Jung and Goddess: the significance of Jungian and post-Jungian theory to the development of the Western Goddess Movement

This study is concerned with the significance of Jungian and post-Jungian theory to the development of the contemporary Western Goddess Movement, which includes the various self-identified nature-based, Pagan, Goddess Feminism, Goddess Consciousness, Goddess Spirituality, Wicca, and Goddess-centred faith traditions that have seen a combined increase in Western adherents over the past five decades and share a common goal to claim Goddess as an active part of Western consciousness and faith traditions. The Western Goddess Movement has been strongly influenced by Jung’s thought, and by feminist revisions of Jungian Theory, sometimes interpreted idiosyncratically, but presented as a route to personal and spiritual transformation. The analysis examines ways in which women encounter Goddess through a process of Jungian Individuation and traces the development of Jungian and post-Jungian theories by identifying the key thinkers and central ideas that helped to shape the development of the Western Goddess Movement. It does so through a close reading and analysis of five biographical ‘rebirth’ memoirs published between 1981 and 1998: Christine Downing’s (1981) The Goddess: Mythological Images of the Feminine; Jean Shinoda Bolen’s (1994) Crossing to Avalon: A Woman’s Midlife Pilgrimage; Sue Monk Kidd’s (1996) The Dance of the Dissident Daughter: A Woman’s Journey from Christian Tradition to the Sacred Feminine; Margaret Starbird’s (1998) The Goddess in the Gospels: Reclaiming the Sacred Feminine; and Phyllis Curott’s (1998) Book of Shadows: A Modern Woman’s Journey into the Wisdom of Witchcraft and the Magic of the Goddess. These five memoirs reflect the diversity of the faith traditions in the Western Goddess Movement. The enquiry centres upon two parallel and complementary research threads: 1) critically examining the content of the memoirs in order to determine their contribution to the development of the Goddess Movement and 2) charting and sourcing the development of the major Jungian and post-Jungian theories championed in the memoirs in order to evaluate the significance of Jungian and post-Jungian thought in the Movement. The aim of this study was to gain a better understanding of the original research question: what is the significance of Jungian and post-Jungian theory for the development of the Western Goddess Movement? Each memoir is subjected to critical review of its intended audiences, its achievements, its functions and strengths, and its theoretical frameworks. Research results offered more than the experiences of five Western women, it also provided evidence to analyse the significance of Jungian and post-Jungian theory to the development of the Western Goddess Movement. The findings demonstrate the vital contributions of the analytical psychology of Carl Jung, and post-Jungians M Esther Harding, Erich Neumann, Christine Downing, E.C. Whitmont, and Jean Shinoda Bolen; the additional contributions of Sue Monk Kidd, Margaret Starbird, and Phyllis Curott, and exhibit Jungian and post-Jungian pathways to Goddess. Through a variety of approaches to Jungian categories, these memoirs constitute a literature of Individuation for the Western Goddess Movement.

