Confined concrete—Its application in R.C. beams and frames

Stress-strain characteristics of concrete confined in steel binders have been determined. A new factor “confinement index” has been introduced for a quantitative measure of the confinement and using these results a “stress-block” has been developed. Tests have been made on simply supported reinforced concrete beams with spiral binder confinement and analysed on the basis of the proposed stress-block. Tests have also been made oon reinforced concrete portal frames and continuous beams with spiral binder confinement at sections of possible plastic hinge formation. An analysis of these tests indicates that a full redistribution of moments has taken place at ultimate.

Stereoelectronic control of Cope rearrangement energetics through remote double bonds in novel, rigid polycyclic frames

The presence and orientation of remote double bonds are shown to completely alter the shapes of Cope rearrangement energy profiles in a heptacyclic system.

Grassmannian fusion frames and its use in block sparse recovery

Tight fusion frames which form optimal packings in Grassmannian manifolds are of interest in signal processing and communication applications. In this paper, we study optimal packings and fusion frames having a specific structure for use in block sparse recovery problems. The paper starts with a sufficient condition for a set of subspaces to be an optimal packing. Further, a method of using optimal Grassmannian frames to construct tight fusion frames which form optimal packings is given. Then, we derive a lower bound on the block coherence of dictionaries used in block sparse recovery. From this result, we conclude that the Grassmannian fusion frames considered in this paper are optimal from the block coherence point of view. (C) 2013 Elsevier B.V. All rights reserved.

Linear filtering in DCT IV/DST IV and MDCT/MDST domain

In this paper, expressions for convolution multiplication properties of DCT IV and DST IV are derived starting from equivalent DFT representations. Using these expressions methods for implementing linear filtering through block convolution in the DCT IV and DST IV domain are proposed. Techniques developed for DCT IV and DST IV are further extended to MDCT and MDST where the filter implementation is near exact for symmetric filters and approximate for non-symmetric filters. No additional overlapping is required for implementing the symmetric filtering in the MDCT domain and hence the proposed algorithm is computationally competitive with DFT based systems. Moreover, inherent 50% overlap between the adjacent frames used for MDCT/MDST domain reduces the blocking artifacts due to block processing or quantization. The techniques are computationally efficient for symmetric filters and provides a new alternative to DFT based convolution.

Application of Maclaurin Series in Structural Analysis

In the simple theory of flexure of beams, the slope, bending moment, shearing force, load and other quantities are functions of a derivative of y with respect to x. It is shown that the elastic curve of a transversely loaded beam can be represented by the Maclaurin series. Substitution of the values of the derivatives gives a direct solution of beam problems. In this paper the method is applied to derive the Theorem or three moments and slope deflection equations. The method is extended to the solution of a rigid portal frame. Finally the method is applied to deduce results on which the moment distribution method of analyzing rigid frames is based.

Electron paramagnetic resonance study of vanadyl ion in K2Zn(SO4)2·6H2O and K2Mg(SO4)2·6H2O

EPR study of the vanadyl ion has been carried out in its paramagnetically dilute form in K2Zn(SO4)2·6H2O and K2Mg(SO4)2·6H2O at room temperature at X-band. The vanadyl ion enters the divalent metal site and preferentially orients itself in the direction of the water molecules forming the octahedron and forms the vanadyl sulfate pentahydrate complex. The g and A tensorscorresponding to the two populous V-O orientations have been analyzed to obtain the principal values and their direction cosines with respect to the crystallographics axes. It is found that the g and A tensor have the same principal frames of reference within the limits of eperimental error. A correlation between the metal-water distance and the populations of the different V-O orientations is observed.

Positional Preferences of Polypurine/Polypyrimidine Tracts in Saccharomyces cerevisiae Genome: Implications for cis Regulation of Gene Expression

The complete genome of the baker's yeast S. cerevisiae was analyzed for the presence of polypurine/polypyrimidine (poly[pu/py]) repeats and their occurrences were classified on the basis of their location within and outside open reading frames (ORFs). The analysis reveals that such sequence motifs are present abundantly both in coding as well as noncoding regions. Clear positional preferences are seen when these tracts occur in noncoding regions. These motifs appear to occur predominantly at a unit nucleosomal length both upstream and downstream of ORFs. Moreover, there is a biased distribution of polypurines in the coding strands when these motifs occur within open reading frames. The significance of the biased distribution is discussed with reference to the occurrence of these motifs in other known mRNA sequences and expressed sequence tags. A model for cis regulation of gene expression is proposed based on the ability of these motifs to form an intermolecular triple helix structure when present within the coding region and/or to modulate nucleosome positioning via enhanced histone affinity when present outside coding regions.

