Variation in water extraction with maize plant density and its impact on model application

The use of maize simulation models to determine the optimum plant population for rainfed environments allows the evaluation of plant populations over multiple years and locations at a lower cost than traditional field experimentation. However the APSIM maize model that has been used to conduct some of these 'virtual' experiments assumes that the maximum rate of soil water extraction by the crop root system is constant across plant populations. This untested assumption may cause grain yield to be overestimated in lower plant populations. A field experiment was conducted to determine whether maximum rates of water extraction vary with plant population, and the maximum rate of soil water extraction was estimated for three plant populations (2.4, 3.5 and 5.5 plants m(-2)) under water limited conditions. Maximum soil water extraction rates in the field experiment decreased linearly with plant population, and no difference was detected between plant populations for the crop lower limit of soil water extraction. Re-analysis of previous maize simulation experiments demonstrated that the use of inappropriately high extraction-rate parameters at low plant populations inflated predictions of grain yield, and could cause erroneous recommendations to be made for plant population. The results demonstrate the importance of validating crop simulation models across the range of intended treatments. (C) 2013 Elsevier E.V. All rights reserved.

Profiling ellagic acid content: The importance of form and ascorbic acid levels

As the importance of plant-based antioxidants to human health becomes clearer there is a rapidly expanding search for rich sources of these compounds. Much attention is currently focussed on the antioxidant potential of ellagic acid (EA). Making assessment difficult is that EA occurs in different forms: free EA, EA glycosides and polymeric ellagitannins. The overall structure of these forms has a pronounced effect on their antioxidant efficiency and is responsible for widely differing reactivity, solubility and hence bioavailability properties. Often associated with EA is vitamin C which also contributes to the plant foods total antioxidant activity. Previous studies have suggested that ascorbic acid may have protective effects on the polyphenol content of plants. With a view to gaining evidence that the bioactive forms of vitamin C influence EA content, several fruits with a range of EA and vitamin C contents were examined. To facilitate a more detailed assessment of the selected fruits antioxidant potential the relative proportions of EA forms were also determined. In strawberries and boysenberries EA content was predominantly in the polymeric form (21% and 12% free EA plus EA glycoside vs total EA levels for strawberry and boysenberry respectively), while in Kakadu plum it was mainly in the free form (70% of total EA). An increasing percentage of dehydroascorbic acid (9 to 14% of total vitamin C) indicating enhanced transformation of ascorbic acid to its oxidative degradation product together with stable free EA levels (≈ 950 mg/100 g DW) over the 4 month frozen storage period for the Kakadu plum samples are consistent with a possible protective effect of EA by ascorbic acid.

Optimisation of resin extraction from an Australian arid grass ‘Triodia pungens’ and its preliminary evaluation as an anti-termite timber coating

Spinifex grasses are the dominant vegetative component in Australian grassland habitats, covering approximately 26% of the Australian landmass. Our ongoing work explores the utility of both the cellulosic and resinous components of this abundant biomass for modern applications and a potential economy for our Aboriginal collaborators. This study is focused on the optimisation of a resin extraction process using solvent, and the subsequent evaluation, via a field trial, of the potential use and efficacy of the resin as an anti-termite coating material. Termiticidal performance was evaluated by re-dissolving the extracted resin in acetone and coating on pine timber blocks. The resin-coated and control blocks were then exposed to a colony of Mastotermes darwiniensis’ (Froggatt) termites, which are the most primitive alive and destructive species in subterranean area, at a trial site in northeast Australia, for six months. The results clearly showed that spinifex resin effectively protected the timber from termite attack, while the uncoated control samples were extensively damaged. By demonstrating an enhanced termite resistance, we here report that plant resins that are produced by arid/semi-arid grasses could be potentially used as treatments to prevent termite attack.

High-Throughput Prediction of Acacia and Eucalypt Lignin Syringyl/Guaiacyl Content Using FT-Raman Spectroscopy and Partial Least Squares Modeling

High-throughput techniques are necessary to efficiently screen potential lignocellulosic feedstocks for the production of renewable fuels, chemicals, and bio-based materials, thereby reducing experimental time and expense while supplanting tedious, destructive methods. The ratio of lignin syringyl (S) to guaiacyl (G) monomers has been routinely quantified as a way to probe biomass recalcitrance. Mid-infrared and Raman spectroscopy have been demonstrated to produce robust partial least squares models for the prediction of lignin S/G ratios in a diverse group of Acacia and eucalypt trees. The most accurate Raman model has now been used to predict the S/G ratio from 269 unknown Acacia and eucalypt feedstocks. This study demonstrates the application of a partial least squares model composed of Raman spectral data and lignin S/G ratios measured using pyrolysis/molecular beam mass spectrometry (pyMBMS) for the prediction of S/G ratios in an unknown data set. The predicted S/G ratios calculated by the model were averaged according to plant species, and the means were not found to differ from the pyMBMS ratios when evaluating the mean values of each method within the 95 % confidence interval. Pairwise comparisons within each data set were employed to assess statistical differences between each biomass species. While some pairwise appraisals failed to differentiate between species, Acacias, in both data sets, clearly display significant differences in their S/G composition which distinguish them from eucalypts. This research shows the power of using Raman spectroscopy to supplant tedious, destructive methods for the evaluation of the lignin S/G ratio of diverse plant biomass materials.

