Vibrational dynamics and boson peak in a supercooled polydisperse liquid

Vibrational density of states (VDOS) in a supercooled polydisperse liquid is computed by diagonalizing the Hessian matrix evaluated at the potential energy minima for systems with different values of polydispersity. An increase in polydispersity leads to an increase in the relative population of localized high-frequency modes. At low frequencies, the density of states shows an excess compared to the Debye squared-frequency law, which has been identified with the boson peak. The height of the boson peak increases with polydispersity and shows a rather narrow sensitivity to changes in temperature. While the modes comprising the boson peak appear to be largely delocalized, there is a sharp drop in the participation ratio of the modes that exist just below the boson peak indicative of the quasilocalized nature of the low-frequency vibrations. Study of the difference spectrum at two different polydispersity reveals that the increase in the height of boson peak is due to a population shift from modes with frequencies above the maximum in the VDOS to that below the maximum, indicating an increase in the fraction of the unstable modes in the system. The latter is further supported by the facilitation of the observed dynamics by polydispersity. Since the strength of the liquid increases with polydispersity, the present result provides an evidence that the intensity of boson peak correlates positively with the strength of the liquid, as observed earlier in many experimental systems.

Vibrational analysis of the (B2P{cyrillic}→X2P{cyrillic}) system of NS

A few red degraded bands attributable to NS have been reported earlier by Fowler and Barker, Dressler and Barrow et al, and they occur in the same region (2300 to 2700 Å) as the bands of the known systems (C2∑+-X2P{cyrillic}) and (A2Δ-X2P{cyrillic}). Measurements made on the heads of some of these weak bands led Barrow et al. to believe that these bands may form a system analogous to the β-system of NO and be due to a2P{cyrillic}-2P{cyrillic} transition. The spectrum of NS has now been studied in a little more detail by means of an uncondensed discharge through dry nitrogen and sulphur vapour in the presence of argon and thirty three bands belonging to this system have been recorded in the region 2280 to 2760 Å. It has been found possible to represent the band heads by means of the equation {Mathematical expression}. Taking the lower state doublet interval as 223 cm-1, it is shown that the separation in the upper state is 94 cm-1. The ratio of the force constants in the upper and the ground states is found to be 0·39 and is nearly the same as that in the β-system of NO (0·30). The present vibrational analysis therefore supports the view that these new red degraded bands of NS arise from a (B2P{cyrillic}→X2P{cyrillic}) transition and the observed intensity distribution in the form of a wide parabola is also in qualitative agreement with what is expected from the moderately large Δ re (∼0·12Å) value.

Vibrational force constant and electron relaxation in H2 and Li2

The force constants of H2 and Li2 are evaluated employing their extended Hartree-Fock wavefunctions by a polynomial fit of their force curves. It is suggested that, based on incomplete multiconfiguration Hartree-Fock wavefunctions, force constants calculated from the energy derivatives are numerically more accurate than those obtained from the derivatives of the Hellmann-Feynman forces. It is observed that electrons relax during the nuclear vibrations in such a fashion as to facilitate the nuclear motions.

Selenoacetamide: Vibrational assignments and normal coordinate analysis

The i.r. spectra of selenoacetamide and its N-deuterated species have been recorded The fundamental frequencies of these compounds have been assigned. Force constants derived for thioacetamide and acetamide were transferred to the present compound and a good agreement with the observed frequencies were achieved. The results are discussed in relation to acetamide and thioacetamide.

Vibrational analysis of boldine hydrochloride using QM/MM approach

A complete vibrational analysis was performed on the molecular structure of boldine hydrochloride using QM/MM method. The equilibrium geometry, harmonic vibrational frequencies and infrared intensities were calculated by QM/MM method with B3LYP/6-31G(d) and universal force field (UFF) combination using ONIOM code. We found the geometry obtained by the QM/MM method to be very accurate, and we can use this rapid method in place of time consuming ab initio methods for large molecules. A detailed interpretation of the infrared spectra of boldine hydrochloride is reported. The scaled theoretical wave numbers are in perfect agreement with the experimental values. The FT-IR spectra of boldine hydrochloride in the region 4000-500 cm(-1) were recorded in CsI (solid phase) and in chloroform with concentration 5 and 10 mg/ml.