Bauer Method of MVDR Spectral Factorization for Pitch Modification in the Source Domain

In our earlier work [1], we employed MVDR (minimum variance distortionless response) based spectral estimation instead of modified-linear prediction method [2] in pitch modification. Here, we use the Bauer method of MVDR spectral factorization, leading to a causal inverse filter rather than a noncausal filter setup with MVDR spectral estimation [1]. Further, this is employed to obtain source (or residual) signal from pitch synchronous speech frames. The residual signal is resampled using DCT/IDCT depending on the target pitch scale factor. Finally, forward filters realized from the above factorization are used to get pitch modified speech. The modified speech is evaluated subjectively by 10 listeners and mean opinion scores (MOS) are tabulated. Further, modified bark spectral distortion measure is also computed for objective evaluation of performance. We find that the proposed algorithm performs better compared to time domain pitch synchronous overlap [3] and modified-LP method [2]. A good MOS score is achieved with the proposed algorithm compared to [1] with a causal inverse and forward filter setup.

Multiple support excitations of open-plane frames by a filtered white noise and soil-structure interaction

Seismic structural design is essentially the estimation of structural response to a forced motion, which may be deterministic or stochastic, imposed on the ground. The assumption that the same ground motion acts at every point of the base of the structure (or at every support) is not always justifiable; particularly in case of very large structures when considerable spatial variability in ground motion can exist over significant distances example long span bridges. This variability is partly due to the delay in arrival of the excitation at different supports (which is called the wave passage effect) and due to heterogeneity in the ground medium which results in incoherency and local effects. The current study examines the influence of the wave passage effect (in terms of delay in arrival of horizontal ground excitation at different supports and neglecting transmission through the structure) on the response of a few open-plane frame building structures with soil-structure interaction. The ground acceleration has been modeled by a suitably filtered white noise. As a special case, the ground excitation at different supports has also been treated as statistically independent to model the extreme case of incoherence due to local effects and due to modifications to the ground motion resulting from wave reflections and refractions in heterogeneous soil media. The results indicate that, even for relatively short spanned building frames, wave passage effect can be significant. In the absence of soil-structure interaction, it can significantly increase the root mean square (rms) value of the shear in extreme end columns for the stiffer frames but has negligible effect on the flexible frames when total displacements are considered. It is seen that pseudo-static displacements increasingly contribute to the rms value of column shear as the time delay increases both for the stiffer and for the more flexible frames. When soil-structure interaction is considered, wave passage effect (in terms of total displacements) is significant only for low soil shear modulus, G. values (where soil-structure interaction significantly lowers the fundamental frequency) and for stiff frames. The contribution of pseudo-static displacement to these rms values is found to decrease with increase in G. In general, wave passage effect for most interactive frames is insignificant compared to the attenuating effect a decrease in G, has on the response of the interactive structure to uniform support excitation. When the excitations at different supports are statistically independent, it is seen that for both the stiff and flexible frames, the rms value of the column shear in extreme end columns is several times larger (more for the stiffer frames) than the value corresponding to uniform base excitation with the pseudo-static displacements contributing over 99% of the rms value of column shear. Soil-structure interaction has an attenuating effect on the rms value of the column shear, the effect decreasing with increase in G,. Here too, the pseudo-static displacements contribute very largely to the column shear. The influence of the wave passage effect on the response of three 2-bay frames with and without soil-structure interaction to a recorded horizontal accelerogram is also examined. (C) 2010 Elsevier Ltd. All rights reserved.

New phase unwrapping strategy for rapid and dense 3D data acquisition in structured light approach

Sinusoidal structured light projection (SSLP) technique, specifically-phase stepping method, is in widespread use to obtain accurate, dense 3-D data. But, if the object under investigation possesses surface discontinuities, phase unwrapping (an intermediate step in SSLP) stage mandatorily require several additional images, of the object with projected fringes (of different spatial frequencies), as input to generate a reliable 3D shape. On the other hand, Color-coded structured light projection (CSLP) technique is known to require a single image as in put, but generates sparse 3D data. Thus we propose the use of CSLP in conjunction with SSLP to obtain dense 3D data with minimum number of images as input. This approach is shown to be significantly faster and reliable than temporal phase unwrapping procedure that uses a complete exponential sequence. For example, if a measurement with the accuracy obtained by interrogating the object with 32 fringes in the projected pattern is carried out with both the methods, new strategy proposed requires only 5 frames as compared to 24 frames required by the later method.

