Two-Phase Metallic Thermal Interface Materials Processed Through Liquid Phase Sintering Followed by Accumulative Roll Bonding

Thermal interface materials (TIMs) form a mechanical and thermal link between a heat source and a heat sink. Thus, they should have high thermal conductivity and high compliance to efficiently transfer heat and accommodate any differential strain between the heat source and the sink, respectively. This paper reports on the processing and the characterization of potential metallic TIM composite solders comprising of Cu, a high conductivity phase, uniformly embedded in In matrix, a highly compliant phase. We propose the fabrication of such a material by a two-step fabrication technique comprising of liquid phase sintering (LPS) followed by accumulative roll bonding (ARB). To demonstrate the efficacy of the employed two-step processing technique, an In-40 vol. % Cu composite solder was produced first using LPS with short sintering periods (30 or 60 s at 160 degrees C) followed by ARB up to five passes, each pass imposing a strain of 50%. Mechanical response and electrical and thermal conductivities of the fabricated samples were evaluated. It was observed that processing through ARB homogenizes the distribution of Cu in an In matrix, disintegrates the agglomerates of Cu powders, and also significantly increases thermal and electrical conductivities, almost attaining theoretically predicted values, without significantly increasing the flow stress. Furthermore, the processing technique also allows the insertion of desired foreign species, such as reduced graphene oxide, in In-Cu for further enhancing a target property, such as electrical conductivity.

Averting biodiversity collapse in tropical forest protected areas

The rapid disruption of tropical forests probably imperils global biodiversity more than any other contemporary phenomenon(1-3). With deforestation advancing quickly, protected areas are increasingly becoming final refuges for threatened species and natural ecosystem processes. However, many protected areas in the tropics are themselves vulnerable to human encroachment and other environmental stresses(4-9). As pressures mount, it is vital to know whether existing reserves can sustain their biodiversity. A critical constraint in addressing this question has been that data describing a broad array of biodiversity groups have been unavailable for a sufficiently large and representative sample of reserves. Here we present a uniquely comprehensive data set on changes over the past 20 to 30 years in 31 functional groups of species and 21 potential drivers of environmental change, for 60 protected areas stratified across the world's major tropical regions. Our analysis reveals great variation in reserve `health': about half of all reserves have been effective or performed passably, but the rest are experiencing an erosion of biodiversity that is often alarmingly widespread taxonomically and functionally. Habitat disruption, hunting and forest-product exploitation were the strongest predictors of declining reserve health. Crucially, environmental changes immediately outside reserves seemed nearly as important as those inside in determining their ecological fate, with changes inside reserves strongly mirroring those occurring around them. These findings suggest that tropical protected areas are often intimately linked ecologically to their surrounding habitats, and that a failure to stem broad-scale loss and degradation of such habitats could sharply increase the likelihood of serious biodiversity declines.

Slow rotation of a sphere in a non-Newtonian fluid with or without suction or injection

The flow generated by the rotation of a sphere in an infinitely extending fluid has recently been studied by Goldshtik. The corresponding problem for non-Newtonian Reiner-Rivlin fluids has been studied by Datta. Bhatnagar and Rajeswari have studied the secondary flow between two concentric spheres rotating about an axis in the non-Newtonian fluids. This last investigation was further generalised by Rajeswari to include the effects of small radial suction or injection. In Part A of the present investigation, we have studied the secondary flow generated by the slow rotation of a single sphere in non-Newtonian fluid obeying the Rivlin-Ericksen constitutive equation. In Part B, the effects of small suction or injection have been studied which is applied in an arbitrary direction at the surface of the sphere. In the absence of suction or injection, the secondary flow for small values of the visco-elastic parameter is similar to that of Newtonian fluids with inclusion of inertia terms in the Oseen approximation. If this parameter exceeds Kc = 18R/219, whereR is the Reynolds number, the breaking of the flow field takes place into two domains, in one of which the stream lines form closed loops. For still higher values of this parameter, the complete reversal of the sense of the flow takes place. When suction or injection is included, the breaking of the flow persists under certain condition investigated in this paper. When this condition is broken, the breaking of the flow is obliterated.

