A Decentralized Session Management Framework for Heterogeneous Ad-Hoc and Fixed Networks

Wireless technologies are continuously evolving. Second generation cellular networks have gained worldwide acceptance. Wireless LANs are commonly deployed in corporations or university campuses, and their diffusion in public hotspots is growing. Third generation cellular systems are yet to affirm everywhere; still, there is an impressive amount of research ongoing for deploying beyond 3G systems. These new wireless technologies combine the characteristics of WLAN based and cellular networks to provide increased bandwidth. The common direction where all the efforts in wireless technologies are headed is towards an IP-based communication. Telephony services have been the killer application for cellular systems; their evolution to packet-switched networks is a natural path. Effective IP telephony signaling protocols, such as the Session Initiation Protocol (SIP) and the H 323 protocol are needed to establish IP-based telephony sessions. However, IP telephony is just one service example of IP-based communication. IP-based multimedia sessions are expected to become popular and offer a wider range of communication capabilities than pure telephony. In order to conjoin the advances of the future wireless technologies with the potential of IP-based multimedia communication, the next step would be to obtain ubiquitous communication capabilities. According to this vision, people must be able to communicate also when no support from an infrastructured network is available, needed or desired. In order to achieve ubiquitous communication, end devices must integrate all the capabilities necessary for IP-based distributed and decentralized communication. Such capabilities are currently missing. For example, it is not possible to utilize native IP telephony signaling protocols in a totally decentralized way. This dissertation presents a solution for deploying the SIP protocol in a decentralized fashion without support of infrastructure servers. The proposed solution is mainly designed to fit the needs of decentralized mobile environments, and can be applied to small scale ad-hoc networks or also bigger networks with hundreds of nodes. A framework allowing discovery of SIP users in ad-hoc networks and the establishment of SIP sessions among them, in a fully distributed and secure way, is described and evaluated. Security support allows ad-hoc users to authenticate the sender of a message, and to verify the integrity of a received message. The distributed session management framework has been extended in order to achieve interoperability with the Internet, and the native Internet applications. With limited extensions to the SIP protocol, we have designed and experimentally validated a SIP gateway allowing SIP signaling between ad-hoc networks with private addressing space and native SIP applications in the Internet. The design is completed by an application level relay that permits instant messaging sessions to be established in heterogeneous environments. The resulting framework constitutes a flexible and effective approach for the pervasive deployment of real time applications.

Internet- karttapalveluiden arviointi ja kehitys strategisessa maankäytön suunnittelussa, tapaustutkimuksena Esikaupunkien renessanssi -hanke

Participation is located in a living and complex environment. Traditional means of participation are only partially able to meet the new environmental requirements. In need are forms of participation which take into account the new opportunities of the environment and residents expertise. Internet map applications are an important channel of participation which potential is in many respects as unexplored and unutilized. They are commonly in inventory the perspectives, bringing out the concerns of the area, and only little for discussing about solutions. Interpretation is usually made by designer. This study focuses on evaluation and development of Internet map applications in strategic land use planning. Subject matter is dealt from designer and the inhabitants point of view. City Planning Department of Helsinki s Esikau-punkien Renessanssi -project and the associated SoftGIS survey acts as the case study. In the beginning of the study I tried to recognize the new environment in which the Internet map applications are placed. The research question is, what kind of challenges and opportunities the e-participation confronts in information society, and what kind of requirements the environmental creates for development of an application. In chapter three I evaluate how successfully these requirements are met in Esikau-punkien Renessanssi -project. I m trying to examine how the application would look like if the environment and the characteristics of the project are met better. The approach is experimental and I try to find new ways to take advantage of Internet maps. I try not to be too limited to current projects and studies. For example, I try to examine how social media and Web 2.0 opportunities can be utilized, and how the learning and shaping nature of planning may be reached in Internet map environment. In chapter four I have developed a new concept for the Esikaupunkien Renessanssi map application, and made images to visualize its operation in practice. I collect all the data in the research and gather it into a new service. The aim is to create a better application for Esikaupunkien Renessanssi -project, which takes into account the living and complex environment of participation and responds to threats and opportunities arising from it. The presented outcome is in many respects different from the current query. In the new service the role of residents is to interact and learn. The traditional standing of the Internet maps and the position of resident as one-sided information donor are questioned. In the concept, the residents innovate and make interpretations too. Influences are taken from a number of modern applications and for example services that make use of social media. The user experience is intended to be interactive, fast and easy. The idea is that the service keeps you up to date with planning matters, not the other way around. Service guides inhabitants, striving to achieve a deeper knowledge of the project's objectives as well as the dynamics and realities that different individuals experience.

