Accurate determination of interference in pin joints Pin-to-plate interference in experimental models of interference-fit joints is significantly overestimated by direct physical measurements, but it can be accurately determined by a simple photoelastic method

Suitable pin-to-hole interference can significantly increase the fatigue life of a pin joint. In practical design, the initial stresses due to interference are high and they are proportional to the effective interference. In experimental studies on such joints, difficulties have been experienced in estimating the interference accurately from physical measurements of pin and hole diameters. A simple photoelastic method has been developed to determine the effective interference to a high degree of accuracy. This paper presents the method and reports illustrative data from a successful application thereof.

Molecular Caches: A caching structure for dynamic creation of application-specific Heterogeneous cache regions

CMPs enable simultaneous execution of multiple applications on the same platforms that share cache resources. Diversity in the cache access patterns of these simultaneously executing applications can potentially trigger inter-application interference, leading to cache pollution. Whereas a large cache can ameliorate this problem, the issues of larger power consumption with increasing cache size, amplified at sub-100nm technologies, makes this solution prohibitive. In this paper in order to address the issues relating to power-aware performance of caches, we propose a caching structure that addresses the following: 1. Definition of application-specific cache partitions as an aggregation of caching units (molecules). The parameters of each molecule namely size, associativity and line size are chosen so that the power consumed by it and access time are optimal for the given technology. 2. Application-Specific resizing of cache partitions with variable and adaptive associativity per cache line, way size and variable line size. 3. A replacement policy that is transparent to the partition in terms of size, heterogeneity in associativity and line size. Through simulation studies we establish the superiority of molecular cache (caches built as aggregations of molecules) that offers a 29% power advantage over that of an equivalently performing traditional cache.

Can biological motion be a biometric?

Biological motion has successfully been used for analysis of a person's mood and other psychological traits. Efforts are made to use human gait as a non-invasive mode of biometric. In this reported work, we try to study the effectiveness of biological gait motion of people as a cue to biometric based person recognition. The data is 3D in nature and, hence, has more information with itself than the cues obtained from video-based gait patterns. The high accuracies of person recognition using a simple linear model of data representation and simple neighborhood based classfiers, suggest that it is the nature of the data which is more important than the recognition scheme employed.

Functional linkages can reveal protein complexes for structure determination

The study of molecular machines, and protein complexes in general, is a growth area of biology. Is there a computational method for inferring which combinations of proteins in an organism are likely to form a crystallizable complex? We use the Protein Data Bank (PDB) to assess the usefulness of inferred functional protein linkages for this task. We find that of 242 nonredundant prokaryotic protein complexes (complexes excluding structural variants of the same protein) from organisms that are shared between the current PDB and the Prolinks functional linkage database, 44% (107/242) contain proteins that are linked at high-confidence by one or more methods of computed functional linkages. This suggests that computing functional linkages will be useful in defining protein complexes for structural studies. We offer a database of such inferred linkages corresponding to likely protein complexes for some 629,952 pairs of proteins in 154 prokaryotes and archea.

Structural Studies of Analgesics and Their Interactions. V.* The Crystal and Molecular Structure of Metamizol Monohydrate

Metamizol, Na[Ct3H16N3045], C13H16N304S-Na +, a sulphonyl derivative of amidopyrine, is perhaps the most widely used non-narcotic analgetic and antiinflammatory pyrazolone derivative. The monohydrate of the compound crystallizes in the monoclinic space group P2Jc with eight molecules in a unit cell of dimensions a = 9.143 (3), b = 49.50 (2), c = 7.314 (2)/k and fl = 90.9 (1) °. The structure was solved by direct methods and refined to an R value of 0.080 for 4466 observed reflections. The two crystallographically independent molecules in the structure have similar dimensions. The elongated molecules are hydrophobic at one end and hydrophilic at the other with the middle portion partly hydrophobic and partly hydrophilic. The pyrazolone group in the structure has dimensions similar to those found in uncomplexed antipyrine and amidopyrine. The crystal structure can be described as consisting of double layers of metamizol molecules stacked perpendicular to the b axis. The adjacent double layers are separated by a layer of Naions and water molecules.

Photocatalytic treatment of municipal wastewater using modified neodymium doped TiO2 hybrid nanoparticles

Photocatalytic degradation of municipal wastewater was investigated using reagent grade TiO2 and modified neodymium doped TiO2 hybrid nanoparticles. For the first time, surface modification of Nd3+ doped TiO2 hybrid nanoparticles were carried out with n-butylamine as surface modifier under mild hydrothermal conditions. The modified nanoparticles obtained were characterized by Powder XRD, FTIR, DLS, TEM, BET surface area, zeta potential and UV-Vis Spectroscopy. The characterization results indicated better morphology, particle size distribution and low agglomeration of the nanoparticles synthesized. It was found that photodegradation of wastewater using surface modified neodymium doped TiO2 nanoparticles was more compared to pure TiO2, which can be attributed to the doping and modification with n-butylamine.

Can equipartition fields produce the tilts of bipolar magnetic regions?

The effect of turbulence on the nonaxisymmetric flux rings of equipartition field strength in bipolar magnetic regions is studied on the basis of the small-scale momentum exchange mechanism and the giant cell drag combined with the Kelvin-Helmholtz drag mechanism. It is shown that the giant cell drag and small-scale momentum exchange mechanism can make equipartition flux loops emerge at low latitudes, in addition to making them exhibit the observed tilts. However, the sizes of the flux tubes have to be restricted to a couple of hundred kilometers. An ad hoc constraint on the footpoints of the flux loops is introduced by not letting them move in the phi direction, and it is found that equipartition fields of any size can be made to emerge at sunspot latitudes with the observed tilts by suitably adjusting the footpoint separations.

