Investing in the future : analysis of TxDOT 1547 Over-Axle Weight Tolerance Permits

The trucking industry has played a significant role in the economic growth in Texas by transporting and distributing commodities using commercial motor vehicles. The Texas Department of Transportation (TxDOT), however, has recognized that the large number of overweight trucks operating on the state highway system has resulted in the deterioration of pavement condition. In addition, the permit fee to carry higher loads above legal limits is much lower than the cost to treat the increase in pavement damage. The primary purpose of the research presented in this paper is to investigate current TxDOT overweight permit structures to support pavement management. The research team analyzed the TxDOT “1547” Over-axle Weight Tolerance Permit structure to support an increase in the fee structure, bringing it more in line with the actual pavement damage. The analysis showed that the revised overweight permit structure could provide an additional $9.3 million annually for pavement maintenance needs by increasing current permit fees. These results were supported by the 2030 Committee for recommendation to the Texas Transportation Commission and consideration by the State Legislature [1]. The research team recommends conducting further research to identify methods for working cooperatively with the trucking industry to develop improved methods for assessing weight damage relationships and developing more effective and accurate means for assessing overweight permit fees.

Peer state assessment of TxDOT maintenance program and practices, part II : test section survey findings and recommendations

This paper presents a road survey as part of a workshop conducted by the Texas Department of Transportation (TxDOT) to evaluate and improve the maintenance practices of the Texas highway system. Directors of maintenance from six peer states (California, Kansas, Georgia, Missouri, North Carolina, and Washington) were invited to this 3-day workshop. One of the important parts of this workshop was a Maintenance Test Section Survey (MTSS) to evaluate a number of pre-selected one-mile roadway sections. The workshop schedule allowed half a day to conduct the field survey and 34 sections were evaluated. Each of the evaluators was given a booklet and asked to rate the selected road sections. The goals of the MTSS were to: 1. Assess the threshold level at which maintenance activities are required as perceived by the evaluators from the peer states; 2. Assess the threshold level at which maintenance activities are required as perceived by evaluators from other TxDOT districts; and 3. Perform a pilot evaluation of the MTSS concept. This paper summarizes the information obtained from survey and discusses the major findings based on a statistical analysis of the data and comments from the survey participants.

Peer state assessment of TxDOT maintenance program and practices, part I : workshop findings and recommendations

To assess and improve their practices, and thus ensure the future excellence of the Texas highway system, the Texas Department of Transportation (TxDOT) sought a forum in which experts from other State Departments of Transportation could evaluate the TxDOT maintenance program and practices based on their expertise. To meet this need, a Peer State Review of TxDOT Maintenance Practices project was organized and conducted by the Center for Transportation Research (CTR) at The University of Texas at Austin. CTR researchers, along with TxDOT staff, conducted a workshop to present TxDOT’s maintenance practices to the visiting peer reviewers and invite their feedback. Directors of maintenance from six different states—California, Kansas, Georgia, Missouri, North Carolina, and Washington—participated in the workshop. CTR and TxDOT worked together to design a questionnaire with 15 key questions to capture the peers’ opinions on maintenance program and practices. This paper compiles and summarizes this information. The examination results suggested that TxDOT should use a more state-wide approach to funding and planning, in addition to funding and planning for each district separately. Additionally, the peers recommended that criteria such as condition and level of service of the roadways be given greater weight in the funding allocation than lane miles or vehicle miles traveled (VMT). The Peer Reviewers also determined that TxDOT maintenance employee experience and communications were strong assets. Additional strengths included the willingness of TxDOT to invite peer reviews of their practices and a willingness to consider opportunities for improvement.

