Evaluation of Ustilago sporoboli-indici as a classical biological control agent for invasive Sporobolus grasses in Australia

Sporobolus pyramidalis, S. africanus, S. natalensis, S. fertilis and S. jacquemontii, known collectively as the weedy Sporobolus grasses, are exotic weeds causing serious economic losses in grazing areas along Australia's entire eastern coast. In one of the first attempts to provide biological control for a grass, the potential of a smut, Ustilago sporoboli-indici, as a biological control agent for all five weedy Sporobolus spp. found in Australia was evaluated in glasshouse studies. Application of basidiospores to 21-day-old Sporobolus seedlings and subsequent incubation in a moist chamber (26 °C, 90% RH, 48 h) resulted in infection of S. pyramidalis, S. africanus, S. natalensis and S. fertilis but not S. jacquemontii. Host-range trials with 13 native Australian Sporobolus spp. resulted in infection of four native species. Evaluation of damage caused by the smut on two Australian native and two weedy Sporobolus spp. showed that the total numbers of flowers infected for the four grasses were in the following order: S. creber > S. fertilis > S. elongatus > S. natalensis with percentage flower infections of 21%, 14%, 12% and 3%, respectively. Significant differences (P = 0.001) were found when the numbers of infected flowers caused by each treatment were compared. The infection of the four native Sporobolus spp. by the smut indicated that it was not sufficiently host specific for release in Australia and the organism was rejected as a potential biological control agent. The implications of these results are discussed.

Studies on the rust Prospodium tuberculatum, a new classical biological control agent released against the invasive alien weed Lantana camara in Australia. 2. Host range

A strain of the rust Prospodium tuberculatum from Brazil was screened as a potential biocontrol agent against 40 Australian Lantana camara forms and 52 closely related, non-target plant species. Results under glasshouse conditions showed that the Brazilian rust strain is pathogenic to only two flower colour forms: pink and pink-edged red. Macro- and microsymptoms were recorded using 11 assessment categories and four susceptibility ratings. No macrosymptoms were observed on any of the non-target plants.

A review of Australian classical biological control of weeds programs and research activities over the past 12 years

Considerable progress has been made towards the successful classical biological control of many of Australia’s exotic weeds over the past decade. Some 43 new arthropod or pathogen agents were released in 19 projects. Effective biological control was achieved in several projects with the outstanding successes being the control of rubber vine, Cryptostegia grandiflora, and bridal creeper, Asparagus asparagoides. Significant developments also occurred in target prioritization, procedures for target and agent approval, funding, infrastructure and cooperation between agencies. Scientific developments included greater emphasis on climate matching, plant and agent phylogeny, molecular diagnostics, agent prioritization and agent evaluation.

Classical Biological Control for the Protection of Natural Ecosystems.

Of the 70 cases of classical biological control for the protection of nature found in our review, there were fewer projects against insect targets (21) than against invasive plants (49), in part, because many insect biological control projects were carried out against agricultural pests, while nearly all projects against plants targeted invasive plants in natural ecosystems. Of 21 insect projects, 81% (17) provided benefits to protection of biodiversity, while 48% (10) protected products harvested from natural systems, and 5% (1) preserved ecosystem services, with many projects contributing to more than one goal. In contrast, of the 49 projects against invasive plants, 98% (48) provided benefits to protection of biodiversity, while 47% (23) protected products, and 25% (12) preserved ecosystem services, again with many projects contributing to several goals. We classified projects into complete control (pest generally no longer important), partial control (control in some areas but not others), and "in progress," for projects in development for which outcomes do not yet exist. For insects, of the 21 projects discussed, 59% (13) achieved complete control of the target pest, 18% (4) provided partial control, and 41% (9) are still in progress. By comparison, of the 49 invasive plant projects considered, 27% (13) achieved complete control, while 33% (16) provided partial control, and 47% (24) are still in progress. For both categories of pests, some projects' success ratings were scored twice when results varied by region. We found approximately twice as many projects directed against invasive plants than insects and that protection of biodiversity was the most frequent benefit of both insect and plant projects. Ecosystem service protection was provided in the fewest cases by either insect or plant biological control agents, but was more likely to be provided by projects directed against invasive plants, likely because of the strong effects plants exert on landscapes. Rates of complete success appeared to be higher for insect than plant targets (59% vs 27%), perhaps because most often herbivores gradually weaken, rather than outright kill, their hosts, which is not the case for natural enemies directed against pest insects. For both insect and plant biological control, nearly half of all projects reviewed were listed as currently in progress, suggesting that the use of biological control for the protection of wildlands is currently very active.

