Designing atmospheric-pressure plasma sources for surface engineering of nanomaterials

Atmospheric-pressure plasma processing techniques emerge as efficient and convenient tools to engineer a variety of nanomaterials for advanced applications in nanoscience and nanotechnology. This work presents different methods, including using a quasi-sinusoidal high-voltage generator, a radio-frequency power supply, and a uni-polar pulse generator, to generate atmospheric-pressure plasmas in the jet or dielectric barrier discharge configurations. The applicability of the atmospheric-pressure plasma is exemplified by the surface modification of nanoparticles for polymeric nanocomposites. Dielectric measurements reveal that representative nanocomposites with plasma modified nanoparticles exhibit notably higher dielectric breakdown strength and a significantly extended lifetime.

Relating urban airborne particle concentrations to shipping using carbon based elemental emission ratios

This study demonstrates a novel method for testing the hypothesis that variations in primary and secondary particle number concentration (PNC) in urban air are related to residual fuel oil combustion at a coastal port lying 30 km upwind, by examining the correlation between PNC and airborne particle composition signatures chosen for their sensitivity to the elemental contaminants present in residual fuel oil. Residual fuel oil combustion indicators were chosen by comparing the sensitivity of a range of concentration ratios to airborne emissions originating from the port. The most responsive were combinations of vanadium and sulfur concentration ([S], [V]) expressed as ratios with respect to black carbon concentration ([BC]). These correlated significantly with ship activity at the port and with the fraction of time during which the wind blew from the port. The average [V] when the wind was predominantly from the port was 0.52 ng.m-3 (87%) higher than the average for all wind directions and 0.83 ng.m-3 (280%) higher than that for the lowest vanadium yielding wind direction considered to approximate the natural background. Shipping was found to be the main source of V impacting urban air quality in Brisbane. However, contrary to the stated hypothesis, increases in PNC related measures did not correlate with ship emission indicators or ship traffic. Hence at this site ship emissions were not found to be a major contributor to PNC compared to other fossil fuel combustion sources such as road traffic, airport and refinery emissions.

Chemical and bioanalytical assessment of coal seam gas associated water

A comprehensive study was undertaken involving chemical (inorganic and organic) and bioanalytical (a suite of 14 in vitro bioassays) assessments of coal seam gas (coal bed methane) associated water (CSGW) in Queensland, Australia. CSGW is a by-product of the gas extraction process and is generally considered as water of poor quality. This was done to better understand what is known about the potential biological and environmental effects associated with the organic constituents of CSGW in Australia. In Queensland, large amounts of associated water must be withdrawn from coal seams to allow extraction of the gas. CSGW is disposed of via release to surface water, reinjected to groundwater or reused for irrigation of crops or pasture, supplied for power station cooling and or reinjected specifically to augment drinking water aquifers. Groundwater samples were collected from private wells tapping into the Walloon Coal Measures, the same coal aquifer exploited for coal seam gas production in the Surat Basin, Australia. The inorganic characteristics of these water samples were almost identical to the CSGW entering the nearby gas company operated Talinga-Condabri Water Treatment Facility. The water is brackish with a pH of 8 to 9, high sodium, bicarbonate and chloride concentrations but low calcium, magnesium and negligible sulphate concentrations. Only low levels of polyaromatic hydrocarbons (PAHs) were detected in the water samples, and neither phenols nor volatile organic compounds were found. Results from the bioassays showed no genotoxicity, protein damage, or activation of hormone receptors (with the exception of the estrogen receptor). However, five of the 14 bioassays gave positive responses: an arylhydrocarbon-receptor gene activation assay (AhR-CAFLUX), estrogenic endocrine activity (ERα-CALUX), oxidative stress response (AREc32), interference with cytokine production (THP1-CPA) and non-specific toxicity (Microtox). The observed effects were benchmarked against known water sources and were similar to secondary treated wastewater effluent, stormwater and surface water. As mixture toxicity modelling demonstrated, the detected PAHs explained less than 5% of the observed biological effects.

Emotional climate and high quality learning experiences in science teacher education

The role of emotion during learning encounters in science teacher education is under-researched and under-theorized. In this case study we explore the emotional climates, that is, the collective states of emotional arousal, of a preservice secondary science education class to illuminate practice for producing and reproducing high quality learning experiences for preservice science teachers. Theories related to the sociology of emotions informed our analyses from data sources such as preservice teachers’ perceptions of the emotional climate of their class, emotional facial expressions, classroom conversations, and cogenerative dialogue. The major outcome from our analyses was that even though preservice teachers reported high positive emotional climate during the professor’s science demonstrations, they also valued the professor’s in the moment reflections on her teaching that were associated with low emotional climate ratings. We co-relate emotional climate data and preservice teachers’ comments during cogenerative dialogue to expand our understanding of high quality experiences and emotional climate in science teacher education. Our study also contributes refinements to research perspectives on emotional climate.