Towards a unified service description language for the internet of services : requirements and first developments

Service-oriented Architectures (SOA) and Web services leverage the technical value of solutions in the areas of distributed systems and cross-enterprise integration. The emergence of Internet marketplaces for business services is driving the need to describe services, not only from a technical level, but also from a business and operational perspective. While, SOA and Web services reside in an IT layer, organizations owing Internet marketplaces are requiring advertising and trading business services which reside in a business layer. As a result, the gap between business and IT needs to be closed. This paper presents USDL (Unified Service Description Language), a specification language to describe services from a business, operational and technical perspective. USDL plays a major role in the Internet of Services to describe tradable services which are advertised in electronic marketplaces. The language has been tested using two service marketplaces as use cases.

Introduction

In this volume we compile and comment on a collection of some of the most important works on nascent entrepreneurship that have appeared in the last two decades. We do not go further back than that because up until1992 hardly any systematic research on the pre-operational stage of business creation was undertaken. In that year, the terms 'nascent entrepreneur' and 'nascent venture' appear for the first time in the research literature (Reynolds and Miller, Chapter l, 1992; Reynolds and White, 1992). This signals the emergence of a new research paradigm designed to study• business creation processes empirically at very early stages, before an operational firm has come into existence. The most central feature of this type of research is that it identifies a statistically representative sample of nascent entrepreneurs (NEs)- people engaged in ongoing but not yet operational business start-ups- via screening interviews with a very large random sample of adults. The overarching research questions pursued in this emerging research tradition are the following: 1. What proportion of individuals (in various population subgroups) are trying to start a new business at any given time? 2. What led them to engage in the creation of a new business? 3. What characteristics and behaviors associated with the founder(s), the venture, the environment and the process are associated with persistence, progress and success in trying to start a new business?

Brisbane Airport Atelier : Team Delta

This architectural and urban design project was conducted as part of the Brisbane Airport Corporations master-planning Atelier, run in conjunction with City Lab. This creation and innovation event brought together approximately 80 designers, associated professionals, and both local and state government representatives to research concepts for future development and planning of the Brisbane airport site. The Team Delta research project explored the development of a new precinct cluster around the existing international terminal building; with a view of reinforcing the sense of place and arrival. The development zone explores the options of developing a subtropical character through landscape elements such as open plazas, tourist attractions, links to existing adjacent waterways, and localised rapid transport options. The proposal tests the possibilities of developing a cultural hub in conjunction with transport infrastructure and the airport terminal(s).

A behavioural car-following model that captures traffic oscillations

This paper presents a behavioral car-following model based on empirical trajectory data that is able to reproduce the spontaneous formation and ensuing propagation of stop-and-go waves in congested traffic. By analyzing individual drivers’ car-following behavior throughout oscillation cycles it is found that this behavior is consistent across drivers and can be captured by a simple model. The statistical analysis of the model’s parameters reveals that there is a strong correlation between driver behavior before and during the oscillation, and that this correlation should not be ignored if one is interested in microscopic output. If macroscopic outputs are of interest, simulation results indicate that an existing model with fewer parameters can be used instead. This is shown for traffic oscillations caused by rubbernecking as observed in the US 101 NGSIM dataset. The same experiment is used to establish the relationship between rubbernecking behavior and the period of oscillations.

Mixed convection flow of micropolar fluid in an open ended arc-shape cavity

Numerical simulations for mixed convection of micropolar fluid in an open ended arc-shape cavity have been carried out in this study. Computation is performed using the Alternate Direct Implicit (ADI) method together with the Successive Over Relaxation (SOR) technique for the solution of governing partial differential equations. The flow phenomenon is examined for a range of values of Rayleigh number, 102 ≤ Ra ≤ 106, Prandtl number, 7 ≤ Pr ≤ 50, and Reynolds number, 10 ≤ Re ≤ 100. The study is mainly focused on how the micropolar fluid parameters affect the fluid properties in the flow domain. It was found that despite the reduction of flow in the core region, the heat transfer rate increases, whereas the skin friction and microrotation decrease with the increase in the vortex viscosity parameter, Δ.

