Diagnostic of Rolling Element Bearings with Envelope Analysis in Non-Stationary Conditions

In the field of rolling element bearing diagnostics, envelope analysis has gained in the last years a leading role among the different digital signal processing techniques. The original constraint of constant operating speed has been relaxed thanks to the combination of this technique with the computed order tracking, able to resample signals at constant angular increments. In this way, the field of application of this technique has been extended to cases in which small speed fluctuations occur, maintaining high effectiveness and efficiency. In order to make this algorithm suitable to all industrial applications, the constraint on speed has to be removed completely. In fact, in many applications, the coincidence of high bearing loads, and therefore high diagnostic capability, with acceleration-deceleration phases represents a further incentive in this direction. This chapter presents a procedure for the application of envelope analysis to speed transients. The effect of load variation on the proposed technique will be also qualitatively addressed.

Nonlinear container ship model for the study of parametric roll resonance

Parametric roll is a critical phenomenon for ships, whose onset may cause roll oscillations up to +-40 degrees, leading to very dangerous situations and possibly capsizing. Container ships have been shown to be particularly prone to parametric roll resonance when they are sailing in moderate to heavy head seas. A Matlab/Simulink parametric roll benchmark model for a large container ship has been implemented and validated against a wide set of experimental data. The model is a part of a Matlab/Simulink Toolbox (MSS, 2007). The benchmark implements a 3rd-order nonlinear model where the dynamics of roll is strongly coupled with the heave and pitch dynamics. The implemented model has shown good accuracy in predicting the container ship motions, both in the vertical plane and in the transversal one. Parametric roll has been reproduced for all the data sets in which it happened, and the model provides realistic results which are in good agreement with the model tank experiments.

A nonlinear observer for estimating transverse stability parameters of marine surface vessels

This paper presents a nonlinear observer for estimating parameters associated with the restoring term of a roll motion model of a marine vessel in longitudinal waves. Changes in restoring, also referred to as transverse stability, can be the result of changes in the vessel's centre of gravity due to, for example, water on deck and also in changes in the buoyancy triggered by variations in the water-plane area produced by longitudinal waves -- propagating along the fore-aft direction along the hull. These variations in the restoring can change dramatically the dynamics of the roll motion leading to dangerous resonance. Therefore, it is of interest to estimate and detect such changes.

Young and Well CRC: Engaging young people as research partners

This paper presents the outcomes of an international collaboration between researchers and young people in Australia and the United States, using participatory design to engage young people as research partners in the collaborative development of a conceptual framework for the Online WellBeing Center (OWBC), a repository of evidence-based mental health tools focused on mental health promotion and the prevention of mental illness developed as part of Young and Well Cooperative Research Centre. Eighteen participants (nine in Australia and nine in USA) were involved as key partners through a series of participatory design workshops to develop the framework for the OWBC. Key objectives of the collaboration included an increased understanding of: how to recruit young people to be part of an international project team collaborating remotely; how to use new technologies to manage communication and maintain engagement; how to apply principles of participatory research to create a youth informed research project; how to develop an international stakeholder partnership to ensure relevancy in value systems, cultural orientation and project outcomes. Recommendations included guidelines for how others can establish international collaborations that integrate young people as active project participants.

Stabilization of parametric roll resonance with active u-tanks via Lyapunov control design

Parametric ship roll resonance is a phenomenon where a ship can rapidly develop high roll motion while sailing in longitudinal waves. This effect can be described mathematically by periodic changes of the parameters of the equations of motion, which lead to a bifurcation. In this paper, the control design of an active u-tank stabilizer is carried out using Lyapunov theory. A nonlinear backstepping controller is developed to provide global exponential stability of roll. An extension of commonly used u-tank models is presented to account for large roll angles, and the control design is tested via simulation on a high-fidelity model of a vessel under parametric roll resonance.

Genetic and phenotypic evidence supports evolutionary divergence of the American flamingo (Phoenicopterus ruber) population in the Galapagos islands

The Galapagos archipelago is characterized by a high degree of endemism across many taxa, linked to the archpelago's oceanic origin and distance from other colonizing land masses. A population of ~ 500 American Flamingos (Phoenicopterus ruber) resides in Galapagos, which is thought to share an historical origin with the American Flamingo currently found in the Caribbean region. Genetic and phenotypic parameters in American Flamingos from Galapagos and from the Caribbean were investigated. Microsatellite and microchondrial DNA markers data showed that the American Flamingo population in Galapagos differs genetically from that in the Caribbean. American Flamingos in Galapagos form a clade which differs by a single common nucleotide substitution from American Flamingos in the Caribbean. The genetic differentiation is also evident from nuclear DNA in that microsatellite data reveal a number of private alleles for the American Flamingo in Galapagos. Analysis of skeletal measurements showed that American Flamingos in Galapagos are smaller than those in the Caribbean primarily due to shorter tarsus length, and differences in body shape sexual dimorphism. American Flamingo eggs from Galapagos have smaller linear dimensions and volumes than those from the Caribbean. The findings are consistent with reproductive isolation of American Flamingo population in Galapagos.

