Use of part records in Merino breeding programs - The inheritance of wool growth and fibre traits during different times of the year to determine their value in Merino breeding programs

Fibre diameter can vary dramatically along a wool staple, especially in the Mediterranean environment of southern Australia with its dry summers and abundance of green feed in spring. Other research results have shown a very low phenotypic correlation between fibre diameter grown between seasons. Many breeders use short staples to measure fibre diameter for breeding purposes and also to promote animals for sale. The effectiveness of this practice is determined by the relative response to selection by measuring fibre traits on a full 12 months wool staple as compared to measuring them only on part of a staple. If a high genetic correlation exists between the part record and the full record, then using part records may be acceptable to identify genetically superior animals. No information is available on the effectiveness of part records. This paper investigated whether wool growth and fibre diameter traits of Merino wool grown at different times of the year in a Mediterranean environment, are genetically the same trait, respectively. The work was carried out on about 7 dyebanded wool sections/animal.year, on ewes from weaning to hogget age, in the Katanning Merino resource flocks over 6 years. Relative clean wool growth of the different sections had very low heritability estimates of less than 0.10, and they were phenotypically and genetically poorly correlated with 6 or 12 months wool growth. This indicates that part record measurement of clean wool growth of these sections will be ineffective as indirect selection criteria to improve wool growth genetically. Staple length growth as measured by the length between dyebands, would be more effective with heritability estimates of between 0.20 and 0.30. However, these measurements were shown to have a low genetic correlation with wool grown for 12 months which implies that these staple length measurements would only be half as efficient as the wool weight for 6 or 12 months to improve total clean wool weight. Heritability estimates of fibre diameter, coefficient of variation of fibre diameter and fibre curvature were relatively high and were genetically and phenotypically highly correlated across sections. High positive phenotypic and genetic correlations were also found between fibre diameter, coefficient of variation of fibre diameter and fibre curvature of the different sections and similar measurements for wool grown over 6 or 12 months. Coefficient of variation of fibre diameter of the sections also had a moderate negative phenotypic and genetic correlation with staple strength of wool staples grown over 6 months indicating that coefficient of variation of fibre diameter of any section would be as good an indirect selection criterion to improve stable strength as coefficient of variation of fibre diameter for wool grown over 6 or 12 months. The results indicate that fibre diameter, coefficient of variation of fibre diameter and fibre curvature of wool grown over short periods of time have virtually the same heritability as that of wool grown over 12 months, and that the genetic correlation between fibre diameter, coefficient of variation of fibre diameter and fibre curvature on part and on full records is very high (rg > 0.85). This indicates that fibre diameter, coefficient of variation of fibre diameter and fibre curvature on part records can be used as selection criteria to improve these traits. However, part records of greasy and clean wool growth would be much less efficient than fleece weight for wool grown over 6 or 12 months because of the low heritability of part records and the low genetic correlation between these traits on part records and on wool grown for 12 months.

The use of temperate species in the Australian subtropics.

Temperate species and tropical crop silage are the basis for forage production for the dairy industry in the Australian subtropics. Irrigation is the key resource needed for production, with little survival of temperate species under rain-grown conditions except for lucerne. Annual ryegrass (Lolium multiflorum), fertilised with either inorganic nitrogen or grown with clovers, is the main cool season forage for the dairy industry. It is sown into fully prepared seedbeds, oversown into tropical grasses, especially kikuyu (Pennisetum clandestinum) or sown after mulching. There has been a continual improvement in the performance of annual and hybrid ryegrass cultivars over the last 25 years. In small plot, cutting experiments, yields of annual ryegrass typically range from 15 to 21 t DM/ha, with equivalent on-farm yields of 7 to 14 t DM/ha of utilised material. Rust (Puccinia coronata) remains the major concern although resistance is more stable than in oats. There have also been major improvements in the performance of perennial ryegrass (L. perenne) cultivars although their persistence under grazing is insufficient to make them a reliable forage source for the subtropics. On the other hand, tall fescue (Festuca arundinacea) and prairie grass (Bromus willdenowii) cultivars perform well under cutting and grazing, although farmer resistance to the use of tall fescue is strong. White clover (Trifolium repens) is a reliable and persistent performer although disease usually reduces its performance in the third year after sowing. Persian (Shaftal) annual clover (T. resupinatum) gives good winter production but the performance of berseem clover (T. alexandrinum) is less reliable and the sub clovers (T. subterraneum) are generally not suited to clay soils of neutral to alkaline pH. Lucerne (Medicago sativa), either as a pure stand or in mixtures, is a high producing legume under both irrigation and natural rainfall. Understanding the importance of leaf and crown diseases, and the development of resistant cultivars, have been the reasons for its reliability. Insects on temperate species are not as serious a problem in the subtropics as in New Zealand (NZ). Fungal and viral diseases, on the other hand, cause many problems and forage performance would benefit from more research into resistance.

