Travel time prediction on signalised urban arterials by applying SARIMA modelling on Bluetooth data

Travel time prediction has long been the topic of transportation research. But most relevant prediction models in the literature are limited to motorways. Travel time prediction on arterial networks is challenging due to involving traffic signals and significant variability of individual vehicle travel time. The limited availability of traffic data from arterial networks makes travel time prediction even more challenging. Recently, there has been significant interest of exploiting Bluetooth data for travel time estimation. This research analysed the real travel time data collected by the Brisbane City Council using the Bluetooth technology on arterials. Databases, including experienced average daily travel time are created and classified for approximately 8 months. Thereafter, based on data characteristics, Seasonal Auto Regressive Integrated Moving Average (SARIMA) modelling is applied on the database for short-term travel time prediction. The SARMIA model not only takes the previous continuous lags into account, but also uses the values from the same time of previous days for travel time prediction. This is carried out by defining a seasonality coefficient which improves the accuracy of travel time prediction in linear models. The accuracy, robustness and transferability of the model are evaluated through comparing the real and predicted values on three sites within Brisbane network. The results contain the detailed validation for different prediction horizons (5 min to 90 minutes). The model performance is evaluated mainly on congested periods and compared to the naive technique of considering the historical average.

Urban traffic state estimation: Fusing point and zone based data

Loop detectors are the oldest and widely used traffic data source. On urban arterials, they are mainly installed for signal control. Recently state of the art Bluetooth MAC Scanners (BMS) has significantly captured the interest of stakeholders for exploiting it for area wide traffic monitoring. Loop detectors provide flow- a fundamental traffic parameter; whereas BMS provides individual vehicle travel time between BMS stations. Hence, these two data sources complement each other, and if integrated should increase the accuracy and reliability of the traffic state estimation. This paper proposed a model that integrates loops and BMS data for seamless travel time and density estimation for urban signalised network. The proposed model is validated using both real and simulated data and the results indicate that the accuracy of the proposed model is over 90%.

Urban Informatics and Public Transport

The holistic urban experience we perceive when immersed in an urban context is at the heart of urban informatics. This experience encompasses all urban elements such as architecture, people, and culture. Urban informatics explores the possibilities and opportunities created by new technologies and information for enhancing the urban experience. Public transport is an essential urban experience. Everyday, urban dwellers takes public transport to commute and move between different parts of the city. Public transport serves people from all over the city and moves them through different places in the city, using different means of transportation. The nature of public transport—involving people, places, and technologies, makes it a fitting context for urban informatics interventions. There are three main aspects of the public transport experience that can readily benefit from urban informatics interventions the: pragmatic aspect, hedonistic aspect, and social aspect. From the pragmatic perspective, these interventions can help people to be more efficient and effective in taking public transport. Hedonistic-related interventions aim to bring enjoyment and fun to our mundane commute. Finally, urban informatics can strengthen the sense of community in a socially-passive context like public transport environments through adopting socially focused interventions.

Day in the Lab : Urban Informatics Research Lab, Queensland University of Technology

The Urban Informatics Research Lab brings together a group of people who focus their research on interdisciplinary topics at the intersection of social, spatial, and technical research domains—that is, people, place, and technology. Those topics are spread across the breadth of urban life—its contemporary issues and its needs, as well as the design opportunities that we have as individuals, groups, communities, and as a whole society. The lab’s current research areas include urban planning and design, civic innovation, mobility and transportation, education and connected learning, environmental sustainability, and food and urban agriculture. The common denominator of the lab’s approach is user-centered design research directed toward understanding, conceptualizing, developing, and evaluating sociotechnical practices as well as the opportunities afforded by innovative digital technology in urban environments.

Recent advances in modeling the vulnerability of transportation networks

It is well known that, for major infrastructure networks such as electricity, gas, railway, road, and urban water networks, disruptions at one point have a knock on effect throughout the network. There is an impressive amount of individual research projects examining the vulnerability of critical infrastructure network. However, there is little understanding of the totality of the contribution made by these projects and their interrelationships. This makes their review a difficult process for both new and existing researchers in the field. To address this issue, a two-step literature review process is used, to provide an overview of the vulnerability of the transportation network in terms of four main themes - research objective, transportation mode, disruption scenario and vulnerability indicator –involving the analysis of related articles from 2001 to 2013. Two limitations of existing research are identified: (1) the limited amount of studies relating to multi-layer transportation network vulnerability analysis, and (2) the lack of evaluation methods to explore the relationship between structure vulnerability and dynamical functional vulnerability. In addition to indicating that more attention needs to be paid to these two aspects in future, the analysis provides a new avenue for the discovery of knowledge, as well as an improved understanding of transportation network vulnerability.

Empirical modelling of the relationship between bus and car speeds on signalised urban networks

Vehicle speed is an important attribute for analysing the utility of a transport mode. The speed relationship between multiple modes of transport is of interest to traffic planners and operators. This paper quantifies the relationship between bus speed and average car speed by integrating Bluetooth data and Transit Signal Priority data from the urban network in Brisbane, Australia. The method proposed in this paper is the first of its kind to relate bus speed and average car speed by integrating multi-source traffic data in a corridor-based method. Three transferable regression models relating not-in-service bus, in-service bus during peak periods, and in-service bus during off-peak periods with average car speed are proposed. The models are cross-validated and the interrelationships are significant.

