Development of calix[4]arene-functionalized microcantilever array sensing system for the rapid, sensitive and simultaneous detection of metal ions in aqueous solutions

The work described in this thesis was conducted with the aim of: 1) investigating the binding capabilities of calix[4]arene-functionalized microcantilevers towards specific metal ions and 2) developing a new16-microcantilever array sensing system for the rapid, and simultaneous detection of metal ions in fresh water. Part I of this thesis reports on the use of three new bimodal calix[4]arenes (methoxy, ethoxy and crown) as potential host/guest sensing layers for detecting selected ions in dilute aqueous solutions using single microcantilever experimental system. In this work it was shown that modifying the upper rim of the calix[4]arenes with a thioacetate end group allow calix[4]arenes to self-assemble on Au(111) forming complete highly ordered monolayers. It was also found that incubating the microcantilevers coated with 5 nm of Inconel and 40 nm of Au for 1 h in a 1.0 M solution of calix[4]arene produced the highest sensitivity. Methoxy-functionalized microcantilevers showed a definite preference for Ca²⁺ ions over other cationic guests and were able to detect trace concentration as low as 10⁻¹² M in aqueous solutions. Microcantilevers modified with ethoxy calix[4]arene displayed their highest sensitivity towards Sr²⁺ and to a lesser extent Ca²⁺ ions. Crown calix[4]arene-modified microcantilevers were however found to bind selectively towards Cs⁺ ions. In addition, the counter anion was also found to contribute to the deflection. For example methoxy calix[4]arene-modified microcantilever was found to be more sensitive to CaCl₂ over other water-soluble calcium salts such as Ca(NO₃)₂ , CaBr₂ and CaI₂. These findings suggest that the response of calix[4]arene-modified microcantilevers should be attributed to the target ionic species as a whole instead of only considering the specific cation and/or anion. Part II presents the development of a 16-microcantilever sensor setup. The implementation of this system involved the creation of data analysis software that incorporates data from the motorized actuator and a two-axis photosensitive detector to obtain the deflection signal originating from each individual microcantilever in the array. The system was shown to be capable of simultaneous measurements of multiple microcantilevers with different coatings. A functionalization unit was also developed that allows four microcantilevers in the array to be coated with an individual sensing layer one at the time. Because of the variability of the spring constants of different cantilevers within the array, results presented were quoted in units of surface stress unit in order to compare values between the microcantilevers in the array.

Role of metalliferous mudstones and graphitic shales in the location, genesis, and paleoenvironment

The Cambrian Tally Pond volcanic belt in central Newfoundland contains numerous volcanogenic massive sulphide (VMS) deposits, prospects, and showings that are locally associated with metalliferous mudstones and/or graphitic shales. Deposits in the belt are bimodal felsic-type VMS that are both base metal- (e.g., Duck Pond, Boundary) and precious metal-enriched (e.g., Lemarchant). At the Lemarchant deposit metalliferous mudstones are genetically and spatially associated with mineralization, whereas the relationship of other mudstones and shales to massive sulphide mineralization is more intricate and remains not fully understood. Metalliferous mudstones represent a hiatus in the volcanic activity where the deposition of hydrothermal products dominated over the abiogenic background sedimentation and/or dilution by volcaniclastic-epiclastic material. Lithogeochemical signatures allow one to distinguish between predominantly hydrothermally or detritally (i.e., non-hydrothermal) derived material. Metalliferous mudstones with a significant hydrothermal component, like those at Lemarchant, have elevated Fe/Al and base-metal contents, compared to detrital shales, and shale-normalized negative Ce and positive Eu anomalies, indicative of deposition from high temperature (>250°C) hydrothermal fluids within an oxygenated water column. Mudstones and shales sampled from other locations in the Tally Pond volcanic belt have more variable signatures ranging from hydrothermal (signatures as above) to non-hydrothermal (no positive Eu-anomalies, flat REE patterns), with some that have mixed (hydrothermal and detrital) signatures. Both S and Pb isotopic compositions indicate that proximal sulphides hosted in mudstones immediately associated with massive sulphide mineralization within the Lemarchant deposit contain a higher proportion of sulphur derived from hydrothermal sources and processes, and have more juvenile lead contributions, when compared to sulphides distal (not associated with massive sulphides) from mineralization. Lead and Nd isotopic compositions of both whole rock and minerals in the Lemarchant mudstones indicate involvement of underlying crustal basement during massive sulphide formation and throughout the evolution of the Tally Pond belt. Metalliferous mudstones precipitated early in the massive sulphide depositional history, but also have undergone syn- and post-ore-forming processes and have a larger lateral extent than the mineralization. Using lithogeochemistry, whole rock and in situ stable and radiogenic isotopes it is possible to distinguish prospective vent proximal (immediately associated with massive sulphide mineralization) from less prospective distal (not associated with massive sulphides) depositional environments and to reconstruct the paleotectonic setting on a deposit- to regional-scale for the Lemarchant deposit and other mudstone-associated prospects in the Tally Pond volcanic belt.

