Comparative performance analysis of drives for induction motors

The asynchronous polyphase induction motor has been the motor of choice in industrial settings for about the past half century because power electronics can be used to control its output behavior. Before that, the dc motor was widely used because of its easy speed and torque controllability. The two main reasons why this might be are its ruggedness and low cost. The induction motor is a rugged machine because it is brushless and has fewer internal parts that need maintenance or replacement. This makes it low cost in comparison to other motors, such as the dc motor. Because of these facts, the induction motor and drive system have been gaining market share in industry and even in alternative applications such as hybrid electric vehicles and electric vehicles. The subject of this thesis is to ascertain various control algorithms’ advantages and disadvantages and give recommendations for their use under certain conditions and in distinct applications. Four drives will be compared as fairly as possible by comparing their parameter sensitivities, dynamic responses, and steady-state errors. Different switching techniques are used to show that the motor drive is separate from the switching scheme; changing the switching scheme produces entirely different responses for each motor drive.

Large eddy simulation of shock boundary layer interaction control using micro-vortex generators

The performance of supersonic engine inlets and external aerodynamic surfaces can be critically affected by shock wave / boundary layer interactions (SBLIs), whose severe adverse pressure gradients can cause boundary layer separation. Currently such problems are avoided primarily through the use of boundary layer bleed/suction which can be a source of significant performance degradation. This study investigates a novel type of flow control device called micro-vortex generators (µVGs) which may offer similar control benefits without the bleed penalties. µVGs have the ability to alter the near-wall structure of compressible turbulent boundary layers to provide increased mixing of high speed fluid which improves the boundary layer health when subjected to flow disturbance. Due to their small size,µVGs are embedded in the boundary layer which provide reduced drag compared to the traditional vortex generators while they are cost-effective, physically robust and do not require a power source. To examine the potential of µVGs, a detailed experimental and computational study of micro-ramps in a supersonic boundary layer at Mach 3 subjected to an oblique shock was undertaken. The experiments employed a flat plate boundary layer with an impinging oblique shock with downstream total pressure measurements. The moderate Reynolds number of 3,800 based on displacement thickness allowed the computations to use Large Eddy Simulations without the subgrid stress model (LES-nSGS). The LES predictions indicated that the shock changes the structure of the turbulent eddies and the primary vortices generated from the micro-ramp. Furthermore, they generally reproduced the experimentally obtained mean velocity profiles, unlike similarly-resolved RANS computations. The experiments and the LES results indicate that the micro-ramps, whose height is h≈0.5δ, can significantly reduce boundary layer thickness and improve downstream boundary layer health as measured by the incompressible shape factor, H. Regions directly behind the ramp centerline tended to have increased boundary layer thickness indicating the significant three-dimensionality of the flow field. Compared to baseline sizes, smaller micro-ramps yielded improved total pressure recovery. Moving the smaller ramps closer to the shock interaction also reduced the displacement thickness and the separated area. This effect is attributed to decreased wave drag and the closer proximity of the vortex pairs to the wall. In the second part of the study, various types of µVGs are investigated including micro-ramps and micro-vanes. The results showed that vortices generated from µVGs can partially eliminate shock induced flow separation and can continue to entrain high momentum flux for boundary layer recovery downstream. The micro-ramps resulted in thinner downstream displacement thickness in comparison to the micro-vanes. However, the strength of the streamwise vorticity for the micro-ramps decayed faster due to dissipation especially after the shock interaction. In addition, the close spanwise distance between each vortex for the ramp geometry causes the vortex cores to move upwards from the wall due to induced upwash effects. Micro-vanes, on the other hand, yielded an increased spanwise spacing of the streamwise vortices at the point of formation. This resulted in streamwise vortices staying closer to the wall with less circulation decay, and the reduction in overall flow separation is attributed to these effects. Two hybrid concepts, named “thick-vane” and “split-ramp”, were also studied where the former is a vane with side supports and the latter has a uniform spacing along the centerline of the baseline ramp. These geometries behaved similar to the micro-vanes in terms of the streamwise vorticity and the ability to reduce flow separation, but are more physically robust than the thin vanes. Next, Mach number effect on flow past the micro-ramps (h~0.5δ) are examined in a supersonic boundary layer at M=1.4, 2.2 and 3.0, but with no shock waves present. The LES results indicate that micro-ramps have a greater impact at lower Mach number near the device but its influence decays faster than that for the higher Mach number cases. This may be due to the additional dissipation caused by the primary vortices with smaller effective diameter at the lower Mach number such that their coherency is easily lost causing the streamwise vorticity and the turbulent kinetic energy to decay quickly. The normal distance between the vortex core and the wall had similar growth indicating weak correlation with the Mach number; however, the spanwise distance between the two counter-rotating cores further increases with lower Mach number. Finally, various µVGs which include micro-ramp, split-ramp and a new hybrid concept “ramped-vane” are investigated under normal shock conditions at Mach number of 1.3. In particular, the ramped-vane was studied extensively by varying its size, interior spacing of the device and streamwise position respect to the shock. The ramped-vane provided increased vorticity compared to the micro-ramp and the split-ramp. This significantly reduced the separation length downstream of the device centerline where a larger ramped-vane with increased trailing edge gap yielded a fully attached flow at the centerline of separation region. The results from coarse-resolution LES studies show that the larger ramped-vane provided the most reductions in the turbulent kinetic energy and pressure fluctuation compared to other devices downstream of the shock. Additional benefits include negligible drag while the reductions in displacement thickness and shape factor were seen compared to other devices. Increased wall shear stress and pressure recovery were found with the larger ramped-vane in the baseline resolution LES studies which also gave decreased amplitudes of the pressure fluctuations downstream of the shock.

