Simultaneous measurement of aerodynamic and heat transfer data for large angle blunt cones in hypersonic shock tunnel

Aerodynamic forces and fore-body convective surface heat transfer rates over a 60 degrees apex-angle blunt cone have been simultaneously measured at a nominal Mach number of 5.75 in the hypersonic shock tunnel HST2. An aluminum model incorporating a three-component accelerometer-based balance system for measuring the aerodynamic forces and an array of platinum thin-film gauges deposited on thermally insulating backing material flush mounted on the model surface is used for convective surface heat transfer measurement in the investigations. The measured value of the drag coefficient varies by about +/-6% from the theoretically estimated value based on the modified Newtonian theory, while the axi-symmetric Navier-Stokes computations overpredict the drag coefficient by about 9%. The normalized values of measured heat transfer rates at 0 degrees angle of attack are about 11% higher than the theoretically estimated values. The aerodynamic and the heat transfer data presented here are very valuable for the validation of CFD codes used for the numerical computation of How fields around hypersonic vehicles.

A new method for the determination of covalent radii

In five-membered aromatic heterocyclic ring systems, a relation between the ratio of the distance between the two α to the two β protons and the covalent radii of the heteroatom is given. It is found that a similar relation is valid for the van der Waals radii also.

Simultaneous Measurement of Strain and Temperature using Type I and Pre-strained Fiber Bragg Gratings

Strain and temperature sensitivities of a type I Bragg grating inscribed in a germania doped silica fiber, fabricated under normal conditions and zero strain, are compared with that of a Bragg grating inscribed under pre-strained condition. The results obtained reveal that the strain and temperature sensitivities of the two gratings are different. Based on these results, we demonstrate a technique which enables discrimination of strain and temperature in a Fiber Bragg Grating (FBG) with a linear response. The present technique allows for an easy implementation of the sensor by providing a direct access to the grating region in the fiber and demands only a simple interrogation system.

Determination of distances of sugar protons from Mn2+ in concanavalin A

1H NMR spin-lattice relaxation time (T1) measurements have been carried out with various sugars, viz. methyl alpha-D-glucopyranoside (alpha-MeGluP), methyl beta-D-lucopyranoside (beta-MeGluP), methyl alpha--annopyranoside (alpha-MeManP), maltose (4-O-alpha-D-glucopyranosyl--glucose), nigerose (3-O-alpha-D-glucopyranosyl-D-glucose), p-nitrophenyl alpha-maltoside (PNP-alpha-maltoside) and p-nitrophenyl beta-maltoside (PNP-beta-maltoside) to determine the distances of sugar protons from Mn2+ in concanavalin A (Con A). With a rotational correlation time of 1.58 x 10(-10) s determined, distances were calculated using Solomon-Bloembergen equation. The data obtained indicated differences in disposition of different groups in the binding site of Con A. An average value of about 10 A was obtained for the distances of sugar protons from Mn2+ in Con A. In the case of mono and disaccharides, the non-reducing end sugar unit was found to be closer to Mn2+ than the reducing end one.

Determination of free elemental sulphur in some petroleum products

Uncombined elemental sulphur in petroleum products such as kerosene, diesel, furnace and gear oil has been determined by conversion into copper(I) sulphide at 150–170°. The copper(I) sulphide can be weighed, or its sulphur content determined by the iodimetric method.

Stress intensity factor determination of radially cracked circular rings subjected to tension using photoelastic technique

A parametric study was carried out to determine the Stress Intensity Factor (SIF) in a cracked circular ring by using the photoelastic technique. The stress intensity factors for mode I deformation were determined by subjecting the specimens to the tensile loading from inner boundary and through the holes. The results of Non-Dimensional Stress Intensity Factor (NDSIF) variation with non-dimensional crack length for both methods of loading are compared with each other and with published results.

Simultaneous effect of lead and cadmium on granulosa cells: A cellular model for ovarian toxicity

Lead (Pb) and cadmium (Cd) are known reproductive toxicants, which accumulate in granulosa cells of the ovary. Female Charles foster rats were treated with sodium acetate (control), lead acetate and cadmium acetate either alone or in combination at a dose 0.05 mg/kg body weight intra-peritoneally for 15 days daily. Animals were killed at proestrous stage and granulosa cells were isolated from the ovaries. Binding of I-125-luteinizing hormone (I-125-LH), I-125-follicle stimulating hormone (I-125-FSH) and 17 beta-hydroxysteroid dehydrogenase activity were measured. As these receptors are localized on the surface of the cell membrane, we also estimated the membrane parameters of these cells. Our results demonstrated that both lead and cadmium caused a significant reduction in gonadotropin binding, which altered steroidogenic enzyme activity of granulosa cells. These changes exhibited a positive correlation with membrane changes of the granulosa cells.

Determination of activation energy for thermal regeneration of EL2 from its metastable state by thermally stimulated photocurrent measurements

It is shown that thermally stimulated photocurrent measurements provide a simple and effective method of determining the activation energy of thermal regeneration rate of EL2 from the metastable state to the normal state in undoped semi‐insulating GaAs. The thermal regeneration rate r is found to be 2.5×108 exp(−0.26 eV/kT) s−1.