Derivation of base-line geochemistry, petrography, and isotopic data for the host rocks to the Lucky Strike deposit and comparison with data from other alteration zones, Buchans Mining Camp, Newfoundland

The Buchans ore bodies of central Newfoundland represent some of the highest grade VMS deposits ever mined. These Kuroko-type deposits are also known for the well developed and preserved nature of the mechanically transported deposits. The deposits are hosted in Cambro-Ordovician, dominantly calc-alkaline, bimodal volcanic and epiclastic sequences of the Notre Dame Subzone, Newfoundland Appalachians. Stratigraphic relationships in this zone are complicated by extensively developed, brittledominated Silurian thrust faulting. Hydrothermal alteration of host rocks is a common feature of nearly all VMS deposits, and the recognition of these zones has been a key exploration tool. Alteration of host rocks has long been described to be spatially associated with the Buchans ore bodies, most notably with the larger in-situ deposits. This report represents a base-line study in which a complete documentation of the geochemical variance, in terms of both primary (igneous) and alteration effects, is presented from altered volcanic rocks in the vicinity of the Lucky Strike deposit (LSZ), the largest in-situ deposit in the Buchans camp. Packages of altered rocks also occur away from the immediate mining areas and constitute new targets for exploration. These zones, identified mostly by recent and previous drilling, represent untested targets and include the Powerhouse (PHZ), Woodmans Brook (WBZ) and Airport (APZ) alteration zones, as well as the Middle Branch alteration zone (MBZ), which represents a more distal alteration facies related to Buchans ore-formation. Data from each of these zones were compared to those from the LSZ in order to evaluate their relative propectivity. Derived litho geochemical data served two functions: (i) to define primary (igneous) trends and (ii) secondary alteration trends. Primary trends were established using immobile, or conservative, elements (i. e., HFSE, REE, Th, Ti0₂, Al₂0₃, P₂0₅). From these, altered volcanic rocks were interpreted in terms of composition (e.g., basalt - rhyodacite) and magmatic affinity (e.g., calc-alkaline vs. tholeiitic). The information suggests that bimodality is a common feature of all zones, with most rocks plotting as either basalt/andesite or dacite (or rhyodacite); andesitic senso stricto compositions are rare. Magmatic affinities are more varied and complex, but indicate that all units are arc volcanic sequences. Rocks from the LSZ/MBZ represent a transitional to calc-alkalic sequence, however, a slight shift in key geochemical discriminants occurs between the foot-wall to the hanging-wall. Specifically, mafic and felsic lavas of the foot-wall are of transitional (or mildly calc-alkaline) affinity whereas the hanging-wall rocks are relatively more strongly calc-alkaline as indicated by enriched LREE/HREE and higher ZrN, NbN and other ratios in the latter. The geochemical variations also serve as a means to separate the units (at least the felsic rocks) into hanging-wall and foot-wall sequences, therefore providing a valuable exploration tool. Volcanic rocks from the WBZ/PHZ (and probably the APZ) are more typical of tholeiitic to transitional suites, yielding flatter mantlenormalized REE patterns and lower ZrN ratios. Thus, the relationships between the immediate mining area (represented by LSZ/MBZ) and the Buchans East (PHZ/WBZ) and the APZ are uncertain. Host rocks for all zones consist of mafic to felsic volcanic rocks, though the proportion of pyroclastic and epiclastic rocks, is greatest at the LSZ. Phenocryst assemblages and textures are common in all zones, with minor exceptions, and