Exploring the stages of change and perceived barriers to treatment models within the context of parental adherence to an early intervention program

Parent-mediated early intervention programs depend on the willingness and ability of parents to complete prescribed activities with their children. In other contexts, internal factors, such as stages of change, and external factors, such as barriers to treatment, have been shown to correlate with adherence to service. This researcher modified the Stages of Change Questionnaire as well as the Barriers to Treatment Participation Scale (BTPS) to use with this population. Despite initial interest, twenty-three parent participants were referred to the researcher over the course of three years, with only five parents taking part in the study. A population base ten times that of the current sample would be required recruit enough participants (fifty-one) to provide sufficient power. This feasibility study discusses the results of the five parent participants. Findings suggest that the modified Stages of Change Questionnaire may not be sensitive enough for use with the current sample, while the modified BTPS may yield useful information for service providers.

Design construction and testing of a heat loop for study of fouling and its interrelationship to corrosion in heat exchanger tubes

A heat loop suitable for the study of thermal fouling and its relationship to corrosion processes was designed, constructed and tested. The design adopted was an improvement over those used by such investigators as Hopkins and the Heat Transfer Research Institute in that very low levels of fouling could be detected accurately, the heat transfer surface could be readily removed for examination and the chemistry of the environment could be carefully monitored and controlled. In addition, an indirect method of electrical heating of the heat transfer surface was employed to eliminate magnetic and electric effects which result when direct resistance heating is employed to a test section. The testing of the loop was done using a 316 stainless steel test section and a suspension of ferric oxide and water in an attempt to duplicate the results obtained by Hopkins. Two types of thermal ·fouling resistance versus time curves were obtained . (i) Asymptotic type fouling curve, similar to the fouling behaviour described by Kern and Seaton and other investigators, was the most frequent type of fouling curve obtained. Thermal fouling occurred at a steadily decreasing rate before reaching a final asymptotic value. (ii) If an asymptotically fouled tube was cooled with rapid cir- ·culation for periods up to eight hours at zero heat flux, and heating restarted, fouling recommenced at a high linear rate. The fouling results obtained were observed to be similar and 1n agreement with the fouling behaviour reported previously by Hopkins and it was possible to duplicate quite closely the previous results . This supports the contention of Hopkins that the fouling results obtained were due to a crevice corrosion process and not an artifact of that heat loop which might have caused electrical and magnetic effects influencing the fouling. The effects of Reynolds number and heat flux on the asymptotic fouling resistance have been determined. A single experiment to study the effect of oxygen concentration has been carried out. The ferric oxide concentration for most of the fouling trials was standardized at 2400 ppM and the range of Reynolds number and heat flux for the study was 11000-29500 and 89-121 KW/M², respectively.