Bioactive Properties of Mushroom (Agaricus bisporus) Stipe Extracts

The antibacterial activity and total phenolic (TP) content of Agaricus bisporus stipes were assessed using solvent and water extracts to determine its bioactivity. Extraction methods included accelerated solvent extraction (ASE) and hot water followed by membrane concentration. Water extract from ASE had the highest TP of 1.08 gallic acid equivalents (GAE)/g dry weight (DW) followed by ethanol at 0.61 mg GAE/g DW and 0.11 mg GAE/g DW for acetone. Acetone extracts inhibited Escherichia coli and Staphylococcus aureus at less than 50%; ethanol inhibited E. coli at 61.9% and S. aureus at 56.6%; and ASE water inhibited E. coli at 78.6% and S. aureus at 65.4%. The TP content of membrane concentrated extract of mushroom was 17 mg GAE in 100 mL. Membrane concentrated water extracts had a higher percentage inhibition on S. aureus than E. coli. Overall, the results were promising for further application of mushroom stipe extracts as a functional food additive. Practical Applications Mushrooms are known for their health benefits and have been identified as a good source of nutrients. The highly perishable nature of mushrooms warrants further processing and preservation to minimize losses along the supply chain. This study explores the possibility of adding value to mushroom stipes, a by-product of the fresh mushroom industry. The extracts assessed indicate the antibacterial activity and phenolic content, and the potential of using these extracts as functional ingredients in the food industry. This study provides valuable information to the scientific community and to the industries developing novel ingredients to meet the market demand for natural food additives.

Soybean rotation and crop residue management to reduce nitrous oxide emissions from sugarcane soils

NITROUS OXIDE (N2O) IS a potent greenhouse gas and the predominant ozone-depleting substance in the atmosphere. Agricultural nitrogenous fertiliser use is the major source of human-induced N2O emissions. A field experiment was conducted at Bundaberg from October 2012 to September 2014 to examine the impacts of legume crop (soybean) rotation as an alternative nitrogen (N) source on N2O emissions during the fallow period and to investigate low-emission soybean residue management practices. An automatic monitoring system and manual gas sampling chambers were used to measure greenhouse gas emissions from soil. Soybean cropping during the fallow period reduced N2O emissions compared to the bare fallow. Based on the N content in the soybean crop residues, the fertiliser N application rate was reduced by about 120 kg N/ha for the subsequent sugarcane crop. Consequently, emissions of N2O during the sugarcane cropping season were significantly lower from the soybean cropped soil than those from the conventionally fertilised (145 kg N/ha) soil following bare fallow. However, tillage that incorporated the soybean crop residues into soil promoted N2O emissions in the first two months. Spraying a nitrification inhibitor (DMPP) onto the soybean crop residues before tillage effectively prevented the N2O emission spikes. Compared to conventional tillage, practising no-till with or without growing a nitrogen catch crop during the time after soybean harvest and before cane planting also reduced N2O emissions substantially. These results demonstrated that soybean rotation during the fallow period followed with N conservation management practices could offer a promising N2O mitigation strategy in sugarcane farming. Further investigation is required to provide guidance on N and water management following soybean fallow to maintain sugar productivity.

Benzyl isothiocyanate: maximising production in papaya tissue extracts

Abstract: Although mainly grown for its sweet flavoured fruit, papaya (Carica papaya) has also been used for pharmacological purposes for many years. The reasons for use are varied with one of the best known being its anti-fungal action. Benzyl isothiocyanate (BITC) is the constituent most often implicated in this activity. Isothiocyanates are formed when the enzyme myrosinase catalyses the hydrolysis of the non-bioactive glucosinolates. This occurs when cellular contents come into contact through chewing, cutting or during extraction processes in the laboratory. While this is common in Brassica vegetables, the glucosinolate-myrosinase system is rare in fruit, papaya being a notable exception. It contains benzyl glucosinolate (BG), the glucosinolate precursor of BITC, in significant quantities. Parameters that determine the amount of BITC formed are duration of hydrolysis, presence/absence of nitrile-specifier proteins and BG content of different cultivars and tissues. We experimented with differing BITC extraction solvents, with the intention of developing a low cost, natural anti-fungal extract based on under-utilised papaya tissues. The findings suggest that papaya seeds, particularly from quarter-ripe fruit, have the potential to produce the highest levels of BITC necessary. Furthermore, they compare well with the nitrile-specifier protein-containing garden cress seeds (Lepidium sativum). To utilise the papaya seeds as a BITC source, an organic solvent such as ethanol is required to extract the largely water-insoluble BITC from the hydrolysed papaya seed mixture.