The use of plant activators in mango postharvest diseases management

Anthracnose and stem end rots are the main postharvest diseases affecting mangoes in Australia and limiting the shelf life of fruits whenever they are not controlled. The management of these diseases has often relied on the use of fungicide applications either as field spray treatments, postharvest dips or both. Because of concerns with continuous fungicide use, other options for the sustainable management of these diseases are needed. Field trials were conducted to assess the efficacy of three plant activators for the control of these diseases over a 2-year period on 20-year old ‘R2E2’ mango trees in north Queensland. The activators evaluated were: Bion, Kasil and Mangocote. The efficacy of these activators was compared with that of a standard industry field spray program using a combination of fungicides, as well as to un¬treated controls. Conditions favoured good development of the target diseases in both years to be able to differentiate treatment effects. Kasil as a drench was as effective as the standard fungicide program on the management of anthracnose and stem end rots. Bion as foliar sprays showed similar efficacy with its effectiveness comparable with the standard spray program. Both activators had significantly less disease incidences when compared with the untreated control. The third activator, Mangocote was not very effective in controlling the target diseases. Its effect was not significantly better than the untreated controls. The results from this 2-year study suggest that plant activators can play an effective role in mango postharvest disease management. Proper timing could reduce the number of fungicide sprays in an integrated disease management program enabling sustainable yields of quality fruits without the continuous concerns of health and environmental risks from continuous reliance on fungicide use.

The Use of Australian Honey in Moist Wound Management

This project has investigated the correlation between antimicrobial activity and the non-peroxide activity of particular Leptospermum-derived honeys. Initial investigations tested the efficacy of these honeys against one particular bacteria (Staphylococcus aureus), while later studies assessed the effect of this honey on a range of food pathogens, animal pathogens (e.g. in mastitis) and human pathogens (e.g. golden Staph). Using honeys sourced from around Australia and screened against several reference microorganisms, the anti-microbial potency of one particular Australian honey (from Leptospermum polygalifolium) was shown to be comparable to NZ Manuka honey (from L.scoparium). The results of this screening of active honeys against pathogenic bacteria has supported the registration of honey by Capilano Honey Limited as a “Drug” with the Therapeutic Goods Administration based on its antimicrobial activity.

Use of sulfuryl fluoride in the management of strongly phosphine-resistant insect pest populations in bulk grain storages in Australia

Sulfuryl fluoride (SF), an effective structural fumigant, is registered recently as Profume™ for controlling insect pests of stored grains and processed commodities. Information on its effectiveness in disinfestation of bulk grain, however, is limited. The ongoing problem with the strong level of resistance to phosphine has been addressed recently through deployment of SF as a ‘resistance breaker’ in bulk storages in Australia. This paper discusses important results on the efficacy of SF against key phosphine- resistant insect pests, lesser grain borer, Rhyzopertha dominca, red flour beetle, Tribolium castaneum, rice weevil, Sitophilus oryzae and the rusty grain beetle, Cryptolestes ferrugineus. We have established CT (g-hm3) profiles for SF against these insect pests at two temperature regimes 25 and 30°C, that showed that both temperature and exposure period (t) has significant influence on the effectiveness of SF than the concentration. Over a seven days fumigation period, CTs of 800 and 400 g-hm3 achieved complete control of all the target pests, including the most strongly phosphine - resistant species, C. ferrugineus at 25 and 30°C, respectively. Results from four industry scale field trials involving currently registered rate of SF (1500 g-hm3) over 2–14 d exposure period, confirmed its effectiveness in achieving complete control of the target pest species. The assessment of postfumigation grain samples across all the test storages indicated that the reinfestation occurs after three months. Monitoring resistance to phosphine in C. ferrugineus over a six year period (2009–2015), showed a significant reduction in resistant populations after the introduction of SF into the fumigation strategy at problematic storage sites. Overall our research concludes that SF is a good candidate to be used as a ‘resistance breaker’ where phosphine resistance is prevalent.