The development of planar high-K/III-V p-channel MOSFETs for post-silicon CMOS

Conventional Si complementary-metal-oxide-semiconductor (CMOS) scaling is fast approaching its limits. The extension of the logic device roadmap for future enhancements in transistor performance requires non-Si materials and new device architectures. III-V materials, due to their superior electron transport properties, are well poised to replace Si as the channel material beyond the 10nm technology node to mitigate the performance loss of Si transistors from further reductions in supply voltage to minimise power dissipation in logic circuits. However several key challenges, including a high quality dielectric/III-V gate stack, a low-resistance source/drain (S/D) technology, heterointegration onto a Si platform and a viable III-V p-metal-oxide-semiconductor field-effect-transistor (MOSFET), need to be addressed before III-Vs can be employed in CMOS. This Thesis specifically addressed the development and demonstration of planar III-V p-MOSFETs, to complement the n-MOSFET, thereby enabling an all III-V CMOS technology to be realised. This work explored the application of InGaAs and InGaSb material systems as the channel, in conjunction with Al2O3/metal gate stacks, for p-MOSFET development based on the buried-channel flatband device architecture. The body of work undertaken comprised material development, process module development and integration into a robust fabrication flow for the demonstration of p-channel devices. The parameter space in the design of the device layer structure, based around the III-V channel/barrier material options of In_x≥0.53Ga_1-xAs/In_0.52Al_0.48As and In_x≥0.1Ga_1-xSb/AlSb, was systematically examined to improve hole channel transport. A mobility of 433 cm²/Vs, the highest room temperature hole mobility of any InGaAs quantum-well channel reported to date, was obtained for the In_0.85Ga_0.15As (2.1% strain) structure. S/D ohmic contacts were developed based on thermally annealed Au/Zn/Au metallisation and validated using transmission line model test structures. The effects of metallisation thickness, diffusion barriers and de-oxidation conditions were examined. Contacts to InGaSb-channel structures were found to be sensitive to de-oxidation conditions. A fabrication process, based on a lithographically-aligned double ohmic patterning approach, was realised for deep submicron gate-to-source/drain gap (L_side) scaling to minimise the access resistance, thereby mitigating the effects of parasitic S/D series resistance on transistor performance. The developed process yielded gaps as small as 20nm. For high-k integration on GaSb, ex-situ ammonium sulphide ((NH₄)₂S) treatments, in the range 1%-22%, for 10min at 295K were systematically explored for improving the electrical properties of the Al₂O₃/GaSb interface. Electrical and physical characterisation indicated the 1% treatment to be most effective with interface trap densities in the range of 4 - 10×10¹²cm^-2eV^-1 in the lower half of the bandgap. An extended study, comprising additional immersion times at each sulphide concentration, was further undertaken to determine the surface roughness and the etching nature of the treatments on GaSb. A number of p-MOSFETs based on III-V-channels with the most promising hole transport and integration of the developed process modules were successfully demonstrated in this work. Although the non-inverted InGaAs-channel devices showed good current modulation and switch-off characteristics, several aspects of performance were non-ideal; depletion-mode operation, modest drive current (I_d,sat=1.14mA/mm), double peaked transconductance (g_m=1.06mS/mm), high subthreshold swing (SS=301mV/dec) and high on-resistance (R_on=845kΩ.μm). Despite demonstrating substantial improvement in the on-state metrics of I_d,sat (11×), g_m (5.5×) and R_on (5.6×), inverted devices did not switch-off. Scaling gate-to-source/drain gap (L_side) from 1μm down to 70nm improved I_d,sat (72.4mA/mm) by a factor of 3.6 and gm (25.8mS/mm) by a factor of 4.1 in inverted InGaAs-channel devices. Well-controlled current modulation and good saturation behaviour was observed for InGaSb-channel devices. In the on-state In_0.3Ga_0.7Sb-channel (I_d,sat=49.4mA/mm, g_m=12.3mS/mm, R_on=31.7kΩ.μm) and In_0.4Ga_0.6Sb-channel (I_d,sat=38mA/mm, g_m=11.9mS/mm, R_on=73.5kΩ.μm) devices outperformed the InGaAs-channel devices. However the devices could not be switched off. These findings indicate that III-V p-MOSFETs based on InGaSb as opposed to InGaAs channels are more suited as the p-channel option for post-Si CMOS.

