62 resultados para Initial Pb
Resumo:
The nucleation-initiated oxidation of a Si surface at very low temperatures in plasmas is demonstrated experimentally, in contrast to the Deal-Grove mechanism, which predicts Si oxidation at a Si/SiO interface and cannot adequately describe the formation of SiO nanodots and oxidation rates at very low (several nanometers) oxide thickness. Based on the experimental results, an alternative oxidation scenario is proposed and supported by multiscale numerical simulations suggesting that saturation of micro- and nanohillocks with oxygen is a trigger mechanism for initiation of Si surface oxidation. This approach is generic and can be applied to describe the kinetics of low-temperature oxidation of other materials. © 2009 American Institute of Physics.
Resumo:
The kinetics of the nucleation and growth of carbon nanotube and nanocone arrays on Ni catalyst nanoparticles on a silicon surface exposed to a low-temperature plasma are investigated numerically, using a complex model that includes surface diffusion and ion motion equations. It is found that the degree of ionization of the carbon flux strongly affects the kinetics of nanotube and nanocone nucleation on partially saturated catalyst patterns. The use of highly ionized carbon flux allows formation of a nanotube array with a very narrow height distribution of half-width 7 nm. Similar results are obtained for carbon nanocone arrays, with an even narrower height distribution, using a highly ionized carbon flux. As the deposition time increases, nanostructure arrays develop without widening the height distribution when the flux ionization degree is high, in contrast to the fairly broad nanostructure height distributions obtained when the degree of ionization is low.
Resumo:
Self-assembly of highly stoichiometric SiC quantum dots still remains a major challenge for the gas/plasma-based nanodot synthesis. By means of a multiscale hybrid numerical simulation of the initial stage (0.1-2.5 s into the process) of deposition of SiCSi (100) quantum dot nuclei, it is shown that equal Si and kst atom deposition fluxes result in strong nonstoichiometric nanodot composition due to very different surface fluxes of Si and C adatoms to the quantum dots. At this stage, the surface fluxes of Si and C adatoms to SiC nanodots can be effectively controlled by manipulating the SiC atom influx ratio and the Si (100) surface temperature. It is demonstrated that at a surface temperature of 800 K the surface fluxes can be equalized after only 0.05 s into the process; however, it takes more then 1 s at a surface temperature of 600 K. Based on the results of this study, effective strategies to maintain a stoichiometric ([Si] [C] =1:1) elemental ratio during the initial stages of deposition of SiCSi (100) quantum dot nuclei in a neutral/ionized gas-based process are proposed.
Resumo:
This research led to the discovery of one of the best preserved remnants of the Earth's surficial environment 3.47 billion years ago. These ancient volcanic and sedimentary rocks contain original minerals and textures that are rare in rocks of this age. The research concentrated on chemical analysis of volcanic rocks to differentiate secondary alteration from the primary magmatic signature. This study contributes to our understanding of melting processes and geochemical reservoirs in the early Earth, which is vital for forward modelling of Earth's geodynamic evolution.
Resumo:
Background: Sexuality is a key component of quality of life and well-being and a need to express one’s sexuality continues into old age. Staff and families in residential aged care facilities often find expressions of sexuality by residents, particularly those living with dementia, challenging and facilities often struggle to address individuals’ needs in this area. This paper describes the development of an assessment tool which enables residential aged care facilities to identify how supportive their organisation is of all residents’ expression of their sexuality, and thereby improve where required. Methods: Multi-phase design using qualitative methods and a Delphi technique. Tool items were derived from the literature and verified by qualitative interviews with aged care facility staff, residents and families. The final item pool was confirmed via a reactive Delphi process. Results: A final item pool of sixty-nine items grouped into seven key areas allows facilities to score their compliance with the areas identified as being supportive of older people’s expression of their sexuality in a residential aged care environment. Conclusions: The sexuality assessment tool (SexAT) guides practice to support the normalization of sexuality in aged care homes and assists facilities to identify where enhancements to the environment, policies, procedures and practices, information and education/training are required. The tool also enables facilities to monitor initiatives in these areas over time.
Resumo:
The controlled synthesis of nanostructured materials remains an ongoing area of research, especially as the size, shape and composition of nanomaterials can greatly influence their properties and applications. In this work we present the electrodeposition of highly dendritic platinum rich platinum-lead nanostructures, where lead acetate acts as an inorganic shape directing agent via underpotential deposition on the growing electrodeposit. It was found that these nanomaterials readily oxidise at potentials below monolayer oxide formation, which significantly impacts on the methanol electrooxidation reaction and correlates with the incipient hydrous oxide adatom mediator (IHOAM) model of electrocatalysis. Additionally these materials were tested for their surface enhanced Raman scattering (SERS) activity, where the high density of sharp tips provides promise for their application as SERS substrates.
