Compact multiport antenna with isolated ports

The small element spacing of compact multiport arrays introduces strong mutual coupling between the antenna ports. Due to this coupling, the input impedance of the array changes when elements excitations are varied, and consequently, the array cannot be matched for an arbitrary excitation. Decoupling networks have in the past been used to provide an additional connection between antenna ports in order to cancel the coupling between elements. An alternative approach is to design the antenna so that each port does not excite a single element, but all elements simultaneously instead. The geometry of the antenna is optimized so that this direct excitation of elements counteracts the mutual coupling, thus yielding decoupled ports. This paper describes the design of such a 4-port antenna.

UWB antenna array for wireless transmission along corridors

A 2-element elliptical patch antenna array with a bi-directional radiation pattern has been developed for ultra wideband indoor wireless communications. The array is constructed by means of feeding two omni-directional elliptical patch elements with a 3-section hybrid power divider. Experimental results show that the array has a stable radiation pattern and low return loss over a broad bandwidth of 64% (3.1 - 6 GHz).

A modified dual-band microstrip monopole antenna

A modified microstrip-fed planar monopole antenna with open circuited coupled line is presented in this paper. The operational bandwidth of the proposed antenna covers the 2.4 GHz ISM band (2.42-2.48 GHz) and the 5 GHz WLAN band (5 GHz to 6 GHz). The radiating elements occupy a small area of 23×8 mm2. The Finite Difference Time Domain method is used to predict the input impedance of the antenna. The calculated return loss shows very good agreement with measured data. Reasonable antenna gain is observed across the operating band. The measured radiation patterns are similar to those of a simple monopole antenna.

Characteristics of a two-layer microstrip patch antenna for Bluetooth applications

A double-layer rectangular patch microstrip antenna suitable for Bluetooth applications is investigated. The patch is etched on a separate substrate which is suspended above the ground plane and supported by an MCX connector. The air gap between the patch and the ground plane increases the impedance bandwidth and can be used to tune the resonant frequency. This paper presents experimental results on the effects of various parameters on the antenna characteristics and provides guidelines for the design of such an antenna.

Microstrip decoupling networks for low-order multi-port arrays with reduced element spacing

An array of monopole elements with reduced element spacing of λ/6 to λ/20 is considered for application in digital beam-forming and direction-finding. The small element spacing introduces strong mutual coupling between the array elements. This paper discusses that decoupling can be achieved analytically for arrays with three elements and describes Kuroda’s identities to realize the lumped elements of the derived decoupling network. Design procedures and equations are proposed. Experimental results are presented. The decoupled array has a bandwidth of 1% and a superdirective radiation pattern.

A superdirective 3-element array for adaptive beamforming

A small array composed of three monopole elements with very small element spacing on the order of λ/6 to λ/20 is considered for application in adaptive beamforming. The properties of this 3-port array are governed by strong mutual coupling. It is shown that for signal-to-noise maximization, it is not sufficient to adjust the weights to compensate for the effects of mutual coupling. The necessity for a RF-decoupling network (RF-DN) and its simple realization are shown. The array with closely spaced elements together with the RF-DN represents a superdirective antenna with a directivity of more than 10 dBi. It is shown that the required fractional frequency bandwidth and the available unloaded Q of the antenna and RF-DN structure determine the lower limit for the element spacing.

Evaluation of the Airdrie Sheriff Youth Court Pilot

A pilot Youth Court was introduced at Airdrie Sheriff Court in June 2004. Its objectives were to: • reduce the frequency and seriousness of re-offending by 16 and 17 year old offenders, particularly persistent offenders (and some 15 year olds who are referred to the court); • promote the social inclusion, citizenship and personal responsibility of these young offenders while maximising their potential; • establish fast track procedures for those young persons appearing before the Youth Court; • enhance community safety, by reducing the harm caused to individual victims of crime and providing respite to those communities which are experiencing high levels of crime; and • test the viability and usefulness of a Youth Court using existing legislation and to demonstrate whether legislative and practical improvements might be appropriate. An evaluation of the pilot commissioned by the Scottish Executive found that it appeared in many respects to be working well. It was a tightly run court that dealt with a heavy volume of business. With its fast track procedures and additional resources it was regarded as a model to be aspired to in all summary court business. Whether a dedicated Youth Court was required or whether procedural improvements would have been possible in the absence of dedicated resources and personnel was, however, more difficult to assess. Two issues in particular required further attention. First, consideration needed to be given to whether the Youth Court should be more explicitly youth focused and what this might entail. Second, greater clarity was required regarding for whom the Youth Court was intended to avoid the risk of net-widening and its consequences for young people.

