Child characteristics associated with delay of gratification in children with Down syndrome

Aim: Children with Down syndrome have been identified as having difficulty delaying gratification when compared to mental age matched children who are developing typically. This study investigated the association between individual characteristics hypopthesized to be associated with ability to delay as well as the strategies children used in a waiting task. Method: Thirty-two children with Down syndrome and 50 typically developing children matched for mental age completed the tasks. Observations of their behaviour while waiting were video-recorded for later analysis. In addition, parents completed questionnaires with respect to their child’s personality and behaviour. Results: Children with Down syndrome were significantly less able to delay gratification than the comparison group. Different patterns of association were found for the two groups between the observational and questionnaire measures and delay time. Conclusions: Children with Down syndrome have greater difficulty delaying gratification than would be predicted on the basis of their mental age. The contributions to delay appear to differ from those for typically developing children and these differences need to be considered when planning interventions for developing this skill

Strategy use of children with Down syndrome in a delay of gratification situation

Background: The capacity to delay gratification has been shown to be a very important developmental task for children who are developing typically. There is evidence that children with Down syndrome have more difficulty with a delay of gratification task than typically developing children of the same mental age. This study focused on the strategies children with Down syndrome use while in a delay of gratification situation to ascertain if these contribute to the differences in delay times from those of typically developing children. Method: Thirty-two children with Down syndrome (15 females) and 50 typically developing children participated in the study. Children with Down syndrome had a mental age, as measured by the Stanford-Binet IV, between 36 and 66 months (M = 45.66). The typically developing children had a mean chronological age of 45.76 months. Children participated in a delay of gratification task where they were offered two or one small treats and asked which they preferred. They were then told that they could have the two treats if they waited for the researcher to return (an undisclosed time of 15 min). If they did not want to wait any longer they could call the researcher back but then they could have only one treat. Twenty-two of the children with Down syndrome and 43 of the typically developing children demonstrated understanding of the task and their data are included here. Sessions were videotaped for later analysis. Results: There were significant differences in the mean waiting times of the two groups. The mean of the waiting times for children with Down syndrome was 181.32 s (SD = 347.62) and was 440.21 s (SD = 377.59) for the typically developing children. Eighteen percent of the group with Down syndrome waited for the researcher to return in comparison to 35% of the typically developing group. Sixty-four percent of children with Down syndrome called the researcher back and the remainder (18%) violated. In the typically developing group 37% called the researcher back and 28% violated. The mean waiting time for the group of children with Down syndrome who called the researcher back was 24 s. Examination of strategy use in this group was therefore very limited. There appeared to be quite similar strategy use across the groups who waited the full 15 min. Conclusions: These results confirm the difficulty children with Down syndrome have in delaying gratification. Teaching strategies for waiting, using information drawn from the behaviours of children who are developing typically may be a useful undertaking. Examination of other contributors to delay ability (e.g., language skills) is also likely to be helpful in understanding the difficulties demonstrated in delaying gratification.

Collective dynamics and control of a 3-D small-world network with time delays

The paper presents a detailed analysis on the collective dynamics and delayed state feedback control of a three-dimensional delayed small-world network. The trivial equilibrium of the model is first investigated, showing that the uncontrolled model exhibits complicated unbounded behavior. Then three control strategies, namely a position feedback control, a velocity feedback control, and a hybrid control combined velocity with acceleration feedback, are then introduced to stabilize this unstable system. It is shown in these three control schemes that only the hybrid control can easily stabilize the 3-D network system. And with properly chosen delay and gain in the delayed feedback path, the hybrid controlled model may have stable equilibrium, or periodic solutions resulting from the Hopf bifurcation, or complex stranger attractor from the period-doubling bifurcation. Moreover, the direction of Hopf bifurcation and stability of the bifurcation periodic solutions are analyzed. The results are further extended to any "d" dimensional network. It shows that to stabilize a "d" dimensional delayed small-world network, at least a "d – 1" order completed differential feedback is needed. This work provides a constructive suggestion for the high dimensional delayed systems.

Establishing initial trust in autonomous delay tolerant networks without centralised PKI

A Delay Tolerant Network (DTN) is one where nodes can be highly mobile, with long message delay times forming dynamic and fragmented networks. Traditional centralised network security is difficult to implement in such a network, therefore distributed security solutions are more desirable in DTN implementations. Establishing effective trust in distributed systems with no centralised Public Key Infrastructure (PKI) such as the Pretty Good Privacy (PGP) scheme usually requires human intervention. Our aim is to build and compare different de- centralised trust systems for implementation in autonomous DTN systems. In this paper, we utilise a key distribution model based on the Web of Trust principle, and employ a simple leverage of common friends trust system to establish initial trust in autonomous DTN’s. We compare this system with two other methods of autonomously establishing initial trust by introducing a malicious node and measuring the distribution of malicious and fake keys. Our results show that the new trust system not only mitigates the distribution of fake malicious keys by 40% at the end of the simulation, but it also improved key distribution between nodes. This paper contributes a comparison of three de-centralised trust systems that can be employed in autonomous DTN systems.

A Bayesian approach to the determination of ignition delay

A novel in-cylinder pressure method for determining ignition delay has been proposed and demonstrated. This method proposes a new Bayesian statistical model to resolve the start of combustion, defined as being the point at which the band-pass in-cylinder pressure deviates from background noise and the combustion resonance begins. Further, it is demonstrated that this method is still accurate in situations where there is noise present. The start of combustion can be resolved for each cycle without the need for ad hoc methods such as cycle averaging. Therefore, this method allows for analysis of consecutive cycles and inter-cycle variability studies. Ignition delay obtained by this method and by the net rate of heat release have been shown to give good agreement. However, the use of combustion resonance to determine the start of combustion is preferable over the net rate of heat release method because it does not rely on knowledge of heat losses and will still function accurately in the presence of noise. Results for a six-cylinder turbo-charged common-rail diesel engine run with neat diesel fuel at full, three quarters and half load have been presented. Under these conditions the ignition delay was shown to increase as the load was decreased with a significant increase in ignition delay at half load, when compared with three quarter and full loads.

