Low f-number microlenses for integration on optical microsystems

This paper presents microlenses (MLs) with low f-number made of AZ4562 photoresist for integration on optical microsystems. The fabrication process was based on the thermal reflow and rehydration. Large series of MLs were fabricated with a width of 35 μm, a thickness of 5 μm, and spaced apart by 3 μm. The MLs were fabricated directly on the surface of a die with type n+/p-substrate junction photodiode fabricated in a standard CMOS process. The measured focal length was 49 μm with a tolerance of ±2 μm (maximum error of ±4%), resulting in a numerical aperture of 33.6 × 10-2 (±1.3 × 10-2). The measurements also revealed an f-number of 1.4.

Optical properties of zirconium oxynitride films: the effect of composition, electronic and crystalline structures

tThis work is devoted to the investigation of zirconium oxynitride (ZrOxNy) films with varied opticalresponses prompted by the variations in their compositional and structural properties. The films wereprepared by dc reactive magnetron sputtering of Zr, using Ar and a reactive gas mixture of N2+ O2(17:3).The colour of the films changed from metallic-like, very bright yellow-pale and golden yellow, for low gasflows to red-brownish for intermediate gas flows. Associated to this colour change there was a significantdecrease of brightness. With further increase of the reactive gas flow, the colour of the samples changedfrom red-brownish to dark blue or even to interference colourations. The variations in composition dis-closed the existence of four different zones, which were found to be closely related with the variationsin the crystalline structure. XRD analysis revealed the change from a B1 NaCl face-centred cubic zirco-nium nitride-type phase for films prepared with low reactive gas flows, towards a poorly crystallizedover-stoichiometric nitride phase, which may be similar to that of Zr3N4with some probable oxygeninclusions within nitrogen positions, for films prepared with intermediate reactive gas flows. For highreactive gas flows, the films developed an oxynitride-type phase, similar to that of -Zr2ON2with someoxygen atoms occupying some of the nitrogen positions, evolving to a ZrO2monoclinic type structurewithin the zone where films were prepared with relatively high reactive gas flows. The analysis carriedout by reflected electron energy loss spectroscopy (REELS) revealed a continuous depopulation of thed-band and an opening of an energy gap between the valence band (2p) and the Fermi level close to 5 eV.The ZrN-based coatings (zone I and II) presented intrinsic colourations, with a decrease in brightness anda colour change from bright yellow to golden yellow, red brownish and dark blue. Associated to thesechanges, there was also a shift of the reflectivity minimum to lower energies, with the increase of thenon-metallic content. The samples lying in the two last zones (zone III, oxynitride and zone IV, oxide films)revealed a typical semi-transparent-optical behaviour showing interference-like colourations only dueto the complete depopulation of the d band at the Fermi level. The samples lying in these zones presentedalso an increase of the optical bandgap from 2 to 3.6 eV.

Efeito da adição de Zr no endurecimento de ligas Al-Sc

Dissertação de mestrado integrado em Engenharia de Materiais

Novas funcionalidades para dispositivos médicos invasivos com imagem

Tese de Doutoramento em Engenharia Eletrónica e de Computadores.

Design of bio-based supramolecular structures through self-assembly of α-lactalbumin and lysozyme

Bovine α-lactalbumin (α-La) and lysozyme (Lys), two globular proteins with highly homologous tertiary structures and opposite isoelectric points, were used to produce bio-based supramolecular structures under various pH values (3, 7 and 11), temperatures (25, 50 and 75 °C) and times (15, 25 and 35 min) of heating. Isothermal titration calorimetry experiments showed protein interactions and demonstrated that structures were obtained from the mixture of α-La/Lys in molar ratio of 0.546. Structures were characterized in terms of morphology by transmission electron microscopy (TEM) and dynamic light scattering (DLS), conformational structure by circular dichroism and intrinsic fluorescence spectroscopy and stability by DLS. Results have shown that protein conformational structure and intermolecular interactions are controlled by the physicochemical conditions applied. The increase of heating temperature led to a significant decrease in size and polydispersity (PDI) of α-La–Lys supramolecular structures, while the increase of heating time, particularly at temperatures above 50 °C, promoted a significant increase in size and PDI. At pH 7 supramolecular structures were obtained at microscale – confirmed by optical microscopy – displaying also a high PDI (i.e. > 0.4). The minimum size and PDI (61 ± 2.3 nm and 0.14 ± 0.03, respectively) were produced at pH 11 for a heating treatment of 75 °C for 15 min, thus suggesting that these conditions could be considered as critical for supramolecular structure formation. Its size and morphology were confirmed by TEM showing a well-defined spherical form. Structures at these conditions showed to be stable at least for 30 or 90 days, when stored at 25 or 4 °C, respectively. Hence, α-La–Lys supramolecular structures showed properties that indicate that they are a promising delivery system for food and pharmaceutical applications.

