of Australian and Canadian legislative and policy approaches is situated within a broader discussion of arguments about parental responsibility, the ‘punitive turn’ in youth justice, and cross-jurisdictional criminal justice policy transfer and convergence. One unexpected finding of our literature survey is the relatively sparse attention given to the issue of parental responsibility for youth crime in legal and criminological literature compared to the attention it receives in the media and popular-public culture. In Part I we examine the different views that have been articulated in the social science literature for and against parental responsibility laws, along with arguments that have been made about why such laws have been enacted in an increasing number of Western countries in recent years. In Part II, we situate our comparative study of Australian and Canadian legislative and policy approaches within a broader discussion of arguments about the ‘punitive turn’ in youth justice, responsibilisation, and cross-jurisdictional criminal justice policy transfer and convergence. In Part III, we identify and examine the scope of different parental responsibility laws that have been enacted in Australia and Canada; noting significant differences in the manner and extent to which parental responsibility laws and policies have been invoked as part of the solution to dealing with youth crime. In our concluding discussion, in Part IV, we try to speculate on some of the reasons for these differences and set an agenda for needed future research on the topic.

The 2008 declaration of independence by the Hong Kong Court and anomalies in the Hong Kong Company Law

Discusses two aspects of Hong Kong law: 1) the judgment of the Hong Kong Court of Final Appeal in A Solicitor v The Law Society of Hong Kong on whether Hong Kong courts were bound, post-1997, by pre-1997 House of Lords or Privy Council decisions, by pre-1997 decisions of their own, or by post-1997 overseas decisions from any jurisdiction; and 2) the need for clarification in the Hong Kong Companies Ordinance of whether a company can have a single legal representative, the ultra vires rule and the duties of company directors

Corporate governance and compliance : preventative measure or just another fad?

In the wake of recent corporate collapses, 'corporate governance' has received unprecedented levels of attention. It can be narrowly defined as how a company is directed and steered. The responsibility of steering a company is entrusted with the board of directors, who become the focus of governance mechanisms.Yet this is not as straightforward as it appears - Australia has experienced massive shifts in business regulations over the past two decades. One innovation in Australian business regulation is 'enforced self-regulation' which combines the benefits of voluntary self-regulation with the coercive power of the State, implemented via a compliance program. A possible hazard of compliance system is that management might treat this responsibility as a 'box ticking' exercise. Therefore effective governance and compliance entails more than setting up internal and regulatory mechanisms; the willingness of various stakeholders to collaborate is crucial. This suggests that managing relationships between stakeholders of an organization is the key to averting corporate collapses.

Does Chinese traditional values matter in regulating China's company directors? Preliminary findings from surveys in Hong Kong

Much has been said about Chinese corporate governance and the new laws on companies. While most literature focuses on either the political or the legal doctrinal issues, this paper argues that Chinese traditional values do matter in Chinese corporate governance. The object of this paper is to report on the preliminary findings of a project supported by the General Research Fund in Hong Kong (HK). Thus far the survey results from HK respondents support our hypothesis. As such, traditional Chinese values should be on the agenda of the next round of company law reforms in China.