Plasma-Aided Nanofabrication : From Plasma Sources to Nanoassembly

In this single work to cover the use of plasma as nanofabrication tool in sufficient depth internationally renowned authors with much experience in this important method of nanofabrication look at reactive plasma as a nanofabrication tool, plasma production and development of plasma sources, as well as such applications as carbon-based nanostructures, low-dimensional quantum confinement structures and hydroxyapatite bioceramics. Written principally for solid state physicists and chemists, materials scientists, and plasma physicists, the book concludes with the outlook for such applications. © 2007 Wiley-VCH Verlag GmbH & Co. KGaA.

Low-frequency, high-density, inductively coupled plasma sources : operation and applications

Operation regimes, plasma parameters, and applications of the low-frequency (∼500 kHz) inductively coupled plasma (ICP) sources with a planar external coil are investigated. It is shown that highly uniform, high-density (ne∼9×1012 cm-3) plasmas can be produced in low-pressure argon discharges with moderate rf powers. The low-frequency ICP sources operate in either electrostatic (E) or electromagnetic (H) regimes in a wide pressure range without any Faraday shield or an external multipolar magnetic confinement, and exhibit high power transfer efficiency, and low circuit loss. In the H mode, the ICP features high level of uniformity over large processing areas and volumes, low electron temperatures, and plasma potentials. The low-density, highly uniform over the cross-section, plasmas with high electron temperatures and plasma and sheath potentials are characteristic to the electrostatic regime. Both operation regimes offer great potential for various plasma processing applications. As examples, the efficiency of the low-frequency ICP for steel nitriding and plasma-enhanced chemical vapor deposition of hydrogenated diamond-like carbon (DLC) films, is demonstrated. It appears possible to achieve very high nitriding rates and dramatically increase micro-hardness and wear resistance of the AISI 304 stainless steel. It is also shown that the deposition rates and mechanical properties of the DLC films can be efficiently controlled by selecting the discharge operating regime.

Changes in teachers’ behaviour in secondary science education : implementing a standards-referenced national curriculum

There is substantial attention worldwide to the quality of secondary school teaching in STEM in Education. This paper reports on the use of Outcome Mapping (OM) as an approach to guide and monitor change in teacher practice and a visual tool, shaped as a Star, to benchmark and monitor this behaviour. OM and the visual tool were employed to guide and document three secondary teachers’ behaviour as they planned, implemented and assessed a science unit in the new Australian standards-referenced curriculum. Five key outcome markers in the teachers’ behaviour were identified together with progress markers — cumulative qualitative indicators — leading to these outcomes. The use of a Star to benchmark and track teachers’ behaviours was particularly useful because it showed teacher behaviour on multiple dimensions simultaneously at various points in time. It also highlighted priorities in need of further attention and provided a pathway to achievement. Hence, OM and the Star representation provide both theoretical and pragmatic approaches to enhancing quality in STEM teaching.

Spectroscopic vibrations of austinite (CaZnAsO4⋅OH) and its mineral structure : Implications for identification of secondary arsenic-containing mineral

Austinite (CaZnAsO4⋅OH) is a unique secondary mineral in arsenic-contaminated mine wastes. The infrared and Raman spectroscopies were used to characterize the austenite vibrations. The IR bands at 369, 790 and 416 cm−1 are assigned to the ν2, ν3 and ν4 vibrations of AsO43− unit, respectively. The Raman bands at 814, 779 and 403 cm−1 correspond to the ν1, ν3 and ν4 vibrations of AsO43− unit respectively. The sharp bands at 3265 cm−1 for IR and 3270 cm−1 both reveals that the structural hydroxyl units exist in the austenite structure. The IR and Raman spectra both show that some SO4 units isomorphically replace AsO4 in austinite. X-ray single crystal diffraction provides the arrangement of each atom in the mineral structure, and also confirms that the conclusions made from the vibrational spectra. Micro-powder diffraction was used to confirm our mineral identification due to the small quantity of the austenite crystals.

Health law : scope, sources and forces

• For the purposes of this chapter, “health law” encapsulates regulation of the medical and health professions, the administration of health services and the maintenance of public health to the extent that it is connected to the provision of health services. • There are diverging views as to whether health law can be regarded as a discrete “area of law”. • Health law draws on other areas of law such as tort law, criminal law and family law. It also draws upon other disciplines, most notably medical and health ethics. • Social and economic forces have influenced the development and direction of health law, and these forces may become even more influential in the future. • The increasingly globalised world has implications for Australia's health systems and raises questions and creates commitments in respect of the international community. • Technological developments, including in respect of treatment, diagnosis and information management, create ongoing challenges for health law. • Patient rights, human rights and consumerism are increasingly key drivers in the development of health law. • Health law is significant to contemporary Australian society because of the gravity of the topics that fall within its ambit, its social relevance to so many aspects of human existence and endeavour, the important role it plays in protecting the vulnerable, and the extent to which it engages with fundamental principles of justice.

Investigation of corona sources in high voltage power lines

This paper describes the results of experiments made in the vicinity of EHV overhead lines to investigate sources of clouds of charged particles using simultaneously-recording arrays of electric field meters to measure direct electric fields produced under ion clouds. E-field measurements, made at one metre above ground level, are correlated with wind speed and direction, and with measurements from ionisation counters and audible corona effects to identify possible positions of sources of corona on adjacent power lines. Measurements made in dry conditions on EHV lines in flat remote locations with no adjacent buildings or large vegetation indicate the presence of discrete ion sources associated with high stress points on some types of line hardware such as connectors and conductor spacers. Faulty line components such as insulators and line fittings are also found to be a possible source of ion clouds.