Bioactive Properties of Mushroom (Agaricus bisporus) Stipe Extracts

The antibacterial activity and total phenolic (TP) content of Agaricus bisporus stipes were assessed using solvent and water extracts to determine its bioactivity. Extraction methods included accelerated solvent extraction (ASE) and hot water followed by membrane concentration. Water extract from ASE had the highest TP of 1.08 gallic acid equivalents (GAE)/g dry weight (DW) followed by ethanol at 0.61 mg GAE/g DW and 0.11 mg GAE/g DW for acetone. Acetone extracts inhibited Escherichia coli and Staphylococcus aureus at less than 50%; ethanol inhibited E. coli at 61.9% and S. aureus at 56.6%; and ASE water inhibited E. coli at 78.6% and S. aureus at 65.4%. The TP content of membrane concentrated extract of mushroom was 17 mg GAE in 100 mL. Membrane concentrated water extracts had a higher percentage inhibition on S. aureus than E. coli. Overall, the results were promising for further application of mushroom stipe extracts as a functional food additive. Practical Applications Mushrooms are known for their health benefits and have been identified as a good source of nutrients. The highly perishable nature of mushrooms warrants further processing and preservation to minimize losses along the supply chain. This study explores the possibility of adding value to mushroom stipes, a by-product of the fresh mushroom industry. The extracts assessed indicate the antibacterial activity and phenolic content, and the potential of using these extracts as functional ingredients in the food industry. This study provides valuable information to the scientific community and to the industries developing novel ingredients to meet the market demand for natural food additives.

Water activity of poultry litter: Relationship to moisture content during a grow-out

Poultry grown on litter floors are in contact with their own waste products. The waste material needs to be carefully managed to reduce food safety risks and to provide conditions that are comfortable and safe for the birds. Water activity (Aw) is an important thermodynamic property that has been shown to be more closely related to microbial, chemical and physical properties of natural products than moisture content. In poultry litter, Aw is relevant for understanding microbial activity; litter handling and rheological properties; and relationships between in-shed relative humidity and litter moisture content. We measured the Aw of poultry litter collected throughout a meat chicken grow-out (from fresh pine shavings bedding material to day 52) and over a range of litter moisture content (10–60%). The Aw increased non-linearly from 0.71 to 1.0, and reached a value of 0.95 when litter moisture content was only 22–33%. Accumulation of manure during the grow-out reduced Aw for the same moisture content. These results are relevant for making decisions regarding litter re-use in multiple grow-outs as well as setting targets for litter moisture content to minimise odour, microbial risks and to ensure necessary litter physical conditions are maintained during a grow-out. Methods to predict Aw in poultry litter from moisture content are proposed.

Measuring free ellagic acid: influence of extraction conditions on recovery by studying solubility and UV-Visible spectra

Recent investigations into plant tissues have indicated that the free form of the natural polyphenolic antioxidant, ellagic acid (EA), is much more plentiful than first envisaged; consequently a re-assessment of solvent systems for the extraction of this water-insoluble form is needed. As EA solubility and its UV-Vis spectrum, commonly used for detection and quantification, are both governed by pH, an understanding of this dependence is vital if accurate EA measurements are to be achieved. After evaluating the pH effects on the solubility and UV-Vis spectra of commercial EA, an extraction protocol was devised that promoted similar pH conditions for both standard solutions and plant tissue extracts. The extraction so devised followed by HPLC with photodiode-array detection (DAD) provided a simple, sensitive and validated methodology that determined free EA in a variety of plant extracts. The use of 100 % methanol or a triethanolamine-based mixture as the standard dissolving solvents were the best choices, while these higher pH-generating solvents were more efficient in extracting EA from the plants tested with the final choice allied to the plants’ natural acidity. Two of the native Australian plants anise myrtle (Syzygium anisatum) and Kakadu plum (Terminalia ferdinandiana) exhibited high concentrations of free EA. Furthermore, the dual approach to measuring EA UV-Vis spectra made possible an assessment of the effect of acidified eluent on EA spectra when the DAD was employed.