The composition of sugarcane juices dervied from burnt cane and whole green cane crop

There has been substantial interest within the Australian sugar industry in product diversification as a means to reduce its exposure to fluctuating raw sugar prices and in order to increase its commercial viability. In particular, the industry is looking at fibrous residues from sugarcane harvesting (trash) and from sugarcane milling (bagasse) for cogeneration and the production of biocommodities, as these are complementary to the core process of sugar production. A means of producing surplus residue (biomass) is to process whole sugarcane crop. In this paper, the composition of different juices derived from different harvesting methods, viz. burnt cane with all trash extracted (BE), green cane with half of the trash extracted (GE), and green cane (whole sugarcane crop) with trash unextracted (GU), were investigated and the results and comparison presented. The determination of electrical conductivity, inorganic composition, and organic acids indicate that both GU and GE cane juice contain a higher proportion of soluble inorganic ions and ionisable organic acids, compared to BE cane juice. It is important to note that there are considerably higher levels of Na ions and citric acid, but relatively low P levels in the GU samples. A higher level of reducing sugars was analysed in the GU samples than the BE samples due to the higher proportion of impurities found naturally in sugarcane tops and leaves. The purity of the first expressed juice (FEJ) of GU cane was on average higher than that of FEJ of BE cane. Results also show that GU juices appear to contain higher levels of proteins and polysaccharides, with no significant difference in starch levels.

Modelling the flow of cane constituents through the milling process of a raw sugar factory

This thesis reports on an investigation to develop an advanced and comprehensive milling process model of the raw sugar factory. Although the new model can be applied to both, the four-roller and six-roller milling units, it is primarily developed for the six-roller mills which are widely used in the Australian sugar industry. The approach taken was to gain an understanding of the previous milling process simulation model "MILSIM" developed at the University of Queensland nearly four decades ago. Although the MILSIM model was widely adopted in the Australian sugar industry for simulating the milling process it did have some incorrect assumptions. The study aimed to eliminate all the incorrect assumptions of the previous model and develop an advanced model that represents the milling process correctly and tracks the flow of other cane components in the milling process which have not been considered in the previous models. The development of the milling process model was done is three stages. Firstly, an enhanced milling unit extraction model (MILEX) was developed to access the mill performance parameters and predict the extraction performance of the milling process. New definitions for the milling performance parameters were developed and a complete milling train along with the juice screen was modelled. The MILEX model was validated with factory data and the variation in the mill performance parameters was observed and studied. Some case studies were undertaken to study the effect of fibre in juice streams, juice in cush return and imbibition% fibre on extraction performance of the milling process. It was concluded from the study that the empirical relations developed for the mill performance parameters in the MILSIM model were not applicable to the new model. New empirical relations have to be developed before the model is applied with confidence. Secondly, a soluble and insoluble solids model was developed using modelling theory and experimental data to track the flow of sucrose (pol), reducing sugars (glucose and fructose), soluble ash, true fibre and mud solids entering the milling train through the cane supply and their distribution in juice and bagasse streams.. The soluble impurities and mud solids in cane affect the performance of the milling train and further processing of juice and bagasse. New mill performance parameters were developed in the model to track the flow of cane components. The developed model is the first of its kind and provides some additional insight regarding the flow of soluble and insoluble cane components and the factors affecting their distribution in juice and bagasse. The model proved to be a good extension to the MILEX model to study the overall performance of the milling train. Thirdly, the developed models were incorporated in a proprietary software package "SysCAD’ for advanced operational efficiency and for availability in the ‘whole of factory’ model. The MILEX model was developed in SysCAD software to represent a single milling unit. Eventually the entire milling train and the juice screen were developed in SysCAD using series of different controllers and features of the software. The models developed in SysCAD can be run from macro enabled excel file and reports can be generated in excel sheets. The flexibility of the software, ease of use and other advantages are described broadly in the relevant chapter. The MILEX model is developed in static mode and dynamic mode. The application of the dynamic mode of the model is still under progress.

