Studies on the conformation of amino acids XII. Energy calculations on prolyl residue

The favoured conformations of the prolyl residue have been obtained by calculating their potential energies arising from bond-angle strain, torsion-angle strain, non-bonded and electrostatic interatomic energies. In addition to the five membered ring, the peptide unit at the amino end (with ω = 180°) and the C′ atom at the carboxyl end have been taken into account. It is found that there are two local minima in the configurational space of the parameters defining the conformation, as is actually observed-one (denoted by B) with Cγ displaced on the same side as C′, which is lower in energy than the other (denoted by A) with Cγ displaced on the opposite side of C′. The other four atoms Cδ, N, Cα, Cβ are nearly in a plane. The conformations of minimum energy (for both A and B) have bond angles very close to the mean observed values while the torsion angles are well within the range observed in various structures for each type. Taking into account the fact that the influence of neighbouring molecules in a crystal structure may make the conformation of a molecule different from the minimal one, the ranges of the conformational parameters for which the energy is within 0.6 kcal/mole above the minimum value (called the "most probable range") and within 1.2 kcal/mole (called the "probable range") have been determined. The ranges thus obtained, agree well with observation, and most of the observed data lie within the most probable ranges, although differing appreciably from the conformation of minimum energy. The study has been extended, in a limited way, to the conformation of the ring in the amino acid proline. Since the nitrogen is tetrahedral in this (as contrasted with being planar in the prolyl residue), it is found that any one of the five atoms can be out of plane (either way), with the other four lying nearly in a plane. These correspond to low energy conformations (up to 1.2 kcal/mole above the minimum). One such example, in which the Cα atom is out of plane is known for dl-proline · HCl. It is also shown that in these calculations energies due to bond length distortions can be neglected to a good degree of approximation, provided the 'best' values of the bond lengths for the particular compound are used in the theoretical calculations.

Rare-earth chromium citrates as precursors for rare-earth chromites: lanthanum biscitrato chromium(III) dihydrate, La[Cr(C6H5O7)2]·2H

The thermal decomposition of lanthanum biscitrato chromium(III) dihydrate has been studied in static air and dynamic argon atmospheres. The complex decomposes in four steps: dehydration, decomposition of the citrate to an intermediate oxycarbonate, formation of LaCrO4(V) from oxycarbonate, and finally decomposition of LaCrO4(V) to LaCrO3. Formation of LaCrCrO4(V) requires the presence of oxygen The decomposition behaviour of a mechanical mixture of lanthanum citrate hydrate and chromium citrate hydrate was compared with that of the citrato complex. Both the starting material and the intermediates were characterized by X-ray diffraction, IR electronic and ESR spectroscopy, surface area and magnetic susceptibility measurements, as well as by chemical analysis. A scheme is proposed for the decomposition of lanthanum biscitrato chromium(III) dihydrate in air. LaCrO3 can be obtained at temperatures as low as 875 K by isothermal decomposition of the complex.

Increasing ionic conductivity of polymer-sodium salt complex by addition of a non-ionic plastic crystal

Ionic conductivity and other physico-chemical properties of a soft matter composite electrolyte comprising of a polymer-sodium salt complex and a non-ionic plastic crystal are discussed here. The electrolyte under discussion comprises of polyethyleneoxide (PEO)-sodium triflate (NaCF3SO3) and succinonitrile (SN). Addition of SN to PEO-NaCF3SO3 resulted in significant enhancement in ionic conductivity. At 50% SN concentration (with respect to weight of polymer), the polymer-plastic composite electrolyte room temperature (= 25 degrees C) ionic conductivity was similar to 1.1 x 10(-4) Omega(-1) cm(-1), approximately 45 times higher than PEO-NaCF3SO3. Observations from ac-impedance spectroscopy along with X-ray diffraction, differential scanning calorimetry and Fourier transform inrared spectroscopy strongly suggest the enhancement in the composite is ionicconductivity due to enhanced ion mobility via decrease in crystallinity of PEO. The free standing composite polymer-plastic electrolytes were more compliable than PEO-NaCF3SO3 thus exhibiting no detrimental effects of succinonitrile addition on the mechanical stability of PEO-NaCF3SO3. We propose that the exploratory PEO-NaCF3SO3-SN system.discussed here will eventually be developed as a prototype electrolyte.for sodium-sulfur batteries capable of operating at ambient and.sub-ambient conditions. (C) 2010 Elsevier B.V. All rights reserved.

