Load modelling : induction motors

Modelling the power systems load is a challenge since the load level and composition varies with time. An accurate load model is important because there is a substantial component of load dynamics in the frequency range relevant to system stability. The composition of loads need to be charaterised because the time constants of composite loads affect the damping contributions of the loads to power system oscillations, and their effects vary with the time of the day, depending on the mix of motors loads. This chapter has two main objectives: 1) describe the load modelling in small signal using on-line measurements; and 2) present a new approach to develop models that reflect the load response to large disturbances. Small signal load characterisation based on on-line measurements allows predicting the composition of load with improved accuracy compared with post-mortem or classical load models. Rather than a generic dynamic model for small signal modelling of the load, an explicit induction motor is used so the performance for larger disturbances can be more reliably inferred. The relation between power and frequency/voltage can be explicitly formulated and the contribution of induction motors extracted. One of the main features of this work is the induction motor component can be associated to nominal powers or equivalent motors

An improved boundary layer scaling with ramp heating on a sloping plate

A scaling analysis for the natural convection boundary layer adjacent to an inclined semi-infinite plate subject to a non-instantaneous heating in the form of an imposed wall temperature which increases linearly up to a prescribed steady value over a prescribed time is reported. The development of the boundary layer flow from start-up to a steady-state has been described based on scaling analyses and verified by numerical simulations. The analysis reveals that, if the period of temperature growth on the wall is sufficiently long, the boundary layer reaches a quasi-steady mode before the growth of the temperature is completed. In this mode the thermal boundary layer at first grows in thickness and then contracts with increasing time. However, if the imposed wall temperature growth period is sufficiently short, the boundary layer develops differently, but after the wall temperature growth is completed, the boundary layer develops as though the startup had been instantaneous. The steady state values of the boundary layer for both cases are ultimately the same.

Topological map induction using neighbourhood information of places

In topological mapping, perceptual aliasing can cause different places to appear indistinguishable to the robot. In case of severely corrupted or non-available odometry information, topological mapping is difficult as the robot is challenged with the loop-closing problem; that is to determine whether it has visited a particular place before. In this article we propose to use neighbourhood information to disambiguate otherwise indistinguishable places. Using neighbourhood information for place disambiguation is an approach that neither depends on a specific choice of sensors nor requires geometric information such as odometry. Local neighbourhood information is extracted from a sequence of observations of visited places. In experiments using either sonar or visual observations from an indoor environment the benefits of using neighbourhood clues for the disambiguation of otherwise identical vertices are demonstrated. Over 90% of the maps we obtain are isomorphic with the ground truth. The choice of the robot’s sensors does not impact the results of the experiments much.

Induction motor load impact on power system eigenvalue sensitivity analysis

Load modelling plays an important role in power system dynamic stability assessment. One of the widely used methods in assessing load model impact on system dynamic response is parametric sensitivity analysis. A composite load model-based load sensitivity analysis framework is proposed. It enables comprehensive investigation into load modelling impacts on system stability considering the dynamic interactions between load and system dynamics. The effect of the location of individual as well as patches of composite loads in the vicinity on the sensitivity of the oscillatory modes is investigated. The impact of load composition on the overall sensitivity of the load is also investigated.

Heating effects in nanofocusing metal wedges

This paper investigates theoretically and numerically local heating effects in plasmon nanofocusing structures with a particular focus on the sharp free-standing metal wedges. The developed model separates plasmon propagation in the wedge from the resultant heating effects. Therefore, this model is only applicable where the temperature increments in a nanofocusing structure are sufficiently small not to result in significant variations of the metal permittivity in the wedge. The problem is reduced to a one-dimensional heating model with a distributed heat source resulting from plasmon dissipation in the metal wedge. A simple heat conduction equation governing the local heating effects in a nanofocusing structure is derived and solved numerically for plasmonic pulses of different lengths and reasonable energies. Both the possibility of achieving substantial local temperature increments in the wedge (with a significant self-influence of the heating plasmonic pulses), and the possibility of relatively weak heating (to ensure the validity of the previously developed nanofocusing theory) are demonstrated and discussed, including the future applications of the obtained results. Applicability conditions for the developed model are also derived and discussed.