Resumo:
BACKGROUND This paper describes the first national burden of disease study for South Africa. The main focus is the burden due to premature mortality, i.e. years of life lost (YLLs). In addition, estimates of the burden contributed by morbidity, i.e. the years lived with disability (YLDs), are obtained to calculate disability-adjusted life years (DALYs); and the impact of AIDS on premature mortality in the year 2010 is assessed. METHOD Owing to the rapid mortality transition and the lack of timely data, a modelling approach has been adopted. The total mortality for the year 2000 is estimated using a demographic and AIDS model. The non-AIDS cause-of-death profile is estimated using three sources of data: Statistics South Africa, the National Department of Home Affairs, and the National Injury Mortality Surveillance System. A ratio method is used to estimate the YLDs from the YLL estimates. RESULTS The top single cause of mortality burden was HIV/AIDS followed by homicide, tuberculosis, road traffic accidents and diarrhoea. HIV/AIDS accounted for 38% of total YLLs, which is proportionately higher for females (47%) than for males (33%). Pre-transitional diseases, usually associated with poverty and underdevelopment, accounted for 25%, non-communicable diseases 21% and injuries 16% of YLLs. The DALY estimates highlight the fact that mortality alone underestimates the burden of disease, especially with regard to unintentional injuries, respiratory disease, and nervous system, mental and sense organ disorders. The impact of HIV/AIDS is expected to more than double the burden of premature mortality by the year 2010. CONCLUSION This study has drawn together data from a range of sources to develop coherent estimates of premature mortality by cause. South Africa is experiencing a quadruple burden of disease comprising the pre-transitional diseases, the emerging chronic diseases, injuries, and HIV/AIDS. Unless interventions that reduce morbidity and delay morbidity become widely available, the burden due to HIV/AIDS can be expected to grow very rapidly in the next few years. An improved base of information is needed to assess the morbidity impact more accurately.
Resumo:
There is increased accountability of initial teacher education (ITE) programs in Australia to develop Graduate teachers who are better prepared. Most ITE programs have been designed using Pedagogical Content Knowledge. Informed by the growing Technological Pedagogical Content Knowledge (TPACK) research, this journal article suggests that ITE programs need to develop Graduate teachers who have the TPACK capabilities to use technologies to support teaching and student learning. Insights from the research and evaluation of the Teaching Teachers for the Future (TTF) Project, which was guided by the TPACK conceptualisation, are provided. The TTF Project, which involved all Higher Education Institutions providing ITE programs in Australia, drew upon the TPACK conceptualisation. The TTF Project research and evaluation included the development and administration of a TTF TPACK Survey and the implementation of the Most Significant Change Methodology. Key findings resulting from the employment of these methodologies are summarised to provide guidance to inform the improvement of ITE programs to develop Graduate TPACK capabilities.
Resumo:
In 2012, the Australian Council of Deans of Education (ACDE), through the Queensland University of Technology, led a MATSITI project focusing on issues related to the retention, support and graduation of Aboriginal and Torres Strait Islander teachers in initial Teacher Education programs across Australia. While some of the barriers that impact on the graduation of Aboriginal and Torres Strait Islander teachers are well, known, this was the first large-scale Australian study to look at the issues nationally and in depth. Thirty-four Teacher Education programs across the country were audited, meetings were held in each state, both Aboriginal and Torres Strait Islander and non-Indigenous Faculty were consulted and approximately 70 Aboriginal and Torres Strait Islander pre-service teachers interviewed. This paper reports on the outcomes of that project, including the evidence that while recruitment into Teacher Education has, in some sites, reached parity, retention rates are well-below expected across the nation. The paper focuses both on the quantitative data and, even more significantly, on the voices of the pre-service teachers themselves, offering insights into the ways forward. As a result of this study, Deans and Heads of School of Teacher Education programs across the country have developed Action Plans alongside their university's Indigenous Higher Education Centres to improve support and retention of Aboriginal and Torres Strait Islander teachers.
Resumo:
We propose a new way to build a combined list from K base lists, each containing N items. A combined list consists of top segments of various sizes from each base list so that the total size of all top segments equals N. A sequence of item requests is processed and the goal is to minimize the total number of misses. That is, we seek to build a combined list that contains all the frequently requested items. We first consider the special case of disjoint base lists. There, we design an efficient algorithm that computes the best combined list for a given sequence of requests. In addition, we develop a randomized online algorithm whose expected number of misses is close to that of the best combined list chosen in hindsight. We prove lower bounds that show that the expected number of misses of our randomized algorithm is close to the optimum. In the presence of duplicate items, we show that computing the best combined list is NP-hard. We show that our algorithms still apply to a linearized notion of loss in this case. We expect that this new way of aggregating lists will find many ranking applications.
