Status of resistance to phosphine in insect pests of stored products in Vietnam

In response to numerous reports of failures to control insect pests of stored products with phosphine in Vietnam, a national survey for resistance to this key fumigant was undertaken in 2009–2011. Data from a more limited survey undertaken by the authors in 2002 in northern Vietnam are also presented. Samples collected in the 2002 survey (Sitophilus oryzae, n=8; Tribolium castaneum, n=8) were tested using a full dose- response assay, while for the 2009–11 survey, F1 generations were tested for resistance with two discriminating dosages of phosphine to detect frequency of weak and strong resistance phenotypes. Compared with a susceptible reference strain, in 2002, resistance to phosphine was indicated in six T. castaneum samples but only two of S. oryzae. Resistance factor, however, did not exceed 2.8-fold in T. castaneum and 1.7 in S. oryzae indicating relatively low frequency and weak expression of resistance. In 2009–11 survey, 176 samples were collected from a range of food and feed storages along the supply chain and from all major regions of Vietnam (125 sites). Rhyzopertha dominica and S. oryzae were the most common species found infesting stored commodities. Resistance was detected at high frequency in all the species. Weak and strong resistance phenotype frequencies were, respectively: Cryptolestes ferrugineus (37 and 58%, n=19), R. dominica (1.5 and 97%, n=65), S. oryzae (34 and 59%, n=82) and T. castaneum (70 and 30%, n=10). Strong resistance phenotype was detected in all the major regions and all parts of the supply chain but frequency was the highest in central storages and animal feed establishments. The increase in frequency and strength of resistance to phosphine in the eight years between the two surveys has been rapid and dramatic. The survey demonstrates the threat of resistance to grain protection in Vietnam and highlights the need for training of fumigators, and the development and adoption of phosphine resistance management tactics nationally.

Developing a commercial hot water treatment to control post-harvest rots on ‘Fiji Red’ papaya

Fiji exports approximately 800 t year-1 of 'Solo Sunrise' papaya marketed as 'Fiji Red' to international markets which include New Zealand, Australia and Japan. The wet weather conditions from November to April each year result in a significant increase in fungal diseases present in Fiji papaya orchards. The two major pathogens that are causing significant post-harvest losses are: stem end rot (Phytophthora palmivora) and anthracnose (Colletotrichum spp.). The high incidence of post-harvest rots has led to increased rejection rates all along the supply chain, causing a reduction in income to farmers, exporters, importers and retailers of Fiji papaya. It has also undermined the superior quality reputation on the market. In response to this issue, the Fiji Papaya industry led by Nature's Way Cooperative, embarked on series of trials supported by the Australian Centre for International Agricultural Research (ACIAR) to determine the most effective and economical post-harvest control in Fiji papaya. Of all the treatments that were examined, a hot water dip treatment was selected by the industry as the most appropriate technology given the level of control that it provide, the cost effectiveness of the treatment and the fact that it was non-chemical. A commercial hot water unit that fits with the existing quarantine treatment and packing facilities has been designed and a cost benefit analysis for the investment carried out. This paper explores the research findings as well as the industry process that has led to the commercial uptake of this important technology.

Resource use and greenhouse gas emissions from grain-finishing beef cattle in seven Australian feedlots: a life cycle assessment

Grain finishing of cattle has become increasingly common in Australia over the past 30 years. However, interest in the associated environmental impacts and resource use is increasing and requires detailed analysis. In this study we conducted a life cycle assessment (LCA) to investigate impacts of the grain-finishing stage for cattle in seven feedlots in eastern Australia, with a particular focus on the feedlot stage, including the impacts from producing the ration, feedlot operations, transport, and livestock emissions while cattle are in the feedlot (gate-to-gate). The functional unit was 1 kg of liveweight gain (LWG) for the feedlot stage and results are included for the full supply chain (cradle-to-gate), reported per kilogram of liveweight (LW) at the point of slaughter. Three classes of cattle produced for different markets were studied: short-fed domestic market (55–80 days on feed), mid-fed export (108–164 days on feed) and long-fed export (>300 days on feed). In the feedlot stage, mean fresh water consumption was found to vary from 171.9 to 672.6 L/kg LWG and mean stress-weighted water use ranged from 100.9 to 193.2 water stress index eq. L/kg LWG. Irrigation contributed 57–91% of total fresh water consumption with differences mainly related to the availability of irrigation water near the feedlot and the use of irrigated feed inputs in rations. Mean fossil energy demand ranged from 16.5 to 34.2 MJ lower heating values/kg LWG and arable land occupation from 18.7 to 40.5 m2/kg LWG in the feedlot stage. Mean greenhouse gas (GHG) emissions in the feedlot stage ranged from 4.6 to 9.5 kg CO2-e/kg LWG (excluding land use and direct land-use change emissions). Emissions were dominated by enteric methane and contributions from the production, transport and milling of feed inputs. Linear regression analysis showed that the feed conversion ratio was able to explain >86% of the variation in GHG intensity and energy demand. The feedlot stage contributed between 26% and 44% of total slaughter weight for the classes of cattle fed, whereas the contribution of this phase to resource use varied from 4% to 96% showing impacts from the finishing phase varied considerably, compared with the breeding and backgrounding. GHG emissions and total land occupation per kilogram of LWG during the grain finishing phase were lower than emissions from breeding and backgrounding, resulting in lower life-time emissions for grain-finished cattle compared with grass finishing.