Cryptographic Software Export Controls in the EU

Certain software products employing digital techniques for encryption of data are subject to export controls in the EU Member States pursuant to Community law and relevant laws in the Member States. These controls are agreed globally in the framework of the so-called Wassenaar Arrangement. Wassenaar is an informal non-proliferation regime aimed at promoting international stability and responsibility in transfers of strategic (dual-use) products and technology. This thesis covers provisions of Wassenaar, Community export control laws and export control laws of Finland, Sweden, Germany, France and United Kingdom. This thesis consists of five chapters. The first chapter discusses the ratio of export control laws and the impact they have on global trade. The ratio is originally defence-related - in general to prevent potential adversaries of participating States from having the same tools, and in particular in the case of cryptographic software to enable signals intelligence efforts. Increasingly as the use of cryptography in a civilian context has mushroomed, export restrictions can have negative effects on civilian trade. Information security solutions may also be took weak because of export restrictions on cryptography. The second chapter covers the OECD's Cryptography Policy, which had a significant effect on its member nations' national cryptography policies and legislation. The OECD is a significant organization,because it acts as a meeting forum for most important industrialized nations. The third chapter covers the Wassenaar Arrangement. The Arrangement is covered from the viewpoint of international law and politics. The Wassenaar control list provisions affecting cryptographic software transfers are also covered in detail. Control lists in the EU and in Member States are usually directly copied from Wassenaar control lists. Controls agreed in its framework set only a minimum level for participating States. However, Wassenaar countries can adopt stricter controls. The fourth chapter covers Community export control law. Export controls are viewed in Community law as falling within the domain of Common Commercial Policy pursuant to Article 133 of the EC Treaty. Therefore the Community has exclusive competence in export matters, save where a national measure is authorized by the Community or falls under foreign or security policy derogations established in Community law. The Member States still have a considerable amount of power in the domain of Common Foreign and Security Policy. They are able to maintain national export controls because export control laws are not fully harmonized. This can also have possible detrimental effects on the functioning of internal market and common export policies. In 1995 the EU adopted Dual-Use Regulation 3381/94/EC, which sets common rules for exports in Member States. Provisions of this regulation receive detailed coverage in this chapter. The fifth chapter covers national legislation and export authorization practices in five different Member States - in Finland, Sweden, Germany, France and in United Kingdom. Export control laws of those Member States are covered when the national laws differ from the uniform approach of the Community's acquis communautaire. Keywords: export control, encryption, software, dual-use, license, foreign trade, e-commerce, Internet

Export of organic matter, sulphate and base cations from boreal headwater catchments downstream to the coast: impacts of land use and climate

The terrestrial export of dissolved organic matter (DOM) is associated with climate, vegetation and land use, and thus is under the influence of climatic variability and human interference with terrestrial ecosystems, their soils and hydrological cycles. The present study provides an assessment of spatial variation of DOM concentrations and export, and interactions between DOM, catchment characteristics, land use and climatic factors in boreal catchments. The influence of catchment characteristics, land use and climatic drivers on the concentrations and export of total organic carbon (TOC), total organic nitrogen (TON) and dissolved organic phosphorus (DOP) was estimated using stream water quality, forest inventory and climatic data from 42 Finnish pristine forested headwater catchments, and water quality monitoring, GIS land use, forest inventory and climatic data from the 36 main Finnish rivers (and their sub-catchments) flowing to the Baltic Sea. Moreover, the export of DOM in relation to land use along a European climatic gradient was studied using river water quality and land use data from four European areas. Additionally, the role of organic and minerogenic acidity in controlling pH levels in Finnish rivers and pristine streams was studied by measuring organic anion, sulphate (SO4) and base cation (Ca, Mg, K and Na) concentrations. In all study catchments, TOC was a major fraction of DOM, with much lower proportions of TON and DOP. Moreover, most of TOC and TON was in a dissolved form. The correlation between TOC and TON concentrations was strong and TOC concentrations explained 78% of the variation in TON concentrations in pristine headwater streams. In a subgroup of 20 headwater catchments with similar climatic conditions and low N deposition in eastern Finland, the proportion of peatlands in the catchment and the proportion of Norway spruce (Picea abies Karsten) of the tree stand had the strongest correlation with the TOC and TON concentrations and export. In Finnish river basins, TOC export increased with the increasing proportion of peatland in the catchment, whereas TON export increased with increasing extent of agricultural land. The highest DOP concentrations and export were recorded in river basins with a high extent of agricultural land and urban areas, reflecting the influence of human impact on DOP loads. However, the most important predictor for TOC, TON and DOP export in Finnish rivers was the proportion of upstream lakes in the catchment. The higher the upstream lake percentage, the lower the export indicating organic matter retention in lakes. Molar TOC:TON ratio decreased from headwater catchments covered by forests and peatlands to the large river basins with mixed land use, emphasising the effect of the land use gradient on the stoichiometry of rivers. This study also demonstrated that the land use of the catchments is related to both organic and minerogenic acidity in rivers and pristine headwater streams. Organic anion dominated in rivers and streams situated in northern Finland, reflecting the higher extent of peatlands in these areas, whereas SO4 dominated in southern Finland and on western coastal areas, where the extent of fertile areas, agricultural land, urban areas, acid sulphate soils, and sulphate deposition is highest. High TOC concentrations decreased pH values in the stream and river water, whereas no correlation between SO4 concentrations and pH was observed. This underlines the importance of organic acids in controlling pH levels in Finnish pristine headwater streams and main rivers. High SO4 concentrations were associated with high base cation concentrations and fertile areas, which buffered the effects of SO4 on pH.