Ignition delay in an ethanol fumigated common rail diesel engine

A novel method for determining ignition delay is presented. This method utilises combustion resonance as a means of determining the onset of ignition. Results are shown from an ethanol fumigation study comprising of substitutions up to 50% at full, three-quarter and half load. It has been demonstrated that at full load there is a decrease in ignition delay with increasing ethanol substitutions, whereas at half load there is an increase in ignition delay with increasing ethanol substitutions. It is suggested that this conflicting result is a consequence of the auto ignition of ethanol.

Determining operations affected by delay in predictive train timetables

Constructing train schedules is vital in railways. This complex and time consuming task is however made more difficult by additional requirements to make train schedules robust to delays and other disruptions. For a timetable to be regarded as robust, it should be insensitive to delays of a specified level and its performance with respect to a given metric, should be within given tolerances. In other words the effect of delays should be identifiable and should be shown to be minimal. To this end, a sensitivity analysis is proposed that identifies affected operations. More specifically a sensitivity analysis for determining what operation delays cause each operation to be affected is proposed. The information provided by this analysis gives another measure of timetable robustness and also provides control information that can be used when delays occur in practice. Several algorithms are proposed to identify this information and they utilise a disjunctive graph model of train operations. Upon completion the sets of affected operations can also be used to define the impact of all delays without further disjunctive graph evaluations.

Ignition delay of bio-fuels in a common-rail compression ignition engine

The utility of a novel technique for determining the ignition delay in a compression ignition engine has been shown. This method utilises statistical modelling in the Bayesian paradigm to accurately resolve the start of combustion from a band-pass in-cylinder pressure signal. Applied to neat diesel and six biofuels, including four fractionations of palm oil of varying carbon chain length and degree of unsaturation, the relationships between ignition delay, cetane number and oxygen content have been explored. It is noted that the expected negative relationship between ignition delay and cetane number held, as did the positive relationship between ignition delay and oxygen content. The degree of unsaturation was also identified as a potential factor influencing the ignition delay.

The optimal duration and delay of first aid treatment for deep partial thickness burn injuries

Using our porcine model of deep dermal partial thickness burn injury, various durations (10min, 20min, 30min or 1h) and delays (immediate, 10min, 1h, 3h) of 15 degrees C running water first aid were applied to burns and compared to untreated controls. The subdermal temperatures were monitored during the treatment and wounds observed weekly for 6 weeks, for re-epithelialisation, wound surface area and cosmetic appearance. At 6 weeks after the burn, tissue biopsies were taken of the scar for histological analysis. Results showed that immediate application of cold running water for 20min duration is associated with an improvement in re-epithelialisation over the first 2 weeks post-burn and decreased scar tissue at 6 weeks. First aid application of cold water for as little as 10min duration or up to 1h delay still provides benefit.

Public sector project delay : the Malaysian perspective and the way forward

Construction delay has been a protracted problem for the Malaysian construction industry. Recent report showed that 80% of public sector projects are behind schedule. This underachieving time performance has led to many problems including public complaints, loss of reputation and revenue for the government and a slump in the industry’s GDP contribution. Research in the area of project delay has mushroomed worldwide with attempts to place mitigation plans, but delay remains a global phenomenon. There is now an urgent need for revolutionizing construction practices and past research, backed up with few successful cases suggests that Supply Chain Management (SCM) could prove beneficial to reduce or eliminate delays in construction. SCM which originated from the automotive manufacturing industry promotes a more collaborative approach to construction management and has recently gained attention of the construction industry. However every country, including Malaysia, would certainly have disparities of their own compared to others being it from the cultural point of view, nature of problems, locality or improvements needed. Therefore, this paper will present part of a Ph.D. research which aims at illustrating the Malaysian construction industry experts’ perception of the Malaysian public sector project delay, provide insight into these dilemmas, highlights the problems with current practices, its effects and the improvements needed. Subsequently, this paper would propose ratification to the problems using SCM. A semi-structured interview has been conducted to practitioners with at least 20 years’ experience in the industry. The findings showed that Malaysia may be unique compared to other countries and that by considering a number of additional factors, SCM could prove beneficial to increase efficiency of the Malaysian public sector projects.

Using pulse transit delay in Z-scan to discriminate between excited-state absorption and other nonlinear processes in ZnO nanocones

We report a new approach that uses the single beam Z-scan technique, to discriminate between excited state absorption (ESA) and two and three photon nonlinear absorption. By measuring the apparent delay or advance of the pulse in reaching the detector, the nonlinear absorption can be unambiguously identified as either instantaneous or transient. The simple method does not require a large range of input fluences or sophisticated pulse-probe experimental apparatus. The technique is easily extended to any absorption process dependent on pulse width and to nonlinear refraction measurements. We demonstrate in particular, that the large nonlinear absorption in ZnO nanocones when exposed to nanosecond 532 nm pulses, is due mostly to ESA, not pure two-photon absorption.

Motor Accident Insurance Act 1994 - reasonable excuse for delay in giving notice under s37

The decisions in Perdis v The Nominal Defendant [2003] QCA 555, Miller v the Nominal Defendant [2003] QCA 558 and Piper v the Nominal Defendant [2003] QCA 557 were handed down contemporaneously by the Queensland Court of Appeal on December 15 2003. They consider important issues as to the construction of key provisions of the Motor Accident Insurance Act 1994 (Qld)