Reducing the global burden of depression : population level analysis of intervention cost-effectiveness in 14 world regions

International evidence on the cost and effects of interventions for reducing the global burden of depression remain scarce. Aims: To estimate the population-level cost-effectiveness of evidence-based depression interventions and their contribution towards reducing current burden. Method: Primary-care-based depression interventions were modelled at the level of whole populations in 14 epidemiological subregions of the world. Total population-level costs (in international dollars or I$) and effectiveness (disability adjusted life years (DALYs) averted) were combined to form average and incremental cost-effectiveness ratios. Results: Evaluated interventions have the potential to reduce the current burden of depression by 10–30%. Pharmacotherapy with older antidepressant drugs, with or without proactive collaborative care, are currently more cost-effective strategies than those using newer antidepressants, particularly in lower-income subregions. Conclusions: Even in resource-poor regions, each DALYaverted by efficient depression treatments in primary care costs less than 1 year of average per capita income, making such interventions a cost-effective use of health resources. However, current levels of burden can only be reduced significantlyif there is a substantialincrease substantial increase intreatment coverage.

Reducing MRI gradient coil vibration with rib stiffeners

This work investigates the effect of rib stiffeners on the free and forced vibration of a gradient coil in a Magnetic Resonance Imaging (MRI) scanner. Several reinforcement schemes are studied in this paper. One scheme utilizes the existing holes in the gradient coil structure (typically reserved for magnetic shims) to produce the reinforcement. Non-ferrous, non-magnetic carbon fibre rib stiffeners are employed to fill these holes in several ways to strengthen a gradient coil. Another scheme replaces the inner half of the gradient coil material with a grid of interconnected axial and circumferential rib stiffeners. It is found that the structural stiffness of the gradient coil increases substantially when the coil is reinforced by carbon fibre rib stiffeners. The reinforcement affects the noise and vibration response of the gradient coil structure in the following ways. It increases the frequency range of forced response of the gradient coil at low frequencies due to the increased resonant frequency of the fundamental mode of the coil. Secondly, it reduces the forced response amplitude of the coil structure (which is governed by the structural stiffness of the coil). Thirdly, it reduces the number of natural modes in the low and medium frequency range and therefore lessens the chance of the coil structure being excited resonantly by magnetic resonance signal acquisition sequences. It is shown that gradient coils modelled by solid finite element models have higher stiffness along the coil’s circumference and lower stiffness in the axial direction than those using shell finite element models.

The nature and extent of policing alcohol related crime and reducing violence in and around late night entertainment areas

