Intermetallic layer formation and influence in solder joints reliability

Dissertação de mestrado integrado em Materials Engineering

Titanium oxide adhesion layer for high temperature annealed Si/Si3N4/TiOx/Pt/LiCoO2 battery structures

This work describes the influence of a high annealing temperature of about 700C on the Si(substrate)/Si3N4/TiOx/Pt/LiCoO2 multilayer system for the fabrication of all-solid-state lithium ion thin film microbatteries. Such microbatteries typically utilize lithium cobalt oxide (LiCoO2) as cathode material with a platinum (Pt) current collector. Silicon nitride (Si3N4) is used to act as a barrier against Li diffusion into the substrate. For a good adherence between Si3N4 and Pt, commonly titanium (Ti) is used as intermediate layer. However, to achieve crystalline LiCoO2 the multilayer system has to be annealed at high temperature. This post-treatment initiates Ti diffusion into the Pt-collector and an oxidation to TiOx, leading to volume expansion and adhesion failures. To solve this adhesion problem, we introduce titanium oxide (TiOx) as an adhesion layer, avoiding the diffusion during the annealing process. LiCoO2, Pt and Si3N4 layers were deposited by magnetron sputtering and the TiOx layer by thermal oxidation of Ti layers deposited by e-beam technique. Asdeposited and annealed multilayer systems using various TiOx layer thicknesses were studied by scanning electron microscopy (SEM) and time-of-flight secondary ion mass spectrometry (ToF-SIMS) and x-ray photoelectron spectroscopy (XPS). The results revealed that an annealing process at temperature of 700C leads to different interactions of Ti atoms between the layers, for various TiOx layer thicknesses (25–45 nm).

Flexible organic–inorganic hybrid layer encapsulation for organic opto-electronic devices

In this work we produce and study the flexible organic–inorganic hybrid moisture barrier layers for the protection of air sensitive organic opto-electronic devices. The inorganic amorphous silicon nitride layer (SiNx:H) and the organic PMMA [poly (methyl methacrylate)] layer are deposited alternatingly by using hot wire chemical vapor deposition (HW-CVD) and spin-coating techniques, respectively. The effect of organic–inorganic hybrid interfaces is analyzed for increasing number of interfaces. We produce highly transparent (∼80% in the visible region) hybrid structures. The morphological properties are analysed providing a good basis for understanding the variation of the water vapor transmission rate (WVTR) values. A minimum WVTR of 4.5 × 10−5g/m2day is reported at the ambient atmospheric conditions for 7 organic/inorganic interfaces. The hybrid barriers show superb mechanical flexibility which confirms their high potential for flexible applications.

Layer-by-layer technique to developing functional nanolaminate films with antifungal activity

The layer-by-layer (LbL) deposition method was used to build up alternating layers (five) of different polyelectrolyte solutions (alginate, zein-carvacrol nanocapsules, chitosan and chitosan-carvacrol emulsions) on an aminolysed/charged polyethylene terephthalate (A/C PET) film. These nanolaminated films were characterised by contact angle measurements and through the determination of water vapour (WVTR) and oxygen (O2TR) transmission rates. The effect of active nanolaminated films against the Alternaria sp. and Rhizopus stolonifer was also evaluated. This procedure allowed developing optically transparent nanolaminated films with tuneable water vapour and gas properties and antifungal activity. The water and oxygen transmission rate values for the multilayer films were lower than those previously reported for the neat alginate or chitosan films. The presence of carvacrol and zein nanocapsules significantly decreased the water transmission rate (up to 40 %) of the nanolaminated films. However, the O2TR behaved differently and was only improved (up to 45 %) when carvacrol was encapsulated, i.e. nanolaminated films prepared by alternating alginate with nanocapsules of zein-carvacrol layers showed better oxygen barrier properties than those prepared as an emulsion of chitosan and carvacrol. These films containing zein-carvacrol nanocapsules also showed the highest antifungal activity (30 %), which did not significantly differ from those obtained with the highest amount of carvacrol, probably due to the controlled release of the active agent (carvacrol) from the zein-carvacrol nanocapsules. Thus, this work shows that nanolaminated films prepared with alternating layers of alginate and zein-carvacrol nanocapsules can be considered to improve the shelf-life of foodstuffs.

Extensive subcutaneous emphysema as a presentation of ischemic colitis

Introduction . Subcutaneous emphysema is usually benign and self-limited; however, it may be associated with a life-threating situation. Case Report . An elderly woman with progressive malaise with extensive subcutaneous emphysema (cervical to abdominal wall) was observed at the emergency department. Colonic perforation was diagnosed and the patient underwent surgery. Intraoperatively, necrosis and perforation of the sigmoid colon into the retroperitoneum were found and a Hartmann procedure was performed. Conclusion . Cervical and thoracic subcutaneous emphysema may be the first sign of intra-abdominal lesion.

Stage at presentation of breast cancer in Luanda, Angola - a retrospective study

Background: It is expected that, by 2020, 15 million new cases of cancer will occur every year in the world, one million of them in Africa. Knowledge of cancer trends in African countries is far from adequate, and improvements in cancer prevention efforts are urgently needed. The aim of this study was to characterize breast cancer clinically and pathologically at presentation in Luanda, Angola; we additionally provide quality information that will be useful for breast cancer care planning in the country. Methods: Data on breast cancer cases were retrieved from the Angolan Institute of Cancer Control, from 2006 to 2014. For women diagnosed in 2009 (5-years of follow-up), demographic, clinical and pathological information, at presentation, was collected, namely age at diagnosis, parity, methods used for pathological diagnoses, tumor pathological characteristics, stage of disease and treatment. Descriptive statistics were performed. Results: The median age of women diagnosed with breast cancer in 2009 was 47 years old (range 25–89). The most frequent clinical presentation was breast swelling with axillary lymph nodes metastasis (44.9 %), followed by a mass larger than 5 cm (14.2 %) and lump (12.9 %). Invasive ductal carcinoma was the main histologic type (81.8 %). Only 10.1 % of cancer cases had a well differentiated histological grade. Cancers were diagnosed mostly at advanced stages (66.7 % in stage III and 11.1 % in stage IV). Discussion: In this study, breast cancer was diagnosed at a very advanced stage. Although it reports data from a single cancer center in Luanda, Angola it reinforces the need for early diagnosis and increasing awareness. According to the main challenges related to breast cancer diagnosis and treatment herein presented, we propose a realistic framework that would allow for the implementation of a breast cancer care program, built under a strong network based on cooperation, teaching, audit, good practices and the organization of health services. Conclusion: Angola needs urgently a program for early diagnosis of breast cancer.