Bioexploration of wild Alaskan berries: From field screening to functional food

Wild berries are fundamental components of traditional diet and medicine for Native American and Alaska Native tribes and contain a diverse array of phytochemicals, including anthocyanins and proanthocyanidins, with known efficacy against metabolic disorders. Bioexploration represents a new paradigm under which bioactive preparations are screened in coordination with indigenous communities, to prepare for subsequent in-depth chemical and biological analysis. The inclusive, participatory philosophical approach utilized in bioexploration has additional benefits that could be realized in seemingly disparate areas, such as education and economics. Five species of wild Alaskan berries (Vaccinium uliginosum, V. ovalifolium, Empetrum nigrum, Rubus chamaemorus, and R. spectabilis) were tested using “Screens-to-Nature” (STN), a community-participatory approach to screen for potential bioactivity, in partnership with tribal members from three geographically distinct Alaskan villages: Akutan, Seldovia, and Point Hope. Berries were subsequently evaluated via HPLC and LC-MS2, yielding significant species and location-based variation in anthocyanins (0.9-438.6 mg eq /100g fw) and proanthocyanins (73.7-625.2 mg eq /100g fw). A-type proanthocyanidin dimers through tetramers were identified in all species tested. Berries were analyzed for in vitro and in vivo activity related to diabetes and obesity. R. spectabilis samples increased preadipocyte-factor-1 levels by 82% over control, and proanthocyanidin-rich fractions from multiple species reduced lipid accumulation in 3T3-L1 adipocytes. Furthermore, extracts of V. uliginosum and E. nigrum (Point Hope) reduced serum glucose levels in C57bl/6j mice up to 45%. The same precepts of bioexploration, especially the inclusion of indigenous community perspectives and knowledge, have relevance in other areas of study, such as education and economics. Studies have established the apathetic, low-motivational environment characteristic of many introductory science laboratory classes is detrimental to student interest, learning, and continuation in scientific education. A primary means of arresting this decline and stimulating the students’ attention and excitement is via engagement in hands-on experimentation and research. Using field workshops, the STN system is investigated as to its potential as a novel participatory educational tool, using assays centered around bioexploration and bioactive plant compounds that hold the potential to offset human health conditions. This evaluation of the STN system provided ample evidence as to its ability to augment and improve science education. Furthermore, Strengths, Weaknesses, Opportunities, and Threats (SWOT) analysis was employed as a theoretical framework to review the potential benefits and hurdles associated with developing a wild Alaskan berry commodity. Synthesizing various sources of information – including logistics and harvest costs, sources of initial capital, opportunities in the current superfruit industry, and socioeconomic factors – the development of a berry commodity proves to be a complex amalgam of competing factors which would require a delicate balance before proceeding.