Knowledge and perceptions of domestic violence services among women in Ghana

Support services are important to the mental and physical well-being of survivors of intimate partner violence. However, researchers and service providers note that survivors seldom report violence to formal domestic violence services in Ghana. Despite calls from service providers for Ghanaians to report domestic violence, few studies have focused on women’s knowledge and perceptions of formal domestic violence services in Ghana and how these perceptions influence their help-seeking behaviour. This thesis presents qualitative findings on Ghanaian women's knowledge and perceptions of formal domestic violence services. Also, challenges to service delivery are explored. Results revealed that awareness among respondents of available services was low. Additionally, most respondents had negative perceptions of these formal services. This study demonstrates that more educational campaigns need to be carried out to raise awareness among Ghanaians on domestic violence and the formal interventions available in the country. Additionally, service providers and policy makers must formulate programmes and policies that are better suited to the uniqueness of the Ghanaian situation.

Design construction and testing of a heat loop for study of fouling and its interrelationship to corrosion in heat exchanger tubes

A heat loop suitable for the study of thermal fouling and its relationship to corrosion processes was designed, constructed and tested. The design adopted was an improvement over those used by such investigators as Hopkins and the Heat Transfer Research Institute in that very low levels of fouling could be detected accurately, the heat transfer surface could be readily removed for examination and the chemistry of the environment could be carefully monitored and controlled. In addition, an indirect method of electrical heating of the heat transfer surface was employed to eliminate magnetic and electric effects which result when direct resistance heating is employed to a test section. The testing of the loop was done using a 316 stainless steel test section and a suspension of ferric oxide and water in an attempt to duplicate the results obtained by Hopkins. Two types of thermal ·fouling resistance versus time curves were obtained . (i) Asymptotic type fouling curve, similar to the fouling behaviour described by Kern and Seaton and other investigators, was the most frequent type of fouling curve obtained. Thermal fouling occurred at a steadily decreasing rate before reaching a final asymptotic value. (ii) If an asymptotically fouled tube was cooled with rapid cir- ·culation for periods up to eight hours at zero heat flux, and heating restarted, fouling recommenced at a high linear rate. The fouling results obtained were observed to be similar and 1n agreement with the fouling behaviour reported previously by Hopkins and it was possible to duplicate quite closely the previous results . This supports the contention of Hopkins that the fouling results obtained were due to a crevice corrosion process and not an artifact of that heat loop which might have caused electrical and magnetic effects influencing the fouling. The effects of Reynolds number and heat flux on the asymptotic fouling resistance have been determined. A single experiment to study the effect of oxygen concentration has been carried out. The ferric oxide concentration for most of the fouling trials was standardized at 2400 ppM and the range of Reynolds number and heat flux for the study was 11000-29500 and 89-121 KW/M², respectively.