Technical efficiency of blood component preparation in blood centres of 10 European countries

Various reasons, such as ethical issues in maintaining blood resources, growing costs, and strict requirements for safe blood, have increased the pressure for efficient use of resources in blood banking. The competence of blood establishments can be characterized by their ability to predict the volume of blood collection to be able to provide cellular blood components in a timely manner as dictated by hospital demand. The stochastically varying clinical need for platelets (PLTs) sets a specific challenge for balancing supply with requests. Labour has been proven a primary cost-driver and should be managed efficiently. International comparisons of blood banking could recognize inefficiencies and allow reallocation of resources. Seventeen blood centres from 10 countries in continental Europe, Great Britain, and Scandinavia participated in this study. The centres were national institutes (5), parts of the local Red Cross organisation (5), or integrated into university hospitals (7). This study focused on the departments of blood component preparation of the centres. The data were obtained retrospectively by computerized questionnaires completed via Internet for the years 2000-2002. The data were used in four original articles (numbered I through IV) that form the basis of this thesis. Non-parametric data envelopment analysis (DEA, II-IV) was applied to evaluate and compare the relative efficiency of blood component preparation. Several models were created using different input and output combinations. The focus of comparisons was on the technical efficiency (II-III) and the labour efficiency (I, IV). An empirical cost model was tested to evaluate the cost efficiency (IV). Purchasing power parities (PPP, IV) were used to adjust the costs of the working hours and to make the costs comparable among countries. The total annual number of whole blood (WB) collections varied from 8,880 to 290,352 in the centres (I). Significant variation was also observed in the annual volume of produced red blood cells (RBCs) and PLTs. The annual number of PLTs produced by any method varied from 2,788 to 104,622 units. In 2002, 73% of all PLTs were produced by the buffy coat (BC) method, 23% by aphaeresis and 4% by the platelet-rich plasma (PRP) method. The annual discard rate of PLTs varied from 3.9% to 31%. The mean discard rate (13%) remained in the same range throughout the study period and demonstrated similar levels and variation in 2003-2004 according to a specific follow-up question (14%, range 3.8%-24%). The annual PLT discard rates were, to some extent, associated with production volumes. The mean RBC discard rate was 4.5% (range 0.2%-7.7%). Technical efficiency showed marked variation (median 60%, range 41%-100%) among the centres (II). Compared to the efficient departments, the inefficient departments used excess labour resources (and probably) production equipment to produce RBCs and PLTs. Technical efficiency tended to be higher when the (theoretical) proportion of lost WB collections (total RBC+PLT loss) from all collections was low (III). The labour efficiency varied remarkably, from 25% to 100% (median 47%) when working hours were the only input (IV). Using the estimated total costs as the input (cost efficiency) revealed an even greater variation (13%-100%) and overall lower efficiency level compared to labour only as the input. In cost efficiency only, the savings potential (observed inefficiency) was more than 50% in 10 departments, whereas labour and cost savings potentials were both more than 50% in six departments. The association between department size and efficiency (scale efficiency) could not be verified statistically in the small sample. In conclusion, international evaluation of the technical efficiency in component preparation departments revealed remarkable variation. A suboptimal combination of manpower and production output levels was the major cause of inefficiency, and the efficiency did not directly relate to production volume. Evaluation of the reasons for discarding components may offer a novel approach to study efficiency. DEA was proven applicable in analyses including various factors as inputs and outputs. This study suggests that analytical models can be developed to serve as indicators of technical efficiency and promote improvements in the management of limited resources. The work also demonstrates the importance of integrating efficiency analysis into international comparisons of blood banking.