Evaluation of the Hamilton Youth Court Pilot 2003-2005

Pilot Youth Courts were introduced at Hamilton Sheriff Court in June 2003 and at Airdrie Sheriff Court in June 2004. Although introduced as one of a number of measures aimed at responding more effectively to youth crime (including young people dealt with through the Children’s Hearings System), the Youth Courts were intended for young people who would otherwise have been dealt with in the adult Sheriff Summary Court. The objectives of the pilot Youth Courts were to: • reduce the frequency and seriousness of re-offending by 16 and 17 year old offenders, particularly persistent offenders (and some 15 year olds who are referred to the court); • promote the social inclusion, citizenship and personal responsibility of these young offenders while maximising their potential; • establish fast track procedures for those young persons appearing before the Youth Court; • enhance community safety, by reducing the harm caused to individual victims of crime and providing respite to those communities which are experiencing high levels of crime; and • test the viability and usefulness of a Youth Court using existing legislation and to demonstrate whether legislative and practical improvements might be appropriate. Evaluation of the Hamilton and Airdrie Sheriff Youth Court pilots suggested that they had been successful in meeting the objectives set for them by the Youth Court Feasibility Group. Both were tightly run courts that dealt with a heavy volume of business. The particular strengths of the Youth Court model over previous arrangements included the fast-tracking of young people to and through the court, the reduction in trials, the availability of a wider range of resources and services for young people and ongoing judicial review. The successful operation of the pilot Youth Courts was dependent upon effective teamwork among the relevant agencies and professionals concerned. Good information sharing, liaison and communication appeared to exist across agencies and the procedures that were in place to facilitate the sharing of information seemed to be working well. This was also facilitated by the presence of dedicated staff within agencies, resulting in clear channels of communication, and in the opportunity provided by the multi-agency Implementation Groups to identify and address operational issues on an ongoing basis. However, whether Youth Courts are required in Scotland or whether procedural improvement were possible in the absence of dedicated resources and personnel was more difficult to assess. Two issues in particular required further attention. First, consideration needed to be given to whether the Youth Courts should be more explicitly youth focused and what this might entail. Second, greater clarity was required regarding for whom the Youth Courts were intended. This suggested the need for further discussion of Youth Court targeting and its potential consequences among the various agencies concerned.

Photocatalytic disinfection of bacterial pollutants using suspended and immobilized TiO(2) powders

The photocatalytic disinfection of Enterobacter cloacae and Enterobacter coli using microwave (MW), convection hydrothermal (HT) and Degussa P25 titania was investigated in suspension and immobilized reactors. In suspension reactors, MW-treated TiO(2) was the most efficient catalyst (per unit weight of catalyst) for the disinfection of E. cloacae. However, HT-treated TiO(2) was approximately 10 times more efficient than MW or P25 titania for the disinfection of E. coli suspensions in surface water using the immobilized reactor. In immobilized experiments, using surface water a significant amount of photolysis was observed using the MW- and HT-treated films; however, disinfection on P25 films was primarily attributed to photocatalysis. Competitive action of inorganic ions and humic substances for hydroxyl radicals during photocatalytic experiments, as well as humic substances physically screening the cells from UV and hydroxyl radical attack resulted in low rates of disinfection. A decrease in colony size (from 1.5 to 0.3 mm) was noted during photocatalytic experiments. The smaller than average colonies were thought to occur during sublethal (•) OH and O(2) (•-) attack. Catalyst fouling was observed following experiments in surface water and the ability to regenerate the surface was demonstrated using photocatalytic degradation of oxalic acid as a model test system

An investigation into the effect of amphiphilic siloxane oligomers on dermal fibroblasts

This study investigates the effect of well-defined poly(dimethylsiloxane)-poly(ethylene glycol) (PDMS-PEG) ABA linear block co-oligomers on the proliferation of human dermal fibroblasts. The co-oligomers assessed ranged in molecular weight (MW) from 1335 to 5208 Da and hydrophilic-lipophilic balance (HLB) from 5.9 to 16.6 by varying the number of both PDMS and PEG units. In general, it was found that co-oligomers of low MW or intermediate hydrophilicity significantly reduced fibroblast proliferation. A linear relationship between down-regulation of fibroblast proliferation, and the ratio HLB/MW was observed at concentrations of 0.1 and 1.0 wt % of the oligomers. This enabled the structures with highest efficiency to be determined. These results suggest the possible use of the PEG-PDMS-PEG block co-oligomers as an alternative to silicone gels for hypertrophic scar remediation.