On the generalized continuum model of dipolar solvation dynamics

The continuum model of dipolar solvation dynamics is reviewed. The effects of non-spherical molecular shapes, of non-Debye dielectric relaxation of the polar solvent and of dielectric inhomogeneity of the solvent around the solute dipole are investigated. Several new theoretical results are presented. It is found that our generalized continuum model, which takes into account the dielectric inhomogeneity of the surrounding solvent, provides a description of solvation dynamics consistent with recent experimental results.

Characterization of barium titanate fine powders formed from hydrothermal crystallization

A detailed evaluation of size, shape and microstrains of BaTiO3 crystallites produced by hydrothermal crystallization at 90 – 180 °C and 0.1 – 1.2 MPa, from amorphous TiO2· xH2O (3 < × < 8) gel and aqueous Ba(OH)2 is presented, using X-ray line-broadening and TEM studies. Whereas the concentration of Ba(OH)2 and the acceptor impurities affect the crystallite shape, the stoichimetry with respect to Ba/Ti, donor as well as acceptor impurities, and the temperature of crystallization influence the microstrains. It is shown that strains in the crystallites are related to the point defects in the lattice. Compensation of the residually present hydroxyl ions in the oxygen sublattice by cation vacancies results in strains leading to metastable presence of the cubic phase at room temperature. Studies on the diffuse phase transition behaviour of these submicron powders show that the stable tetragonal phase is produced only on annealing at high temperatures where the mobility of cations vacancies are larger. Heat-treatment reduces anisotropy and strain in undoped samples, whereas annealing is less effective in doped materials. Comparison of the crystillite size by TEM showed better agreement with the Warren—Averbach method.

Structural and spectral perspectives of a novel thiosemicarbazone synthesized from di-2-pyridyl ketone and 4-phenyl-3-thiosemicarbazide

A new thiosemicarbazone, HL is synthesized from di-2-pyridyl ketone and 4-phenyl-3-thiosemicarbazide and structurally and spectrochemically characterized. H-1 NMR, C-13 NMR, COSY, HMQC and IR spectra of the compound are studied and the proton magnetic resonance spectrum reveals some unprecedented observations. The thione form is predominant in the solid state, as supported by the crystal structure and IR data, while a thiol-thione equilibrium is proposed in the solution state by NMR studies. The compound crystallizes into a monoclinic lattice with space group C2/c and the ZE conformation is exhibited by the thiosemicarbazone. Intra- and intermolecular hydrogen-bonding interactions give rise to a two-dimensional packing in the crystal lattice

Studies on a nanocomposite solid polymer electrolyte with hydrotalcite as a filler

We have prepared a new nanocomposite polymer electrolyte using nanoparticles of hydrotalcite, an anionic clay, as the filler. Hydrotalcite has the chemical composition [M-1-x(2+) M-x(3+) (OH)(2)](x+) [A(x/n)(n-)center dot mH(2)O] where M2+ is a divalent cation (e.g. Mg2+, Ni2+, Co2+,etc.) and M3+ is a trivalent cation (e.g. Al3+, Fe3+, Cr3+, etc.). A(n-) is an anion intercalated between the positively charged double hydroxide layers. The nanoparticles of [Mg0.67Al0.33 (OH)(2)] [(CO3)(0.17)center dot mH(2)O] were prepared by the co-precipitation method (average particle size as observed by TEM similar to 50 nm) and were doped into poly(ethylene glycol) PEG (m.w.2000) complexed with LiCIO4. Samples with different wt.% of hydrotalcite were prepared and characterized using XRD, DSC, TGA, impedance spectroscopy and NMR. Ionic conductivity for the pristine sample, similar to 7.3 x 10(-7) S cm(-1), was enhanced to a maximum of = 1.1 x 10(-5) S cm(-1) for 3.6 wt.% nanoparticle doped sample. We propose that the enhancement of ionic conductivity is caused by percolation effects of the high conductivity paths provided by interfaces between the nanoparticles and the polymer electrolyte. (C) 2010 Elsevier B.V. All rights reserved.