Ultrafine particle emission of waste incinerators and comparison to the exposure of urban citizens

On the basis of the growing interest on the impact of airborne particles on human exposure as well as the strong debate in Western countries on the emissions of waste incinerators, this work reviewed existing literature to: (i) show the emission factors of ultrafine particles (particles with a diameter less than 100 nm) of waste incinerators, and; (ii) assess the contribution of waste incinerators in terms of ultrafine particles to exposure and dose of people living in the surrounding areas of the plants in order to estimate eventual risks. The review identified only a limited number of studies measuring ultrafine particle emissions, and in general they report low particle number concentrations at the stack (the median value was equal to 5.5×103 part cm-3), in most cases higher than the outdoor background value. The lowest emissions were achieved by utilization of the bag-house filter which has an overall number-based filtration efficiency higher than 99%. Referring to reference case, the corresponding emission factor is equal to 9.1×1012 part min-1, that is lower than one single high-duty vehicle. Since the higher particle number concentrations found in the most contributing microenvironments to the exposure (indoor home, transportation, urban outdoor), the contribution of the waste incinerators to the daily dose can be considered as negligible.

Real-time traffic state estimation in urban corridors from heterogeneous data

In recent years, rapid advances in information technology have led to various data collection systems which are enriching the sources of empirical data for use in transport systems. Currently, traffic data are collected through various sensors including loop detectors, probe vehicles, cell-phones, Bluetooth, video cameras, remote sensing and public transport smart cards. It has been argued that combining the complementary information from multiple sources will generally result in better accuracy, increased robustness and reduced ambiguity. Despite the fact that there have been substantial advances in data assimilation techniques to reconstruct and predict the traffic state from multiple data sources, such methods are generally data-driven and do not fully utilize the power of traffic models. Furthermore, the existing methods are still limited to freeway networks and are not yet applicable in the urban context due to the enhanced complexity of the flow behavior. The main traffic phenomena on urban links are generally caused by the boundary conditions at intersections, un-signalized or signalized, at which the switching of the traffic lights and the turning maneuvers of the road users lead to shock-wave phenomena that propagate upstream of the intersections. This paper develops a new model-based methodology to build up a real-time traffic prediction model for arterial corridors using data from multiple sources, particularly from loop detectors and partial observations from Bluetooth and GPS devices.

TrainYarn: Probing perceptions of social space in urban commuter trains

We studied the ways that urban commuter train passengers experience their journeys. We present the design process and in-situ evaluation of TrainYarn, a mobile app prototype designed to facilitate social interaction between co-located urban train passengers. Through the deployment of the prototype, we sought to probe perceptions of social space with a view to positively impact the assessment of public transport. Our results support that our target users saw value in the use of TrainYarn, perceiving it as emancipatory, in alignment with their communicative needs, and having the ability to transform their perceptions of social space. To further inform future research and practice, we put forward a series of design recommendations.

Comparing China's city transportation and economic networks

The city system has been a prevailing research issue in the fields of urban geography and regional economics. Not only do the relationships between cities in the city system exist in the form of rankings, but also in a more general network form. Previous work has examined the spatial structure of the city system in terms of its separate industrial networks, such as in transportation and economic activity, but little has been done to compare different networks. To rectify this situation, this study analyzes and reveals the spatial structural features of China’s city system by comparing its transportation and economic urban networks, thus providing new avenues for research on China’s city network. The results indicate that these two networks relate with each other by sharing structural equivalence with a basic diamond structure and a layered intercity structure decreasing outwards from the national centers. A decoupling effect also exists between them as the transportation network contributes to a balanced regional development, while the economic network promotes agglomeration economies. The law of economic development and the government both play important roles in the articulation between these two networks, and the gap between them can be shortened by related policy reforms and the improvement of the transportation network.

Guest editorial: Urban nature for resilient and liveable cities

It is a transforming experience to imagine that in 50 years, our current built environment might look as foreign to our grandchildren as the computers of the 1960s look to us today. We can already see emerging attempts to create cities that are resilient and liveable in the face of physical stresses including population growth, increasing climate variability, resource shortages and pollution. The capacity for transforming every aspect of development towards resilience and liveability goals is profoundly exciting, from heating and cooling through to energy generation, water reticulation, food production, transportation, communication and recreational spaces...

Air pollution levels measured at traffic hot spots : Brisbane urban corridor study

Air pollution levels were monitored continuously over a period of 4 weeks at four sampling sites along a busy urban corridor in Brisbane. The selected sites were representative of industrial and residential types of urban environment affected by vehicular traffic emissions. The concentration levels of submicrometer particle number, PM2.5, PM10, CO, and NOx were measured 5-10 meters from the road. Meteorological parameters and traffic flow rates were also monitored. The data were analysed in terms of the relationship between monitored pollutants and existing ambient air quality standards. The results indicate that the concentration levels of all pollutants exceeded the ambient air background levels, in certain cases by up to an order of magnitude. While the 24-hr average concentration levels did not exceed the standard, estimates for the annual averages were close to, or even higher than the annual standard levels.

How can land and urban development make houses healthier?

Traditionally, the main focus of the professional community involved with indoor air quality has been indoor pollution sources, preventing or reducing their emissions, as well as lowering the impact of the sources by replacing the polluted indoor air with "fresh" outdoor air. However, urban outdoor air cannot often be considered "fresh", as it contains high concentrations of pollutants emitted from motor vehicles - the main outdoor pollution sources in cities. Evidence from epidemiological studies conducted worldwide demonstrates that outdoor air quality has considerable effects on human health, despite the fact that people spend the majority of their time indoors. This is because pollution from outdoors penetrates indoors and becomes a major constituent of indoor pollution. Urban land and transport development has significant impact on the overall air quality of the urban airshed as well as the pollution concentration in the vicinity of high-density traffic areas. Therefore, an overall improvement in indoor air quality would be achieved by lowering urban airshed pollution, as well as by lowering the impact of the hot spots on indoor air. This paper explores the elements of urban land and vehicle transport developments, their impact on global and local air quality, and how the science of outdoor pollution generation and transport in the air could be utilized in urban development towards lowering indoor air pollution.