Influence of Rainfall and Catchment Characteristics on Urban Stormwater Quality

The accuracy and reliability of urban stormwater quality modelling outcomes are important for stormwater management decision making. The commonly adopted approach where only a limited number of factors are used to predict urban stormwater quality may not adequately represent the complexity of the quality response to a rainfall event or site-to-site differences to support efficient treatment design. This paper discusses an investigation into the influence of rainfall and catchment characteristics on urban stormwater quality in order to investigate the potential areas for errors in current stormwater quality modelling practices. It was found that the influence of rainfall characteristics on pollutant wash-off is step-wise based on specific thresholds. This means that a modelling approach where the wash-off process is predicted as a continuous function of rainfall intensity and duration is not appropriate. Additionally, other than conventional catchment characteristics, namely, land use and impervious surface fraction, other catchment characteristics such as impervious area layout, urban form and site specific characteristics have an important influence on both, pollutant build-up and wash-off processes. Finally, the use of solids as a surrogate to estimate other pollutant species was found to be inappropriate. Individually considering build-up and wash-off processes for each pollutant species should be the preferred option.

Planning for the impact of distributed solar energy on the grid

The behaviour of single installations of solar energy systems is well understood; however, what happens at an aggregated location, such as a distribution substation, when output of groups of installations cumulate is not so well understood. This paper considers groups of installations attached to distributions substations on which the load is primarily commercial and industrial. Agent-based modelling has been used to model the physical electrical distribution system and the behaviour of equipment outputs towards the consumer end of the network. The paper reports the approach used to simulate both the electricity consumption of groups of consumers and the output of solar systems subject to weather variability with the inclusion of cloud data from the Bureau of Meteorology (BOM). The data sets currently used are for Townsville, North Queensland. The initial characteristics that indicate whether solar installations are cost effective from an electricity distribution perspective are discussed.

Lynch syndrome-associated breast cancers: clinicopathologic characteristics of a case series from the colon cancer family registry

Purpose: The recognition of breast cancer as a spectrum tumor in Lynch syndrome remains controversial. The aim of this study was to explore features of breast cancers arising in Lynch syndrome families. Experimental Design: This observational study involved 107 cases of breast cancer identified from the Colorectal Cancer Family Registry (Colon CFR) from 90 families in which (a) both breast and colon cancer co-occurred, (b) families met either modified Amsterdam criteria, or had at least one early-onset (<50 years) colorectal cancer, and (c) breast tissue was available within the biospecimen repository for mismatch repair (MMR) testing. Eligibility criteria for enrollment in the Colon CFR are available online. Breast cancers were reviewed by one pathologist. Tumor sections were stained for MLH1, PMS2, MSH2, and MSH6, and underwent microsatellite instability testing. Results: Breast cancer arose in 35 mutation carriers, and of these, 18 (51%) showed immunohistochemical absence of MMR protein corresponding to the MMR gene mutation segregating the family. MMR-deficient breast cancers were more likely to be poorly differentiated (P = 0.005) with a high mitotic index (P = 0.002), steroid hormone receptor–negative (estrogen receptor, P = 0.031; progesterone receptor, P = 0.022), and to have peritumoral lymphocytes (P = 0.015), confluent necrosis (P = 0.002), and growth in solid sheets (P < 0.001) similar to their colorectal counterparts. No difference in age of onset was noted between the MMR-deficient and MMR-intact groups. Conclusions: MMR deficiency was identified in 51% of breast cancers arising in known mutation carriers. Breast cancer therefore may represent a valid tissue option for the detection of MMR deficiency in which spectrum tumors are lacking

An assessment for cost effective maintenance and operation of the Callide Power Station electrical system, using reliability evaluation

The reliable operation of the electrical system at Callide Power Station is of extreme importance to the normal everyday running of the Station. This study applied the principles of reliability to do an analysis on the electrical system at Callide Power Station. It was found that the level of expected outage cost increased exponentially with a declining level of maintenance. Concluding that even in a harsh economic electricity market where CS Energy tries and push their plants to the limit, maintenance must not be neglected. A number of system configurations were found to increase the reliability of the system and reduce the expected outage costs. A number of other advantages were identified as a result of using reliability principles to do this study on the Callide electrical system configuration.