Cloning and sequence of a cDNA encoding a novel hybrid prolme-rich protein associated with cytokinin-induced haustoria formation in Cuscuta reflexa

A complete cDNA encoding a novel hybrid Pro-rich protein (HyPRP) was identified by differentially screening 3x10(4) recombinant plaques of a Cuscuta reflexa cytokinin-induced haustorial cDNA library constructed in lambda gt10. The nucleotide (nt) sequence consists of: (i) a 424-bp 5'-non coding region having five start codons (ATGs) and three upstream open reading frames (uORFs); (ii) an ORF of 987 bp with coding potential for a 329-amino-acid (aa) protein of M(r), 35203 with a hydrophobic N-terminal region including a stretch of nine consecutive Phe followed by a Pro-rich sequence and a Cys-rich hydrophobic C terminus; and (iii) a 178-bp 3'-UTR (untranslated region). Comparison of the predicted aa sequence with the NBRF and SWISSPROT databases and with a recent report of an embryo-specific protein of maize [Jose-Estanyol et al., Plant Cell 4 (1992) 413-423] showed it to be similar to the class of HyPRPs encoded by genes preferentially expressed in young tomato fruits, maize embryos and in vitro-cultured carrot embryos. Northern analysis revealed an approx. 1.8-kb mRNA of this gene expressed in the subapical region of the C. reflexa vine which exhibited maximum sensitivity to cytokinin in haustorial induction.

PocketAlign A Novel Algorithm for Aligning Binding Sites in Protein Structures

A fundamental task in bioinformatics involves a transfer of knowledge from one protein molecule onto another by way of recognizing similarities. Such similarities are obtained at different levels, that of sequence, whole fold, or important substructures. Comparison of binding sites is important to understand functional similarities among the proteins and also to understand drug cross-reactivities. Current methods in literature have their own merits and demerits, warranting exploration of newer concepts and algorithms, especially for large-scale comparisons and for obtaining accurate residue-wise mappings. Here, we report the development of a new algorithm, PocketAlign, for obtaining structural superpositions of binding sites. The software is available as a web-service at http://proline.physicslisc.emetin/pocketalign/. The algorithm encodes shape descriptors in the form of geometric perspectives, supplemented by chemical group classification. The shape descriptor considers several perspectives with each residue as the focus and captures relative distribution of residues around it in a given site. Residue-wise pairings are computed by comparing the set of perspectives of the first site with that of the second, followed by a greedy approach that incrementally combines residue pairings into a mapping. The mappings in different frames are then evaluated by different metrics encoding the extent of alignment of individual geometric perspectives. Different initial seed alignments are computed, each subsequently extended by detecting consequential atomic alignments in a three-dimensional grid, and the best 500 stored in a database. Alignments are then ranked, and the top scoring alignments reported, which are then streamed into Pymol for visualization and analyses. The method is validated for accuracy and sensitivity and benchmarked against existing methods. An advantage of PocketAlign, as compared to some of the existing tools available for binding site comparison in literature, is that it explores different schemes for identifying an alignment thus has a better potential to capture similarities in ligand recognition abilities. PocketAlign, by finding a detailed alignment of a pair of sites, provides insights as to why two sites are similar and which set of residues and atoms contribute to the similarity.

Linear Filtering in MDCT domain

In this paper, expressions for convolution multiplication properties of MDCT are derived starting from the equivalent DFT representations. Using these expressions, methods for implementing linear filtering through block convolution in the MDCT domain are presented. The implementation is exact for symmetric filters and approximate for non-symmetric filters in the case of rectangular window based MDCT. For a general MDCT window function, the filtering is done on the windowed segments and hence the convolution is approximate for symmetric as well as non-symmetric filters. This approximation error is shown to be perceptually insignificant for symmetric impulse response filters. Moreover, the inherent $50 \%$ overlap between adjacent frames used in MDCT computation does reduce this approximation error similar to smoothing of other block processing errors. The presented techniques are useful for compressed domain processing of audio signals.

STEM+: A Fair and Efficient Algorithm for Scheduling on the DSCH in UMTS Networks

In Universal Mobile Telecommunication Systems (UMTS), the Downlink Shared Channel (DSCH) can be used for providing streaming services. The traffic model for streaming services is different from the commonly used continuously- backlogged model. Each connection specifies a required service rate over an interval of time, k, called the "control horizon". In this paper, our objective is to determine how k DSCH frames should be shared among a set of I connections. We need a scheduler that is efficient and fair and introduce the notion of discrepancy to balance the conflicting requirements of aggregate throughput and fairness. Our motive is to schedule the mobiles in such a way that the schedule minimizes the discrepancy over the k frames. We propose an optimal and computationally efficient algorithm, called STEM+. The proof of the optimality of STEM+, when applied to the UMTS rate sets is the major contribution of this paper. We also show that STEM+ performs better in terms of both fairness and aggregate throughput compared to other scheduling algorithms. Thus, STEM+ achieves both fairness and efficiency and is therefore an appealing algorithm for scheduling streaming connections.