A new method of interfacing battery/supercapacitor energy storage systems for distributed energy sources

Battery-supercapacitor hybrid energy storage systems can achieve better power and energy performances compared to their individual use. These hybrid systems require separate dc-dc converters, or at least one dc-dc converter for the supercapacitor bank, to connect them to the dc-link of the grid connecting inverter. However, the use of such dc-dc converters introduces additional cost and power losses. Therefore, the possibility of direct connection of energy storage systems, to the dc-link of a diode clamped 3-level inverter is investigated in this paper. Even though the proposed topology does not use dc-dc converters, a vector selection method is proposed to produce a similar control flexibility that is found in the separate dc-dc converter topology. The major issue with the proposed system is the imminent imbalance of the neutral point potential. A PWM technique with modified carriers is used to solve this problem. Simulations are carried out using MATLAB/SIMULINK to verify the efficacy of the proposed system.

Secondary user relations in emerging mobile computing environments

Mobile technologies are enabling access to information in diverse environ.ments, and are exposing a wider group of individuals to said technology. Therefore, this paper proposes that a wider view of user relations than is usually considered in information systems research is required. Specifically, we examine the potential effects of emerging mobile technologies on end-­‐user relations with a focus on the ‘secondary user’, those who are not intended to interact directly with the technology but are intended consumers of the technology’s output. For illustration, we draw on a study of a U.K. regional Fire and Rescue Service and deconstruct mobile technology use at Fire Service incidents. Our findings provide insights, which suggest that, because of the nature of mobile technologies and their context of use, secondary user relations in such emerging mobile environments are important and need further exploration.

Integrated chronic disease management in primary-secondary care : a systematic literature review of the evidence

Introduction: Diabetes has traditionally been managed as a single chronic disease state, but it exists with co-morbidities such as depression and metabolic syndrome. Treatment is multifaceted, requiring both primary and secondary care, however, the delivery of diabetes care is often fragmented. Integrated chronic disease management is a growing model of interest, and is underpinned by the chronic care model (CCM), devised as a guide for primary care management of patients with chronic conditions. The model identifies six key elements for effective care, and has shown promise in improving the management of diabetes. Aim: To find empirical evidence of integrated care interventions targeted at co-morbidities including diabetes, across primary/secondary care. Method: A systematic review of peer reviewed literature from PubMed, CINAHL, Embase, Cochrane Library and Joanna Briggs was performed. Studies were reviewed according to inclusion criteria- studies published in English, between 2004-2014, empirical studies, studies with evidence of primary/secondary implementation, and those dealing with chronic co-morbid disease states. Results: 51 studies met the inclusion criteria. Included studies were mostly from the US (38), with five from Australia, UK (2), Canada (2), Netherlands (1), Norway (1), Ireland (1), and one multi-country study. It was found that all interventions adopted at least one (average 3-4) of the chronic care model, with the majority implementing delivery system redesign activities within the primary care practice/s. We found evidence of interventions which significantly reduced emergency department and hospital admissions, improved processes of care, patient health outcomes such as HbA1c, improved patient satisfaction, and reduced costs. Conclusion/Implications for practice: Diabetes exists as a co-morbid disease, requiring both primary and secondary care. We found that integrated care interventions adopting elements of the chronic care model positively impacted on patient outcomes, service utilisation, as well as costs. This review has highlighted that it may not be necessary to adopt all CCM elements to improve clinical outcomes, patient satisfaction and costs.

An observational analysis of the impact of board dynamics and directors’ participation on perceived board effectiveness

This study addresses calls for closer examination of board dynamics by offering an inside view of director interactions. Video-observations of three board meetings at each of two Australian corporations matched with director interviews and secondary data reveal distinct patterns of director interactions, their sources of variation and impact on perceived board effectiveness. Our data reveal that director interactions are multi-dimensional and dynamic: while group interactions across agenda items are similar, with a few directors leading the discussion, the contributing directors change across items. Moreover, directors’ inclusiveness and evenness of participation are associated with higher perceptions of board effectiveness. Last, we find that director interactions change with the nature of the items, board climate and board meeting arrangements. The study contributes to the literature by moving beyond the individual-level analysis of directors’ skills or independence, and offering a detailed view of how the joint group and individual dimensions of board dynamics affect board functioning.

A contextual analysis of secondary home economic teachers' agency in a time of mandatory curriculum change

This qualitative research explored secondary Home Economics teachers' perceptions of their teacher agency to influence classroom, department and school level curriculum decision making. Teachers responded to curriculum change with proactive, reactive and/or passive agency. Findings indicated that teachers' perceptions of their classroom agency remained high. However, agency decreased at department and school levels. Recent changes in schools as a result of the Australian Curriculum; NAPLAN and Queensland Studies Authority have resulted in changes that have been detrimental to teacher agency. Agency was enacted differently depending on whether change was teacher initiated or mandated by authority.