Ultra high pressure homogenization (UHPH) inactivation of Bacillus amyloliquefaciens spores in phosphate buffered saline (PBS) and milk

Ultra high pressure homogenization (UHPH) opens up new areas for dynamic high pressure assisted thermal sterilization of liquids. Bacillus amyloliquefaciens spores are resistant to high isostatic pressure and temperature and were suggested as potential surrogate for high pressure thermal sterilization validation. B. amyloliquefaciens spores suspended in PBS buffer (0.01 M, pH 7.0), low fat milk (1.5%, pH 6.7), and whole milk (3.5%, pH 6.7) at initial concentration of similar to 10(6) CFU/mL were subjected to UHPH treatments at 200, 300, and 350 MPa with an inlet temperature at similar to 80 degrees C. Thermal inactivation kinetics of B. amyloliquefaciens spores in PBS and milk were assessed with thin wall glass capillaries and modeled using first-order and Weibull models. The residence time during UHPH treatments was estimated to determine the contribution of temperature to spore inactivation by UHPH. No sublethal injury was detected after UHPH treatments using sodium chloride as selective component in the nutrient agar medium. The inactivation profiles of spores in PBS buffer and milk were compared and fat provided no clear protective effect for spores against treatments. Treatment at 200 MPa with valve temperatures lower than 125 degrees C caused no reduction of spores. A reduction of 3.5 log(10)CFU/mL of B. amyloliquefaciens spores was achieved by treatment at 350 MPa with a valve temperature higher than 150 degrees C. The modeled thermal inactivation and observed inactivation during UHPH treatments suggest that temperature could be the main lethal effect driving inactivation.

Die Feldspatgehalte quartärzeitlicher Sande Niedersachsens

The feldspar contents of 373 samples from quaternary sands of Lower Saxony (West Germany) were determined. The samples were taken in all parts of Lower Saxony and represent a selec- tion of quaternary Sediments of different age and genetic origin. 7 different methods of investigation were tested to determine the content of feldspar both qualitative and quantitative. Polarizing mioroscopy, x-ray diffractometry, Chemical analysis and staining fit these aims best. The most important results of these investigations are: - The quarternary Lower Saxonian sands have an average content of 4.4 weight-% potassium feldspars and 0.8 weight-% plagio- clase. - All tested samples have a similar qualitative feldspar compo- sition. There are monocline, tricline and - more rare - per- thitic potassium feldspars with a rather high (greater 80 %) KAlSi3O8 content. From the plagioclase feldspars only albite, oligoclase and little andesine were indicated. - The potassium feldspar content is higher in each sample than the plagioclase content. - The feldspar content depends on age and genetic origin of each sand. Generally spoken the feldspar content lessens with increasing age. Glaciofluviatile and basin sands usually have a higher feldspar content than fluvial or aeolian sands of the same age. - The feldspar content is highly influenced by grain size com- position. A minimum of feldspar content lies between 0.4 and 1 .0 mm grain size. Fine sands usually have a higher feldspar content than coarse sands. The reason for this phenomenon is weathering. - There are no regional differences in the amount of feldspar content. - The feldspar content is not high enough for commercial mining.