The effectiveness of dietary counselling versus oral nutrition supplements in improving nutritional intake in malnourished patients with Chronic Obstructive Pulmonary Disease (COPD)

The evidence for nutritional support in COPD is almost entirely based on oral nutritional supplements (ONS) yet despite this dietary counseling and food fortification (DA) are often used as the first line treatment for malnutrition. This study aimed to investigate the effectiveness of ONS vs. DA in improving nutritional intake in malnourished outpatients with COPD. 70 outpatients (BMI 18.4 SD 1.6 kg/m2, age 73 SD 9 years, severe COPD) were randomised to receive a 12-week intervention of either ONS or DA (n 33 ONS vs. n 37 DA). Paired t-test analysis revealed total energy intakes significantly increased with ONS at week 6 (+302 SD 537 kcal/d; p = 0.002), with a slight reduction at week 12 (+243 SD 718 kcal/d; p = 0.061) returning to baseline levels on stopping supplementation. DA resulted in small increases in energy that only reached significance 3 months post-intervention (week 6: +48 SD 623 kcal/d, p = 0.640; week 12: +157 SD 637 kcal/d, p = 0.139; week 26: +247 SD 592 kcal/d, p = 0.032). Protein intake was significantly higher in the ONS group at both week 6 and 12 (ONS: +19.0 SD 25.0 g/d vs. DA: +1.0 SD 13.0 g/d; p = 0.033 ANOVA) but no differences were found at week 26. Vitamin C, Iron and Zinc intakes significantly increased only in the ONS group. ONS significantly increased energy, protein and several micronutrient intakes in malnourished COPD patients but only during the period of supplementation. Trials investigating the effects of combined nutritional interventions are required.

Investigation of RuO2/Ta2O5 thin film evolution by thermogravimetry combined with mass spectrometry

The thermal evolution process of RuO2–Ta2O5/Ti coatings with varying noble metal content has been investigated under in situ conditions by thermogravimetry combined with mass spectrometry. The gel-like films prepared from alcoholic solutions of the precursor salts (RuCl3·3H2O, TaCl5) onto titanium metal support were heated in an atmosphere containing 20% O2 and 80% Ar up to 600 °C. The evolution of the mixed oxide coatings was followed by the mass spectrometric ion intensity curves. The cracking of retained solvent and the combustion of organic surface species formed were also followed by the mass spectrometric curves. The formation of carbonyl- and carboxylate-type surface species connected to the noble metal was identified by Fourier transform infrared emission spectroscopy. These secondary processes–catalyzed by the noble metal–may play an important role in the development of surface morphology and electrochemical properties. The evolution of the two oxide phases does not take place independently, and the effect of the noble metal as a combustion catalyst was proved.

Orals ain't orals : how instruction and assessment practices affect delivery choices with prepared student oral presentations.

Despite an ostensibly technology-driven society, the ability to communicate orally is still seen as an essential ability for students at school and university, as it is for graduates in the workplace. The need to develop effective oral communication skills is often tied to future work-related tasks. One tangible way that educators have assessed proficiency in this area is through prepared oral presentations. While some use the terms oral communication and oral presentation interchangeably, other writers question the role more formal presentations play in the overall development of oral communication skills. Adding to the discussion, this paper is part of a larger study examining the knowledge and skills students bring into the academy from previous educational experiences. The study examines some of the teaching and assessment methods used in secondary schools to develop oral communication skills through the use of formal oral presentations. Specifically, it will look at assessment models and how these are used as a form of instruction as well as how they contribute to an accurate evaluation of student abilities. The purpose of this paper is to explore key terms and identify tensions between expectations and practice. Placing the emphasis on the ‘oral’ aspect of this form of communication this paper will particularly look at the ‘delivery’ element of the process.

Polyurethane (PU) scaffolds prepared by solvent casting/particulate leaching (SCPL) combined with centrifugation

This article reports an enhanced solvent casting/particulate (salt) leaching (SCPL) method developed for preparing three-dimensional porous polyurethane (PU) scaffolds for cardiac tissue engineering. The solvent for the preparation of the PU scaffolds was a mixture of dimethylformamide (DFM) and tetrahydrofuran (THF). The enhanced method involved the combination of a conventional SCPL method and a step of centrifugation, with the centrifugation being employed to improve the pore uniformity and the pore interconnectivity of scaffolds. Highly porous three-dimensional scaffolds with a well interconnected porous structure could be achieved at the polymer solution concentration of up to 20% by air or vacuum drying to remove the solvent. When the salt particle sizes of 212-295, 295-425, or 425-531 µm and a 15% w/v polymer solution concentration were used, the porosity of the scaffolds was between 83-92% and the compression moduli of the scaffolds were between 13 kPa and 28 kPa. Type I collagen acidic solution was introduced into the pores of a PU scaffold to coat the collagen onto the pore walls throughout the whole PU scaffold. The human aortic endothelial cells (HAECs) cultured in the collagen-coated PU scaffold for 2 weeks were observed by scanning electron microscopy (SEM). It was shown that the enhanced SCPL method and the collagen coating resulted in a spatially uniform distribution of cells throughout the collagen-coated PU scaffold.

A qualitative study of the experience of oral cancer among Taiwanese men

The incidence and mortality of oral cancer in Taiwanese men have increased over the past decade, primarily associated with a surge in the popularity of betel quid chewing. The aim of this study was to examine the experience of six Taiwanese men with oral cancer, who were aged between 40 and 60 years, using a qualitative approach. The three major themes emerging from the data include: (i) understanding the cancer diagnosis; (ii) the challenges of cancer treatment; and (iii) adapting to difference. Increasing nurses' understanding of the experiential aspects of oral cancer in this population is required if nurses are to develop successful health promotion programmes and nursing interventions to meet these patients' needs.

