Synthesis Of (+/-)-2-Isopropyl-5,6-Dimethylbicyclo[3.2.1]Oct-6-En-8-One

Methanolic hydrogen chloride cyclization of the triketone 8, prepared from the Mannich base 7 and 2-methylcyclopentane-1,3-dione, gives ketones 9 and 10. NaBH4 reduction of 9 followed by Grignard reaction with CH3MgI affords the diol 12. Catalytic hydrogenation of 12 followed by PCC oxidation yields the ketoalcohol 13. Dehydration of 13 with SOCl2/pyridine results in a 1:1 mixture of the endo-14 and exo-15 olefins, separated by chromatography.

Synthesis Of (+/-)-Beta-Cuparenone Via 3-Oxa-Beta-Cuparenone

Grignard reaction followed by ozonolysis, or ozonolysis followed by Grignard reaction on the pentenoate 8, generates the diol 9. Cyclodehydration of 9 leads to the 3-oxacuparene (6), whereas PCC oxidation furnishes the 3-oxa-beta-cuparenone (7). Methanesulfonic acid-P2O5 transforms 7 into cyclopentenones 4, 5, known precursors to beta-cuparenone (3), and the naphthalenone 14.

Synthesis of Cost-Optimal Shell-and-Tube Heat Exchangers

Synthesis of cost-optimal shell-and-tube heat exchangers is a difficult task since it involves a large number of parameters. An attempt is made in this article to simplify the process of choosing the parameter values that will minimize the cost of any heat exchanger satisfying a given heat duty and a particular set of constraints. The simplification is based on decoupling of the geometric and the thermal aspects of the problem. The concept of curves for cost-optimal design is introduced and is shown to simplify the synthesis process for shell-and-tube heat exchangers.

Synthetic investigations on illudinine: a new synthesis of methyl 8-methoxy-2,2-dimethyl-7-oxo-1,2,3,5,6,7-hexahydro-s-indacene-4-carboxylate

A new strategy for the total synthesis of methyl 8-methoxy-2,2-dimethyl-7-oxo-1,2,3,5,6,7-hexahydro-s-indacene-4-carboxylate 4, a key intermediate in the synthesis of illudalanes, is reported. The key step in this strategy is a new method of preparation of indanones from tetralones. Thus, the furfurylidene derivative of 6-methoxy-3,4-dihydronaphthalen-1-(2H)-one is oxidised to the dicarboxylic acid 9a which is cyclodehydrated to methyl 7-methoxy-1-oxoindan-4-carboxylate 10. Similar reactions on the tetrahydronaphthalenone 25, obtained from 6-methoxy-1,2,3,4-tetrahydronaphthalene-7-carbaldehyde 11 by sequential transformations including a regiospecific benzylic oxidation resulted in the hexahydro-s-indacenone 4, thus completing a formal synthesis of illudinine 1.

Synthesis, spectral and structural studies on metal complexes of Schiff bases involving vitamin B6 and histamine

Six metal complexes of Schiff bases involving Vitamin B6 and the decarboxylated amino acid histamine have been synthesised and characterized. Crystal structures have been determined for [CuL1(H2O)Br]-NO31(L1= pyridoxylidenehistamine) and [Cu2L22(NO3)2]·6H2O 2(L2= 5′-phosphopyridoxylidenehistaminate). The crystal structure of complex 1[space group P[1 with combining macron], a= 8.161(2), b= 10.368(2), c= 11.110(2)Å, α= 105.18(1), β= 102.12(1), γ= 72.10(1)° and Z= 2; R= 0.072, R′= 0.083] consists of square-pyramidally co-ordinated copper with the tridentate Schiff base in the zwitterionic form, whereas in 2[space group P[1 with combining macron], a= 8.727(1), b= 10.308(1), c= 12.845(2)Å, α= 110.00(1), β= 78.94(1), γ= 114.35(1)° and Z= 1; R= 0.035, R′= 0.034] the copper has the same co-ordination geometry but the tetradentate Schiff-base ligand exists as a monoanion. The conformational parameters deduced from such structures are important for understanding the stereochemical aspects of Vitamin B6-catalysed model reactions involving histidine.

Tandem Michael reaction. Synthesis of bridged diketones

Addition of NaOMe, NaOEt, or NaOPr(i) to dispironaphthalenone 1 resulted in the formation of diketones 4a-c and 5a-c. The structure assigned to 4a was confirmed by conversion to the known hemiacetal 3. Similar addition of carbon nucleophiles like diethyl malonate, dimethyl malonate, methyl cyanoacetate, and ethyl cyanoacetate afforded diketones 4d-g. Formation of these compounds has been rationalized.

