The prehistory of Suomussalmi, eastern Finland; the first billion years as revealed by isotopes and the composition of granitoid suites

The four papers summarized in this thesis deal with the Archean and earliest Paleoproterozoic granitoid suites observed in the Suomussalmi district, eastern Finland. Geologically, the area belongs to the Kianta Complex of the Western Karelian Terrane in the Karelian Province of the Fennoscandian shield. The inherited zircons up to 3440 Ma old together with Sm Nd and Pb Pb data confirm the existence of previously anticipated Paleoarchean protocrust in Suomussalmi. The general timeline of granitoid magmatism is similar to that of the surrounding areas. TTG magmatism occurred in three distinct phases: ca 2.95 Ga, 2.83 2.78 Ga and 2.76 2.74 Ga. In Suomussalmi the TTGs sensu stricto (K2O/Na2O less than 0.5) belong to the low-HREE type and are interpreted as partial melts of garnet amphibolites, which did not significantly interact with mantle peridotites. Transitional TTGs (K2O/Na2O more than 0.5), present in Suomussalmi and absent from surrounding areas, display higher LILE concentrations, but otherwise closely resemble the TTGs sensu stricto and indicate that recycling of felsic crust commenced in Suomussalmi 200 Ma earlier than in surrounding areas. The youngest TTG phase was coeval with the intrusion of the Likamännikkö quartz alkali feldspar syenite (2741 ± 2 Ma) complex. The complex contains angular fragments of ultrabasic rock, which display considerable compositional heterogeneity and are interpreted as cumulates containing clinopyroxene (generally altered to actinolite), apatite, allanite, epidote, and albite. The quartz alkali feldspar syenite cannot be regarded as alkaline sensu stricto, despite clear alkaline affinities. Within Likamännikkö there are also calcite carbonatite patches, which display mantle-like O- and C-isotope values, as well as trace element characteristics consistent with a magmatic origin, and could thus be among the oldest known carbonatites in the world. Sanukitoid (2.73 2.71 Ga) and quartz diorite suites (2.70 Ga) overlap within error margins and display compositional similarities, but can be differentiated from each other on the basis of higher Ba, K2O and LREE contents of the sanukitoids. The Likamännikkö complex, sanukitoids and quartz diorites are interpreted as originating from the metasomatized mantle and mark the diversification of the granitoid clan after 200 Ma of evolution dominated by the TTG suite. Widespread migmatization and the intrusion of anatectic leucogranitoids as dykes and intrusions of varying size took place at 2.70 2.69 Ga, following collisional thickening of the crust. The leucogranitoids and leucosomes of migmatized TTGs are compositionally alike and characterized by high silica contents and a leucocratic appearance. Due to compositional overlap, definitive discrimination between leucogranitoids and transitional TTGs requires isotope datings and/or knowledge of field relationships. Leucogranitoids represent partial melts of the local TTGs, both the sensu stricto and transitional types, mostly derived under water fluxed conditions, with possible fluid sources being late sanukitoids and quartz diorites as well as dehydrating lower crust. The Paleoproterozoic 2.44 2.39 Ga A-type granitoids of the Kianta Complex emplaced in an extensional environment are linked to the coeval and more widespread mafic intrusions and dykes observed over most of the Archean nucleus of the Fennoscandian shield. The A-type intrusions in the Suomussalmi area are interpreted as partial melts of the Archean lower crust and display differences in composition and magnetite content, which indicate differences in the composition and oxidation state of the source.

Loading of itraconazole into porous silica and silicon microparticles: characterization and dissolution tests

Most new drug molecules discovered today suffer from poor bioavailability. Poor oral bioavailability results mainly from poor dissolution properties of hydrophobic drug molecules, because the drug dissolution is often the rate-limiting event of the drug’s absorption through the intestinal wall into the systemic circulation. During the last few years, the use of mesoporous silica and silicon particles as oral drug delivery vehicles has been widely studied, and there have been promising results of their suitability to enhance the physicochemical properties of poorly soluble drug molecules. Mesoporous silica and silicon particles can be used to enhance the solubility and dissolution rate of a drug by incorporating the drug inside the pores, which are only a few times larger than the drug molecules, and thus, breaking the crystalline structure into a disordered, amorphous form with better dissolution properties. Also, the high surface area of the mesoporous particles improves the dissolution rate of the incorporated drug. In addition, the mesoporous materials can also enhance the permeability of large, hydrophilic drug substances across biological barriers. T he loading process of drugs into silica and silicon mesopores is mainly based on the adsorption of drug molecules from a loading solution into the silica or silicon pore walls. There are several factors that affect the loading process: the surface area, the pore size, the total pore volume, the pore geometry and surface chemistry of the mesoporous material, as well as the chemical nature of the drugs and the solvents. Furthermore, both the pore and the surface structure of the particles also affect the drug release kinetics. In this study, the loading of itraconazole into mesoporous silica (Syloid AL-1 and Syloid 244) and silicon (TOPSi and TCPSi) microparticles was studied, as well as the release of itraconazole from the microparticles and its stability after loading. Itraconazole was selected for this study because of its highly hydrophobic and poorly soluble nature. Different mesoporous materials with different surface structures, pore volumes and surface areas were selected in order to evaluate the structural effect of the particles on the loading degree and dissolution behaviour of the drug using different loading parameters. The loaded particles were characterized with various analytical methods, and the drug release from the particles was assessed by in vitro dissolution tests. The results showed that the loaded drug was apparently in amorphous form after loading, and that the loading process did not alter the chemical structure of the silica or silicon surface. Both the mesoporous silica and silicon microparticles enhanced the solubility and dissolution rate of itraconazole. Moreover, the physicochemical properties of the particles and the loading procedure were shown to have an effect on the drug loading efficiency and drug release kinetics. Finally, the mesoporous silicon particles loaded with itraconazole were found to be unstable under stressed conditions (at 38 qC and 70 % relative humidity).