Application of commercially available, low-cost, miniaturised NIR spectrometers to the assessment of the sugar content of intact fruit

Recent decreases in costs, and improvements in performance, of silicon array detectors open a range of potential applications of relevance to plant physiologists, associated with spectral analysis in the visible and short-wave near infra-red (far-red) spectrum. The performance characteristics of three commercially available ‘miniature’ spectrometers based on silicon array detectors operating in the 650–1050-nm spectral region (MMS1 from Zeiss, S2000 from Ocean Optics, and FICS from Oriel, operated with a Larry detector) were compared with respect to the application of non-invasive prediction of sugar content of fruit using near infra-red spectroscopy (NIRS). The FICS–Larry gave the best wavelength resolution; however, the narrow slit and small pixel size of the charge-coupled device detector resulted in a very low sensitivity, and this instrumentation was not considered further. Wavelength resolution was poor with the MMS1 relative to the S2000 (e.g. full width at half maximum of the 912 nm Hg peak, 13 and 2 nm for the MMS1 and S2000, respectively), but the large pixel height of the array used in the MMS1 gave it sensitivity comparable to the S2000. The signal-to-signal standard error ratio of spectra was greater by an order of magnitude with the MMS1, relative to the S2000, at both near saturation and low light levels. Calibrations were developed using reflectance spectra of filter paper soaked in range of concentrations (0–20% w/v) of sucrose, using a modified partial least squares procedure. Calibrations developed with the MMS1 were superior to those developed using the S2000 (e.g. coefficient of correlation of 0.90 and 0.62, and standard error of cross-validation of 1.9 and 5.4%, respectively), indicating the importance of high signal to noise ratio over wavelength resolution to calibration accuracy. The design of a bench top assembly using the MMS1 for the non-invasive assessment of mesocarp sugar content of (intact) melon fruit is reported in terms of light source and angle between detector and light source, and optimisation of math treatment (derivative condition and smoothing function).

Ginger (Zingiber officinale) autotetraploids with improved processing quality produced by an in vitro colchicine treatment

Ginger autotetraploids were produced by immersing shoot tips in a 0.5% w/v colchicine, 2% v/v dimethyl sulfoxide solution for 2 h. Stomatal measurements were used as an early indicator of ploidy differences in culture with mean stomata length of tetraploids (49.2 μm) being significantly larger than the diploid (38.8 µm). Of the 500 shoot tips treated, 2% were characterised as stable autotetraploid lines following field evaluation over several seasons. Results were confirmed with flow cytometry and, of the 7 lines evaluated for distinctness and uniformity, 6 were solid tetraploid mutants and 1 was a periclinal chimera. Significant differences were noted between individual tetraploid lines in terms of shoot length, leaf length, leaf width, size of rhizome sections (knob weight) and fibre content. The solid autotetraploid lines had significantly wider, greener leaves than the diploids, they had significantly fewer but thicker shoots and, although ‘Queensland’ (the diploid parent from which the tetraploids were derived) had a greater total rhizome mass at harvest, its knob size was significantly smaller. From the autotetraploid lines, one line was selected for commercial release as ‘Buderim Gold’. It compared the most favourably with ‘Queensland’ in terms of the aroma/flavour profile and fibre content at early harvest, and had consistently good rhizome yield. More importantly it produced large rhizome sections, resulting in a higher recovery of premium grade confectionery ginger and a more attractive fresh market product.

In vitro Induction of Banana Autotetraploids by Colchicine Treatment of Micropropagated Diploids

Alternative breeding strategies, based on colchicine-induced autotetraploids, have been proposed as a means of introducing disease resistance into banana breeding programs. This paper describes techniques for the in vitro induction of banana autotetraploids by the use of colchicine on cultured explants. The technique can be readily applied and large numbers of autotetraploids produced. The optimum treatment involved immersing shoot tips in a 0.5% w/v colchicine solution for 2 h under aseptic conditions. Dimethyl sulfoxide (DMSO) was applied with the colchicine treatments to increase cell permeability and so absorption of colchicine, resulting in the optimum treatment unchanged at 0.5% colchicine, but including the addition of 2% v/v DMSO. Of the shoot tips treated over 30% were induced to the autotetraploid level. Methods for in vitro selection of induced tetraploids from treated diploid plantlets were also developed. Tetraploid plants were more robust with thicker pseudostems, roots and broader leaves than diploids and they could be selected on these morphological characteristics. Mean stornatal lengths of diploid banana plants growing in vitro were significantly smaller (16.0 pm) than the tetraploids (26.9pm) and were used as a more reliable indicator of ploidy than morphological criteria alone. A root tip squash technique using carbol fuchsin was developed for positive confirmation of ploidy change by chromosome counts. Although chimerism and reversion to the diploid form occurred, it was not considered a problem because of the large number of autotetraploids induced. Stable autotetraploids were recovered and established in the field and were characterised by their large, drooping leaves and thick pseudostems. They have retained these characteristics for more than 3 years in the field.

Impact of 1-methylcyclopropene treatment on the sensory quality of 'Bartlett' pear fruit

The ethylene biosynthesis inhibitor, 1-methylcyclopropene (1-MCP), has been commercially used to extend the storage life of European pear fruit and to allow shipment to distant markets. However, the influence of 1-MCP on the ability of fruit to ripen to an acceptable sensory quality has not been investigated in 'Bartlett' pear, one of the most aromatic of pear fruit. In the current study, early-, mid- and late-season 'Bartlett' pear fruit were treated with 0.6μLL-1 1-MCP at 0°C for 24h, 100μLL-1 ethylene at 20°C for 24h, or untreated before immediate transfer to 20°C for ripening until eating soft (13N firmness). Fruit from each treatment were subjected to objective and sensory quality evaluation once ripe. Sensory quality showed differences related to harvest maturity; the importance of harvest maturity depended on the treatment. Treatment with 1-MCP effectively slowed fruit ripening and therefore extended postharvest life, but also resulted in fully ripened pears with more desirable sensory traits, as compared with ethylene-treated and untreated pears. The enhanced sensory quality was related to higher sweetness, juiciness and pear aroma and reduced fermented aroma, gritty texture and tart taste. In addition, the sensory profiles of 1-MCP-treated pears were more stable among fruit from the three harvest dates than the ethylene-treated pears, which exhibited very different sensory profiles between early- and late-season fruits. © 2015 Elsevier B.V.