A formate bridged Ni(II) sheet and its 3D analogue in presence of a linear organic linker: Synthesis, crystal structure and magnetic properties

Reaction of formamide with Ni(NO3)(2)center dot 6H(2)O under hydrothermal condition in a mixture of MeOH/H2O forms a two-dimensional formate bridged sheet Ni(HCOO)(2)(MeOH)(2) (1). X-ray structure analysis reveals the conversion of formamide to formate which acts as a bridging ligand in complex 1 where the axial sites of Ni(II) are occupied by methanol used as a solvent. An analogous reaction in presence of 4,4'-bipyridyl (4,4'-bipy) yielded a three-dimensional structure Ni(HCOO)(2)(4,4'-bpy) (2). DC magnetic measurements as a function of temperature and field established the presence of spontaneous magnetization with T-c (Curie temperature) = 17 and 20.8 K in 1 and 2, respectively, which can be attributed due to spin-canting. DFT calculations were performed to corroborate the magnetic results of 1 and 2. (C) 2010 Elsevier Ltd. All rights reserved.

Rapid synthesis of room temperature ferromagnetic Ag-doped LaMnO3 perovskite phases by the solution combustion method

We report the rapid solution combustion synthesis and characterization of Ag-substituted LaMnO3 phases at relatively low temperature using oxalyl dihydrazide, as fuel. Structural parameters were refined by the Rietveld method using powder X-ray diffraction data. While the parent LaMnO3 crystallizes in the orthorhombic structure, the Ag-substituted compounds crystallize in the rhombohedral symmetry. On increasing Ag-content, unit cell volume and Mn-O-Mn bond angle decreases. The Fourier transform infra red spectrum shows two absorption bands corresponding to Mn-O stretching vibration (v(s) mode) and Mn-O-Mn deformation vibration (v(b) mode) around 600 cm(-1) and 400 cm(-1) for the compositions x = 0.0, 0.05 and 0.10, respectively. Electrical resistivity measurements reveal that composition-controlled metal to insulator transition, with the maximum metal to insulator being 280 K for the composition La0.75Ag0.25MnO3. Increase in magnetic moment was observed with increase in Ag-content. The maximum magnetic moment of 35 emu/g was observed for the composition La0.80Ag0.20MnO3. (C) 2010 Elsevier Ltd. All rights reserved.

Mechanism of gel-to-crystallite conversion process in the synthesis of nanocrystalline multinary oxides

Description of gel-to-crystallite conversion process is made towards the synthesis of nanocrystalline titanates and aluminates. Thermodynamic and kinetic factors governing the conversion of a gel to meta-stable and stable nanocrystalline products(s) are discussed. Correlations between these factors and the preparative conditions employed for the syntheses of titanates and aluminates are arrived at.

Synthesis and Identification of a new class of antileukemic agents containing 2-(arylcarboxamide)-(S)-6-amino-4,5,6,7-tetrahydrobenzod]thiazole

Recently we have reported the effect of (S)-6-aryl urea/thiourea substituted-2-amino-4,5,6,7-tetrahydrobenzod]thiazole derivatives as potent anti-leukemic agents. To elucidate further the Structure Activity Relationship (SAR) studies on the anti-leukemic activity of (S)-2,6-diamino-4,5,6,7 tetrahydrobenzod]thiazole moiety, a series of 2-arlycarboxamide substituted-(S)-6-amino-4,5,6,7-tetrahydrobenzod]thiazole were designed, synthesized and evaluated for their anti-leukemic activity by trypan blue exclusion, 3-(4,5-dimethylthiazol-2-yl)-2,5-diphenyltetrazolium bromide (MTT), lactate dehydrogenase (LDH) assays and cell cycle analysis. Results suggest that the position, number and bulkiness of the substituent on the phenyl ring of aryl carboxamide moiety at 2nd position of 6-amino-4,5,6,7-tetrhydrobenzod]thiazole play a key role in inhibiting the proliferation of leukemia cells. Compounds with ortho substitution showed poor activity and with meta and para substitution showed good activity. (C) 2010 Elsevier Masson SAS. All rights reserved.

Biomimetic synthesis of silver nanoparticles by Citrus limon (lemon) aqueous extract and theoretical prediction of particle size

In the present study silver nanoparticles were rapidly synthesized at room temperature by treating silver ions with the Citrus limon (lemon) extract The effect of various process parameters like the reductant con centration mixing ratio of the reactants and the concentration of silver nitrate were studied in detail In the standardized process 10(-2) M silver nitrate solution was interacted for 411 with lemon Juice (2% citric acid concentration and 0 5% ascorbic acid concentration) in the ratio of 1 4(vol vol) The formation of silver nanoparticles was confirmed by Surface Plasmon Resonance as determined by UV-Visible spectra in the range of 400-500 nm X ray diffraction analysis revealed the distinctive facets (1 1 1 200 220 2 2 2 and 3 1 1 planes) of silver nanoparticles We found that citric acid was the principal reducing agent for the nanosynthesis process FT IR spectral studies demonstrated citric acid as the probable stabilizing agent Silver nanoparticles below 50 nm with spherical and spheroidal shape were observed from transmission electron microscopy The correlation between absorption maxima and particle sizes were derived for different UV-Visible absorption maxima (corresponding to different citric acid concentrations) employing MiePlot v 3 4 The theoretical particle size corresponding to 2% citric acid concentration was corn pared to those obtained by various experimental techniques like X ray diffraction analysis atomic force microscopy and transmission electron microscopy (C) 2010 Elsevier B V All rights reserved