Correlations between frequency of infra-red active vibrational modes and copper-oxygen distance in copper oxides. Application to superconductors

The infra-red spectra of a large number of ternary Cu(II) oxides with at least a quasi square-planar coordination of oxygen around the copper ions have been studied. The frequency of the bands with the highest frequency,v max, is found to correlate extremely well with the shortest Cu–O distance.v max increases at an impressive rate of sim20 cm–1 per 0.01 Å when the Cu–O distance becomes less than 1.97 Å, which is the Cu2+–O2– distance in square-planar CuO4 complexes as obtained from empirical ionic radii considerations. The marked sensitivity may be used as a ldquotitrationrdquo procedure not only to assign bands but also to obtain diagnostic information about local coordination in compounds derived, for example, from the YBa2Cu3O7–d structure such as LaCaBaCu3O7–d . The only example where this correlation fails is in the two-layer non-superconducting oxides derived from La2(Ca, Sr)Cu2O6. The significance of this result is discussed. The marked dependence of frequency on the bond-distance is qualitatively examined in terms of an increased electron-phonon coupling to account for the observed tendency of the superconducting transition temperature to go through a maximum as the average basal plane Cu–O distance is decreased.

Vibrational Spectra and Normal Coordinate Analysis of N-Methyl Thiourea

The infrared spectra of N-methylthiourea (NMTU) and its N-deuterated and S-methylated species were measured. Assignment of the infrared and Raman spectra of NMTU has been accomplished by correlation with thiourea and by use of infrared band shifts on N-deuteration as well as S-methylation. Normal coordinate analysis was performed for all the fundamentals of NMTU and NMTU-d3, the assignments obtained from the force field calculations being discussed in relation to those in other related thioureas and thioamides. The potential barriers to the internal rotations for the �NH2, �CH3, and �CN groups were estimated from the force constants.

Vibrational Spectra and Assignments for the Fundamental Vibrations of Imidazolidine-2-thione and -2-selenone

Infrared spectra of imidazolidine-2-thione (N,N?-ethylenethiourea, ETU) and its N,N?-deuterated (ETU-d2) and S-methylthiouronium iodides have been recorded from 4000 to 30 cm?1. Normal coordinate analyses of ETU and ETU-d2 have been made for all the fundamental frequencies, employing a Urey-Bradley potential function supplemented with valence type constants for the out of plane modes of the planar skeleton. Raman frequencies of ETU from literature have been utilised. The results of the vibrational analyses are discussed in relation to the group frequencies in structurally related molecules and frequency shifts on deuteration and S-methylation. The normal coordinate treatment is also performed for the planar vibrations of imidazolidine-2-selenone (N,N?-ethyleneselenourea, ESU) to propose assignments for ESU and so also to support the assignments of ETU.

Vibrational analysis of 1,3-thiazolidine-2-thione and its selenium analogue

The i.r. spectra of 1,3-thiazolidine-2-thione, ?2-selone and their N-deuteriated derivatives have been investigated in the region between 4000 and 20 cm?1. A complete assignment of the fundamental vibrational frequencies has been made based upon the normal coordinate analysis carried out using a simple Urey�Bradley force field supplemented by the valence force constants for the out-of-plane vibrations of the planar molecular skeleton. The proposed assignments are discussed in relation to the group frequencies in structurally related molecules and in terms of the computed potential energy distributions among the symmetry coordinates.

Ab initio studies of the structure and vibrational spectra of methyl isocyanide-borane and acetonitrile-borane

The SCF/DZP and MP2/DZP methods of ab initio quantum chemistry have been utilized to study the structure, vibrational spectra, binding energy, and barrier to internal rotation of methyl isocyanide-borane and acetonitrile-borane adducts. The eclipsed conformation of the complexes was predicted to be a minimum, and the staggered form is a transition state with a barrier height of about 10 cal/mol. The vibrational analyses of CH3NC-BH3 and CH3CN-BH3 and several of their isotopomers have been carried out by the GF matrix method. Computations have also been carried out for free CH3NC and CH3CN in order to investigate the changes in CH3NC and CH3CN as a result of their complex formation with BH3. To obtain an acceptable set of force constants, a recently proposed procedure ''RECOVES'' has been utilized. The increase in the N=C/C=N stretching force constant of CH3NC/CH3CN on adduct formation is interpreted with the help of Parr and Borkman's model. The binding energies for the two adducts have been determined taking basis set superposition error (BSSE) into consideration. The effect of the BSSE on structure, dipole moment, and vibrational frequencies of CH3CN and CH3NC is also evaluated. The predicted infrared band intensities for the two complexes are in good agreement with the experimentally observed features, and they have been utilized in the assignment of vibrational frequencies.