A linear ramp control circuit using two LM 556 dual timers

A simple linear ramp control circuit, suitable for use with force-commutated thyrister circuits is discussed here. The circuit is based on only two IM 558 dual timer iCs, operating from a single 15 V supply. The reset terminals facilitate inhibition of the output of any stage. The use of this circuit in a thyristor chopper operating at 400 Hz 13 described.

Self-tuning control of a class of multivariable non-linear systems

Self-tuning is applied to the minimum variance control of non-linear multivariable systems which can be characterized by a ' multivariable Hammerstein model '. It is also shown that such systems are not amenable to self-tuning control if control costing is to be included in the performance criterion.

Microprocessor-Based Field-Oriented Control of A CSI-Fed Induction Motor Drive

This paper describes the method of field orientation of the stator current vector with respect to the stator, mutual, and rotor flux vectors, for the control of an induction motor fed from a current source inverter (CSI). A control scheme using this principle is described for orienting the stator current with respect to the rotor flux, as this gives natural decoupling between the current coordinates. A dedicated microcomputer system developed for implementing this scheme has been described. The experimental results are also presented.

On Bit Steering in the Minimization of the Control Memory of Microprogrammed Processors

The microcommands constituting the microprogram of the control memory of a microprogrammed processor can be partitioned into a number of disjoint sets. Some of these sets are then encoded to minimize the word width of the ROM storing the microprogram. A further reduction in the width of the ROM words can be achieved by a technique known as bit steering where one or more bits are shared by two or more sets of microcommands. These sets are called the steerable sets. This correspondence presents a simple method for the detection and encoding of steerable sets. It has been shown that the concurrency matrix of two steerable sets exhibits definite patterns of clusters which can be easily recognized. A relation "connection" has been defined which helps in the detection of three-set steerability. Once steerable sets are identified, their encoding becomes a straightforward procedure following the location of the identifying clusters on the concurrency matrix or matrices.

A simple firing delay control circuit for bridge converters

A simple ramp control firing circuit, suitable for use with fully controlled, line-commutated thyristor bridge circuits, is discussed here. This circuit uses very few components and generates the synchronized firing pulses in a simple way. It operates from a single 15 V Supply and has an inherent pulse inhibit facility. This circuit provides the synchronized firing pulses for both thyristors of the same limb in a bridge. To ensure reliability, wide triggering pulses are used, which are modulated to pass through the pulse transformers1 and demodulated before being fed to the thyristor gates. The use of throe such circuits only for a three-phase bridge is discussed.