Conservation value, biodiversity value and methods of assessment in regenerating and human disturbed tropical forest

Although the value of primary forests for biodiversity conservation is well known, the potential biodiversity and conservation value of regenerating forests remains controversial. Many factors likely contribute to this, including: 1. the variable ages of regenerating forests being studied (often dominated by relatively young regenerating forests); 2. the potential for confounding on-going human disturbance (such as logging and hunting); 3. the relatively low number of multi-taxa studies; 4. the lack of studies that directly compare different historic disturbances within the same location; 5. contrasting patterns from different survey methodologies and the paucity of knowledge on the impacts across different vertical levels of rainforest biodiversity (often due to a lack of suitable methodologies available to assess them). We also know relatively little as to how biodiversity is affected by major current impacts, such as unmarked rainforest roads, which contribute to this degradation of habitat and fragmentation. This thesis explores the potential biodiversity value of regenerating rainforests under the best of scenarios and seeks to understand more about the impact of current human disturbance to biodiversity; data comes from case studies from the Manu and Sumaco Biosphere Reserves in the Western Amazon. Specifically, I compare overall biodiversity and conservation value of a best case regenerating rainforest site with a selection of well-studied primary forest sites and with predicted species lists for the region; including a focus on species of key conservation concern. I then investigate the biodiversity of the same study site in reference to different types of historic anthropogenic disturbance. Following this I investigate the impacts to biodiversity from an unmarked rainforest road. In order to understand more about the differential effects of habitat disturbance on arboreal diversity I directly assess how patterns of butterfly biodiversity vary between three vertical strata. Although assessments within the canopy have been made for birds, invertebrates and bats, very few studies have successfully targeted arboreal mammals. I therefore investigate the potential of camera traps for inventorying arboreal mammal species in comparison with traditional methodologies. Finally, in order to investigate the possibility that different survey methodologies might identify different biodiversity patterns in habitat disturbance assessments, I investigate whether two different but commonly used survey methodologies used to assess amphibians, indicate the same or different responses of amphibian biodiversity to historic habitat change by people. The regenerating rainforest study site contained high levels of species richness; both in terms of alpha diversity found in nearby primary forest areas (87% ±3.5) and in terms of predicted primary forest diversity from the region (83% ±6.7). This included 89% (39 out of 44) of the species of high conservation concern predicted for the Manu region. Faunal species richness in once completely cleared regenerating forest was on average 13% (±9.8) lower than historically selectively logged forest. The presence of the small unmarked road significantly altered levels of faunal biodiversity for three taxa, up to and potentially beyond 350m into the forest interior. Most notably, the impact on biodiversity extended to at least 32% of the whole reserve area. The assessment of butterflies across strata showed that different vertical zones within the same rainforest responded differently in areas with different historic human disturbance. A comparison between forest regenerating after selective logging and forest regenerating after complete clearance, showed that there was a 17% greater reduction in canopy species richness in the historically cleared forest compared with the terrestrial community. Comparing arboreal camera traps with traditional ground-based techniques suggests that camera traps are an effective tool for inventorying secretive arboreal rainforest mammal communities and detect a higher number of cryptic species. Finally, the two survey methodologies used to assess amphibian communities identified contrasting biodiversity patterns in a human modified rainforest; one indicated biodiversity differences between forests with different human disturbance histories, whereas the other suggested no differences between forest disturbance types. Overall, in this thesis I find that the conservation and biodiversity value of regenerating and human disturbed tropical forest can potentially contribute to rainforest biodiversity conservation, particularly in the best of circumstances. I also highlight the importance of utilising appropriate study methodologies that to investigate these three-dimensional habitats, and contribute to the development of methodologies to do so. However, care should be taken when using different survey methodologies, which can provide contrasting biodiversity patterns in response to human disturbance.

Components and circuits for tunneling diode based high frequency sources

Terahertz (THz) technology has been generating a lot of interest because of the potential applications for systems working in this frequency range. However, to fully achieve this potential, effective and efficient ways of generating controlled signals in the terahertz range are required. Devices that exhibit negative differential resistance (NDR) in a region of their current-voltage (I-V ) characteristics have been used in circuits for the generation of radio frequency signals. Of all of these NDR devices, resonant tunneling diode (RTD) oscillators, with their ability to oscillate in the THz range are considered as one of the most promising solid-state sources for terahertz signal generation at room temperature. There are however limitations and challenges with these devices, from inherent low output power usually in the range of micro-watts (uW) for RTD oscillators when milli-watts (mW) are desired. At device level, parasitic oscillations caused by the biasing line inductance when the device is biased in the NDR region prevent accurate device characterisation, which in turn prevents device modelling for computer simulations. This thesis describes work on I-V characterisation of tunnel diode (TD) and RTD (fabricated by Dr. Jue Wang) devices, and the radio frequency (RF) characterisation and small signal modelling of RTDs. The thesis also describes the design and measurement of hybrid TD oscillators for higher output power and the design and measurement of a planar Yagi antenna (fabricated by Khalid Alharbi) for THz applications. To enable oscillation free current-voltage characterisation of tunnel diodes, a commonly employed method is the use of a suitable resistor connected across the device to make the total differential resistance in the NDR region positive. However, this approach is not without problems as the value of the resistor has to satisfy certain conditions or else bias oscillations would still be present in the NDR region of the measured I-V characteristics. This method is difficult to use for RTDs which are fabricated on wafer due to the discrepancies in designed and actual resistance values of fabricated resistors using thin film technology. In this work, using pulsed DC rather than static DC measurements during device characterisation were shown to give accurate characteristics in the NDR region without the need for a stabilisation resistor. This approach allows for direct oscillation free characterisation for devices. Experimental results show that the I-V characterisation of tunnel diodes and RTD devices free of bias oscillations in the NDR region can be made. In this work, a new power-combining topology to address the limitations of low output power of TD and RTD oscillators is presented. The design employs the use of two oscillators biased separately, but with the combined output power from both collected at a single load. Compared to previous approaches, this method keeps the frequency of oscillation of the combined oscillators the same as for one of the oscillators. Experimental results with a hybrid circuit using two tunnel diode oscillators compared with a single oscillator design with similar values shows that the coupled oscillators produce double the output RF power of the single oscillator. This topology can be scaled for higher (up to terahertz) frequencies in the future by using RTD oscillators. Finally, a broadband Yagi antenna suitable for wireless communication at terahertz frequencies is presented in this thesis. The return loss of the antenna showed that the bandwidth is larger than the measured range (140-220 GHz). A new method was used to characterise the radiation pattern of the antenna in the E-plane. This was carried out on-wafer and the measured radiation pattern showed good agreement with the simulated pattern. In summary, this work makes important contributions to the accurate characterisation and modelling of TDs and RTDs, circuit-based techniques for power combining of high frequency TD or RTD oscillators, and to antennas suitable for on chip integration with high frequency oscillators.