Process Analytical Technology Approach on Fluid Bed Granulation and Drying : Identifying Critical Relationships and Constructing the Design Space

Fluid bed granulation is a key pharmaceutical process which improves many of the powder properties for tablet compression. Dry mixing, wetting and drying phases are included in the fluid bed granulation process. Granules of high quality can be obtained by understanding and controlling the critical process parameters by timely measurements. Physical process measurements and particle size data of a fluid bed granulator that are analysed in an integrated manner are included in process analytical technologies (PAT). Recent regulatory guidelines strongly encourage the pharmaceutical industry to apply scientific and risk management approaches to the development of a product and its manufacturing process. The aim of this study was to utilise PAT tools to increase the process understanding of fluid bed granulation and drying. Inlet air humidity levels and granulation liquid feed affect powder moisture during fluid bed granulation. Moisture influences on many process, granule and tablet qualities. The approach in this thesis was to identify sources of variation that are mainly related to moisture. The aim was to determine correlations and relationships, and utilise the PAT and design space concepts for the fluid bed granulation and drying. Monitoring the material behaviour in a fluidised bed has traditionally relied on the observational ability and experience of an operator. There has been a lack of good criteria for characterising material behaviour during spraying and drying phases, even though the entire performance of a process and end product quality are dependent on it. The granules were produced in an instrumented bench-scale Glatt WSG5 fluid bed granulator. The effect of inlet air humidity and granulation liquid feed on the temperature measurements at different locations of a fluid bed granulator system were determined. This revealed dynamic changes in the measurements and enabled finding the most optimal sites for process control. The moisture originating from the granulation liquid and inlet air affected the temperature of the mass and pressure difference over granules. Moreover, the effects of inlet air humidity and granulation liquid feed rate on granule size were evaluated and compensatory techniques used to optimize particle size. Various end-point indication techniques of drying were compared. The ∆T method, which is based on thermodynamic principles, eliminated the effects of humidity variations and resulted in the most precise estimation of the drying end-point. The influence of fluidisation behaviour on drying end-point detection was determined. The feasibility of the ∆T method and thus the similarities of end-point moisture contents were found to be dependent on the variation in fluidisation between manufacturing batches. A novel parameter that describes behaviour of material in a fluid bed was developed. Flow rate of the process air and turbine fan speed were used to calculate this parameter and it was compared to the fluidisation behaviour and the particle size results. The design space process trajectories for smooth fluidisation based on the fluidisation parameters were determined. With this design space it is possible to avoid excessive fluidisation and improper fluidisation and bed collapse. Furthermore, various process phenomena and failure modes were observed with the in-line particle size analyser. Both rapid increase and a decrease in granule size could be monitored in a timely manner. The fluidisation parameter and the pressure difference over filters were also discovered to express particle size when the granules had been formed. The various physical parameters evaluated in this thesis give valuable information of fluid bed process performance and increase the process understanding.

Psychophysiology of flow experience : An explorative study

This study explored the possibilities the psychophysiological methodology offer to flow research. Facial electromyography has often been used to index valence, and electrodermal activity to index arousal, the two basic dimensions of emotion. It was hypothesized that these measures can also be used to examine enjoyment, a basic component of flow experiment. A digital game was used to induce flow, and physiological activity of 32 subjects was measured continuously. Flow State Scale was used to assess flow. Activity of corrugator supercilii muscle, an index of negative valence, was negatively correlated with flow reports, as hypothesized. Contrary to hypothesis, skin conductance level, an index of arousal, was unrelated to self-reported flow. The results for association between flow and zygomaticus major and orbicularis oculi muscle activities, indices of positive valence, were inconclusive, possibly due to experimental design where only tonic measures were available. Psychophysiological methods are recommended for future studies of flow. Specifically, the time series approach may be particularly viable in examining the temporal aspects of flow, an area currently unexplored. Furthermore, it is suggested that digital game research would benefit from psychophysiological study of game-related flow.