Can Dufour's gland compounds honestly signal fertility in the primitively eusocial wasp Ropalidia marginata?

Unlike queens of typical primitively eusocial species, Ropalidia marginata queens are docile and non-interactive, and hence cannot be using dominance to maintain their status. It appears that the queen maintains reproductive monopoly through a pheromone, of which the Dufour's gland is at least one source. Here, we reconfirm earlier results showing that queens and workers can be correctly classified on a discriminant function using the compositions of their respective Dufour's glands, and also demonstrate consistent queen-worker differences based on categories of compounds and on single compounds also in some cases. Since the queen pheromone is expected to be an honest signal of the fecundity of a queen, we investigate the correlation of Dufour's gland compounds with ovarian activation of queens. Our study shows that Dufour's gland compounds in R. marginata correlate with the state of ovarian activation of queens, suggesting that such compounds may portray the fecundity of a queen, and may indeed function as honest signals of fertility.

High sensitive Static fiber Bragg grating strain sensing using lasers locked to relative frequency reference

A novel high sensitive fiber Bragg grating (FBG) strain sensing technique using lasers locked to relative frequency reference is proposed and analyzed theoretically. Static strain on FBG independent of temperature can be measured by locking frequency of diode laser to the mid reflection frequency of matched reference FBG, which responds to temperature similar to that of the sensor FBG, but is immune to strain applied to the same. Difference between light intensities reflected from the sensor and reference FBGs (proportional to the difference between respective pass band gains at the diode laser frequency) is not only proportional to the relative strain between the sensor and reference FBGs but also independent of servo residual frequency errors. Usage of relative frequency reference avoids all complexities involved in the usage of absolute frequency reference, hence, making the system simple and economical. Theoretical limit for dynamic and static strain sensitivities considering all major noise contributions are of the order of 25 (p epsilon) / root Hz and 1.2 n epsilon / root Hz respectively.

Can one electrochemically measure the statistical morphology of a rough electrode

We have developed a theory for an electrochemical way of measuring the statistical properties of a nonfractally rough electrode. We obtained the expression for the current transient on a rough electrode which shows three times regions: short and long time limits and the transition region between them. The expressions for these time ranges are exploited to extract morphological information about the surface roughness. In the short and long time regimes, we extract information regarding various morphological features like the roughness factor, average roughness, curvature, correlation length, dimensionality of roughness, and polynomial approximation for the correlation function. The formulas for the surface structure factors (the measure of surface roughness) of rough surfaces in terms of measured reversible and diffusion-limited current transients are also obtained. Finally, we explore the feasibility of making such measurements.

Electrophilic additions to 7-methylenenorbornenes and 7- isopropylidenenorbornenes:can remote substituents swamp electrostatic control of π-face selectivity

pi-Face selectivities in electrophilic additiions (typically CCl2) to 7-methylenenorbornenes and 7-isopropylidenenorbornenes are modulated by endo-substituents.

Layered Tabu Search Algorithm for Large-MIMO Detection and a Lower Bound on ML Performance

In this paper, we are concerned with low-complexity detection in large multiple-input multiple-output (MIMO) systems with tens of transmit/receive antennas. Our new contributions in this paper are two-fold. First, we propose a low-complexity algorithm for large-MIMO detection based on a layered low-complexity local neighborhood search. Second, we obtain a lower bound on the maximum-likelihood (ML) bit error performance using the local neighborhood search. The advantages of the proposed ML lower bound are i) it is easily obtained for MIMO systems with large number of antennas because of the inherent low complexity of the search algorithm, ii) it is tight at moderate-to-high SNRs, and iii) it can be tightened at low SNRs by increasing the number of symbols in the neighborhood definition. Interestingly, the proposed detection algorithm based on the layered local search achieves bit error performances which are quite close to this lower bound for large number of antennas and higher-order QAM. For e. g., in a 32 x 32 V-BLAST MIMO system, the proposed detection algorithm performs close to within 1.7 dB of the proposed ML lower bound at 10(-3) BER for 16-QAM (128 bps/Hz), and close to within 4.5 dB of the bound for 64-QAM (192 bps/Hz).

Bayesian Learning for Joint Sparse OFDM Channel Estimation and Data Detection

The impulse response of a typical wireless multipath channel can be modeled as a tapped delay line filter whose non-zero components are sparse relative to the channel delay spread. In this paper, a novel method of estimating such sparse multipath fading channels for OFDM systems is explored. In particular, Sparse Bayesian Learning (SBL) techniques are applied to jointly estimate the sparse channel and its second order statistics, and a new Bayesian Cramer-Rao bound is derived for the SBL algorithm. Further, in the context of OFDM channel estimation, an enhancement to the SBL algorithm is proposed, which uses an Expectation Maximization (EM) framework to jointly estimate the sparse channel, unknown data symbols and the second order statistics of the channel. The EM-SBL algorithm is able to recover the support as well as the channel taps more efficiently, and/or using fewer pilot symbols, than the SBL algorithm. To further improve the performance of the EM-SBL, a threshold-based pruning of the estimated second order statistics that are input to the algorithm is proposed, and its mean square error and symbol error rate performance is illustrated through Monte-Carlo simulations. Thus, the algorithms proposed in this paper are capable of obtaining efficient sparse channel estimates even in the presence of a small number of pilots.