Influence of crossed electric and quantizing magnetic fields on the Einstein relation in nonlinear optical, optoelectronic and related materials: Simplified theory, relative comparison and suggestion for experimental determination

An attempt is made to study the Einstein relation for the diffusivity-to-mobility ratio (DMR) under crossed fields' configuration in nonlinear optical materials on the basis of a newly formulated electron dispersion law by incorporating the crystal field in the Hamiltonian and including the anisotropies of the effective electron mass and the spin-orbit splitting constants within the framework of kp formalisms. The corresponding results for III-V, ternary and quaternary compounds form a special case of our generalized analysis. The DMR has also been investigated for II-VI and stressed materials on the basis of various appropriate dispersion relations. We have considered n-CdGeAs2, n-Hg1-xCdxTe, n-In1-xGaxAsyP1-y lattice matched to InP, p-CdS and stressed n-InSb materials as examples. The DMR also increases with increasing electric field and the natures of oscillations are totally band structure dependent with different numerical values. It has been observed that the DMR exhibits oscillatory dependences with inverse quantizing magnetic field and carrier degeneracy due to the Subhnikov-de Haas effect. An experimental method of determining the DMR for degenerate materials in the present case has been suggested. (C) 2010 Elsevier B.V. All rights reserved.

Simultaneous display of image and spectrum in the same plane: a generalized analysis

A generalized analysis, using the Vander Lugt operational notation, of the building block optical system comprising a single holographic optical element (HOE) for achieving simultaneous display of the spectrum and the image of an object in a single plane, has been carried out. The salient features of this analysis are: (1) it allows comprehensive characterization of the HOE, (2) it provides insights into the many possible configurations for the system, and (3) it explains the existing results in a consistent manner.

Simultaneous Utilization of Glucose and Sucrose by Thermophilic Fungi

The utilization of mixtures of glucose and sucrose at nonlimiting concentrations was studied in batch cultures of two common thermophilic fungi, Thermomyces lanuginosus and Penicilium duponti. The sucrose-utilizing enzymes (sucrose permease and invertase) in both fungi were inducible. Both sugars were used concurrently,regardless of their relative proportion in the mixture. At the optimal growth temperature (50C), T.lanuginosus utilized sucrose earlier than it did glucose, but at a suboptimal growth temperature (30°C) the two sugars were utilized at nearly comparable rates. The coutilization of the two sugars was most likely possible because (i) invertase was insensitive to catabolite repression by glucose, (ii) the activity and affinity of the glucose transport system were lowered when sucrose was included in the growth medium, and (iii) the activity of the glucose uptake system was also subject to repression by high concentrations of glucose itself. The concurrent utilization of the available carbon sources by thermophilic fungi might be an adaptive strategy for opportunistic growth in nature under conditions of low nutrient availability and thermal fluctuations in the environment.

Functional linkages can reveal protein complexes for structure determination

The study of molecular machines, and protein complexes in general, is a growth area of biology. Is there a computational method for inferring which combinations of proteins in an organism are likely to form a crystallizable complex? We use the Protein Data Bank (PDB) to assess the usefulness of inferred functional protein linkages for this task. We find that of 242 nonredundant prokaryotic protein complexes (complexes excluding structural variants of the same protein) from organisms that are shared between the current PDB and the Prolinks functional linkage database, 44% (107/242) contain proteins that are linked at high-confidence by one or more methods of computed functional linkages. This suggests that computing functional linkages will be useful in defining protein complexes for structural studies. We offer a database of such inferred linkages corresponding to likely protein complexes for some 629,952 pairs of proteins in 154 prokaryotes and archea.

Use of metastable equilibria for determination of Gibbs energy of solids

Attempts are made to measure activities of both components of a binary alloy (A�B) at 650 K using a solid-state galvanic cell incorporating a new composite solid electrolyte. Since the ionic conductivity of the composite solid electrolyte is three orders of magnitude higher than that of pure CaF2, the cell can be operated at lower temperatures. The alloy phase is equilibrated in separate experiments with flourides of each component and fluorine potential is measured. The mixture of the alloy (A�B) and the fluoride of the more reactive component (BF2) is stable, while (A�B) + AF2 mixture is metastable, Factors governing the possible use of metastable equilibria have been elucidated in this study. In the Co�Ni system, where the difference in Gibbs energies of formation of the fluorides is 21.4 kJ/mol, emf of the cell with metastable phases at the electrode is constant for periods ranging from 90 to 160 ks depending on alloy composition. Subsequently, the emf decreases because of the onset of the displacement reaction. In the Ni�Mn system, measurement of the activity of Ni using metastable equilibria is not fully successful at 650 K because of the large driving force for the displacement reaction (208.8 kJ/mol). Critical factors in the application of metastable equilibria are the driving force for displacement reaction and diffusion coefficients in both the alloy and fluoride solid solution.