Investigation of novel cuprates of the TlCa1-xLnxSr2Cu2O7- δ (Ln=rare earth) series showing electron- or hole-superconductivity depending on the composition

Superconductivity in cuprates of the general formula TlCa1-xLnxSr2Cu2O7+ delta has been investigated as a function of Ln and x. Compositions with 0.25<or=x<or=0.8 are superconducting for all Ln with Tc in the range 60-90 K (except when Ln=Yb where x=1 is also superconducting); the value of the Tc varies with x as well as Ln. When x approximately=0.25, electrons are the majority charge carriers, while holes are the majority carrier when x >0.25. Thus, these cuprates exhibit a composition-dependent electron- or hole-superconductivity. In the normal state, most of the members of the series traverse compositionally determined metal-insulator transitions. High-energy spectroscopies show the presence of Cu in the 1+ and 2+ states. The Raman frequency around 525 cm-1 characteristic of the Tl-O2-Cu linkage is sensitive to both Ln and x, indicating a possible involvement in the mechanism of superconductivity.

Correlated electronic states of C-60 fragments

We have studied electronic states of various fragments of C-60 within the Pariser-Parr-Pople (PPP) model and have obtained structural, magnetic and spectral properties of these molecules. The fragments studied include corannulene, fluoranthene and pyracylene. Pyracylene is studied using the exact valence bond (VB) approach while fluoranthene and corannulene are studied using a novel restricted CI technique which employs molecular orbitals for constructing the VB functions. The electronic excitations, bond order and ring currents are calculated for these systems. From these studies, the wide range of absorptions in C-60 can be viewed as those localized on pyracylene units or on the corannulene/fluoranthene units. The bond orders and ring currents show the hexagons to be similar to benzene rings. The pentagon-hexagon bonds are also found to be longer than the hexagon-hexagon bonds.

Nitrogen Derivatives Of C-60 And C-70 - Interaction Of Fullerenes With Nitrogen In Gas-Phase

Mass spectrometric studies show that contact-arc vaporization of graphite in a partial atmosphere of N2 or NH3 yields nitrogenous products tentatively assigned to species such as C70N2, C59N6, C59N4 and C59N2 involving addition of or substitution by nitrogen along with the species due to C2 and C4 losses. Mass spectrometry and other techniques have been employed to identify products of the nucleophilic addition of aliphatic amines to C60 and C70 in solution phase.

Electrical switching studies on AS(40)Te(60-x)Se(x) and As35Te65-xSex glasses

The I-V characteristics of bulk As40Te60-xSex and As35Te65-xSex glasses have been studied with a current sweep of 0-18 mA-0, over a wide range of compositions (4 less than or equal to x less than or equal to 22). All the glasses studied showed a threshold electrical switching behaviour. The number of switching cycles withstood by the samples has been found to depend on the ON-state current. It is seen that the switching voltages increase with increase in selenium content. Further, the switching voltages are found to be almost independent of the thickness of the sample (d), in the range 0.18-0.3 mm. Also, the switching voltages and the number of switching cycles withstood by the samples are found to decrease with temperature.

Anderson transitions in Ln1-x Sr x CoO3 (Ln═Pr or Nd)

Electrical conductivity measurements show that Ln1-x Sr x CoO3, (Ln = Pr or Nd) undergoes a non-metal-metal transition when x≈0 3. The d.c. conductivity of compositions with 0or a change in the mechanism of conduction (around 350 K) from variable range hopping to transport at E c. All these transport properties suggest that Co4+ ions in Ln1-x Sr x CoO3 (0orm a degenerate gas and that the states at the Fermi energy are Anderson localized.

Tetrathiomolybdate-Mediated Ring Opening of Isatoic Anhydrides: An Entry to S-Alkyl or S-Aryl 2-Aminobenzenecarbothioate Derivatives

Decarboxylative thioesterification of isatoic anhydrides mediated by benzyl(triethyl)ammonium tetrathiomolybdate gave the corresponding S-alkyl or S-aryl 2-aminobenzenecarbothioate derivatives at 60 degrees C. At ambient temperature, organic disulfides were reductive cleaved in the presence of tetrathiomolybdate to generate thiolate anions in situ; this was followed by attack on isatoic anhydrides to give the corresponding S-alkyl or S-aryl 2-aminobenzenecarbothioate derivatives. Additionally, it was shown that multistep reactions could be performed with tetrathiomolybdate, starting with an alkyl halide as a precursor of an alkyl disulfide, which, in turn, was used for ring opening of isatoic anhydrides.