An alkaline direct borohydride fuel cell with hydrogen peroxide as oxidant

A novel alkaline direct borohydride fuel cell (ADBFC) using varying concentrations of hydrogen peroxide as oxidant and sodium borohydride with sodium hydroxide, each of differing concentration, as fuel is reported. A peak power density of ca. 150 in W cm(-2) at a cell voltage of 540 mV can be achieved from the optimized ADBFC operating at 70 degrees C. (c) 2004 Elsevier B.V. All rights reserved.

An alkaline direct borohydride fuel cell with hydrogen peroxide as oxidant

A novel alkaline direct borohydride fuel cell (ADBFC) using varying concentrations of hydrogen peroxide as oxidant and sodium borohydride with sodium hydroxide, each of differing concentration, as fuel is reported. A peak power density of ca. 150 in W cm(-2) at a cell voltage of 540 mV can be achieved from the optimized ADBFC operating at 70 degrees C. (c) 2004 Elsevier B.V. All rights reserved.

Peroxo-bridged divanadate as selective bromide oxidant in bromoperoxidation

Diperoxovanadate is effective only in presence of free vanadate in vanadium-dependent bromoperoxidation at physiological pH. Peroxide in the form of bridged divanadate complex (VOOV-type), but not the bidentate form as in diperoxovanadate, is proposed to be the oxidant of bromide. In order to obtain direct evidence, peroxo-divanadate complexes with glycyl-glycine, glycyl-alanine and glycyl-asparagine as heteroligands were synthesized. By elemental analysis and spectral studies they were characterized to be triperoxo-divanadates, [V2O2(O-2)(3)(peptide)(3)]. H2O, with the two vanadium atoms bridged by a peroxide and a heteroligand. The dipeptide seems to stabilize the peroxo-bridge by inter-ligand interaction, possibly hydrogen bonding. This is indicated by rapid degradation of these compounds on dissolving in water with partial loss of peroxide accompanied by release of bubbles of oxygen. The V-51-NMR spectra of such solutions showed diperoxovanadate and decavanadate (oligomerized from vanadate) as the products. Additional oxygen was released on treating these solutions with catalase as expected of residual diperoxovanadate. The solid compounds when added to the reaction mixtures showed transient, rapid bromoperoxidation reaction, but not oxidation of NADH or inactivation of glucose oxidase, the other two activities shown by a mixture of diperoxovanadate and vanadyl. This demonstration of peroxide-bridged divanadate as powerful, selective oxidant of bromide, active at physiological pH, should make it a possible candidate of mimic in the action of vanadium in bromoperoxidase proteins.

An oxidative cross-dehydrogenative-coupling reaction in water using molecular oxygen as the oxidant: vanadium catalyzed indolation of tetrahydroisoquinolines

An aerobic oxidative cross-dehydrogenative coupling reaction between sp(3) C-H and sp(2) C-H bonds is developed by employing a vanadium catalyst (10 mol%) in an aqueous medium using molecular oxygen as the oxidant. This environmentally benign strategy exhibits larger substrate scope and shows high regioselectivity.

nvestigations on the Stability and Extinction of a Laminar Diffusion Flame Over a Porous Flat Plate

The limits of stability and extinction of a laminar diffusion flame have been experimentally studied in a two-dimensional laminar boundary layer over a porous flat plate through which n-pentane vapour was uniformly injected. The stability and extinction boundaries are mapped on a plot of free stream oxidant velocity versus fuel injection velocity. Effects of free stream temperature and of dilution of fuel and oxidant on these boundaries have been examined. The results show that there exists a limiting oxidant flux beyond which the diffusion flame cannot be sustained. This limiting oxidant flux has been found to depend_on the free stream oxygen concentration, fuel concentration and injection'velocity of the fuel.

Reactivity of µ-Peroxo-Bridged Dimeric Vanadate in Bromoperoxidation

Diglycyl triperoxodivanadate [V2O2(O2)3(Gly H)2(H2O)2], a synthetic compound with μ-peroxo-bridge derived from H2O2and vanadate, oxidized bromide to a bromination-competent intermediate in phosphate buffer and physiological pH. This is in contrast to the requirement of acid medium with H2O2as the oxidant. Addition of its solid to bromide solution instantly produced a 262-nm-absorbing compound that converted phenol red (a trap) to its 592-nm-absorbing bromo-derivative. The high bromination activity was lost on dissolving this compound in water and the solution showed the presence of peroxovanadates (mono and di) and vanadates (V1and oligomeric V10) in51V-NMR spectrum. Of these, diperoxovanadate and vanadate together supported slow bromination activity by a second set of reactions including bromide-assisted reductive formation of vanadyl. Bromination activity dependent on vanadyl was sensitive to oxidation by excess H2O2and to complexation by EDTA, whereas that of triperoxodivanadate was relatively insensitive. Vanadyl and diperoxovanadate are capable of forming a μ-peroxo-bridged complex that is essentially similar to the synthetic vanadate dimer used in the present experiments. It appears that a μ-peroxo-intermediate is the proximal oxidant of bromide in vanadium-catalyzed bromoperoxidation.