Pre-harvest measurement of pine stands for sawing production planning.

To enhance the utilization of the wood, the sawmills are forced to place more emphasis on planning to master the whole production chain from the forest to the end product. One significant obstacle to integrating the forest-sawmill-market production chain is the lack of appropriate information about forest stands. Since the wood procurement point of view in forest planning systems has been almost totally disregarded there has been a great need to develop an easy and efficient pre-harvest measurement method, allowing separate measurement of stands prior to harvesting. The main purpose of this study was to develop a measurement method for pine stands which forest managers could use in describing the properties of the standing trees for sawing production planning. Study materials were collected from ten Scots pine stands (Pinus sylvestris) located in North Häme and South Pohjanmaa, in southern Finland. The data comprise test sawing data on 314 pine stems, dbh and height measures of all trees and measures of the quality parameters of pine sawlog stems in all ten study stands as well as the locations of all trees in six stands. The study was divided into four sub-studies which deal with pine quality prediction, construction of diameter and dead branch height distributions, sampling designs and applying height and crown height models. The final proposal for the pre-harvest measurement method is a synthesis of the individual sub-studies. Quality analysis resulted in choosing dbh, distance from stump height to the first dead branch (dead branch height), crown height and tree height as the most appropriate quality characteristics of Scots pine. Dbh and dead branch height are measured from each pine sample tree while height and crown height are derived from dbh measures by aid of mixed height and crown height models. Pine and spruce diameter distribution as well as dead branch height distribution are most effectively predicted by the kernel function. Roughly 25 sample trees seems to be appropriate in pure pine stands. In mixed stands the number of sample trees needs to be increased in proportion to the intensity of pines in order to attain the same level of accuracy.

Estimation of cutting volume with three inventory methods for harvest planning in Canadian boreal forests.

Two methods of pre-harvest inventory were designed and tested on three cutting sites containing a total of 197 500 m3 of wood. These sites were located on flat-ground boreal forests located in northwestern Quebec. Both methods studied involved scaling of trees harvested to clear the road path one year (or more) prior to harvest of adjacent cut-blocks. The first method (ROAD) considers the total road right-of-way volume divided by the total road area cleared. The resulting volume per hectare is then multiplied by the total cut-block area scheduled for harvest during the following year to obtain the total estimated cutting volume. The second method (STRATIFIED) also involves scaling of trees cleared from the road. However, in STRATIFIED, log scaling data are stratified by forest stand location. A volume per hectare is calculated for each stretch of road that crosses a single forest stand. This volume per hectare is then multiplied by the remaining area of the same forest stand scheduled for harvest one year later. The sum of all resulting estimated volumes per stand gives the total estimated cutting-volume for all cut-blocks adjacent to the studied road. A third method (MNR) was also used to estimate cut-volumes of the sites studied. This method represents the actual existing technique for estimating cutting volume in the province of Quebec. It involves summing the cut volume for all forest stands. The cut volume is estimated by multiplying the area of each stand by its estimated volume per hectare obtained from standard stock tables provided by the governement. The resulting total estimated volume per cut-block for all three methods was then compared with the actual measured cut-block volume (MEASURED). This analysis revealed a significant difference between MEASURED and MNR methods with the MNR volume estimate being 30 % higher than MEASURED. However, no significant difference from MEASURED was observed for volume estimates for the ROAD and STRATIFIED methods which respectively had estimated cutting volumes 19 % and 5 % lower than MEASURED. Thus the ROAD and STRATIFIED methods are good ways to estimate cut-block volumes after road right-of-way harvest for conditions similar to those examined in this study.