ISO 13567 - The Proposed International Standard for Structuring Layers in Computer Aided Building Design

Layering is a widely used method for structuring data in CAD-models. During the last few years national standardisation organisations, professional associations, user groups for particular CAD-systems, individual companies etc. have issued numerous standards and guidelines for the naming and structuring of layers in building design. In order to increase the integration of CAD data in the industry as a whole ISO recently decided to define an international standard for layer usage. The resulting standard proposal, ISO 13567, is a rather complex framework standard which strives to be more of a union than the least common denominator of the capabilities of existing guidelines. A number of principles have been followed in the design of the proposal. The first one is the separation of the conceptual organisation of information (semantics) from the way this information is coded (syntax). The second one is orthogonality - the fact that many ways of classifying information are independent of each other and can be applied in combinations. The third overriding principle is the reuse of existing national or international standards whenever appropriate. The fourth principle allows users to apply well-defined subsets of the overall superset of possible layernames. This article describes the semantic organisation of the standard proposal as well as its default syntax. Important information categories deal with the party responsible for the information, the type of building element shown, whether a layer contains the direct graphical description of a building part or additional information needed in an output drawing etc. Non-mandatory information categories facilitate the structuring of information in rebuilding projects, use of layers for spatial grouping in large multi-storey projects, and storing multiple representations intended for different drawing scales in the same model. Pilot testing of ISO 13567 is currently being carried out in a number of countries which have been involved in the definition of the standard. In the article two implementations, which have been carried out independently in Sweden and Finland, are described. The article concludes with a discussion of the benefits and possible drawbacks of the standard. Incremental development within the industry, (where ”best practice” can become ”common practice” via a standard such as ISO 13567), is contrasted with the more idealistic scenario of building product models. The relationship between CAD-layering, document management product modelling and building element classification is also discussed.

Psychologically-Based and Content-Oriented Experience in Entertainment Virtual Environments

In daily life, rich experiences evolve in every environmental and social interaction. Because experience has a strong impact on how people behave, scholars in different fields are interested in understanding what constitutes an experience. Yet even if interest in conscious experience is on the increase, there is no consensus on how such experience should be studied. Whatever approach is taken, the subjective and psychologically multidimensional nature of experience should be respected. This study endeavours to understand and evaluate conscious experiences. First I intro-duce a theoretical approach to psychologically-based and content-oriented experience. In the experiential cycle presented here, classical psychology and orienting-environmental content are connected. This generic approach is applicable to any human-environment interaction. Here I apply the approach to entertainment virtual environments (VEs) such as digital games and develop a framework with the potential for studying experiences in VEs. The development of the methodological framework included subjective and objective data from experiences in the Cave Automatic Virtual Environment (CAVE) and with numerous digital games (N=2,414). The final framework consisted of fifteen factor-analytically formed subcomponents of the sense of presence, involvement and flow. Together, these show the multidimensional experiential profile of VEs. The results present general experiential laws of VEs and show that the interface of a VE is related to (physical) presence, which psychologically means attention, perception and the cognitively evaluated realness and spatiality of the VE. The narrative of the VE elicits (social) presence and involvement and affects emotional outcomes. Psychologically, these outcomes are related to social cognition, motivation and emotion. The mechanics of a VE affect the cognitive evaluations and emotional outcomes related to flow. In addition, at the very least, user background, prior experience and use context affect the experiential variation. VEs are part of many peoples lives and many different outcomes are related to them, such as enjoyment, learning and addiction, depending on who is making the evalua-tion. This makes VEs societally important and psychologically fruitful to study. The approach and framework presented here contribute to our understanding of experiences in general and VEs in particular. The research can provide VE developers with a state-of-the art method (www.eveqgp.fi) that can be utilized whenever new product and service concepts are designed, prototyped and tested.