Sense of home, sense of place : a morpho-typological comparative study of Florida and Queensland

Cities in the 21st century have become layered and complex systems not only in terms of physical form, but also social and cultural structure. Consolidated tools to analyze the urban environment have today to be improved including a strong interdisciplinary perspective in order to understand and manage the unprecedented complexity our cities are facing. Redevelopments, new estates, internal and external migrations are all dynamics which are deeply modifying the built environment directly or indirectly also affecting local identity, culture and social structure. This paper investigates the relationship between urban form and social behaviors, with particular attention to the perception of the built environment and its use by long term residents, recent migrants as well as tourists. A comparative study is suggested between South East Queensland and Florida; this two regions share common features such as subtropical climate, similar lifestyle, leisure cities and canal estates. Neighborhoods on the Gold and Sunshine Coasts have been designed using the communities of Florida, such as Celebration or Seaside, as models. These regions share also significant migration processes, similar social problems and high crime rates, which directly affect the local economies. Comparing Florida and SEQ could provide an understanding of different strategies adopted and how urban development and lifestyle can be managed maintaining social equity and security. This study, investigates people’s perception of built form and how this affects the use of public space. The relationship between built environment and social behaviour has been previously investigated, for example by environmental psychology; the innovation proposed by this research is to study the perception of place in leisure cities at multiple levels. Locals, migrants and tourists have different understanding of the built form in the same location; this understanding affects the use of space and the attitude to visit or avoid some precincts. The research methodology integrates traditional morpho-typological investigations with qualitative methods; data are collected in the first phase through online surveys about perception of urban forms. Findings guide then the selection of neighbourhoods to be investigated in detail through questionnaires and Nolli maps, specifying morphological regions as well as recurrent building typologies. A final phase includes interviews with selected stakeholders. Major urban projects are discussed addressing how they are used and perceived by locals, migrants or tourists; the comparison between SEQ and Florida allows the identification of strategies to address migration issues in both regions with particular attention to urban form and placemaking dynamics.

Unbalance identification in large steam turbo-generator unit using a model-based method

Fault identification in industrial machine is a topic of major importance under engineering point of view. In fact, the possibility to identify not only the type, but also the severity and the position of a fault occurred along a shaft-line allows quick maintenance and shorten the downtime. This is really important in the power generation industry where the units are often of several tenths of meters long and where the rotors are enclosed by heavy and pressure-sealed casings. In this paper, an industrial experimental case is presented related to the identification of the unbalance on a large size steam turbine of about 1.3 GW, belonging to a nuclear power plant. The case history is analyzed by considering the vibrations measured by the condition monitoring system of the unit. A model-based method in the frequency domain, developed by the authors, is introduced in detail and it is then used to identify the position of the fault and its severity along the shaft-line. The complete model of the unit (rotor – modeled by means of finite elements, bearings – modeled by linearized damping and stiffness coefficients and foundation – modeled by means of pedestals) is analyzed and discussed before being used for the fault identification. The assessment of the actual fault was done by inspection during a scheduled maintenance and excellent correspondence was found with the identified one by means of authors’ proposed method. Finally a complete discussion is presented about the effectiveness of the method, even in presence of a not fine tuned machine model and considering only few measuring planes for the machine vibration.

Experimental evidences in bearing diagnostics for traction system of high speed trains

Rolling element bearings are the most critical components in the traction system of high speed trains. Monitoring their integrity is a fundamental operation in order to avoid catastrophic failures and to implement effective condition based maintenance strategies. Generally, diagnostics of rolling element bearings is usually performed by analyzing vibration signals measured by accelerometers placed in the proximity of the bearing under investigation. Several papers have been published on this subject in the last two decades, mainly devoted to the development and assessment of signal processing techniques for diagnostics. The experimental validation of such techniques has been traditionally performed by means of laboratory tests on artificially damaged bearings, while their actual effectiveness in specific industrial applications, particularly in rail industry, remains scarcely investigated. This paper is aimed at filling this knowledge gap, by addressing the diagnostics of bearings taken from the service after a long term operation on the traction system of a high speed train. Moreover, in order to test the effectiveness of the diagnostic procedures in the environmental conditions peculiar to the rail application, a specific test-rig has been built, consisting of a complete full-scale train traction system, able to reproduce the effects of wheeltrack interaction and bogie-wheelset dynamics. The results of the experimental campaign show that suitable signal processing techniques are able to diagnose bearing failures even in this harsh and noisy application. Moreover, the most suitable location of the sensors on the traction system is proposed, in order to limit their number.