MOE and MOR assessment technologies for improving graded recovery of exotic pines in Australia.

This project was designed to provide the structural softwood processing industry with the basis for improved green and dry grading to allow maximise MGP grade yields, consistent product performance and reduced processing costs. To achieve this, advanced statistical techniques were used in conjunction with state-of-the-art property measurement systems. Specifically, the project aimed to make two significant steps forward for the Australian structural softwood industry: • assessment of technologies, both existing and novel, that may lead to selection of a consistent, reliable and accurate device for the log yard and green mill. The purpose is to more accurately identify and reject material that will not make a minimum grade of MGP10 downstream; • improved correlation of grading MOE and MOR parameters in the dry mill using new analytical methods and a combination of devices. The three populations tested were stiffness-limited radiata pine, strength-limited radiata pine and Caribbean pine. Resonance tests were conducted on logs prior to sawmilling, and on boards. Raw data from existing in-line systems were captured for the green and dry boards. The dataset was analysed using classical and advanced statistical tools to provide correlations between data sets and to develop efficient strength and stiffness prediction equations. Stiffness and strength prediction algorithms were developed from raw and combined parameters. Parameters were analysed for comparison of prediction capabilities using in-line parameters, off-line parameters and a combination of in-line and off-line parameters. The results show that acoustic resonance techniques have potential for log assessment, to sort for low stiffness and/or low strength, depending on the resource. From the log measurements, a strong correlation was found between the average static MOE of the dried boards within a log and the predicted value. These results have application in segregating logs into structural and non-structural uses. Some commercial technologies are already available for this application such as Hitman LG640. For green boards it was found that in-line and laboratory acoustic devices can provide a good prediction of dry static MOE and moderate prediction for MOR.There is high potential for segregating boards at this stage of processing. Grading after the log breakdown can improve significantly the effectiveness of the mill. Subsequently, reductions in non-structural volumes can be achieved. Depending on the resource it can be expected that a 5 to 8 % reduction in non structural boards won’t be dried with an associated saving of $70 to 85/m3. For dry boards, vibration and a standard Metriguard CLT/HCLT provided a similar level of prediction on stiffness limited resource. However, Metriguard provides a better strength prediction in strength limited resources (due to this equipment’s ability to measure local characteristics). The combination of grading equipment specifically for stiffness related predictors (Metriguard or vibration) with defect detection systems (optical or X-ray scanner) provides a higher level of prediction, especially for MOR. Several commercial technologies are already available for acoustic grading on board such those from Microtec, Luxscan, Falcon engineering or Dynalyse AB for example. Differing combinations of equipment, and their strategic location within the processing chain, can dramatically improve the efficiency of the mill, the level of which will vary depending of the resource. For example, an initial acoustic sorting on green boards combined with an optical scanner associated with an acoustic system for grading dry board can result in a large reduction of the proportion of low value low non-structural produced. The application of classical MLR on several predictors proved to be effective, in particular for MOR predictions. However, the usage of a modern statistics approach(chemometrics tools) such as PLS proved to be more efficient for improving the level of prediction. Compared to existing technologies, the results of the project indicate a good improvement potential for grading in the green mill, ahead of kiln drying and subsequent cost-adding processes. The next stage is the development and refinement of systems for this purpose.

Strength and stiffness assessment technologies for improving grading effectiveness of radiata pine wood.

This work was designed to provide the Australian structural radiata pine processing industry with some indications for improving stress grading methods and/or technologies to give an increase in structural grade yields, and significantly reduce processing costs without compromising product quality. To achieve this, advanced statistical techniques were used in conjunction with state-of-the-art property measurement systems applied to the same sample of sawn timber. Acoustic vibration analyses were conducted on green and dry boards. Raw data from existing in-line systems was captured on the same boards. The Metriguard HCLT stress rating system was used as the "reference" machine grading because of its current common use in the industry. A WoodEye optical scanning system and an X-ray LHG scanner were also able to provide relevant information on knots. The data set was analyzed using classical and advanced statistical tools to provide correlations between data sets, and to develop efficient strength and stiffness prediction equations. Reductions in non-structural dry volumes can be achieved..

