Pasture production and composition response after killing Eucalypt trees with herbicides in central Queensland

Clearing woodlands is practised world-wide to increase crop and livestock production, but can result in unintended consequences including woody regrowth and land degradation. The pasture response of 2 eucalypt woodlands in the central Queensland rangelands to killing trees with herbicides, in the presence or absence of grazing and regular spring burning, was recorded over 7 or 8 years to determine the long-term sustainability of these common practices. Herbage mass and species composition plus tree dynamics were monitored in 2 replicated experiments at each site. For 8 years following herbicide application, killing Eucalyptus populnea F. Muell. (poplar box) trees resulted in a doubling of native pasture herbage mass from that of the pre-existing woodland, with a tree basal area of 8.7 m2 ha-1. Conversely, over 7 years with a similar range of seasons, killing E. melanophloia F. Muell. (silver-leaved ironbark) trees of a similar tree basal area had little impact on herbage mass grown or on pasture composition for the first 4 years before production then increased. Few consistent changes in pasture composition were recorded after killing the trees, although there was an increase in the desirable grasses Dichanthium sericeum (R. Br.) A. Camus (Queensland bluegrass) and Themeda triandra Forssk. (kangaroo grass) when grazed conservatively. Excluding grazing allowed more palatable species of the major grasses to enhance their prominence, but seasonal conditions still had a major influence on their production in particular years. Pasture crown basal area was significantly higher where trees had been killed, especially in the poplar box woodland. Removing tree competition did not have a major effect on pasture composition that was independent of other management impositions or seasons, and it did not result in a rapid increase in herbage mass in both eucalypt communities. The slow pasture response to tree removal at one site indicates that regional models and economic projections relating to tree clearing require community-specific inputs.

Genetic variation in growth and wood-quality traits of Corymbia citriodora subsp. variegata across three sites in south-east Queensland, Australia

Ten growth or wood-quality traits were assessed in three nearby Corymbia citriodora subsp. variegata (CCV) open-pollinated family-within-provenance trials (18 provenances represented by a total of 374 families) to provide information for the development of a breeding program targeting both pulp and solid-wood products. Growth traits (diameter at breast high over bark [DBH], height and conical volume) were assessed at 3 and 7 years of age. Wood-quality traits (density [DEN], Kraft pulp yield [KPY], modulus of elasticity [MoE] and microfibril angle [MfA]) were predicted using near-infrared spectroscopy on wood samples collected from these trials when aged between 10 and 12 years. The high average KPY, DEN and MoE, and low average MfA observed indicates CCV is very suitable for both pulp and timber products. All traits were under moderate to strong genetic control. In across- trials analyses, high (>0.4) heritability estimates were observed for height, DEN, MoE and MfA, while moderate heritability estimates (0.24 to 0.34) were observed for DBH, volume and KPY. Most traits showed very low levels of genotype × site interaction. Estimated age–age genetic correlations for growth traits were strong at both the family (0.97) and provenance (0.99) levels. Relationships among traits (additive genetic correlation estimates) were favourable, with strong and positive estimates between growth traits (0.84 to 0.98), moderate and positive values between growth and wood-quality traits (0.32 to 0.68), moderate and positive between KPY and MoE (0.64), and high and positive between DEN and MoE (0.82). However, negative (but favourable) correlations were detected between MfA and all other evaluated traits (−0.31 to −0.96). The genetic correlation between the same trait expressed on two different sites, at family level, ranged from 0.24 to 0.42 for growth traits, and from 0.29 to 0.53 for wood traits. Therefore simultaneous genetic improvement of growth and wood property traits in CCV for the target environment in south-east Queensland should be possible, given the moderate to high estimates of heritability and favourable correlations amongst all traits studied, unless genotype × site interactions are greater than was evident. © 2016 NISC (Pty) Ltd