On the oscillatory behavior of transient Rayleigh Benard convection of air for 2D channel flow at moderate Rayleigh numbers

Unsteady numerical simulation of Rayleigh Benard convection heat transfer from a 2D channel is performed. The oscillatory behavior is attributed to recirculation of ascending and descending flows towards the core of the channel producing organized rolled motions. Variation of the parameters such as Reynolds number, channel outlet flow area and inclination of the channel are considered. Increasing Reynolds number (for a fixed Rayleigh number), delays the generation of vortices. The reduction in the outflow area leads to the later and the less vortex generation. As the time progresses, more vortices are generated, but the reinforced mean velocity does not let the eddies to enter the core of the channel. Therefore, they attach to the wall and reduce the heat transfer area. The inclination of the channel (both positive and negative) induces the generated vortices to get closer to each other and make an enlarged vortex.

Maintenance test section survey : data collection and analysis

A Maintenance Test Section Survey (MTSS) was conducted as part of a Peer State Review of the Texas Maintenance Program conducted October 5–7, 2010. The purpose of the MTSS was to conduct a field review of 34 highway test sections and obtain participants’ opinions about pavement, roadside, and maintenance conditions. The goal was to cross reference or benchmark TxDOT’s maintenance practices based on practices used by selected peer states. Representatives from six peer states (California, Georgia, Kansas, Missouri, North Carolina, and Washington) were invited to Austin to attend a 3-day Peer State Review of TxDOT Maintenance Practices Workshop and to participate in a field survey of a number of pre-selected one-mile roadway sections. It should be emphasized that the objective of the survey was not to evaluate and grade or score TxDOT’s road network but rather to determine whether the selected roadway sections met acceptable standards of service as perceived by Directors of Maintenance or senior maintenance managers from the peer states...

The entrepreneurial process

This chapter revolves around research-based insights into the entrepreneurial process. By is meant the process of setting up a new business activity resulting in a new market offer. This new offer may be made by a new or an existing firm, although the main focus here is on the start-up of new, independent firms. Further, the new offer may be innovative, bringing to the market something that was not offered before or imita­tive i.e., a new competitor enters the market with products or services very similar to what other firms are already offering. Although the lsatter type of process may be less complex and also have less market impact, it still entails most of the steps that typically have to be taken in order to get a business up and running. If successful, it also shares, at least to some degree, the consequences that signify entrepreneurial processes: - it gives consumers new choice alternatives - it gives incumbent firms reason to shape up - it attracts additional followers to enter the market, further reinforcing the first two effects (Davidsson, 2004). Besides, imitatlve starr-ups outnumber by far innovative ones (Reynolds et al., 2003; Samuelsson and Davidsson, 2009).

The public hospital system

When you finish this chapter you should be able to: * understand how the public hospital system is funded by the Federal, state and territory governments * appreciate some of the major funding issues facing public hospitals in Australia * have a beginning understandingof casemix Deagnosis Related Groups (DRGs) * have insight into the position of the various interest groups funding public hospitals in Australia.

The effects of lane-changing on the immediate follower : anticipation, relaxation, and change in driver characteristics

This paper investigates the effects of lane-changing in driver behavior by measuring (i) the induced transient behavior and (ii) the change in driver characteristics, i.e., changes in driver response time and minimum spacing. We find that the transition largely consists of a pre-insertion transition and a relaxation process. These two processes are different but can be reasonably captured with a single model. The findings also suggest that lane-changing induces a regressive effect on driver characteristics: a timid driver (characterized by larger response time and minimum spacing) tends to become less timid and an aggressive driver less aggressive. We offer an extension to Newell’s car-following model to describe this regressive effect and verify it using vehicle trajectory data.

Microscopic traffic hysteresis in traffic oscillations : a behavioral perspective

This paper studies traffic hysteresis arising in traffic oscillations from a behavioral perspective. It is found that the occurrence and type of traffic hysteresis is closely correlated with driver behavior when experiencing traffic oscillations and with the time driver reaction begins relative to the starting deceleration wave. Statistical results suggest that driver behavior is different depending on its position along the oscillation. This suggests that different car-following models should be used inside the different stages of an oscillation in order to replicate realistic congestion features.