Stock assessment of whaler and hammerhead sharks (Carcharhinidae and Sphyrnidae) in Queensland

This stock assessment provides detailed results for the most common sharks encountered by Queensland commercial fishers. These sharks come from the whaler (Carcharhinidae) and hammerhead (Sphyrnidae) families and comprise sharpnose sharks (Rhizoprionodon taylori and R. oligolinx), the milk shark (R. acutus), the creek whaler (Carcharhinus fitzroyensis), the hardnose shark (C. macloti), the spot-tail shark (C. sorrah), the Australian blacktip shark (C. tilstoni), the common blacktip shark (C. limbatus), the spinner shark (C. brevipinna), bull and pigeye sharks (C. leucas and C. amboinensis), the winghead shark (Eusphyra blochii), the scalloped hammerhead (Sphyrna lewini) and the great hammerhead (S. mokarran). Reef sharks were excluded because fishery observer data indicated that they were largely spatially segregated from sharks caught in the inshore net fisheries. The three common species of reef sharks in Queensland, which are all whaler sharks, are the grey reef shark Carcharhinus amblyrhynchos, the blacktip reef shark C. melanopterus and the whitetip reef shark Triaenodon obesus.

Status of resistance to phosphine in insect pests of stored products in Vietnam

In response to numerous reports of failures to control insect pests of stored products with phosphine in Vietnam, a national survey for resistance to this key fumigant was undertaken in 2009–2011. Data from a more limited survey undertaken by the authors in 2002 in northern Vietnam are also presented. Samples collected in the 2002 survey (Sitophilus oryzae, n=8; Tribolium castaneum, n=8) were tested using a full dose- response assay, while for the 2009–11 survey, F1 generations were tested for resistance with two discriminating dosages of phosphine to detect frequency of weak and strong resistance phenotypes. Compared with a susceptible reference strain, in 2002, resistance to phosphine was indicated in six T. castaneum samples but only two of S. oryzae. Resistance factor, however, did not exceed 2.8-fold in T. castaneum and 1.7 in S. oryzae indicating relatively low frequency and weak expression of resistance. In 2009–11 survey, 176 samples were collected from a range of food and feed storages along the supply chain and from all major regions of Vietnam (125 sites). Rhyzopertha dominica and S. oryzae were the most common species found infesting stored commodities. Resistance was detected at high frequency in all the species. Weak and strong resistance phenotype frequencies were, respectively: Cryptolestes ferrugineus (37 and 58%, n=19), R. dominica (1.5 and 97%, n=65), S. oryzae (34 and 59%, n=82) and T. castaneum (70 and 30%, n=10). Strong resistance phenotype was detected in all the major regions and all parts of the supply chain but frequency was the highest in central storages and animal feed establishments. The increase in frequency and strength of resistance to phosphine in the eight years between the two surveys has been rapid and dramatic. The survey demonstrates the threat of resistance to grain protection in Vietnam and highlights the need for training of fumigators, and the development and adoption of phosphine resistance management tactics nationally.

Improved models for estimating temporal changes in carbon sequestration in above-ground biomass of mixed-species environmental plantings