Pre-colonial institutions and long-run development in Latin America

The present doctoral thesis studies the association between pre-colonial institutions and long-run development in Latin America. The thesis is organised as follows: Chapter 1 places the motivation of the thesis by underlying relevant contributions in the literature on long-run development. I then set out the main objective of the thesis, followed by a brief outline of it. In Chapter 2, I study the effects of pre-colonial institutions on present-day socioeconomic outcomes for Latin America. The main thesis of this chapter is that more advanced pre-colonial institutions relate to better socioeconomic outcomes today - principally, but not only, through their effects on the Amerindian population. I test such hypothesis with a dataset of 324 sub-national administrative units covering all mainland Latin American countries. The extensive range of controls covers factors such as climate, location, natural resources, colonial activities and pre-colonial characteristics - plus country fixed effects. Results strongly support the main thesis. In Chapter 3, I further analyse the association between pre-colonial institutions and present-day economic development in Latin America by using the historical ethnic homelands as my main unit of analysis. The main hypothesis is that ethnic homelands inhabited by more advanced ethnic groups -as measured by their levels of institutional complexity- relate to better economic development today. To track these long-run effects, I construct a new dataset by digitising historiographical maps allowing me to pinpoint the geospatial location of ethnic homelands as of the XVI century. As a result, 375 ethnic homelands are created. I then capture the levels of economic development at the ethnic homeland level by making use of alternative economic measures --satellite light density data. After controlling for country-specific characteristics and applying a large battery of geographical, locational, and historical factors, I found that the effects of pre-colonial institutions relate to a higher light density --as a proxy for economic activity- in ethnic homelands where more advanced ethnic groups lived. In Chapter 4, I explore a mechanism linking the persistence of pre-colonial institutions in Latin America over the long-run: Colonial and post-colonial strategies along with the ethnic political capacity worked in tandem allowing larger Amerindian groups to "support" the new political systems in ways that would benefit their respective ethnic groups as well as the population at large. This mechanism may have allowed the effects of pre-colonial institutions to influence socioeconomic development outcomes up to today. To shed lights on this mechanism, I combine the index of pre-colonial institutions prepared for the second chapter of the present thesis with individual-level survey data on people's attitudes. By controlling for key observable and unobservable country-specific characteristics, the main empirical results show that areas with a history of more advanced pre-colonial institutions increase the probability of individuals supporting present-day political institutions. Finally, in Chapter 5, I summarise the main findings of the thesis, and emphasise the key weaknesses of the study as well as potential avenues for future research.

Polymer microspheres: synthesis, characterisation and post-functionalisation by olefin metathesis

Porous polymer particles are used in an extraordinarily wide range of advanced and everyday applications, from combinatorial chemistry, solid-phase organic synthesis and polymer-supported reagents, to environmental analyses and the purification of drinking water. The installation and exploitation of functional chemical handles on the particles is often a prerequisite for their successful exploitation, irrespective of the application and the porous nature of the particles. New methodology for the chemical modification of macroreticular polymers is the primary focus of the work presented in this thesis. Porous polymer microspheres decorated with a diverse range of functional groups were synthesised by the post-polymerisation chemical modification of beaded polymers via olefin cross metathesis. The polymer microspheres were prepared by the precipitation polymerisation of divinylbenzene in porogenic (pore-forming) solvents; the olefin cross-metathesis (CM) functionalisation reactions exploited the pendent (polymer-bound) vinyl groups that were not consumed by polymerisation. Olefin CM reactions involving the pendent vinyl groups were performed in dichloromethane using second-generation Grubbs catalyst (Grubbs II), and a wide range of coupling partners used. The results obtained indicate that high quality, porous polymer microspheres synthesised by precipitation polymerisation in near-θ solvents can be functionalised by olefin CM under very mild conditions to install a diverse range of chemical functionalities into a common polydivinylbenzene precursor. Gel-type polymer microspheres were prepared by the precipitation copolymerisation reaction of divinylbenzene and allyl methacrylate in neat acetonitrile. The unreacted pendent vinyl groups that were not consumed by polymerisation were subjected to internal and external olefin metathesis-based hypercrosslinking reactions. Internal hypercrosslinking was carried out by using ring-closing metathesis (RCM) reactions in toluene using Grubbs II catalyst. Under these conditions, hypercrosslinked (HXL) polymers with specific surface areas around 500 m2g-1 were synthesised. External hypercrosslinking was attempted by using CM/RCM in the presence of a multivinyl coupling partner in toluene using second-generation Hoveyda-Grubbs catalyst. The results obtained indicate that no HXL polymers were obtained. However, during the development of this methodology, a new type of polymerisation was discovered with tetraallylorthosilicate as monomer.