WHIPPET: a novel tool for prioritizing invasive plant populations for regional eradication

Large geographic areas can have numerous incipient invasive plant populations that necessitate eradication. However, resources are often deficient to address every infestation. Within the United States, weed lists (either state-level or smaller unit) generally guide the prioritization of eradication of each listed species uniformly across the focus region. This strategy has several limitations that can compromise overall effectiveness, which include spending limited resources on 1) low impact populations, 2) difficult to access populations, or 3) missing high impact populations of low priority species. Therefore, we developed a novel science-based, transparent, analytical ranking tool to prioritize weed populations, instead of species, for eradication and tested it on a group of noxious weeds in California. For outreach purposes, we named the tool WHIPPET (Weed Heuristics: Invasive Population Prioritization for Eradication Tool). Using the Analytic Hierarchy Process that included expert opinion, we developed three major criteria, four sub-criteria, and four sub-sub-criteria, taking into account both species and population characteristics. Subject matter experts weighted and scored these criteria to assess the relative impact, potential spread, and feasibility of eradication (major criteria) for 100 total populations of 19 species. Species-wide population scores indicated that conspecific populations do not necessarily group together in the final ranked output. Thus, priority lists based solely on species-level characteristics are less effective compared to a blended prioritization based on both species attributes and individual population and site parameters. WHIPPET should facilitate a more efficacious decision-making process allocating limited resources to target invasive plant infestations with the greatest predicted impacts to the region under consideration.

Impact of low temperature storage on active and storage forms of folate in choy sum (Brassica rapa subsp parachinensis)

Choy sum (Brassica rapa subsp. parachinensis) is a dark green leafy vegetable that contains high folate (vitamin B9) levels comparable to spinach. Folate is essential for the maintenance of human health and is obtained solely through dietary means. Analysis of the edible portion of choy sum by both microbiological assay and LC-MS/MS indicated that total folate activity remained significantly unchanged over 3 weeks storage at 4 degrees C. Inedible fractions consisted primarily of outer leaves, which showed signs of rotting after 14d, and a combination of rotting and yellowing after 21 d, contributing to 20% and 40% of product removal, respectively. Following deconjugation of the folate present in choy sum to monoglutamate and diglutamate derivatives, the principal forms (vitamers) of folate detected in choy sum were 5-methyltetrahydrofolate and 5-formyl tetrahydrofolate, followed by tetrahydrofolate (THF), 5,10-methenyl-THF, and 10-formyl folic acid. During storage, a significant decline in 5-formyl-THF was observed, with a slight but not significant increase in the combined 5-methyl-THF derivatives. The decline in 5-formyl-THF in relation to the other folate vitamers present may indicate that 5-formyl-THF is being utilised as a folate storage reserve, being interconverted to more metabolically active forms of folate, such as 5-methyl-THF. Although folate vitamer profile changed over the storage period, total folate activity did not significantly change. From a human nutritional perspective this is important, as while particular folate vitamers (e.g. 5-methyl-THF) are necessary for maintaining vital aspects of plant metabolism, it is less important to the human diet, as humans can absorb and interconvert multiple forms of folate. The current trial indicates that it is possible to store choy sum for up to 3 weeks at 4 degrees C without significantly affecting total folate concentration of the edible portion. Crown Copyright (C) 2012 Published by Elsevier B.V. All rights reserved.

Increased reproductive success in older female red kangaroos and the impact of harvesting

Wildlife harvesting has a long history in Australia, including obvious examples of overexploitation. Not surprisingly, there is scepticism that commercial harvesting can be undertaken sustainably. Kangaroo harvesting has been challenged regularly at Administrative Appeals Tribunals and elsewhere over the past three decades. Initially, the concern from conservation groups was sustainability of the harvest. This has been addressed through regular, direct monitoring that now spans > 30 years and a conservative harvest regime with a low risk of overharvest in the face of uncertainty. Opposition to the harvest now continues from animal rights groups whose concerns have shifted from overall harvest sustainability to side effects such as animal welfare, and changes to community structure, genetic composition and population age structure. Many of these concerns are speculative and difficult to address, requiring expensive data. One concern is that older females are the more successful breeders and teach their daughters optimal habitat and diet selection. The lack of older animals in a harvested population may reduce the fitness of the remaining individuals; implying population viability would also be compromised. This argument can be countered by the persistence of populations under harvesting without any obvious impairment to reproduction. Nevertheless, an interesting question is how age influences reproductive output. In this study, data collected from a number of red kangaroo populations across eastern Australia indicate that the breeding success of older females is up to 7-20% higher than that of younger females. This effect is smaller than that of body condition and the environment, which can increase breeding success by up to 30% and 60% respectively. Average age of mature females in a population may be reduced from 9 to 6 years old, resulting in a potential reduction in breeding success of 3-4%. This appears to be offset in harvested populations by improved condition of females from a reduction in kangaroo density. There is an important recommendation for management. The best insurance policy against overharvest and unwanted side effects is not research, which could be never-ending. Rather, it is a harvest strategy that includes safeguards against uncertainty such as harvest reserves, conservative quotas and regular monitoring. Research is still important in fine tuning that strategy and is most usefully incorporated as adaptive management where it can address the key questions on how populations respond to harvesting.