Assessing the potential of the rust fungus Puccinia spegazzinii as a classical biological control agent for the invasive weed Mikania micrantha in Papua New Guinea

The rust fungus Puccinia spegazzinii was introduced into Papua New Guinea (PNG) in 2008 as a classical biological control agent of the invasive weed Mikania micrantha (Asteraceae), following its earlier release in India, mainland China and Taiwan. Prior to implementing field releases in PNG, assessments were conducted to determine the most suitable rust pathotype for the country, potential for damage to non-target species, most efficient culturing method and potential impact to M. micrantha. The pathotype from eastern Ecuador was selected from the seven pathotypes tested, since all the plant populations evaluated from PNG were highly susceptible to it. None of the 11 plant species (representing eight families) tested to confirm host specificity showed symptoms of infection, supporting previous host range determination. A method of mass-producing inoculum of the rust fungus, using a simple technology which can be readily replicated in other countries, was developed. Comparative growth trials over one rust generation showed that M. micrantha plants infected with the rust generally had both lower growth rates and lower final dry weights, and produced fewer nodes than uninfected plants. There were significant correlations between the number of pustules and (a) the growth rate, (b) number of new nodes and (c) final total dry weight of single-stemmed plants placed in open sunlight and between the number of pustules and number of new nodes of multi-stemmed plants placed under cocoa trees. The trials suggest that field densities of M. micrantha could be reduced if the rust populations are sufficiently high. Crown Copyright (C) 2013 Published by Elsevier Inc. All rights reserved.

Prospects for the classical biological control of Calotropis procera (Apocynaceae) using co-evolved insects

Calotropis procera (Apocynaceae), a native of tropical Africa, the Middle East and the Indian subcontinent, is a serious environmental and rangeland weed of Australia and Brazil. It is also a weed in Hawaii in USA, the Caribbean Islands, the Seychelles, Mexico, Thailand, Vietnam and many Pacific Islands. In the native range C. procera has many natural enemies, thus classical biological control could be the most cost-effective option for its long-term management. Based on field surveys in India and a literature search, some 65 species of insects and five species of mites have been documented on C. procera and another congeneric-invador C. gigantea in the native range. All the leaf-feeding and stem-boring agents recorded on Calotropis spp. have wide host range. Three pre-dispersal seed predators,the Aak weevil Paramecops farinosus and the Aak fruit fly Dacuspersicus in the Indian subcontinent, and the Sodom apple fruit fly Dacus longistylus in the Middle East have been identified as prospective biological control agents based on their field host range. In Australia and Brazil, where C. procera has the potential to spread across vast areas, pre-dispersal seed predators would help to limit the spread of the weed. While the fruits of C. procera vary in size and shape across its range, those from India are similar to the ones in Australia and Brazil. Hence, seed-feeding insects from India are more likely to be suitable due to adaptation to fruit size and morphology. Future survey efforts for potential biological control agents should focus on North Africa.

Overcoming barriers to the successful implementation of a classical biological control strategy for the exotic invasive weed Mikania micrantha in the Asia-Pacific region

Mikania micrantha (Asteraceae) commonly known as mikania, is a major invasive alien plant (IAP) in the tropical humid agricultural and forest zones of the Asia-Pacific region. This fast-growing Neotropical vine is able to smother plants in agricultural ecosystems, agroforestry and natural habitats, reducing productivity and biodiversity. Fungal pathogens were first investigated for the classical biological control of this weed in 1996. This resulted in the selection and screening of the highly host-specific and damaging rust pathogen, Puccinia spegazzinii (Pucciniales). It was first released in India and China in 2005/6, although it is not believed to have established. Since then, it has been released successfully in Taiwan, Papua New Guinea (PNG), Fiji and most recently Vanuatu. The rust has established and is spreading rapidly after applying lessons learned from the first releases on the best rust pathotype and release strategy. In PNG, direct monitoring of vegetation change has demonstrated that the rust is having a significant impact on M. micrantha, with no unpredicted non-target impacts. Despite this, the authorities in many countries where mikania is a problem remain cautious about releasing the rust. In Western Samoa, introduction of the rust was not pursued because of a conflict of interest, and the perception that mikania suppresses even worse weeds. For some, ‘pathophobia’ is still a major obstacle. In Indonesia, where insects for weed CBC have been introduced, pathogens will currently not be considered. In other countries such as Bhutan and Myanmar, there are no baseline data on the presence and impact of IAPs and, with no history of CBC, no institutional framework for implementing this approach. Malaysia has a well-developed framework, but capacity needs to be built in the country. Overall, it remains critical to have champions at decision making levels. Hence, even with an effective ‘off-the-shelf’ agent available, implementation of mikania CBC still requires significant inputs tailored to the countries’ specific needs.