Electron paramagnetic resonance evidence for Jahn-Teller glasses

Single crystal E.P.R. studies of copper as a dopant in lithium potassium sulphate, lithium ammonium sulphate and lithium sodium sulphate have been carried out from room temperature down to 77K. The three Jahn-Teller (JT) systems behave very similarly to one another. The room temperature dynamic JT spectra with giso = 2·19 ± 0·01 and Aiso = ±(33 ± 4) times 10-4 cm-1 transform around 247 K to spectra characterized by randomly frozen-in axial strains with g‖ = 2·4307 ± 0·0005, g⊥ = 2·083 ± 0·001, A‖ = ±(116 ± 2) times 10-4 cm-1 and A⊥ = ∓(14 ± 4) times 10-4 cm-1. We proposed that the low temperature phase (below 247 K) of each of these systems provides an example of a Jahn-Teller glass.

Macroscopic approach to multichannel disordered conductors

We present a theory of multichannel disordered conductors by directly studying the statistical distribution of the transfer matrix for the full system. The theory is based on the general properties of the scattering system: flux conservation, time-reversal invariance, and the appropriate combination requirement when two wires are put together. The distribution associated with systems of very small length is then selected on the basis of a maximum-entropy criterion; a fixed value is assumed for the diffusion coefficient that characterizes the evolution of the distribution as the length increases. We obtain a diffusion equation for the probability distribution and compute the average of a few relevant quantities.

Structural and spectral perspectives of a novel thiosemicarbazone synthesized from di-2-pyridyl ketone and 4-phenyl-3-thiosemicarbazide

A new thiosemicarbazone, HL is synthesized from di-2-pyridyl ketone and 4-phenyl-3-thiosemicarbazide and structurally and spectrochemically characterized. H-1 NMR, C-13 NMR, COSY, HMQC and IR spectra of the compound are studied and the proton magnetic resonance spectrum reveals some unprecedented observations. The thione form is predominant in the solid state, as supported by the crystal structure and IR data, while a thiol-thione equilibrium is proposed in the solution state by NMR studies. The compound crystallizes into a monoclinic lattice with space group C2/c and the ZE conformation is exhibited by the thiosemicarbazone. Intra- and intermolecular hydrogen-bonding interactions give rise to a two-dimensional packing in the crystal lattice. (c) 2005 Elsevier B.V. All rights reserved.

Reactions of tetrahalogeno-o-benzoquinones—Part VII. Reaction of alkyl-2-naphthols with tetrachloro-o-benzoquinone

Reaction of 8-methyl-2-naphthol (4a) with the quinone3 gave a mixture of 8-methyl-2,2-(tetrachlorohenylenedioxy)naphthalen-1(2H)-one (1b) and 8-methyl-1,1-(tetrachloro-o-phenylenedioxy)naphthalen-2(1H)-one (2b) in almost equal amounts. Similarly, reaction of the naphthols (4b), (4d) and (4e) with3 gave the corresponding dienones (1c &2c), (1e &2e) and (1f &2f) in almost equal amounts. Reaction of 8-t-butyl-2-naphthol (4c) with3 gave exclusively 8-t-butyl-2,2-(tetrachloro--henylenedioxy)-naphthalen-1(2H)-one (1d). Oxidation of 3-t-butyl-2-naphthol (4f) with3 gave a mixture of 3-t-butyl-2,2-(tetrachloro-o-phenylendioxy) nephthalene-1(2H)-one(1g) and 3-t-butyl-1,1-(tetrachloro--phenylenedioxy)naphthelen-2 (1H)-one (2g) in the ratio 1∶6. Thus, onlyt-butyl group exherts pronounced steric influence on the rearrangement observed in the reaction of β-naphthol with the quinone3. Structures of all the compounds have been established by spectral data.

Crystal structure of hexanediamine-glutamic acid complex

Polyamines are some of the most important and ubiquitous small molecules that modulate several functions of plant, animal and bacterial cells. Despite the simplicity of their chemical structure, their specific interactions with other biomolecules cannot be explained solely on the basis of their electrostatic properties. To evolve a structural understanding on the specificity of these interactions it is necessary to determine the structure of complexes of polyamines with other, representative biomolecules. This paper reports the structure of the 1:2 complex of hexanediamine and L-glutamic acid. The complex crystallizes in the monoclonic space group P2(1) with a = 5.171(1) angstrom, b = 22.044(2) angstrom, c = 10.181(2) angstrom and beta = 104.51(1)-degrees. The structure was refined to an R factor of 6.6%. The structures of these complexes not only suggest the importance of hydrogen-bonding interactions of polyamines but also provide some insight into other complementary interactions probably important for the specificity of biomolecular interactions.