Resumo:
Achieving the combination of delayed and immediate release of a vaccine from a delivery device without applying external triggers remains elusive in implementing single administration vaccination strategies. Here a means of vaccine delivery is presented, which exploits osmosis to trigger delayed burst release of an active compound. Poly(-caprolactone) capsules of 2 mm diameter were prepared by dip-coating, and their burst pressure and release characteristics were evaluated. Burst pressures (in bar) increased with wall thickness (t in mm) following Pburst = 131.t + 3.4 (R2 = 0.93). Upon immersion in PBS, glucose solution-filled capsules burst after 8.7 ± 2.9 days. Copolymers of hydrophobic -caprolactone and hydrophilic polyethylene glycol were synthesized and their physico-chemical properties were assessed. With increasing hydrophilic content, the copolymer capsules showed increased water uptake rates and maximum weight increase, while the burst release was earlier: 5.6 ± 2.0 days and 1.9 ± 0.2 days for 5 and 10 wt% polyethylene glycol, respectively. The presented approach enables the reproducible preparation of capsules with high versatility in materials and properties, while these vaccine delivery vehicles can be prepared separately from, and independently of the active compound.
Resumo:
Different human activities like combustion of fossil fuels, biomass burning, industrial and agricultural activities, emit a large amount of particulates into the atmosphere. As a consequence, the air we inhale contains significant amount of suspended particles, including organic and inorganic solids and liquids, as well as various microorganism, which are solely responsible for a number of pulmonary diseases. Developing a numerical model for transport and deposition of foreign particles in realistic lung geometry is very challenging due to the complex geometrical structure of the human lung. In this study, we have numerically investigated the airborne particle transport and its deposition in human lung surface. In order to obtain the appropriate results of particle transport and deposition in human lung, we have generated realistic lung geometry from the CT scan obtained from a local hospital. For a more accurate approach, we have also created a mucus layer inside the geometry, adjacent to the lung surface and added all apposite mucus layer properties to the wall surface. The Lagrangian particle tracking technique is employed by using ANSYS FLUENT solver to simulate the steady-state inspiratory flow. Various injection techniques have been introduced to release the foreign particles through the inlet of the geometry. In order to investigate the effects of particle size on deposition, numerical calculations are carried out for different sizes of particles ranging from 1 micron to 10 micron. The numerical results show that particle deposition pattern is completely dependent on its initial position and in case of realistic geometry; most of the particles are deposited on the rough wall surface of the lung geometry instead of carinal region.
Resumo:
The Warburton Basin of central Australia has experienced a complex tectonic and fluid-flow history, resulting in the formation of various authigenic minerals. Geochemical and geochronological analyses were undertaken on vein carbonates from core samples of clastic sediments. Results were then integrated with zircon U–Pb dating and uraninite U–Th–total Pb dating from the underlying granite. Stable and radiogenic isotopes (δ18O, Sr and εNd), as well as trace element data of carbonate veins indicate that >200 °C basinal fluids of evolved meteoric origin circulated through the Warburton Basin. Almost coincidental ages of these carbonates (Sm–Nd; 432 ± 12 Ma) with primary zircon (421 ± 3.8 Ma) and uraninite (407 ± 16 Ma) ages from the granitic intrusion point towards a substantial period of active tectonism and an elevated thermal regime during the mid Silurian. We hypothesise that such a thermal regime may have resulted from extensional tectonism and concomitant magmatic activity following regional orogenesis. This study shows that the combined application of geochemical and geochronological analyses of both primary and secondary species may constrain the timing of tectonomagmatic events and associated fluid flow in intraplate sedimentary basins. Furthermore, this work suggests that the Sm–Nd-isotopic system is surprisingly robust and can record geologically meaningful age data from hydrothermal mineral species.
Resumo:
Background Risky single occasion drinking (RSOD; 4 or more drinks in <6 h) more than doubles the risk of injury in young people (15 - 25 years). The potential role of smartphone apps in reducing RSOD in young people is yet to be explored. Objective: To describe the initial prototype testing of ‘Ray's Night Out’, a new iPhone app targeting RSOD in young people. Method Quantitative and qualitative methods were used to evaluate the quality, perceived utility, and acceptability of the app among nine young people (19e23 years). Results Participants reported Ray's Night Out had good to excellent levels of functionality and visual appeal, acceptable to good levels of entertainment, interest and information, and acceptable levels of customization and interactivity. Young people thought the app had high levels of youth appeal, would prompt users to think about their alcohol use limits, but was unlikely to motivate a change in alcohol use in its current form. Qualitative data provided several suggestions for improving the app. Conclusion Following revision, Ray's Night Out could provide an effective intervention for RSOD in non help-seeking young people. A randomized controlled trial is currently underway to test the final prototype of the app.