Role of the Central Metal Ion and Ligand Charge in the DNA Binding and Modification by Metallosalen Complexes

Several metal complexes of three different functionalized salen derivatives have been synthesized. The salens differ in terms of the electrostatic character and the location of the charges. The interactions of such complexes with DNA were first investigated in detail by UV−vis absorption titrimetry. It appears that the DNA binding by most of these compounds is primarily due to a combination of electrostatic and other modes of interactions. The melting temperatures of DNA in the presence of various metal complexes were higher than that of the pure DNA. The presence of additional charge on the central metal ion core in the complex, however, alters the nature of binding. Bis-cationic salen complexes containing central Ni(II) or Mn(III) were found to induce DNA strand scission, especially in the presence of co-oxidant as revealed by plasmid DNA cleavage assay and also on the basis of the autoradiogram obtained from their respective high-resolution sequencing gels. Modest base selectivity was observed in the DNA cleavage reactions. Comparisons of the linearized and supercoiled forms of DNA in the metal complex-mediated cleavage reactions reveal that the supercoiled forms are more susceptible to DNA scission. Under suitable conditions, the DNA cleavage reactions can be induced either by preformed metal complexes or by in situ complexation of the ligand in the presence of the appropriate metal ion. Also revealed was the fact that the analogous complexes containing Cu(II) or Cr(III) did not effect any DNA strand scission under comparable conditions. Salens with pendant negative charges on either side of the precursor salicylaldehyde or ethylenediamine fragments did not bind with DNA. Similarly, metallosalen complexes with net anionic character also failed to induce any DNA modification activities.

Poly (vinyl alcohol) hydrogel membrane as electrolyte for direct borohydride fuel cells

A direct borohydride fuel cell (DBFC) employing a poly (vinyl alcohol)hydrogel membrane electrolyte (PHME) is reported. The DBFC employs an AB(5) Misch metal alloy as anode and a goldplated stainless steel mesh as cathode in conjunction with aqueous alkaline solution of sodium borohydride as fuel and aqueous acidified solution of hydrogen peroxide as oxidant. Room temperature performances of the PHME-based DBFC in respect of peak power outputs; ex-situ cross-over of oxidant, fuel,anolyte and catholyte across the membrane electrolytes; utilization efficiencies of fuel and oxidant, as also cell performance durability are compared with a similar DBFC employing a NafionA (R)-117 membrane electrolyte (NME). Peak power densities of similar to 30 and similar to 40 mW cm(-2) are observed for the DBFCs with PHME and NME, respectively. The crossover of NaBH4 across both the membranes has been found to be very low. The utilization efficiencies of NaBH4 and H2O2 are found to be similar to 24 and similar to 59%, respectively for the PHME-based DBFC; similar to 18 and similar to 62%, respectively for the NME-based DBFC. The PHME and NME-based DBFCs exhibit operational cell potentials of similar to 1 center dot 2 and similar to 1 center dot 4 V, respectively at a load current density of 10 mA cm(-2) for similar to 100 h.

Two highly unsymmetrical tetradentate (N3O) Schiff base copper(II) complexes: Template synthesis, structural characterization, magnetic and computational studies

Two new copper(II) complexes, [Cu-2(L-1)(2)](ClO4)(2) (1) and [Cu(L-2)(ClO4)] (2), of the highly unsymmetrical tetradentate (N3O) Schiff base ligands HL1 and HL2 (where HL1 = N-(2-hydroxyacetophenone)-bis-3-aminopropylamine and HL2 = N-(salicyldehydine)-bis-3-aminopropylamine) have been synthesised using a template method. Their single crystal X-ray structures show that in complex 1 two independent copper(II) centers are doubly bridged through sphenoxo-O atoms (O1A and O1B) of the two ligands and each copper atom is five-coordinated with a distorted square pyramidal geometry. The asymmetric unit of complex 2 consists of two crystallographically independe N-(salicylidene) bis(aminopropyl)amine-copper(II) molecules, A and B, with similar square pyramidal geometries. Cryomagnetic susceptibility measurements (5-300 K) on complex 1 reveal a distinct antiferromagnetic interaction with J=-23.6 cm(-1), which is substantiated by a DFT calculation (J=-27.6 cm(-1)) using the B3LYP functional. Complex 1, immobilized over highly ordered hexagonal mesoporous silica, shows moderate catalytic activity for the epoxidation of cyclohexene and styrene in the presence of TBHP as an oxidant.