Carbon balance and component CO2 fluxes in boreal Scots pine stands

The forest vegetation takes up atmospheric carbon dioxide (CO2) in photosynthesis. Part of the fixed carbon is released back into the atmosphere during plant respiration but a substantial part is stored as plant biomass, especially in the stems of trees. Carbon also accumulates in the soil as litter and via the roots. CO2 is released into the atmosphere from these carbon stocks in the decomposition of dead biomass. Carbon balance of a forest stand is the difference between the CO2 uptake and CO2 efflux. This study quantifies and analyses the dynamics of carbon balance and component CO2 fluxes in four Southern Finnish Scots pine stands that covered the typical economic rotation time of 80 years. The study was based on direct flux measurements with chambers and eddy covariance (EC), and modelling of component CO2 fluxes. The net CO2 exchange of the stand was partitioned into component fluxes: photosynthesis of trees and ground vegetation, respiration of tree foliage and stems, and CO2 efflux from the soil. The relationships between the component fluxes and the environmental factors (light, temperature, atmospheric CO2, air humidity and soil moisture) were studied with mathematical modelling. The annual CO2 balance varied from a source of about 400 g C/m2 at a recently clearcut site to net CO2 uptake of 200 300 g C/m2 in a middle-aged (40-year-old) and a mature (75-year-old) stand. A 12-year-old sapling site was at the turning point from source to a sink of CO2. In the middle-aged stand, photosynthetic production was dominated by trees. Under closed pine canopies, ground vegetation accounted for 10 20% of stand photosynthesis whereas at the open sites the proportion and also the absolute photosynthesis of ground vegetation was much higher. The aboveground respiration was dominated by tree foliage which accounted for one third of the ecosystem respiration. Rate of wood respiration was in the order of 10% of total ecosystem respiration. CO2 efflux from the soil dominated the ecosystem respiratory fluxes in all phases of stand development. Instantaneous and delayed responses to the environmental driving factors could predict well within-year variability in photosynthetic production: In the short term and during the growing season photosynthesis follows primarily light while the seasonal variation is more strongly connected to temperature. The temperature relationship of the annual cycle of photosynthesis was found to be almost equal in the southern boreal zone and at the timberline in the northern boreal zone. The respiratory fluxes showed instantaneous and seasonal temperature relationships but they could also be connected to photosynthesis at an annual timescale.

Macroseismology as a Component of Seismicity Assessments in an Intraplate Region: Studies of Northern Europe with Emphasis on Finland

This work focuses on the role of macroseismology in the assessment of seismicity and probabilistic seismic hazard in Northern Europe. The main type of data under consideration is a set of macroseismic observations available for a given earthquake. The macroseismic questionnaires used to collect earthquake observations from local residents since the late 1800s constitute a special part of the seismological heritage in the region. Information of the earthquakes felt on the coasts of the Gulf of Bothnia between 31 March and 2 April 1883 and on 28 July 1888 was retrieved from the contemporary Finnish and Swedish newspapers, while the earthquake of 4 November 1898 GMT is an example of an early systematic macroseismic survey in the region. A data set of more than 1200 macroseismic questionnaires is available for the earthquake in Central Finland on 16 November 1931. Basic macroseismic investigations including preparation of new intensity data point (IDP) maps were conducted for these earthquakes. Previously disregarded usable observations were found in the press. The improved collection of IDPs of the 1888 earthquake shows that this event was a rare occurrence in the area. In contrast to earlier notions it was felt on both sides of the Gulf of Bothnia. The data on the earthquake of 4 November 1898 GMT were augmented with historical background information discovered in various archives and libraries. This earthquake was of some concern to the authorities, because extra fire inspections were conducted in three towns at least, i.e. Tornio, Haparanda and Piteå, located in the centre of the area of perceptibility. This event posed the indirect hazard of fire, although its magnitude around 4.6 was minor on the global scale. The distribution of slightly damaging intensities was larger than previously outlined. This may have resulted from the amplification of the ground shaking in the soft soil of the coast and river valleys where most of the population was found. The large data set of the 1931 earthquake provided an opportunity to apply statistical methods and assess methodologies that can be used when dealing with macroseismic intensity. It was evaluated using correspondence analysis. Different approaches such as gridding were tested to estimate the macroseismic field from the intensity values distributed irregularly in space. In general, the characteristics of intensity warrant careful consideration. A more pervasive perception of intensity as an ordinal quantity affected by uncertainties is advocated. A parametric earthquake catalogue comprising entries from both the macroseismic and instrumental era was used for probabilistic seismic hazard assessment. The parametric-historic methodology was applied to estimate seismic hazard at a given site in Finland and to prepare a seismic hazard map for Northern Europe. The interpretation of these results is an important issue, because the recurrence times of damaging earthquakes may well exceed thousands of years in an intraplate setting such as Northern Europe. This application may therefore be seen as an example of short-term hazard assessment.