Using simulation techniques to investigate methods to determine resistance of helminths to anthelmintic treatment

The widespread and increasing resistance of internal parasites to anthelmintic control is a serious problem for the Australian sheep and wool industry. As part of control programmes, laboratories use the Faecal Egg Count Reduction Test (FECRT) to determine resistance to anthelmintics. It is important to have confidence in the measure of resistance, not only for the producer planning a drenching programme but also for companies investigating the efficacy of their products. The determination of resistance and corresponding confidence limits as given in anthelmintic efficacy guidelines of the Standing Committee on Agriculture (SCA) is based on a number of assumptions. This study evaluated the appropriateness of these assumptions for typical data and compared the effectiveness of the standard FECRT procedure with the effectiveness of alternative procedures. Several sets of historical experimental data from sheep and goats were analysed to determine that a negative binomial distribution was a more appropriate distribution to describe pre-treatment helminth egg counts in faeces than a normal distribution. Simulated egg counts for control animals were generated stochastically from negative binomial distributions and those for treated animals from negative binomial and binomial distributions. Three methods for determining resistance when percent reduction is based on arithmetic means were applied. The first was that advocated in the SCA guidelines, the second similar to the first but basing the variance estimates on negative binomial distributions, and the third using Wadley’s method with the distribution of the response variate assumed negative binomial and a logit link transformation. These were also compared with a fourth method recommended by the International Co-operation on Harmonisation of Technical Requirements for Registration of Veterinary Medicinal Products (VICH) programme, in which percent reduction is based on the geometric means. A wide selection of parameters was investigated and for each set 1000 simulations run. Percent reduction and confidence limits were then calculated for the methods, together with the number of times in each set of 1000 simulations the theoretical percent reduction fell within the estimated confidence limits and the number of times resistance would have been said to occur. These simulations provide the basis for setting conditions under which the methods could be recommended. The authors show that given the distribution of helminth egg counts found in Queensland flocks, the method based on arithmetic not geometric means should be used and suggest that resistance be redefined as occurring when the upper level of percent reduction is less than 95%. At least ten animals per group are required in most circumstances, though even 20 may be insufficient where effectiveness of the product is close to the cut off point for defining resistance.

Chemical phytotoxicity testing facility for warm-season turfgrasses

The registration of new agricultural chemicals (particularly herbicides) for turf use requires supporting data on their possible phytotoxic effects across a representative range of turfgrass species and cultivars. This process has been streamlined by the establishment of dedicated phytotoxicity testing site. This facility has enabled phytotoxicity screening of new chemicals to be conducted more quickly, thoroughly and economically than the previous piecemeal ad hoc approach. During the three years of this project, 39 products were screened on the site.

Optimise efficacy of broiler house treatments for the management of lesser mealworm

The Australian chicken meat industry requires effective agents for the management of lesser mealworm in broiler houses. The only two appropriate insecticides currently registered are cyfluthrin and spinosad, with gamma cyhalothrin being developed for registration. The industry requires the efficacy of cyfluthrin to be investigated, with progress and adoption of the latter two chemicals. Optimising the efficacy of each chemical and studying them singly and in rotation will, in addition to improving their efficacy, reduce overall insecticide use and improve their cost effectiveness.

Extension of Chemical Phytotoxicity Testing Facility for Warm-Season Turfgrasses

The turf industry needs to access a range of more selective, effective and environmentally acceptable pesticides, which will help to address environmental concerns while maintaining the industry's internationally competitive status. This includes both new pesticides being developed globally for turf use and older generic chemicals previously registered for other agricultural purposes and now requiring extension of that registration for use in turf.

Herbicides to control poisonous Pimelea species (Thymelaeaceae)

Pimelea poisoning is an ongoing, periodically serious problem for cattle producers in inland Australia. The annual native plants of the Thymelaeaceae family that cause the problem are widespread and animal management is currently the main means of minimizing poisoning. However, there are situations in the higher rainfall parts of the natural distribution area of these plants where farming and quite intensive property development do occur and here the use of selective herbicides may be an option. This research looked for herbicides that could be considered for registration for Pimelea control, bearing in mind the large potential costs involved if used over large areas. Group I hormone herbicides (for example 2,4-D) were quite effective as was metsulfuron-methyl and glyphosate at doses commonly registered for use on broad-leafed weeds. On the basis of minimizing costs and quickly suppressing seed-set, metsulfuron-methyl at 3.5e5 g a.i. ha1 and 2,4-D at 375e500 g a.i. ha1 were the most promising. Where medic (Medicago spp.) persistence is vital, 2,4-DB at 240e300 g a.i. ha1 could be used and glyphosate at 1 kg a.i. ha1 would be effective on fallowed ground if costwas not an overriding concern.

The Use of Australian Honey in Moist Wound Management

This project has investigated the correlation between antimicrobial activity and the non-peroxide activity of particular Leptospermum-derived honeys. Initial investigations tested the efficacy of these honeys against one particular bacteria (Staphylococcus aureus), while later studies assessed the effect of this honey on a range of food pathogens, animal pathogens (e.g. in mastitis) and human pathogens (e.g. golden Staph). Using honeys sourced from around Australia and screened against several reference microorganisms, the anti-microbial potency of one particular Australian honey (from Leptospermum polygalifolium) was shown to be comparable to NZ Manuka honey (from L.scoparium). The results of this screening of active honeys against pathogenic bacteria has supported the registration of honey by Capilano Honey Limited as a “Drug” with the Therapeutic Goods Administration based on its antimicrobial activity.