The influence of nitrogen and oxygen additions on the thermal characteristics of aluminium-based thin films

The ternary aluminium oxynitride (AlNxOy) system offers the possibility to obtain a wide range of properties by tailoring the ratio between pure Al, AlNx and AlOy and therefore opening a significant number of possible applications. In this work the thermal behaviour of AlNxOy thin films was analysed by modulated infrared radiometry (MIRR), taking as reference the binary AlOy and AlNx systems. MIRR is a non-contact and non-destructive thermal wave measurement technique based on the excitation, propagation and detection of temperature oscillations of very small amplitudes. The intended change of the partial pressure of the reactive gas (N2 and/or O2) influenced the target condition and hence the deposition characteristics which, altogether, affected the composition and microstructure of the films. Based on the MIRR measurements and their qualitative and quantitative interpretation, some correlations between the thermal transport properties of the films and their chemical/physical properties have been found. Furthermore, the potential of such technique applied in this oxynitride system, which present a wide range of different physical responses, is also discussed. The experimental results obtained are consistent with those reported in previous works and show a high potential to fulfil the demands needed for the possible applications of the systems studied. They are clearly indicative of an adequate thermal response if this particular thin film system is aimed to be applied in small sensor devices or in electrodes for biosignal acquisition, such as those for electroencephalography or electromyography as it is the case of the main research area that is being developed in the group.

The Portuguese programme one laptop per child: political, educational and social impact

In 2008, the XVII Portuguese Constitutional Government launched the ‘e.escolinha’ programme, within the Technological Plan for Education, which set out the distribution of a computer, called ‘Magalhães’, designed for chil-dren attending the 1st cycle of basic education. Suspended in 2011 by the XIX Government, this programme has allowed, however, almost 500 000 children to have access to a personal computer. It was expected that this political measure would “revolutionise” the national education system by bringing changes to the pedagogical practices of teachers and the learning processes of children and by achieving educational success, in general. Based on documental analysis and on a set of interviews with key decision-makers in conceiving, implementing and monitoring this governmental initiative, the fi rst part of this chapter presents and analyses the ‘e.escolinha’ initiative and the policies be-hind that governmental programme, seeking to disassemble those objectives and provide some insights into the relationship between discourses, rhetoric, and reality. After that, the chapter focuses on children’s uses and practices with the ‘Magalhães’ laptop, at school and at home. Based on the results of questionnaires fi lled in by approximately 1500 children from 32 First Cycle public schools of the municipality of Braga (north of Portugal) and also from questionnaires applied to their parents and teachers, this chapter intends to analyse the real impact of this initiative for children, family and school. It also seeks to discuss the contribution of this educational policy to children’s digital literacy and also to their own and their families’ social and digital inclusion. To understand if it represented an added value to teachers’ pedagogical practice is another of its aims. The fi ndings point out a major focus on technology and access rather than on uses and competences or even on social, educational and cultural change. In fact, a major conclusion is the existence of a strong gap between the policy and the practices, typical of a top-down policy design. This study is an integrant part of a research project titled “Navigating with ‘Magalhães’: Study on the Impact of Digital Media in Schoolchildren” conducted at the University of Minho, Portugal, financed by the Portuguese Foundation for Science and Technology [PTDC/CCI-COM/101381/2008] and co-funded by the European Regional Development Fund [COMPETE: FCOMP-01-0124-FEDER-009056].

Encapsulation and controlled release of bioactive compounds in lactoferrin-glycomacropeptide nanohydrogels : curcumin and caffeine as model compounds

Curcumin and caffeine (used as lipophilic and hydrophilic model compounds, respectively) were successfully encapsulated in lactoferrin-glycomacropeptide (Lf-GMP) nanohydrogels by thermal gelation showing high encapsulation efficiencies (>90 %). FTIR spectroscopy confirmed the encapsulation of bioactive compounds in Lf-GMP nanohydrogels and revealed that according to the encapsulated compound different interactions occur with the nanohydrogel matrix. The successful encapsulation of bioactive compounds in Lf-GMP nanohydrogels was also confirmed by fluorescence measurements and confocal laser scanning microscopy. TEM images showed that loaded nanohydrogels maintain their spherical shape with sizes of 112 and 126 nm for curcumin and caffeine encapsulated in Lf-GMP nanohydrogels, respectively; in both cases a polydispersity of 0.2 was obtained. The release mechanisms of bioactive compounds through Lf-GMP nanohydrogels were evaluated at pH 2 and pH 7, by fitting the Linear Superimposition Model to the experimental data. The bioactive compounds release was found to be pH-dependent: at pH 2, relaxation is the governing phenomenon for curcumin and caffeine compounds and at pH 7 Ficks diffusion is the main mechanism of caffeine release while curcumin was not released through Lf-GMP nanohydrogels.

Influence of chitosan coating on protein-based nanohydrogels properties and in vitro gastric digestibility

Chitosan coating was applied in Lactoferrin (Lf)-Glycomacropeptide (GMP) nanohydrogels by layer-by-layer coating process. A volume ratio of 0.1 of Lf-GMP nanohydrogels (0.2 mg.mL-1, at pH 5.0) to chitosan (1 mg.mL-1, at pH 3) demonstrated to be the optimal condition to obtain stable nanohydrogels with size of 230 ± 12 nm, a PdI of 0.22 ± 0.02 and a -potential of 30.0 ± 0.15 mV. Transmission electron microscopy (TEM) images showed that the application of chitosan coating in Lf-GMP did not affect the spherical shape of nanohydrogels and confirmed the low aggregation of nanohydrogels in solution. The analysis of chemical interactions between chitosan and Lf-GMP nanohydrogels were performed by Fourier transform infrared spectroscopy (FTIR) and by circular dichroism (CD) that revealed that a specific chemical interaction occurring between functional groups of protein-based nanohydrogels and active groups of the chitosan was established. The effect of chitosan coating on release mechanisms of Lf-GMP nanohydrogels at acid conditions (pH 2, 37 ºC) was evaluated by the encapsulation of a model compound (caffeine) in these systems. Linear Superposition Model was used to fit the experimental data and revealed that Fick and relaxation mechanisms are involved in caffeine release. It was also observed that the Fick contribution increase with the application of chitosan coating. In vitro gastric digestion was performed with Lf-GMP nanohydrogels and Lf-GMP nanohydrogels with chitosan coating and it was observed that the presence of chitosan improve the stability of Lf and GMP (proteins were hydrolysed at a slower rate and were present in solution by longer time). Native electrophoreses revealed that the nanohydrogels without coating remained intact in solution until 15 min and with chitosan coating remained intact until 60 min, during gastric digestion.