are not useful for discrimination purposes. Felsic rocks from all zones are dominated by sericiteclay+/- silica alteration, whereas mafic rocks are dominated by chlorite- quartz- sericite alteration. Pyrite is ubiquitous in all moderately altered rocks and minor associated base metal sulphides occur locally. The exception is at Lucky Strike, where stockwork quartzveining contains abundant base-metal mineralization and barite. Rocks completely comprised of chlorite (chloritite) also occur in the LSZ foot-wall. In addition, K-feldspar alteration occurs in felsic volcanic rocks at the MBZ associated with Zn-Pb-Ba and, notably, without chlorite. This zone represents a peripheral, but proximal, zone of alteration induced by lower temperature hydrothermal fluids, presumably with little influence from seawater. Alteration geochemistry was interpreted from raw data as well as from mass balanced (recalculated) data derived from immobile element pairs. The data from the LSZ/MBZ indicate a range in the degree of alteration from only minor to severe modification of precursor compositions. Ba tends to show a strong positive correlation with K₂0, although most Ba occurs as barite. With respect to mass changes, Al₂0₃, Ti0₂ and P₂0₅ were shown to be immobile. Nearly all rocks display mass loss of Na₂O, CaO, and Sr reflecting feldspar destruction. These trends are usually mirrored by K₂0-Rb and MgO addition, indicating sericitic and chloritic alteration, respectively. More substantial gains ofK₂0 often occur in rocks with K-feldspar alteration, whereas a few samples also displayed excessive MgO enrichment and represent chloritites. Fe₂0₃ indicates both chlorite and sulphide formation. Si0₂ addition is almost always the case for the altered mafic rocks as silica often infills amygdules and replaces the finer tuffaceous material. The felsic rocks display more variability in Si0₂. Silicic, sericitic and chloritic alteration trends were observed from the other zones, but not K-feldspar, chloritite, or barite. Microprobe analysis of chlorites, sericites and carbonates indicate: (i) sericites from all zones are defined as muscovite and are not phengitic; (ii) at the LSZ, chlorites ranged from Fe-Mg chlorites (pycnochlorite) to Mg-rich chlorite (penninite), with the latter occurring in the stockwork zone and more proximal alteration facies; (iii) chlorites from the WBZ were typical of those from the more distal alteration facies of the LSZ, plotting as ripidolite to pycnochlorite; (iv) conversely, chlorite from the PHZ plot with Mg-Al-rich compositions (chlinochlore to penninite); and (v) carbonate species from each zone are also varied, with calcite occurring in each zone, in addition to dolomite and ankerite in the PHZ and WBZ, respectively. Lead isotope ratios for galena separates from the different various zones, when combined with data from older studies, tend to cluster into four distinctive fields. Overall, the data plot on a broad mixing line and indicate evolution in a relatively low-μ environment. Data from sulphide stringers in altered MBZ rocks, as well as from clastic sulphides (Sandfill prospect), plot in the Buchans ore field, as do the data for galena from altered rocks in the APZ. Samples from the Buchans East area are even more primitive than the Buchans ores, with lead from the PHZ plotting with the Connel Option prospect and data from the WBZ matching that of the Skidder prospect. A sample from a newly discovered debris flow-type sulphide occurrence (Middle Branch East) yields lead isotope ratios that are slightly more radiogenic than Buchans and plot with the Mary March alteration zone. Data within each cluster are interpreted to represent derivation from individual hydrothermal systems in which metals were derived from a common source.