Integration and optimization of pressure retarded osmosis with reverse osmosis for power generation and high efficiency desalination

Salinity gradient power is proposed as a source of renewable energy when two solutions of different salinity are mixed. In particular, Pressure Retarded Osmosis (PRO) coupled with a Reverse Osmosis process (RO) has been previously suggested for power generation, using RO brine as the draw solution. However, integration of PRO with RO may have further value for increasing the extent of water recovery in a desalination process. Consequently, this study was designed to model the impact of various system parameters to better understand how to design and operate practical PRO-RO units. The impact of feed salinity and recovery rate for the RO process on the concentration of draw solution, feed pressure, and membrane area of the PRO process was evaluated. The PRO system was designed to operate at maximum power density of . Model results showed that the PRO power density generated intensified with increasing seawater salinity and RO recovery rate. For an RO process operating at 52% recovery rate and 35 g/L feed salinity, a maximum power density of 24 W/m2 was achieved using 4.5 M NaCl draw solution. When seawater salinity increased to 45 g/L and the RO recovery rate was 46%, the PRO power density increased to 28 W/m2 using 5 M NaCl draw solution. The PRO system was able to increase the recovery rate of the RO by up to 18% depending on seawater salinity and RO recovery rate. This result suggested a potential advantage of coupling PRO process with RO system to increase the recovery rate of the desalination process and reduce brine discharge.

Nonradial directional performance measurement with undesirable outputs: An application to OECD and Non-OECD countries

The objective of this paper is to provide a more comprehensive e±ciency measure to estimate the performance of OECD and non-OECD countries. A Russell directional distance function that appropriately credits the decision-making unit not only for increase in desirable outputs but also for the decrease of undesirable outputs is derived from the proposed weighted Russell directional distance model. The method was applied to a panel of 116 countries from 1992 to 2010. This framework also decomposes the comprehensive efficiency measure into individual input/ output components' inefficiency scores that are useful for policy making. The results reveal that the OECD countries perform better than the non-OECD countries in overall, goods,labor and capital efficiencies, but worse in bad and energy efficiencies.

Chapter 1: Precarious creativity: Global media, local labor

In most parts of the world, screen media workers—actors, directors, gaffers, and makeup artists—consider Hollywood to be glamorous and aspirational. If given the opportunity to work on a major studio lot, many would make the move, believing the standards of professionalism are high and the history of accomplishment is renowned. Moreover, as a global leader, Hollywood offers the chance to rub shoulders with talented counterparts and network with an elite labor force that earns top-tier pay and benefits. Yet despite this reputation, veterans say the view from inside isn’t so rosy, that working conditions have been deteriorating since the 1990s if not earlier. This grim outlook is supported by industry statistics that show the number of good jobs has been shrinking as studios outsource production to Atlanta, London, and Budapest, among others...

Incorporating the interrelationship between primary and support processes in monitoring and optimising longwall coal mining efficiency

This thesis increased the researchers understanding of the relationship between operations and maintenance in underground longwall coal mines, using data from a Queensland underground coal mine. The thesis explores various relationships between recorded variables. Issues with human recorded data was uncovered, and results emphasised the significance of variables associated with conveyor operation to explain production.

Measuring tax efficiency: A tax optimality index

This paper introduces an index of tax optimality that measures the distance of some current tax structure from the optimal tax structure in the presence of public goods. This index is defined on the [0, 1] interval and measures the proportion of the optimal tax rates that will achieve the same welfare outcome as some arbitrarily given initial tax structure. We call this number the Tax Optimality Index. We also show how the basic methodology can be altered to derive a revenue equivalent uniform tax, which measures the tax burden implied by the public sector. A numerical example is used to illustrate the method developed, and extensions of the analysis to handle models with multiple households and nonlinear taxation structures are undertaken.