Nanomorphology influence on the light conversion mechanisms in highly efficient diketopyrrolopyrrole based organic solar cells

In this work, diketopyrrolopyrrole-based polymer bulk heterojunction solar cells with inverted and regular architecture have been investigated. The influence of the polymer:fullerene ratio on the photoactive film nanomorphology has been studied in detail. Transmission Electron Microscopy and Atomic Force Microscopy reveal that the resulting film morphology strongly depends on the fullerene ratio. This fact determines the photocurrent generation and governs the transport of free charge carriers. Slight variations on the PCBM ratio respect to the polymer show great differences on the electrical behavior of the solar cell. Once the polymer:fullerene ratio is accurately adjusted, power conversion efficiencies of 4.7% and 4.9% are obtained for inverted and regular architectures respectively. Furthermore, by correlating the optical and morphological characterization of the polymer:fullerene films and the electrical behavior of solar cells, an ad hoc interpretation is proposed to explain the photovoltaic performance as a function of this polymer:blend composition.

Supramolecular organization in fluorene/indenofluorene-oligothiophene alternating conjugated copolymers

A series of conjugated copolymers containing fluorene or indenofluorene units alternating with oligothiophene segments, with potential interest for use as the active layer in field-effect transistors, is investigated. Atomic force microscopy analysis of the morphology of thin deposits shows either the formation of fibrillar structures, which are the signature of long-range π stacking, or the presence of untextured aggregates, resulting from disordered assembly. These morphologies are interpreted in terms of the supramolecular organization of the conjugated chains. Molecular modeling simulations indicate that the commensurability between the lengths of the monomer units and the presence of alkyl side groups are the two key structural factors governing the chain organization into highly ordered assemblies. The most favorable structures are those combining fluorene (indenofluorene) units with unsubstituted bithiophene (terthiophene) segments.

Working notes for TopSig at ShARe/CLEF 2013

We used our TopSig open-source indexing and retrieval tool to produce runs for the ShARe/CLEF eHealth 2013 track. TopSig was used to produce runs using the query fields and provided discharge summaries, where appropriate. Although the improvement was not great TopSig was able to gain some benefit from utilising the discharge summaries, although the software needed to be modified to support this. This was part of a larger experiment involving determining the applicability and limits to signature-based approaches.

The Corporate Governance Effects of Audit Committee

This chapter provides a synthesis and evaluation of empirical research on the governance effects associated with audit committees. Given recent policy recommendations in several countries aimed at strengthening these committees, it is important to establish what research evidence demonstrates about their existing governance contribution. A framework for analyzing the impact of audit committees is described, identifying potential perceived effects which may have led to their adoption and documented effects on aspects of the audit function, on financial reporting quality and on corporate performance. It is also shown that most of the existing research has focused on factors associated with audit committee existence, characteristics, and measures of activity and there is very little evidence on the processes associated with the operation of audit committees and the manner in which they influence organizational behavior. It is clear that there is no automatic relationship between the adoption of audit committee structures or characteristics and the achievement of particular governance effects, and caution may be needed over expectations that greater codification around factors such as audit committee members’ independence and expertise as the means of ‘‘correcting’’ past weaknesses in the arrangements for audit committees. The most fundamental question concerning what difference audit committees make in practice continues to be an important area for research development. For future research we suggest: (1) greater consideration of the organizational and institutional contexts in which audit committees operate; (2) explicit theorization of the processes associated with audit committee operation; (3) complementing extant research methods with field studies; and (4) investigation of unintended as well as expected consequences of audit committees.

Intensity and seasonality of physical activity of children during school recess

This study aimed to quantify the intensity of physical activity (PA) of children during school recess (RE), compare the AF gender and seasonal influences. The sample consisted of 30 girls (11.2 ± 1.3 years) and 20 boys (11.3 ± 0.8 years). Heart rate was monitored for three consecutive REs in winter (INV) and spring (PRI) with intensity of the activity being classified as low, moderate and vigorous. Descriptive statistics were used for general data, t test for independent samples for differences between the sexes, paired t test for seasonality. Differences were found between INV and PRI temperatures. Girls had a significant reduction in the AF INV to PRI, which was not observed among boys. The RE represented a small contribution to daily recommendations of AF.

Applying digital product memories in industrial production

Industrial production and supply chains face increased demands for mass customization and tightening regulations on the traceability of goods, leading to higher requirements concerning flexibility, adaptability, and transparency of processes. Technologies for the ’Internet of Things' such as smart products and semantic representations pave the way for future factories and supply chains to fulfill these challenging market demands. In this chapter a backend-independent approach for information exchange in open-loop production processes based on Digital Product Memories DPMs is presented. By storing order-related data directly on the item, relevant lifecycle information is attached to the product itself. In this way, information handover between several stages of the value chain with focus on the manufacturing phase of a product has been realized. In order to report best practices regarding the application of DPM in the domain of industrial production, system prototype implementations focusing on the use case of producing and handling a smart drug case are illustrated.