Transmission and progression to disease of Mycobacterium tuberculosis phylogenetic lineages in The Netherlands

The aim of this study was to determine if mycobacterial lineages affect infection risk, clustering, and disease progression among Mycobacterium tuberculosis cases in The Netherlands. Multivariate negative binomial regression models adjusted for patient-related factors and stratified by patient ethnicity were used to determine the association between phylogenetic lineages and infectivity (mean number of positive contacts around each patient) and clustering (as defined by number of secondary cases within 2 years after diagnosis of an index case sharing the same fingerprint) indices. An estimate of progression to disease by each risk factor was calculated as a bootstrapped risk ratio of the clustering index by the infectivity index. Compared to the Euro-American reference, Mycobacterium africanum showed significantly lower infectivity and clustering indices in the foreign-born population, while Mycobacterium bovis showed significantly lower infectivity and clustering indices in the native population. Significantly lower infectivity was also observed for the East African Indian lineage in the foreign-born population. Smear positivity was a significant risk factor for increased infectivity and increased clustering. Estimates of progression to disease were significantly associated with age, sputum-smear status, and behavioral risk factors, such as alcohol and intravenous drug abuse, but not with phylogenetic lineages. In conclusion, we found evidence of a bacteriological factor influencing indicators of a strain's transmissibility, namely, a decreased ability to infect and a lower clustering index in ancient phylogenetic lineages compared to their modern counterparts. Confirmation of these findings via follow-up studies using tuberculin skin test conversion data should have important implications on M. tuberculosis control efforts.

La carte postale et la représentation des espaces public et intime

La carte postale est un kaléidoscope de vues, d’ornements et de couleurs, qui consacre un tout petit espace au message. C’est à la photographie et aux procédés de reproduction photomécaniques que revient le mérite d’avoir industrialisé la production de la carte postale. Et ce sont les clichés de villes, avec leurs monuments et leurs paysages, qui confèrent à la carte postale son statut de moyen de communication de masse et qui lui concèdent une affinité avec l’industrie du tourisme. La carte postale s’est ainsi emparée de l’ambition photographique de reproduire le monde, s’alliant aux « besoins de l’exploration, des expéditions et des relevés topographiques » du médium photographique à ses débuts. Ayant comme point de départ la carte postale, notre objectif est de montrer les conséquences culturelles de la révolution optique, commencée au milieu du XIXe siècle, avec l’invention de l’appareil photo, et consumée dans la seconde moitié du XXe siècle, avec l’apparition de l’ordinateur. En effet, depuis l’apparition de l’appareil photographique et des cartes postales jusqu’au flux de pixels de Google Images et aux images satellite de Google Earth, un entrelacement de territoire, puissance et technique a été mis en oeuvre, la terre devenant, en conséquence, de plus en plus auscultée par les appareils de vision, ce qui impacte sur la perception de l’espace. Nous espérons pouvoir montrer avec cette étude que la lettre traditionnelle est à l’email ce que la carte postale est au post que l’on publie dans un blog ou dans des réseaux comme Facebook et Twitter. À notre sens, les cartes postales correspondent à l’ouverture maximale du système postal moderne, qui d’universel devient dépendant et partie intégrante des réseaux télématiques d’envoi. Par elles sont annoncés, en effet, la vitesse de transmission de l’information, la brièveté de la parole et l’hégémonie de la dimension imagétique du message, et pour finir, l’embarras provoqué par la fusion de l’espace public avec l’espace privé.

Contribution to an efficient transmission of information to the textile fashion consumer and the influence in sustainable attitudes

The concepts involved in sustainable textile fashion, demanding good knowledge about raw materials, processes, end use properties and circuits amongst others, are able to determine the way the textile product is designed and the behavior of the consumer, regarding life style and buying decisions. The textile product`s life integrates raw materials, their processing, distribution, use by the consumer and destination of the product after useful lifetime, this is, his complete life cycle. It is very important to recognize the power of the consumer to influence parameters related to sustainability, namely when he decides how, when and why he buys and afterwards by the attitudes taken during and after use. The conscious act of consumption involves ethical, ecological and technical knowledge in which the concern is overall lifecycle of the fashion product and not exclusively aesthetic and symbolic values strongly related with its ephemeral nature. The present work proposes the classification of textile products by means of an innovative label aiming to establish a rating related to the Life of Fashion Products, by using parameters considered with especial impact in lifecycle, as textile fibers, processing conditions, generated wastes, commercialization circuits, durability and cleaning procedures. This label for sustainable fashion products aims to assist the stakeholders with informed attitudes and correct decisions in order to promote the objectives of sustainable fashion near designers, consumers and industrial experts.

In-line rheo-optical microstructural characterization of complex polymer systems

Tese de Doutoramento em Ciência e Engenharia de Polímeros e Compósitos.