Plantings of mixed native species (termed 'environmental plantings') are increasingly being established for carbon sequestration whilst providing additional environmental benefits such as biodiversity and water quality. In Australia, they are currently one of the most common forms of reforestation. Investment in establishing and maintaining such plantings relies on having a cost-effective modelling approach to providing unbiased estimates of biomass production and carbon sequestration rates. In Australia, the Full Carbon Accounting Model (FullCAM) is used for both national greenhouse gas accounting and project-scale sequestration activities. Prior to undertaking the work presented here, the FullCAM tree growth curve was not calibrated specifically for environmental plantings and generally under-estimated their biomass. Here we collected and analysed above-ground biomass data from 605 mixed-species environmental plantings, and tested the effects of several planting characteristics on growth rates. Plantings were then categorised based on significant differences in growth rates. Growth of plantings differed between temperate and tropical regions. Tropical plantings were relatively uniform in terms of planting methods and their growth was largely related to stand age, consistent with the un-calibrated growth curve. However, in temperate regions where plantings were more variable, key factors influencing growth were planting width, stand density and species-mix (proportion of individuals that were trees). These categories provided the basis for FullCAM calibration. Although the overall model efficiency was only 39-46%, there was nonetheless no significant bias when the model was applied to the various planting categories. Thus, modelled estimates of biomass accumulation will be reliable on average, but estimates at any particular location will be uncertain, with either under- or over-prediction possible. When compared with the un-calibrated yield curves, predictions using the new calibrations show that early growth is likely to be more rapid and total above-ground biomass may be higher for many plantings at maturity. This study has considerably improved understanding of the patterns of growth in different types of environmental plantings, and in modelling biomass accumulation in young (<25. years old) plantings. However, significant challenges remain to understand longer-term stand dynamics, particularly with temporal changes in stand density and species composition. © 2014.

A mitochondrial species identification assay for Australian blacktip sharks (Carcharhinus tilstoni, C. limbatus and C. amblyrhynchoides) using real-time PCR and high-resolution melt analysis

Tropical Australian shark fisheries target two morphologically indistinguishable blacktip sharks, the Australian blacktip (Carcharhinus tilstoni) and the common blacktip (C. limbatus). Their relative contributions to northern and eastern Australian coastal fisheries are unclear because of species identification difficulties. The two species differ in their number of precaudal vertebrae, which is difficult and time consuming to obtain in the field. But, the two species can be distinguished genetically with diagnostic mutations in their mitochondrial DNA ND4 gene. A third closely related sister species, the graceful shark C. amblyrhynchoides, can also be distinguished by species-specific mutations in this gene. DNA sequencing is an effective diagnostic tool, but is relatively expensive and time consuming. In contrast, real-time high-resolution melt (HRM) PCR assays are rapid and relatively inexpensive. These assays amplify regions of DNA with species-specific genetic mutations that result in PCR products with unique melt profiles. A real-time HRM PCR species-diagnostic assay (RT-HRM-PCR) has been developed based on the mtDNA ND4 gene for rapid typing of C. tilstoni, C. limbatus and C. amblyrhynchoides. The assay was developed using ND4 sequences from 66 C. tilstoni, 33. C. limbatus and five C. amblyrhynchoides collected from Indonesia and Australian states and territories; Western Australia, the Northern Territory, Queensland and New South Wales. The assay was shown to be 100% accurate on 160 unknown blacktip shark tissue samples by full mtDNA ND4 sequencing.

Harvesting and Collection of Animal Forest Species

The harvest and trade of corals and other benthic organisms from the world’s shallow tropical reefs is a lucrative industry that can have positive socioeconomic benefits for communities while supplying the increasing demand specimens for aquaria and curios. For most countries, this trade has historically been almost entirely unregulated. More recently, in response to concerns about the rapid decline of some reefs in the face of anthropogenic and natural pressures, as well as indications of depletions and even localized extinctions of some species caused by harvesting, there have been attempts to improve the sustainability of the industry. Both developing and developed countries face different impediments to this reform, the most pressing and common of which is the lack of reliable data on world trade through CITES. Thereafter, differences in the processes through which reform can be implemented are based principally on the length of the supply chain from collection to export, the degree of industry stewardship, and resourcing. The coral collection fishery in Queensland, Australia, provides an example where continual improvements in reporting and risk assessments and adopting a comanagement approach are delivering better adaptive management of the resource, although the on-ground sustainability benefits of this approach are still to be tested. A simpler approach to sustainable use of coral is to favor the replacement of wild harvested specimens with those bred or grown entirely in an aquaculture facility (as opposed to merely collected and then grown out in culture). Yet there are major impediments to this change, including the dependence of many public aquaria on the same sources as the hobbyist community, difficulties of culturing some species in captivity, and infrastructure costs. Nevertheless, this approach will likely play an important part in reef conservation efforts in the future.