Telcagepant is a new oral treatment for migraine

Background : Migraine is a common cause of disability. Many subjects (30 – 40%) do not respond to the 5-HT 1B/1D agonists (the triptans) commonly used in the treatment of migraine attacks. Calcitonin gene-related protein (CGRP) receptor antagonism is a new approach to the treatment of migraine attacks. Objectives/methods : This evaluation is of a Phase III clinical trial comparing telcagepant, an orally active CGRP receptor antagonist, with zolmitriptan in subjects during an attack of migraine. Results : Telcagepant 300 mg has a similar efficacy to zolmitriptan in relieving pain, phonophobia, photophobia, and nausea. Telcagepant was better tolerated than zolmitriptan. Conclusions : The initial Phase III clinical trial results with telcagepant are promising but several further clinical trials are needed to determine the place of telcagepant in the treatment of migraine attacks

The oral health of critically ill children

Introduction. In adults, oral health has been shown to worsen during critical illness as well as influence systemic health. There is a paucity of paediatric critical care research in the area of oral health; hence the purpose of the Critically ill Children’s Oral Health (CCOH) study is to describe the status of oral health of critically ill children over time spent in the paediatric intensive care unit (PICU). The study will also examine the relationship between poor oral health and a variety of patient characteristics and PICU therapies and explore the relationship between dysfunctional oral health and PICU related Healthcare-Associated Infections (HAI). Method. An observational study was undertaken at a single tertiary-referral PICU. Oral health was measured using the Oral Assessment Scale (OAS) and culturing oropharyngeal flora. Information was also collected surrounding the use of supportive therapies, clinical characteristics of the children and the occurrence of PICU related HAI. Results. Forty-six participants were consecutively recruited to the CCOH study. Of the participants 63% (n=32) had oral dysfunction while 41% (n=19) demonstrated pathogenic oropharyngeal colonisation during their critical illness. The potential systemic pathogens isolated from the oropharynx and included Candida sp., Staphylococcus aureus, Haemophilus influenzae, Enterococcus sp. and Pseudomonas aeruginosa. The severity of critical illness had a significant positive relationship (p=0.046) with pathogenic and absent colonisation of the oropharynx. Sixty-three percent of PICU-related HAI involved the preceding or simultaneous colonisation of the oropharynx by the causative pathogen. Conclusion. Given the prevalence of poor oral health during childhood critical illness and the subsequent potential systemic consequences, evidence based oral hygiene practices should be developed and validated to guide clinicians when nursing critically ill children.

Porous PLGA microspheres effectively loaded with BSA protein by electrospraying combined with phase separation in liquid nitrogen

Polymer microspheres loaded with bioactive particles, biomolecules, proteins, and/or growth factors play important roles in tissue engineering, drug delivery, and cell therapy. The conventional double emulsion method and a new method of electrospraying into liquid nitrogen were used to prepare bovine serum albumin (BAS)-loaded poly(lactic-co-glycolic acid) (PLGA) porous microspheres. The particle size, the surface morphology and the internal porous structure of the microspheres were observed using scanning electron microscopy (SEM). The loading efficiency, the encapsulation efficiency, and the release profile of the BSA-loaded PLGA microspheres were measured and studied. It was shown that the microspheres from double emulsion had smaller particle sizes (3-50 m), a less porous structure, a poor loading efficiency (5.2 %), and a poor encapsulation efficiency (43.5%). However, the microspheres from the electrospraying into liquid nitrogen had larger particle sizes (400-600 m), a highly porous structure, a high loading efficiency (12.2%), and a high encapsulation efficiency (93.8%). Thus the combination of electrospraying with freezing in liquid nitrogen and subsequent freeze drying represented a suitable way to produce polymer microspheres for effective loading and sustained release of proteins.

Combined marrow stromal cell-sheet techniques and high-strength biodegradable composite scaffolds for engineered functional bone grafts

In this study, cell sheets comprising multilayered porcine bone marrow stromal cells (BMSC) were assembled with fully interconnected scaffolds made from medical-grade polycaprolactone–calcium phosphate (mPCL–CaP), for the engineering of structural and functional bone grafts. The BMSC sheets were harvested from culture flasks and wrapped around pre-seeded composite scaffolds. The layered cell sheets integrated well with the scaffold/cell construct and remained viable, with mineralized nodules visible both inside and outside the scaffold for up to 8 weeks culture. Cells within the constructs underwent classical in vitro osteogenic differentiation with the associated elevation of alkaline phosphatase activity and bone-related protein expression. In vivo, two sets of cell-sheet-scaffold/cell constructs were transplanted under the skin of nude rats. The first set of constructs (554mm3) were assembled with BMSC sheets and cultured for 8 weeks before implantation. The second set of constructs (10104mm3) was implanted immediately after assembly with BMSC sheets, with no further in vitro culture. For both groups, neo cortical and well-vascularised cancellous bone were formed within the constructs with up to 40% bone volume. Histological and immunohistochemical examination revealed that neo bone tissue formed from the pool of seeded BMSC and the bone formation followed predominantly an endochondral pathway, with woven bone matrix subsequently maturing into fully mineralized compact bone; exhibiting the histological markers of native bone. These findings demonstrate that large bone tissues similar to native bone can be regenerated utilizing BMSC sheet techniques in conjunction with composite scaffolds whose structures are optimized from a mechanical, nutrient transport and vascularization perspective.