3D hierarchical rutile TiO2 and metal-free organic sensitizer producing dye-sensitized solar cells 8.6% conversion efficiency

Three-dimensional (3D) hierarchical nanoscale architectures comprised of building blocks, with specifically engineered morphologies, are expected to play important roles in the fabrication of 'next generation' microelectronic and optoelectronic devices due to their high surface-to-volume ratio as well as opto-electronic properties. Herein, a series of well-defined 3D hierarchical rutile TiO2 architectures (HRT) were successfully prepared using a facile hydrothermal method without any surfactant or template, simply by changing the concentration of hydrochloric acid used in the synthesis. The production of these materials provides, to the best of our knowledge, the first identified example of a ledgewise growth mechanism in a rutile TiO2 structure. Also for the first time, a Dye-sensitized Solar Cell (DSC) combining a HRT is reported in conjunction with a high-extinction-coefficient metal-free organic sensitizer (D149), achieving a conversion efficiency of 5.5%, which is superior to ones employing P25 (4.5%), comparable to state-of-the-art commercial transparent titania anatase paste (5.8%). Further to this, an overall conversion efficiency 8.6% was achieved when HRT was used as the light scattering layer, a considerable improvement over the commercial transparent/reflector titania anatase paste (7.6%), a significantly smaller gap in performance than has been seen previously.

Evaluation of polymeric nanomedicines targeted to PSMA: Effect of ligand on targeting efficiency

Targeted nanomedicines offer a strategy for greatly enhancing accumulation of a therapeutic within a specific tissue in animals. In this study, we report on the comparative targeting efficiency toward prostate-specific membrane antigen (PSMA) of a number of different ligands that are covalently attached by the same chemistry to a polymeric nanocarrier. The targeting ligands included a small molecule (glutamate urea), a peptide ligand, and a monoclonal antibody (J591). A hyperbranched polymer (HBP) was utilized as the nanocarrier and contained a fluorophore for tracking/analysis, whereas the pendant functional chain-ends provided a handle for ligand conjugation. Targeting efficiency of each ligand was assessed in vitro using flow cytometry and confocal microscopy to compare degree of binding and internalization of the HBPs by human prostate cancer (PCa) cell lines with different PSMA expression status (PC3-PIP (PSMA+) and PC3-FLU (PSMA−). The peptide ligand was further investigated in vivo, in which BALB/c nude mice bearing subcutaneous PC3-PIP and PC3-FLU PCa tumors were injected intravenously with the HBP-peptide conjugate and assessed by fluorescence imaging. Enhanced accumulation in the tumor tissue of PC3-PIP compared to PC3-FLU highlighted the applicability of this system as a future imaging and therapeutic delivery vehicle.

Development of an efficiency equation for solar evaporator- collectors

Considering the growing energy needs and concern for environmental degradation, clean and inexhaustible energy sources, e.g solar energy are receiving greater attention for various applications. The use of solar energy systems for low temperature applications reduces the burden on conventional fossil fuels and has little or no harmful effects on the environment. The performance of a solar system depends to a great extent on the collector used for the conversion of solar radiant energy to thermal energy. A solar evaporatorcollector (SEC) is basically an unglazed flat plate collector where refrigerant, like R134a, is used as the working fluid. As the operating temperature of SEC is very low, it collects energy both from solar irradiation and ambient energy leading to a much higher efficiency than the conventional collectors. The capability of SEC to utilize ambient energy also enables the system to operate at night. Therefore it is not appropriate to use for the evaluation of performance of SEC by conventional efficiency equation where ambient energy and condensation is not considered as energy input in addition to irradiation. In the National University of Singapore, several Solar Assisted Heat Pump (SAHP) systems were built for the evaluation of performance under the metrological condition of Singapore for thermal applications of desalination and SEC was the main component to harness renewable energy. In this paper, the design and performance of SEC are explored. Furthermore, an attempt is made to develop an efficiency equation for SEC and maximum efficiency attained 98% under the meteorological condition of Singapore.