Use of business analysis in beef businesses to direct management practice change for climate adaptation outcomes

Beef businesses in northern Australia are facing increased pressure to be productive and profitable with challenges such as climate variability and poor financial performance over the past decade. Declining terms of trade, limited recent gains in on-farm productivity, low profit margins under current management systems and current climatic conditions will leave little capacity for businesses to absorb climate change-induced losses. In order to generate a whole-of-business focus towards management change, the Climate Clever Beef project in the Maranoa-Balonne region of Queensland trialled the use of business analysis with beef producers to improve financial literacy, provide a greater understanding of current business performance and initiate changes to current management practices. Demonstration properties were engaged and a systematic approach was used to assess current business performance, evaluate impacts of management changes on the business and to trial practices and promote successful outcomes to the wider industry. Focus was concentrated on improving financial literacy skills, understanding the business’ key performance indicators and modifying practices to improve both business productivity and profitability. To best achieve the desired outcomes, several extension models were employed: the ‘group facilitation/empowerment model’, the ‘individual consultant/mentor model’ and the ‘technology development model’. Providing producers with a whole-of-business approach and using business analysis in conjunction with on-farm trials and various extension methods proved to be a successful way to encourage producers in the region to adopt new practices into their business, in the areas of greatest impact. The areas targeted for development within businesses generally led to improvements in animal performance and grazing land management further improving the prospects for climate resilience.

Using bacteria in banana for efficient use of fertilizer

This project aims to develop sustainable banana production practices by improving efficiency of fertilizer use. We will investigate how we can reintroduce endophytic beneficial bacteria that can be established inside the banana host to provide lasting and durable benefits to growth. In the current research we have been able to isolate bacteria from inside banana and preliminary characterisation indicates isolates with a range of attributes for improved efficiency of fertilizer uptake. Experimentation will include evaluation in vitro and pot trials and field trials using bacteria most likely to increase plant access to nutrients as well to compare nutrient impacts from conventional verses slow release fertilizer.

Learning from the past to predict the future: an historical analysis of grass invasions in northern Australia

An important focus of biosecurity is anticipating future risks, but time lags between introduction, naturalisation, and (ultimately) impact mean that future risks can be strongly influenced by history. We conduct a comprehensive historical analysis of tropical grasses (n = 155) that have naturalised in Australia since European settlement (1788) to determine what factors shaped historical patterns of naturalisation and future risks, including for the 21 species that cause serious negative impacts. Most naturalised species were from the Old World (78 %), were introduced for use in pasture (64.5 %), were first recorded prior to 1940 (84.5 %) and naturalised before 1980 (90.3 %). Patterns for high-impact species were similar, with all being first recorded in Australia by 1940, and only seven naturalised since then-five intentionally introduced as pasture species. Counter to expectations, we found no evidence for increased naturalisation with increasing trade, including for species introduced unintentionally for which the link was expected to be strongest. New pathways have not emerged since the 1930s despite substantial shifts in trading patterns. Furthermore, introduction and naturalisation rates are now at or approaching historically low levels. Three reasons were identified: (1) the often long lag phase between introduction and reported naturalisation means naturalisation rates reflect historical trends in introduction rates; (2) important introduction pathways are not directly related to trade volume and globalisation; and (3) that species pools may become depleted. The last of these appears to be the case for the most important pathway for tropical grasses, i.e. the intentional introduction of useful pasture species. Assuming that new pathways don't arise that might result in increased naturalisation rates, and that current at-border biosecurity practices remain in place, we conclude that most future high-impact tropical grass species are already present in Australia. Our results highlight the need to continually test underlying assumptions regarding future naturalisation rates of high-impact invasive species, as conclusions have important implications for how best to manage future biosecurity risks.