Variation in water extraction with maize plant density and its impact on model application

The use of maize simulation models to determine the optimum plant population for rainfed environments allows the evaluation of plant populations over multiple years and locations at a lower cost than traditional field experimentation. However the APSIM maize model that has been used to conduct some of these 'virtual' experiments assumes that the maximum rate of soil water extraction by the crop root system is constant across plant populations. This untested assumption may cause grain yield to be overestimated in lower plant populations. A field experiment was conducted to determine whether maximum rates of water extraction vary with plant population, and the maximum rate of soil water extraction was estimated for three plant populations (2.4, 3.5 and 5.5 plants m(-2)) under water limited conditions. Maximum soil water extraction rates in the field experiment decreased linearly with plant population, and no difference was detected between plant populations for the crop lower limit of soil water extraction. Re-analysis of previous maize simulation experiments demonstrated that the use of inappropriately high extraction-rate parameters at low plant populations inflated predictions of grain yield, and could cause erroneous recommendations to be made for plant population. The results demonstrate the importance of validating crop simulation models across the range of intended treatments. (C) 2013 Elsevier E.V. All rights reserved.

Spatial impact of projected changes in rainfall and temperature on wheat yields in Australia

Climate projections over the next two to four decades indicate that most of Australia’s wheat-belt is likely to become warmer and drier. Here we used a shire scale, dynamic stress-index model that accounts for the impacts of rainfall and temperature on wheat yield, and a range of climate change projections from global circulation models to spatially estimate yield changes assuming no adaptation and no CO2 fertilisation effects. We modelled five scenarios, a baseline climate (climatology, 1901–2007), and two emission scenarios (“low” and “high” CO2) for two time horizons, namely 2020 and 2050. The potential benefits from CO2 fertilisation were analysed separately using a point level functional simulation model. Irrespective of the emissions scenario, the 2020 projection showed negligible changes in the modelled yield relative to baseline climate, both using the shire or functional point scale models. For the 2050-high emissions scenario, changes in modelled yield relative to the baseline ranged from −5 % to +6 % across most of Western Australia, parts of Victoria and southern New South Wales, and from −5 to −30 % in northern NSW, Queensland and the drier environments of Victoria, South Australia and in-land Western Australia. Taking into account CO2 fertilisation effects across a North–south transect through eastern Australia cancelled most of the yield reductions associated with increased temperatures and reduced rainfall by 2020, and attenuated the expected yield reductions by 2050.

Impact of nitrification inhibitor (DMPP) on soil nitrous oxide emissions from an intensive broccoli production system in sub-tropical Australia

Vegetable cropping systems are often characterised by high inputs of nitrogen fertiliser. Elevated emissions of nitrous oxide (N2O) can be expected as a consequence. In order to mitigate N2O emissions from fertilised agricultural fields, the use of nitrification inhibitors, in combination with ammonium based fertilisers, has been promoted. However, no data is currently available on the use of nitrification inhibitors in sub-tropical vegetable systems. A field experiment was conducted to investigate the effect of the nitrification inhibitor 3,4-dimethylpyrazole phosphate (DMPP) on N2O emissions and yield from broccoli production in sub-tropical Australia. Soil N2O fluxes were monitored continuously (3 h sampling frequency) with fully automated, pneumatically operated measuring chambers linked to a sampling control system and a gas chromatograph. Cumulative N2O emissions over the 5 month observation period amounted to 298 g-N/ha, 324 g-N/ha, 411 g-N/ha and 463 g-N/ha in the conventional fertiliser (CONV), the DMPP treatment (DMPP), the DMMP treatment with a 10% reduced fertiliser rate (DMPP-red) and the zero fertiliser (0N), respectively. The temporal variation of N2O fluxes showed only low emissions over the broccoli cropping phase, but significantly elevated emissions were observed in all treatments following broccoli residues being incorporated into the soil. Overall 70–90% of the total emissions occurred in this 5 weeks fallow phase. There was a significant inhibition effect of DMPP on N2O emissions and soil mineral N content over the broccoli cropping phase where the application of DMPP reduced N2O emissions by 75% compared to the standard practice. However, there was no statistical difference between the treatments during the fallow phase or when the whole season was considered. This study shows that DMPP has the potential to reduce N2O emissions from intensive vegetable systems, but also highlights the importance of post-harvest emissions from incorporated vegetable residues. N2O mitigation strategies in vegetable systems need to target these post-harvest emissions and a better evaluation of the effect of nitrification inhibitors over the fallow phase is needed.