Workers are doing it for themselves? Local labor solidarity in precarious times

Historically, organized labor has played a fundamental role in guaranteeing basic rights and privileges for screen media workers and defending union and guild members (however unevenly) from egregious abuses of power. Yet, despite the recent turn to labor in media and cultural studies, organized labor today has received only scant attention, even less so in locations outside Hollywood. This presentation thus intervenes in two significant ways: first, it acknowledges the ongoing global ‘undoing’ of organized labor as a consequence of footloose production and conglomeration within the screen industries, and second, it examines a case example of worker solidarity and political praxis taking shape outside formal labor institutions in response to those structural shifts. Accordingly, it links an empirical study of individual agency to broader debates associated with the spatial dynamics of screen media production, including local capacity, regional competition, and precariousness. Drawing from ethnographic interviews with local film and television workers in Glasgow, Scotland, I consider the political alliance among three nascent labor organizations in the city: one for below-the-line crew, one for facility operators, and (oddly enough) one for producers. Collectively, the groups share a desire to transform Glasgow into a global production hub, following the infrastructure developments in nearby cities like Belfast, Prague, and Budapest. They furthermore frame their objectives in political terms: establishing global scale is considered a necessary maneuver to improve local working conditions like workplace safety, income disparity, skills training, and job access. Ultimately, I argue these groups are a product of an inadequate union structure and outdated policy vision for the screen sector , once-supportive institutions currently out of sync with the global realities of media production. Furthermore, the groups’ advocacy efforts reveal the extent to which workers themselves (in additional to capital) can seek “spatial fixes” to suture their prospects to specific political and economic goals. Of course, such activities manifest under conditions outside of the workers’ control but nevertheless point to an important tension within capitalist social relations, namely that the agency to reshape the spatial relationships in their own lives recasts the geography of labor in terms that aren’t inherent or exclusive to the interests of global capital.

Optimising the operational energy efficiency of an open-pit coal mine system

This thesis investigates factors that impact the energy efficiency of a mining operation. An innovative mathematical framework and solution approach are developed to model, solve and analyse an open-pit coal mine. A case study in South East Queensland is investigated to validate the approach and explore the opportunities for using it to aid long, medium and short term decision makers.

The efficiency of bounding vampires

Vampire bats, Desmodus rotundus, must maximize their feeding cycle of one blood meal per day by being efficient in the stalking and acquisition of their food. Riskin and Hermanson documented the running gait of the common vampire bat and observed they were efficient at running speeds, using longer stride lengths and thus decreased stride frequency. We obtained preliminary data on gait maintained for up to 10 minutes on a moving treadmill belt at speeds ranging from 0.23 to 0.74 m/s, which spanned a range from walking to running gaits. Bats tended to transition between gaits at about 0.40 m/s. Fourteen bats were studied and included four that were able to walk or run for 10 minutes. There was no significant change in either stride duration or frequency associated with an increase in speed. We estimated O2 consumption and CO2 production both before and 5 minutes after exercise, and found that O2 consumption increased 1 minute and 5 minutes after exercise. CO2 levels increased significantly 1 minute after exercise, but tended back towards pre-exercise level 5 minutes after exercise. Two bats were tested for blood O2, CO2 and pH levels. Interestingly, pH levels fell from 7.3 to about 7.0, indicating lactate accumulation.

Creative Labor in Cinema and Media Industries

Introduction The rapidly burgeoning popularity of cinema at the beginning of the 20th century favored industrialized modes of creativity organized around large production studios that could churn out a steady stream of narrative feature films. By the mid-1910s, a handful of Hollywood studios became leaders in the production, distribution, and exhibition of popular commercial movies. In order to serve incessant demand for new titles, the studios relied on a set of conventions that allowed them to regularize production and realize workplace efficiencies. This entailed a socialized mode of creativity that would later be adopted by radio and television broadcasters. It would also become a model for cinema and media production around the world, both for commercial and state-supported institutions. Even today the core tenets of industrialized creativity prevail in most large media enterprises. During the 1980s and 1990s, however, media industries began to change radically, driven by forces of neoliberalism, corporate conglomeration, globalization, and technological innovation. Today, screen media are created both by large-scale production units and by networked ensembles of talent and skilled labor. Moreover, digital media production may take place in small shops or via the collective labor of media users or fans who have attracted attention due to their hyphenated status as both producers and users of media (i.e., “prosumers”). Studies of screen media labor fall into five conceptual and methodological categories: historical studies of labor relations, ethnographically inspired investigations of workplace dynamics, critical analyses of the spatial and social organization of labor, and normative assessments of industrialized creativity.