5 resultados para tooth occlusion
em eResearch Archive - Queensland Department of Agriculture
Resumo:
A 2 × 2 factorial combination of thinned or unthinned, and pruned or unpruned 11-year-old Eucalyptus dunnii (DWG) and 12-year-old Corymbia citriodora subsp. variegata (CCV) was destructively sampled to provide 60 trees in total per species. Two 1.4 m long billets were cut from each tree and were rotary veneered in a spindleless lathe down to a 45 mm diameter core to expose knots which were classified as either alive, partially occluded or fully occluded. Non-destructive evaluation of a wider range of thinning treatments available in these trials was undertaken with Pilodyn and Fakopp tools. Disc samples were also taken for basic density and modulus of elasticity. Differences between treatments for all wood property assessments were generally small and not significantly different.Thinning and pruning had little effect on the stem diameter growth required to achieve occlusion, therefore occlusion would be more rapid after thinning due to more rapid stem diameter growth. The difference between the treatments of greatest management interest, thinned and pruned (T&P) and unthinned and unpruned (UT&UP) were small. The production of higher value clear wood produced after all knots had occluded, measured as the average stem diameter growth over occlusion of the three outermost knots, was approximately 2 centimetres diameter. Two of the treatments can be ruled out as viable management alternatives: (i) the effect of thinning without pruning (T&UP) is clear, leading to a large inner core of stem wood containing knots (large knotty core diameter) and (ii) pruning without thinning (UT&P) results in a small knotty core diameter, however the tree and therefore log diameters are also small.
Resumo:
Sheep in western Queensland have been predominantly reared for wool. When wool prices became depressed interest in the sheep meat industry, increased. For north west Queensland producers, opportunities may exist to participate in live sheep and meat export to Asia. A simulation model was developed to determine whether this sheep producing area has the capability to provide sufficient numbers of sheep under variable climatic conditions while sustaining the land resources. Maximum capacity for sustainability of resources (as described by stock numbers) was derived from an in-depth study of the agricultural and pastoral potential of Queensland. Decades of sheep production and climatic data spanning differing seasonal conditions were collated for analysis. A ruminant biology model adapted from Grazplan was used to simulate pregnancy rate. Empirical equations predict mortalities, marking rates, and weight characteristics of sheep of various ages from simple climatic measures, stocking rate and reproductive status. The initial age structure of flocks was determined by running the model for several years with historical climatic conditions. Drought management strategies such as selling a proportion of wethers progressively down to two-tooth and oldest ewes were incorporated. Management decisions such as time of joining, age at which ewes were cast-for-age, wether turn-off age and turning-off rate of lambs vary with geographical area and can be specified at run time. The model is run for sequences of climatic conditions generated stochastically from distributions based on historical climatic data correlated in some instances. The model highlights the difficulties of sustaining a consistent supply of sheep under variable climatic conditions.
Resumo:
The potential for using imidacloprid (a neonicotinoid) and indoxacarb (an oxadiazine) as grain protectants was investigated in bioassays against resistant strains of five stored grain beetles. The species investigated were Rhyzopertha dominica (F.) (the lesser grain borer), Sitophilus oryzae (L.) (the rice weevil), Tribolium castaneum (Herbst) (the rust-red flour beetle), Oryzaephilus surinamensis (L.) (the saw tooth flour beetle), and Cryptolestes ferrugineus (Stephens) (the flat grain beetle). Each of these species has developed resistance to one or more protectants, including organophosphorus insecticides, synthetic pyrethroids and the juvenile hormone analogue methoprene. Mortality and reproduction after a 2-week exposure of adults to treated wheat depended on species, dose and insecticide. Imidacloprid had no effect on S. oryzae at any dose, but none of the other species produced any live progeny at 10 mg/kg. Indoxacarb had no effect on T. castaneum at any dose, but none of the other species produced any live progeny at 5 mg/kg. The results show that although both imidacloprid and indoxacarb can control at least four of the five key pests tested at doses comparable to those used for organophosphorus protectants, more potent neonicotinoid or oxadiazine insecticides would be needed than either of these to provide broad spectrum protection of stored grain.
Resumo:
Microbes and their exopolysaccharides (EPS) can block xylem vessels, thereby increasing the hydraulic resistance and decreasing the vase life of cut flowers and foliage. Scanning electron microscopy (SEM) provides a powerful tool for investigation of bacteria-induced xylem occlusion. However, conventional preparation protocols for SEM involving chemicals can cause loss of hydrated EPS material, and thereby damage the bacterial biofilms during dehydration. A modified chemical fixation protocol involving pre-fixation with 75 mM lysine plus 2.5% glutaraldehyde followed by the normal fixation in 3% glutaraldehyde was, therefore, tested for improved preservation of bacterial biofilm at the stem-ends of cut Acacia holosericea foliage stems. Stem-end segments with different stages of bacterial growth were obtained from stems stood into water. The lysine-based protocol was compared with four other processing protocols of critical point drying (CPD) without fixation (control), freeze-drying (FD), conventional chemical fixation followed by drying with hexamethyldisilazane (HMDS), and conventional chemical fixation with CPD. The non-fixed control. FD and the glutaraldehyde fixation with HMDS drying gave poor preservation of hydrated material, including bacterial EPS. Conventional glutaraldehyde fixation followed by CPD was superior to these three methods in terms of better preserving the EPS. However, this fourth method gave condensation of biofilms during dehydration. In contrast, the modified lysine-based protocol resulted in superior preservation of EPS and biofilm structure. Thus, this fifth method was the most appropriate for examination of bacterial stem-end blockage in cut ornamentals. (C) 2012 Elsevier B.V. All rights reserved.
Resumo:
Maintaining a high rate of water uptake is crucial for maximum longevity of cut stems. Physiological gel/tylosis formation decreases water transport efficiency in the xylem. The primary mechanism of action for post-harvest Cu2+ treatments in improving cut flower and foliage longevity has been elusive. The effect of Cu2+ on wound-induced xylem vessel occlusion was investigated for Acacia holosericea A. Cunn. ex G. Don. Experiments were conducted using a Cu2+ pulse (5 h, 2.2 mM) and a Cu2+ vase solution (0.5 mM) vs a deionized water (DIW) control. Development of xylem blockage in the stem-end region 10 mm proximal to the wounded stem surface was examined over 21 days by light and transmission electron microscopy. Xylem vessels of stems stood into DIW were occluded with gels secreted into vessel lumens via pits from surrounding axial parenchyma cells. Gel secretion was initiated within 1-2 days post-wounding and gels were detected in the xylem from day 3. In contrast, Cu2+ treatments disrupted the surrounding parenchyma cells, thereby inhibiting gel secretion and maintaining the vessel lumens devoid of occlusions. The Cu2+ treatments significantly improved water uptake by the cut stems as compared to the control. © 2013 Scandinavian Plant Physiology Society.