Agreement between self-reported use of in vitro fertilization or ovulation induction, and medical insurance claims in Australian women aged 28–36 years

STUDY QUESTION: What is the self-reported use of in vitro fertilization (IVF) and ovulation induction (OI) in comparison with insurance claims by Australian women aged 28–36 years? SUMMARY ANSWER: The self-reported use of IVF is quite likely to be valid; however, the use of OI is less well reported. WHAT IS KNOWN AND WHAT THIS PAPER ADDS: Population-based research often relies on the self-reported use of IVF and OI because access to medical records can be difficult and the data need to include sufficient personal identifying information for linkage to other data sources. There have been few attempts to explore the reliability of the self-reported use of IVF and OI using the linkage to medical insurance claims for either treatment. STUDY DESIGN: This prospective, population-based, longitudinal study included the cohort of women born during 1973–1978 and participating in the Australian Longitudinal Study on Women's Health (ALSWH) (n = 14247). From 1996 to 2009, participants were surveyed up to five times. PARTICIPANTS AND SETTING: Participants self-reported their use of IVF or OI in two mailed surveys when aged 28–33 and 31–36 years (n = 7280), respectively. This study links self-report survey responses and claims for treatment or medication from the universal national health insurance scheme (i.e. Medicare Australia). MAIN RESULTS AND THE ROLE OF CHANCE: Comparisons between self-reports and claims data were undertaken for all women consenting to the linkage (n = 3375). The self-reported use of IVF was compared with claims for OI for IVF (Kappa, K = 0.83), oocyte collection (K = 0.82), sperm preparation (K = 0.83), intracytoplasmic sperm injection (K = 0.40), fresh embryo transfers (K = 0.82), frozen embryo transfers (K = 0.64) and OI for IVF medication (K = 0.17). The self-reported use of OI was compared with ovulation monitoring (K = 0.52) and OI medication (K = 0.71). BIAS, CONFOUNDING AND OTHER REASONS FOR CAUTION: There is a possibility of selection bias due to the inclusion criteria for participants in this study: (1) completion of the last two surveys in a series of five and (2) consent to the linkage of their responses with Medicare data. GENERALIZABILITY TO OTHER POPULATIONS: The results are relevant to questionnaire-based research studies with infertile women in developed countries. STUDY FUNDING/COMPETING INTEREST(S): ALSWH is funded by the Australian Government Department of Health and Ageing. This research is funded by a National Health and Medical Research Council Centre of Research Excellence grant.

Involvement of KLF4 in sulforaphane- and iberin-mediated induction of p21waf1/cip1

Sulforaphane (SF; 4-methylsulfinylbutyl isothiocyanate), a dietary compound derived from broccoli, may exhibit chemopreventive properties by inducing cell cycle arrest via induction of cyclin-dependent kinase inhibitor 1A (p21(waf1/cip1)), but the exact molecular mechanism has not been determined. Here we evaluate the role of the transcription factor Kruppel-like factor 4 (KLF4) in mediating the induction of p21(waf1/cip1) and cellular differentiation by SF and iberin (IB; 3-methylsulphinyl propyl isothiocyanate), also derived from broccoli. Exposure of Caco-2 and Caco-2/TC7 cells to SF and IB increased expression of both KLF4 and p21(waf1/cip1), whereas exposure of HT29 cells resulted only in induction of p21(waf1/cip1). In Caco-2 cells, small interfering RNA knock down of KLF4 expression attenuated induction of p21(waf1/cip1) in response to either SF or IB treatment. Contrary to expectation, prolonged exposure to SF reduced sucrase isomaltase activity, a marker of small intestinal differentiation in Caco-2 cells. Additional support for the SF-mediated induction of p21(waf1/cip1) by KLF4 was obtained from analyses of gastric tissue of Apc(Min/+) mice following acute intervention with SF but not from the analyses of other tissue of the intestinal tract. These results suggest that induction of p21(waf1/cip1) by SF or IB may be partly mediated by KLF4 in some colon cancer cells and tissues.

Overdue choices : how information and role in decision-making influence women's preferences for induction for prolonged pregnancy

Background: Enabling women to make informed decisions is a crucial component of consumer-focused maternity care. Current evidence suggests that health care practitioners’ communication of care options may not facilitate patient involvement in decision-making. The aim of this study was to investigate the effect of specific variations in health caregiver communication on women’s preferences for induction of labor for prolonged pregnancy. Methods: A convenience sample of 595 female participants read a hypothetical scenario in which an obstetrician discusses induction of labor with a pregnant woman. Information provided on induction and the degree of encouragement for the woman’s involvement in decision-making was manipulated to create four experimental conditions. Participants indicated preference with respect to induction, their perceptions of the quality of information received, and other potential moderating factors. Results: Participants who received information that was directive in favor of medical intervention were significantly more likely to prefer induction than those given nondirective information. No effect of level of involvement in decision-making was found. Participants’ general trust in doctors moderated the relationship between health caregiver communication and preferences for induction, such that the influence of information provided on preferences for induction differed across levels of involvement in decision-making for women with a low trust in doctors, but not for those with high trust. Many women were not aware of the level of information required to make an informed decision. Conclusions: Our findings highlight the potential value of strategies such as patient decision aids and health care professional education to improve the quality of information available to women and their capacity for informed decision-making during pregnancy and birth. (BIRTH 39:3 September 2012)

How can schools support beginning teachers? A call for timely induction and mentoring for effective teaching

Induction programs largely focus on informing the beginning teacher about the school culture and infrastructure yet the core business of education is teaching and learning. This qualitative study uses a survey, questionnaire, and interviews to investigate 10 beginning teachers’ needs towards becoming effective teachers in their first year of teaching. Findings were synonymous with studies in other countries that showed they required more support in the induction process, particularly around the school context, networking, managing people, and creating work-life balances. It also found that these beginning teachers required more support in school culture and infrastructure with stronger consideration of developing teaching practices, such as: pedagogical knowledge development and behaviour management. It highlighted willing and capable assigned mentors who can model practices and provide feedback on the beginning teachers’ practices as pivotal to induction and mentoring processes.