On the ignition and extinction problems in forced convection systems

In this paper the problem of ignition and extinction has been formulated for the flow of a compressible fluid with Prandtl and Schmidt numbers taken as unity. In particular, the problems of (i) a jet impinging on a wall of combustible material and (ii) the opposed jet diffusion flame have been studied. In the wall jet case, three approximations in the momentum equation namely, (i) potential flow, (ii) viscous flow, (ii) viscous incompressible with k = 1 and (iii) Lees' approximation (taking pressure gradient terms zero) are studied. It is shown that the predictions of the mass flow rates at extinction are not very sensitive to the approximations made in the momentum equation. The effects of varying the wall temperature in the case (i) and the jet temperature in the case (ii) on the extinction speeds have been studied. The effects of varying the activation energy and the free stream oxidant concentration in case (ii), have also been investigated.

New benzidine procedure for determination of manganese in biological samples

A simple and accurate method for the determination of 0.25 to 1.0 μg. of manganese (in samples containing 1 to 4 μg. of manganese) has been developed by modifying the conditions for the reaction between permanganate and benzidine. Manganese is oxidized with potassium periodate in orthophosphoric acid and selectively estimated in the presence of excess oxidant with benzidine in formic acid. The procedure is applicable for estimation of manganese in biological samples, with recoveries in the range 97.5 to 106.1%.

Potentiometric titrations in nonaqueous cerimetry

Potassium iodide and hydroquinone can be estimated potentiometrically in nonaqueous medium using ammonium nitrato cerate as oxidant. A platinum indicator electrode coupled with either a glass electrode or an antimony electrode as reference electrode, can be used in nonaqueous medium satisfactorily, for following the potentiometric titration. Direct potentiometric titration of xanthate with ammonium nitrato cerate in nonaqueous medium yields slightly lower values than the actual values in presence of platinum indicator electrode.

Determination of carbon disulphide by chloramine-T

Carbon disulphide, on treatment with alcoholic potash, can readily be oxidised quantitatively by chloramine-T, converting all the sulphur to sulphuric acid. Fourteen equivalents of the oxidant are consumed for every mole of carbon disulphide. Since excess of chloramine-T may be determined iodimetrically, this reaction may be used for the determination of carbon disulphide. It may also be applied to the determination of xanthates.

Chronopotentiometry with power-law perturbation functions at an expanding plane electrode with and without a preceding blank period for systems with a coupled first-order homogeneous chemical reaction

The systems formalism is used to obtain the interfacial concentration transients for power-law current input at an expanding plane electrode. The explicit results for the concentration transients obtained here pertain to arbitrary homogeneous reaction schemes coupled to the oxidant and reductant of a single charge-transfer step and the power-law form without and with a preceding blank period (for two types of power-law current profile, say, (i) I(t) = I0(t−t0)q for t greater-or-equal, slanted t0, I(t) = 0 for t < t0; and (ii) I(t) = I0tq for t greater-or-equal, slanted t0, I(t) = 0 for t < t0). Finally the potential transients are obtained using Padé approximants. The results of Galvez et al. (for E, CE, EC, aC) (J. Electroanal. Chem., 132 (1982) 15; 146 (1983) 221, 233, 243), Molina et al. (for E) (J. Electroanal. Chem., 227 (1987) 1 and Kies (for E) (J. Electroanal. Chem., 45 (1973) 71) are obtained as special cases.

Synthesis, characterization and antioxidant activity of angiotensin converting enzyme inhibitors

Angiotensin converting enzyme (ACE) catalyzes the conversion of angiotensin I (Ang I) to angiotensin II (Ang II). ACE also cleaves the terminal dipeptide of vasodilating hormone bradykinin (a nonapeptide) to inactivate this hormone. Therefore, inhibition of ACE is generally used as one of the methods for the treatment of hypertension. `Oxidative stress' is another disease state caused by an imbalance in the production of oxidants and antioxidants. A number of studies suggest that hypertension and oxidative stress are interdependent. Therefore, ACE inhibitors having antioxidant property are considered beneficial for the treatment of hypertension. As selenium compounds are known to exhibit better antioxidant behavior than their sulfur analogues, we have synthesized a number of selenium analogues of captopril, an ACE inhibitor used as an antihypertensive drug. The selenium analogues of captopril not only inhibit ACE activity but also effectively scavenge peroxynitrite, a strong oxidant found in vivo.