Development of an intelligent earthwork optimization system

Tese de Doutoramento em Engenharia Civil.

Variation of the physicochemical and morphological characteristics of solvent casted poly(vinylidene fluoride) along its binary phase diagram with dimethylformamide

Poly(vinylidene fluoride), PVDF, films and membranes were prepared by solvent casting from dimethylformamide, DMF, by systematically varying polymer/solvent ratio and solvent evaporation temperature. The effect of the processing conditions on the morphology, degree of porosity, mechanical and thermal properties and crystalline phase of the polymer were evaluated. The obtained microstructure is explained by the Flory-Huggins theory. For the binary system, the porous membrane formation is attributed to a spinodal decomposition of the liquid-liquid phase separation. The morphological features were simulated through the correlation between the Gibbs total free energy and the Flory-Huggins theory. This correlation allowed the calculation of the PVDF/DMF phase diagram and the evolution of the microstructure in different regions of the phase diagram. Varying preparation conditions allow tailoring polymer 2 microstructure while maintaining a high degree of crystallinity and a large β crystalline phase content. Further, the membranes show adequate mechanical properties for applications in filtration or battery separator membranes.

Sensory intensity assessment of olive oils using an electronic tongue

Olive oils may be commercialized as intense, medium or light, according to the intensity perception of fruitiness, bitterness and pungency attributes, assessed by a sensory panel. In this work, the capability of an electronic tongue to correctly classify olive oils according to the sensory intensity perception levels was evaluated. Cross-sensitivity and non-specific lipid polymeric membranes were used as sensors. The sensor device was firstly tested using quinine monohydrochloride standard solutions. Mean sensitivities of 14±2 to 25±6 mV/decade, depending on the type of plasticizer used in the lipid membranes, were obtained showing the device capability for evaluating bitterness. Then, linear discriminant models based on sub-sets of sensors, selected by a meta-heuristic simulated annealing algorithm, were established enabling to correctly classify 91% of olive oils according to their intensity sensory grade (leave-one-out cross-validation procedure). This capability was further evaluated using a repeated K-fold cross-validation procedure, showing that the electronic tongue allowed an average correct classification of 80% of the olive oils used for internal-validation. So, the electronic tongue can be seen as a taste sensor, allowing differentiating olive oils with different sensory intensities, and could be used as a preliminary, complementary and practical tool for panelists during olive oil sensory analysis.

Enhanced resistive switching and multilevel behavior in bilayered HfAlO/HfAlOx structures for non-volatile memory applications

In this work, hafnium aluminum oxide (HfAlO) thin films were deposited by ion beam sputtering deposition technique on Si substrate. The presence of oxygen vacancies in the HfAlOx layer deposited in oxygen deficient environment is evidenced from the photoluminescence spectra. Furthermore, HfAlO(oxygen rich)/HfAlOx(oxygen poor) bilayer structures exhibit multilevel resistive switching (RS), and the switching ratio becomes more prominent with increasing the HfAlO layer thickness. The bilayer structure with HfAlO/HfAlOx thickness of 30/40 nm displays the enhanced multilevel resistive switching characteristics, where the high resistance state/ intermediate resistance state (IRS) and IRS/low resistance state resistance ratios are 102 and 5 105 , respectively. The switching mechanisms in the bilayer structures were investigated by the temperature dependence of the three resistance states. This study revealed that the multilevel RS is attributed to the coupling of ionic conduction and the metallic conduction, being the first associated to the formation and rupture of conductive filaments related to oxygen vacancies and the second with the formation of a metallic filament. Moreover, the bilayer structures exhibit good endurance and stability in time.

The influence of nitrogen and oxygen additions on the thermal characteristics of aluminium-based thin films

The ternary aluminium oxynitride (AlNxOy) system offers the possibility to obtain a wide range of properties by tailoring the ratio between pure Al, AlNx and AlOy and therefore opening a significant number of possible applications. In this work the thermal behaviour of AlNxOy thin films was analysed by modulated infrared radiometry (MIRR), taking as reference the binary AlOy and AlNx systems. MIRR is a non-contact and non-destructive thermal wave measurement technique based on the excitation, propagation and detection of temperature oscillations of very small amplitudes. The intended change of the partial pressure of the reactive gas (N2 and/or O2) influenced the target condition and hence the deposition characteristics which, altogether, affected the composition and microstructure of the films. Based on the MIRR measurements and their qualitative and quantitative interpretation, some correlations between the thermal transport properties of the films and their chemical/physical properties have been found. Furthermore, the potential of such technique applied in this oxynitride system, which present a wide range of different physical responses, is also discussed. The experimental results obtained are consistent with those reported in previous works and show a high potential to fulfil the demands needed for the possible applications of the systems studied. They are clearly indicative of an adequate thermal response if this particular thin film system is aimed to be applied in small sensor devices or in electrodes for biosignal acquisition, such as those for electroencephalography or electromyography as it is the case of the main research area that is being developed in the group.

Factors associated with the donation and non-donation of embryos for research: a systematic review

Background: Systematic knowledge on the factors that influence the decisions of IVF users regarding embryo donation for research is a core need for patient-centred policies and ethics in clinical practice. However, no systematic review has been provided on the motivations of patients who must decide embryo disposition. This paper fills this gap, presenting a systematic review of quantitative and qualitative studies, which synthesizes the current body of knowledge on the factors and reasons associated with IVF patients’ decisions to donate or not to donate embryos for research. Methods: A systematic search of studies indexed in PubMed, ISIWoK and PsycINFO, published before November 2013, was conducted. Only empirical, peer-reviewed, full-length, original studies reporting data on factors and reasons associated with the decision concerning donation or non-donation of embryos for research were included. Eligibility and data extraction were performed by two independent researchers and disagreements were resolved by discussion or a third reviewer, if required. The main quantitative findings were extracted and synthesized and qualitative data were assessed by thematic content analysis. Results: A total of 39 studies met the inclusion criteria and were included in the review. More than half of the studies (n ¼ 21) used a quantitative methodology, and the remaining were qualitative (n ¼ 15) or mixed-methods (n ¼ 3) studies. The studies were derived mainly from European countries (n ¼ 18) and the USA(n ¼ 11). The proportion of IVF users who donated embryos for research varied from 7% in a study in France to 73% in a Swiss study. Those who donate embryos for research reported feelings of reciprocity towards science and medicine, positive views of research and high levels of trust in the medical system. They described their decision as better than the destruction of embryos and as an opportunity to help others or to improve health and IVF treatments. The perception of risks, the lack of information concerning research projects and the medical system and the conceptualization of embryos in terms of personhood were the most relevant motives for not donating embryos for research. Results relating to the influence of sociodemographic characteristics and reproductive and gynaecological history were mostly inconclusive. Conclusions: Three iterative and dynamic dimensions of the IVF patients’ decision to donate or not to donate embryos for research emerged from this review: the hierarquization of the possible options regarding embryo disposition, according to the moral, social and instrumental status attributed to embryos; patients’ understanding of expectations and risks of the research on human embryos; and patients’ experiences of information exchange and levels of trust in the medical-scientific institutions.