Development of a survey instrument to measure TEFL academics' perceptions about, individual and workplace characteristics for conducting research

The Chinese Ministry of Education (MOE) initiatives to improve the English competence of college students, as well as increased proficiency level of entering college students (Cheng, 2002) have contributed to greater demands on Teaching English as a Foreign Language (TEFL) academics (MOE, 2004), as “the upgrading of national English proficiency, then, is predicated largely on the professional competence of the teaching force” (Hu, 2005, p. 655). For TEFL academics, one component of this competence is the capacity to conduct research (Shu, 2002), which also reflects other changes in Chinese higher education. The aspirations of higher education institutions at all levels have led to more rigorous recruitment policies and promotion requirements (Che, 2004; Wang, 2007), stressing research as an important indicator of academics’ performance (Shi, 2002; Pan, 2006). These changes highlight the role of research in higher education institutions’ efforts to raise their national status and world ranking (Zhang, Wang, & He, 2006), and have exerted influences on faculty’s academic role. Academics are obliged to engage in research activities, and this has posed challenges to teaching-oriented institutions and disciplines.

Cultural diplomacy with Chinese characteristics : the case of Confucius Institutes in Australia

Since 2004,China has set up more than 400 Confucius Institutes and 500 Confucius Classrooms in 108 countries to promote Chinese language and culture. Despite these impressive numbers, these institutions are still surprisingly under-studied. This article uses Confucius Institutes in Australia as a case study to deepen the understanding of China’s new cultural diplomacy tool. The article describes Confucius Institutes as a form of strategic stakeholder engagement and argues that this collaborative tool of cultural diplomacy depends heavily on the commitment of its local stakeholders.

Partial melt processing and electrical properties of Bi-Sr-Ca-Cu-o superconducting thick films on (100) MgO substrates

Superconducting thick films of Bi2Sr2CaCu2Oy (Bi-2212) on single-crystalline (100) MgO substrates have been prepared using a doctor-blade technique and a partial-melt process. It is found that the phase composition and the amount of Ag addition to the paste affect the structure and superconducting properties of the partially melted thick films. The optimum heat treatment schedule for obtaining high Jc has been determined for each paste. The heat treatment ensures attainment of high purity for the crystalline Bi-2212 phase and high orientation of Bi-2212 crystals, in which the c-axis is perpendicular to the substrate. The highest Tc, obtained by resistivity measurement, is 92.2 K. The best value for Jct (transport) of these thick films, measured at 77 K in self-field, is 8 × 10 3 Acm -2.

Advanced battery storage control for an autonomous microgrid

A new control method for battery storage to maintain acceptable voltage profile in autonomous microgrids is proposed in this article. The proposed battery control ensures that the bus voltages in the microgrid are maintained during disturbances such as load change, loss of micro-sources, or distributed generations hitting power limit. Unlike the conventional storage control based on local measurements, the proposed method is based on an advanced control technique, where the reference power is determined based on the voltage drop profile at the battery bus. An artificial neural network based controller is used to determine the reference power needed for the battery to hold the microgrid voltage within regulation limits. The pattern of drop in the local bus voltage during power imbalance is used to train the controller off-line. During normal operation, the battery floats with the local bus voltage without any power injection. The battery is charged or discharged during the transients with a high gain feedback loop. Depending on the rate of voltage fall, it is switched to power control mode to inject the reference power determined by the proposed controller. After a defined time period, the battery power injection is reduced to zero using slow reverse-droop characteristics, ensuring a slow rate of increase in power demand from the other distributed generations. The proposed control method is simulated for various operating conditions in a microgrid with both inertial and converter interfaced sources. The proposed battery control provides a quick load pick up and smooth load sharing with the other micro-sources in a disturbance. With various disturbances, maximum voltage drop over 8% with conventional energy storage is reduced within 2.5% with the proposed control method.

Power system sensitivity analysis considering induction motor loads

Power system operation and planning are facing increasing uncertainties especially with the deregulation process and increasing demand for power. Probabilistic power system stability assessment and probabilistic power system planning have been identified by EPRI as one of the important trends in power system operations and planning. Probabilistic small signal stability assessment studies the impact of system parameter uncertainties on system small disturbance stability characteristics. Researches in this area have covered many uncertainties factors such as controller parameter uncertainties and generation uncertainties. One of the most important factors in power system stability assessment is load dynamics. In this paper, composite load model is used to consider the uncertainties from load parameter uncertainties impact on system small signal stability characteristics. The results provide useful insight into the significant stability impact brought to the system by load dynamics. They can be used to help system operators in system operation and planning analysis.

Analytical model for fault section estimation and state identification of unobserved protective relays in power systems [电力系统故障诊断与不可观测保护状态识别的解析模型]

In recent years, some models have been proposed for the fault section estimation and state identification of unobserved protective relays (FSE-SIUPR) under the condition of incomplete state information of protective relays. In these models, the temporal alarm information from a faulted power system is not well explored although it is very helpful in compensating the incomplete state information of protective relays, quickly achieving definite fault diagnosis results and evaluating the operating status of protective relays and circuit breakers in complicated fault scenarios. In order to solve this problem, an integrated optimization mathematical model for the FSE-SIUPR, which takes full advantage of the temporal characteristics of alarm messages, is developed in the framework of the well-established temporal constraint network. With this model, the fault evolution procedure can be explained and some states of unobserved protective relays identified. The model is then solved by means of the Tabu search (TS) and finally verified by test results of fault scenarios in a practical power system.