The misuse of alcohol is well documented in Australia and has been associated with disorders and harms that often require police attention. The extent of alcohol-related incidents requiring police attention has been recorded as substantial in some Australian cities (Arro, Crook, & Fenton, 1992; Davey & French, 1995; Ireland & Thommeny, 1993). A significant proportion of harmful drinking occurs in and around licensed premises (Jochelson, 1997; Stockwell, Masters, Phillips, Daly, Gahegan, Midford, & Philp, 1998; Borges, Cherpitel, & Rosovsky, 1998) and most of these incidents are not reported to police (Bryant & Williams, 2000; Lister, Hobbs, Hall, & Winlow, 2000). Alcohol-related incidents have also been found to be concentrated in certain places at certain times (Jochelson, 1997) and therefore manipulating the context in which these incidents occur may provide a means to prevent and reduce the harm associated with alcohol misuse. One of the major objectives of the present program of research was to investigate the occurrence and resource impact of alcohol-related incidents on operational (general duties) policing across a large geographical area. A second objective of the thesis was to examine the characteristics and temporal/spatial dynamics of police attended alcohol incidents in the context of Place Based theories of crime. It was envisaged that this approach would reveal the patterns of the most prevalent offences and demonstrate the relevance of Place Based theories of crime to understanding these patterns. In addition, the role of alcohol, time and place were also explored in order to examine the association between non criminal traffic offences and other types of criminal offences. A final objective of the thesis was to examine the impact of a situational crime prevention strategy that had been initiated to reduce the violence and disorder associated with late-night liquor trading premises. The program of research in this doctorate thesis has been undertaken through the presentation of published papers. The research was conducted in three stages which produced six manuscripts, five of which were submitted to peer reviewed journals and one that was published in a peer reviewed conference proceedings. Stage One included two studies (Studies 1 & 2) both of which involved a cross sectional approach to examine the prevalence and characteristics of alcohol-related incidents requiring police attendance across three large geographical areas that included metropolitan cities, provincial regions and rural areas. Stage Two of the program of research also comprised two cross sectional quantitative studies (Studies 3 & 4) that investigated the temporal and spatial dynamics of the major offence categories attended by operational police in a specific Police District (Gold Coast). Stage Three of the program of research involved two studies (Studies 5 & 6) that assessed the effectiveness of a situational crime prevention strategy. The studies employed a pre-post design to assess the impact on crime, disorder and violence by preventing patrons from entering late-night liquor trading premises between 3 a.m. and 5 a.m. (lockout policy). Although Study Five was solely quantitative in nature, Study Six included both quantitative and qualitative aspects. The approach adopted in Study Six, therefore facilitated not only a quantative comparison of the impact of the lockout policy on different policing areas, but also enabled the processes related to the implementation of the lockout policy to be examined. The thesis reports a program of research involving a common data collection method which then involved a series of studies being conducted to explore different aspects of the data. The data was collected from three sources. Firstly a pilot phase was undertaken to provide participants with training. Secondly a main study period was undertaken immediately following the pilot phase. The first and second sources of data were collected between 29th March 2004 and 2nd May 2004. Thirdly, additional data was collected between the 1st April 2005 and 31st May 2005. Participants in the current program of research were first response operational police officers who completed a modified activity log over a 9 week period (4 week pilot phase & 5 week survey study phase), identifying the type, prevalence and characteristics of alcohol-related incidents that were attended. During the study period police officers attended 31,090 alcohol-related incidents. Studies One and Two revealed that a substantial proportion of current police work involves attendance at alcohol-related incidents (i.e., 25% largely involving young males aged between 17 and 24 years). The most common incidents police attended were vehicle and/or traffic matters, disturbances and offences against property. The major category of offences most likely to involve alcohol included vehicle/traffic matters, disturbances and offences against the person (e.g., common & serious assaults). These events were most likely to occur in the late evenings and early hours of the morning on the weekends, and importantly, usually took longer for police to complete than non alcohol-related incidents. The findings in Studies Three and Four suggest that serious traffic offences, disturbances and offences against the person share similar characteristics and occur in concentrated places at similar times. In addition, it was found that time, place and incident type all have an influence on whether an incident attended by a police officer is alcohol-related. Alcohol-related incidents are more likely to occur in particular locations in the late evenings and early mornings on the weekends. In particular, there was a strong association between the occurrence of alcohol-related disturbances and alcohol-related serious traffic offences in regards to place and time. In general, stealing and property offences were not alcohol-related and occurred in daylight hours during weekdays. The results of Studies Five and Six were mixed. A number of alcohol-related offences requiring police attention were significantly reduced for some policing areas and for some types of offences following the implementation of the lockout policy. However, in some locations the lockout policy appeared to have a negative or minimal impact. Interviews with licensees revealed that although all were initially opposed to the lockout policy as they believed it would have a negative impact on business, most perceived some benefits from its introduction. Some of the benefits included, improved patron safety and the development of better business strategies to increase patron numbers. In conclusion, the overall findings of the six studies highlight the pervasive nature of alcohol across a range of criminal incidents, demonstrating the tremendous impact alcohol-related incidents have on police. The findings also demonstrate the importance of time and place in predicting the occurrence of alcohol-related offences. Although this program of research did not set out to test Place Based theories of crime, these theories were used to inform the interpretation of findings. The findings in the current research program provide evidence for the relevance of Place Based theories of crime to understanding the factors contributing to violence and disorder, and designing relevant crime prevention strategies. For instance, the results in Studies Five and Six provide supportive evidence that this novel lockout initiative can be beneficial for public safety by reducing some types of offences in particular areas in and around late-night liquor trading premises. Finally, intelligent-led policing initiatives based on problem oriented policing, such as the lockout policy examined in this thesis, have potential as a major crime prevention technique to reduce specific types of alcohol-related offences.