Finite volume approach of natural convection in a triangular enclosure with localized heating from below

In this study, natural convection heat transfer and buoyancy driven flows have been investigated in a right angled triangular enclosure. The heater located on the bottom wall while the inclined wall is colder and the remaining walls are maintained as adiabatic. Governing equations of natural convection are solved through the finite volume approach, in which buoyancy is modeled via the Boussinesq approximation. Effects of different parameters such as Rayleigh number, aspect ratio, prantdl number and heater location are considered. Results show that heat transfer increases when the heater is moved toward the right corner of the enclosure. It is also revealed that increasing the Rayleigh number, increases the strength of free convection regime and consequently increases the value of heat transfer rate. Moreover, larger aspect ratio enclosure has larger Nusselt number value. In order to have better insight, streamline and isotherms are shown.

Thermo-magnetic convection of paramagnetic fluids with non-instantaneous heating

The unsteady boundary-layer development for thermomagnetic convection of paramagnetic fluids inside a square cavity has been considered in this study. The cavity is placed in a microgravity condition (no gravitation acceleration) and under a uniform magnetic field which acts vertically. A ramp temperature boundary condition is applied on left vertical side wall of the cavity where the temperature initially increases with time up to some specific time and maintain constant thereafter. A distinct magnetic convection boundary layer is developed adjacent to the left vertical wall due to the effect of the magnetic body force generated on the paramagnetic fluid. An improved scaling analysis has been performed using triple-layer integral method and verified by numerical simulations. The Prandtl number has been chosen greater than unity varied over 5-100. Moreover, the effect of various values of the magnetic parameter and magnetic Rayleigh number on the fluid flow and heat transfer has been shown.

Power system sensitivity analysis considering induction motor loads

Power system operation and planning are facing increasing uncertainties especially with the deregulation process and increasing demand for power. Probabilistic power system stability assessment and probabilistic power system planning have been identified by EPRI as one of the important trends in power system operations and planning. Probabilistic small signal stability assessment studies the impact of system parameter uncertainties on system small disturbance stability characteristics. Researches in this area have covered many uncertainties factors such as controller parameter uncertainties and generation uncertainties. One of the most important factors in power system stability assessment is load dynamics. In this paper, composite load model is used to consider the uncertainties from load parameter uncertainties impact on system small signal stability characteristics. The results provide useful insight into the significant stability impact brought to the system by load dynamics. They can be used to help system operators in system operation and planning analysis.

Enhanced photocatalytic activity of titanium oxide nanotubes after heating treatment

Titanium oxide nanotubes were obtained by an electrochemical anodization method. Scanning electron microscope results demonstrate that the diameter of the tubes is about 120 nm and the length of the tubes is around 13 μm. Transmission electron microscope results indicate that the nanotubes are assembled by numerous nanoparticles and tube-like structure remains well after heat treatment at 400-600 °C. The photocatalysis performance of the nanotubes was evaluated in terms of the decomposition rate of methyl orange under UV irradiation. The results show that the photocatalytic activity was enhanced through the heating treatment of the nanotubes, and the nanotubes heated at 600 °C exhibits the best photocatalytic activity. X-ray diffraction patterns indicate that there is no phase transformation during the heat treatment. Therefore, the enhanced activity can be attributed to the improvement of nanotubes crystallinity, which may provide more insights about the effect of the crystallinity on the photocatalytic performance.

Beginning teachers’ achievements and challenges : implications for induction and mentoring

It is recognised worldwide that beginning teachers require more support as reasons for high attrition rates (e.g., lack of appreciation from colleagues, unsatisfying working conditions, inadequate teacher preparation) indicate current systems are failing them. One way of addressing their specific needs is to understand their achievements and challenges during their first year of teaching. This qualitative study tracks 10 beginning primary teachers’ achievements and challenges at two points (April and September) during their first year of teaching in Australian public schools. Findings showed that building relationships and behaviour management were considered achievements at these two points, yet behaviour management was also considered a challenge. Other challenges included: learning differentiation, working with parents, and negotiating a life-work balance. Induction into the school culture and infrastructure continued to be important, especially developing skills on handling difficult parents and creating a life-work balance. Simultaneously, they required mentoring for effective teaching in classroom management and differentiation. A two-prong approach of induction into the school culture and infrastructure and mentoring for effective teaching needs to continue throughout the first year of teaching, and possibly beyond.