Airborne collision scenario flight tests : impact of angle measurement errors on reactive vision-based avoidance control

The future emergence of many types of airborne vehicles and unpiloted aircraft in the national airspace means collision avoidance is of primary concern in an uncooperative airspace environment. The ability to replicate a pilot’s see and avoid capability using cameras coupled with vision based avoidance control is an important part of an overall collision avoidance strategy. But unfortunately without range collision avoidance has no direct way to guarantee a level of safety. Collision scenario flight tests with two aircraft and a monocular camera threat detection and tracking system were used to study the accuracy of image-derived angle measurements. The effect of image-derived angle errors on reactive vision-based avoidance performance was then studied by simulation. The results show that whilst large angle measurement errors can significantly affect minimum ranging characteristics across a variety of initial conditions and closing speeds, the minimum range is always bounded and a collision never occurs.

Characteristics of culturally and linguistically diverse mental health clients

The present study examined Queensland Transcultural Mental Health Centre (QTMHC) client characteristics in order to provide a better understanding for development of future health service delivery models. Archived data that was collected for 1499 clients over two years period (2007-2009) was analysed using descriptive statistics and Chi squares. The results indicated that clients were referred from a range of sources and were generally adults. There were more women than men, who sought services. At least half of the clients had language barriers and relied on bilingual workers. Most frequently expressed mental health issues were mood disorder symptoms, followed by symptoms of schizophrenia and psychosis and anxiety. Acculturation strains and stressors were described as the most common psychosocial issues. Mental health and psychosocial issues differed for age, gender and world regions from which the CALD clients originated. The findings provided an understanding of clients who seek services at QTMHC. Various ways in which transcultural services and data bases can be further improved are discussed.

A lightweight biometric signature scheme for user authentication over networks

We introduce a lightweight biometric solution for user authentication over networks using online handwritten signatures. The algorithm proposed is based on a modified Hausdorff distance and has favorable characteristics such as low computational cost and minimal training requirements. Furthermore, we investigate an information theoretic model for capacity and performance analysis for biometric authentication which brings additional theoretical insights to the problem. A fully functional proof-of-concept prototype that relies on commonly available off-the-shelf hardware is developed as a client-server system that supports Web services. Initial experimental results show that the algorithm performs well despite its low computational requirements and is resilient against over-the-shoulder attacks.

Effect of family relatedness on characteristics of estimated IBD probabilities in relation to precision of QTL estimates

Background: A random QTL effects model uses a function of probabilities that two alleles in the same or in different animals at a particular genomic position are identical by descent (IBD). Estimates of such IBD probabilities and therefore, modeling and estimating QTL variances, depend on marker polymorphism, strength of linkage and linkage disequilibrium of markers and QTL, and the relatedness of animals in the pedigree. The effect of relatedness of animals in a pedigree on IBD probabilities and their characteristics was examined in a simulation study. Results: The study based on nine multi-generational family structures, similar to a pedigree structure of a real dairy population, distinguished by an increased level of inbreeding from zero to 28 % across the studied population. Highest inbreeding level in the pedigree, connected with highest relatedness, was accompanied by highest IBD probabilities of two alleles at the same locus, and by lower relative variation coefficients. Profiles of correlation coefficients of IBD probabilities along the marked chromosomal segment with those at the true QTL position were steepest when the inbreeding coefficient in the pedigree was highest. Precision of estimated QTL location increased with increasing inbreeding and pedigree relatedness. A method to assess the optimum level of inbreeding for QTL detection is proposed, depending on population parameters. Conclusions: An increased overall relationship in a QTL mapping design has positive effects on precision of QTL position estimates. But the relationship of inbreeding level and the capacity for QTL detection depending on the recombination rate of QTL and adjacent informative marker is not linear. © 2010 Freyer et al., licensee BioMed Central Ltd.

A high frequency current source converter with adjustable magnitude to drive high power piezoelectric transducers

A general electrical model of a piezoelectric transducer for ultrasound applications consists of a capacitor in parallel with RLC legs. A high power voltage source converter can however generate significant voltage stress across the transducer that creates high leakage currents. One solution is to reduce the voltage stress across the piezoelectric transducer by using an LC filter, however a main drawback is changing the piezoelectric resonant frequency and its characteristics. Thereby it reduces the efficiency of energy conversion through the transducer. This paper proposes that a high frequency current source converter is a suitable topology to drive high power piezoelectric transducers efficiently.