Severe workplace conflict : the experience of mobbing

Workplace mobbing is a particularly serious phenomenon that is extremely costly to organizations and the health of those targeted. This article reports on a study of self-identified targets of mobbing. Findings support a five-stage process of mobbing, which commences with unresolved conflict and leads ultimately to expulsion from the organization. Participants report a number of experiences, such as lengthy investigations and escalation of conflict, that result in an increasingly unbalanced sense of power away from the individual and towards the organization. Revealed is a mismatch between the expected organizational justice processes and support and the actual experience. Recommendations for approaching this problem are discussed.

Globalization of science education : comment and a commentary

The globalized nature of modern society has generated a number of pressures that impact internationally on countries’ policies and practices of science education. Among these pressures are key issues of health and environment confronting global science, global economic control through multinational capitalism, comparative and competitive international testing of student science achievement, and the desire for more humane and secure international society. These are not all one-way pressures and there is evidence of both more conformity in the intentions and practices of science education and of a greater appreciation of how cultural differences, and the needs of students as future citizens can be met. Hence while a case for economic and competitive subservience of science education can be made, the evidence for such narrowing is countered by new initiatives that seek to broaden its vision and practices. The research community of science education has certainly widened internationally and this generates many healthy exchanges, although cultural styles of education other than Western ones are still insufficiently recognized. The dominance of English language within these research exchanges is, however, causing as many problems as it solves. Science education, like education as a whole, is a strongly cultural phenomenon, and this provides a healthy and robust buffer to the more negative effects of globalization

Biological responses of human bone marrow mesenchymal stem cells to Sr-M-Si (M = Zn, Mg) silicate bioceramics

Strontium (Sr), Zinc (Zn), magnesium (Mg), and silicon (Si) are reported to be essential trace elements for the growth and mineralization of bone. We speculated that the combination of these bioactive elements in bioceramics may be effective to regulate the osteogenic property of boneforming cells. In this study, two Sr-containing silicate bioceramics, Sr2ZnSi2O7 (SZS) and Sr2MgSi2O7 (SMS), were prepared. The biological response of human bone marrow mesenchymal stem cells (BMSCs) to the two bioceramics (in the forms of powders and dense ceramic bulks) was systematically studied. In powder form, the effect of powder extracts on the viability and alkaline phosphatase (ALP) activity of BMSCs was investigated. In ceramic disc form, both direct and indirect coculture of BMSCs with ceramic discs were used to investigate their biological response, including attachment, proliferation, ALP activity, and bone-related genes expression. Beta-tricalcium phosphate (b-TCP) and akermanite (Ca2MgSi2O7, CMS) were used as control materials. The results showed that the Sr, Zn, and Si (or Sr, Mg, and Si)-containing ionic products from SZS and SMS powders enhanced ALP activity of BMSCs, compared to those from b-TCP. Both SZS and SMS ceramic discs supported the growth of BMSCs, and most importantly, significantly enhanced the ALP activity and bone-related genes expression of BMSCs as compared to b-TCP. The results suggest that the specific combination of bioactive ions (Sr, Zn, Si, e.g.) in bioceramics is a viable way to improve the biological performance of biomaterials, and the form of materials and surface properties were nonnegligible factors to influence cell response.

Predictors of young people’s charitable intentions to donate money : an extended theory of planned behavior perspective

An extended theory of planned behavior (TPB) was used to predict young people’s intentions to donate money to charities in the future. Students (N = 210; 18-24 years) completed a questionnaire assessing their attitude, subjective norm, perceived behavioral control [PBC], moral obligation, past behavior and intentions toward donating money. Regression analyses revealed the extended TPB explained 61% of the variance in intentions to donate money. Attitude, PBC, moral norm, and past behavior predicted intentions, representing future targets for charitable giving interventions.

ATF5, a possible regulator of osteogenic differentiation in human adipose-derived stem cells

The regulatory pathways involved in maintaining the pluripotency of embryonic stem cells are partially known, whereas the regulatory pathways governing adult stem cells and their "stem-ness" are characterized to an even lesser extent. We, therefore, screened the transcriptome profiles of 20 osteogenically induced adult human adipose-derived stem cell (ADSC) populations and investigated for putative transcription factors that could regulate the osteogenic differentiation of these ADSC. We studied a subgroup of donors' samples that had a disparate osteogenic response transcriptome from that of induced human fetal osteoblasts and the rest of the induced human ADSC samples. From our statistical analysis, we found activating transcription factor 5 (ATF5) to be significantly and consistently down-regulated in a randomized time-course study of osteogenically differentiated adipose-derived stem cells from human donor samples. Knockdown of ATF5 with siRNA showed an increased sensitivity to osteogenic induction. This evidence suggests a role for ATF5 in the regulation of osteogenic differentiation in adipose-derived stem cells. To our knowledge, this is the first report that indicates a novel role of transcription factors in regulating osteogenic differentiation in adult or tissue specific stem cells. © 2012 Wiley Periodicals, Inc.